• Clinics in Shoulder and Elbow
• /
• v.26 no.4
• /
• pp.438-444
• /
• 2023

Irreparable massive rotator cuff tears can significantly impact daily life; and these types of tears can be difficult to repair completely, especially in younger patients who are more active and have higher functional requirements. Since its introduction by Mihata and the colleagues, superior capsular reconstruction (SCR) has gained popularity in the treatment of irreparable massive rotator cuff tears and has shown promising short-term results. A variety of studies have focused on the clinical and biomechanical outcomes of this procedure. This article reviews the biomechanics, indications for the surgical procedure, graft options, surgical technique, and rehabilitation from SCR.

• Progress in Medical Physics
• /
• v.26 no.1
• /
• pp.28-35
• /
• 2015

In this study, we investigated the effects of an iterative reconstruction algorithm and an automatic exposure control (AEC) technique on image quality and radiation dose through phantom experiments with coronary computed tomography (CT) angiography protocols. We scanned the AAPM CT performance phantom using 320 multi-detector-row CT. At the tube voltages of 80, 100, and 120 kVp, the scanning was repeated with two settings of the AEC technique, i.e., with the target standard deviations (SD) values of 33 (the higher tube current) and 44 (the lower tube current). The scanned projection data were reconstructed also in two ways, with the filtered back projection (FBP) and with the iterative reconstruction technique (AIDR-3D). The image quality was evaluated quantitatively with the noise standard deviation, modulation transfer function, and the contrast to noise ratio (CNR). More specifically, we analyzed the influences of selection of a tube voltage and a reconstruction algorithm on tube current modulation and consequently on radiation dose. Reduction of image noise by the iterative reconstruction algorithm compared with the FBP was revealed eminently, especially with the lower tube current protocols, i.e., it was decreased by 46% and 38%, when the AEC was established with the lower dose (the target SD=44) and the higher dose (the target SD=33), respectively. As a side effect of iterative reconstruction, the spatial resolution was decreased by a degree that could not mar the remarkable gains in terms of noise reduction. Consequently, if coronary CT angiogprahy is scanned and reconstructed using both the automatic exposure control and iterative reconstruction techniques, it is anticipated that, in comparison with a conventional acquisition method, image noise can be reduced significantly with slight decrease in spatial resolution, implying clinical advantages of radiation dose reduction, still being faithful to the ALARA principle.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.99-100
• /
• 2016

In a AC motor used by three phase inverter, the phase current must be measured to control instantaneous torque. It is expensive to use current sensor for measuring current in low cost motor. So, shunt resistor is used to measure current. But, the method sensing the phase current using shunt resistor cannot perform the vector control in high speed because of the area that impossible to restore three phase current. In this paper, predictive current is proposed for reconstructing the current in the impossible current sensing area that reduce the current ripple in TSSI(Three shunt sensing inverter) for PMSM.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.6
• /
• pp.33-38
• /
• 2016

Understanding of current features of collapsed buildings, terrain, and other infrastructures is a critical issue for disaster site managers. On the other hand, a comprehensive site investigation of current location of survivors buried under the remains of a building is a difficult task for disaster managers due to the difficulties in acquiring the various information on the disaster sites. To overcome these circumstances, such as large disaster sites and limited capability of rescue workers, this study makes use of a drone (unmanned aerial vehicle) to effectively obtain current image data from large disaster areas. The framework of 3D model reconstruction of disaster sites using aerial imagery acquired by drones was also presented. The proposed methodology is expected to assist fire fighters and workers on disaster sites in making a rapid and accurate identification of the survivors under collapsed buildings.

• International Journal of Highway Engineering
• /
• v.16 no.2
• /
• pp.73-89
• /
• 2014

PURPOSES : The objective of this study is to investigate the current state of the practice, examining the steps in the process recommended by various agencies and the Asphalt Recycling and Reclaiming Association (ARRA)-namely mix design, structural design, structural capacity evaluation, and material characterization-in order to better understand the implications of hot in-place recycling (HIR). METHODS : In addition, the current practice of state departments of transportation (DOTs) is here reviewed with the purpose of learning from successful past experiences so as to forestall any difficulties that may emerge under similar circumstances. Also, HIR benefits, including reduced costs, improved construction processes, and environmental friendliness are presented, as well as advantages and disadvantages of HIR application. RESULTS : Most of the United States highway system is now deteriorating so that rehabilitation or reconstruction techniques are required for the most distressed roads, taking into account ways to increase the effectiveness of existing budgets. Several options are available in rehabilitating distressed roads, and the choice among these depends on many factors, including pavement distress condition, funding, and design life. Among these techniques, Hot In-Place Recycling (HIR) has emerged as a cost-effective treatment for deteriorated pavements, and has been proven an effective long-term strategy for pavement rehabilitation.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2006.05a
• /
• pp.264-267
• /
• 2006

This paper describes the accident analysis by modeling the current transformer mounting in meaium voltage metal-clad switchgear(MCSG). In analyzing the accident the reconstruction at the current transformer mounting(VCB connecting guide) has to be taken into account. The accident was modelled as a 3-phase ground fault mounting between the end plate of a high voltage lines and the safety shutter at the current transformer mounting of the VCB inside the metal clad switchgear. Since the outside maintenance of the metal clad switchgear is restricted by the enclosed compartments, its circumference has to be kept clean. Through the reconstruction results, it was confirmed that the fault of the enclosed switchboard could be reduced when the shutter made of Fe material was changed into an insulation.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.9
• /
• pp.293-299
• /
• 2012

Electrical impedance tomography is an imaging modality for determining the electrical properties inside a domain. Small currents are injected and the resulting voltages are measured through the electrodes. The internal electrical properties are reconstructed based on these voltage and current data. In this paper, a novel on-line Landweber algorithm was developed to fast estimate the resistivity distribution in the inverse calculation. Additionally, to enhance the reconstruction performance, a step-length was computed from the eigenvalue of the weighting matrix. The numerical experiments have been performed to evaluate the reconstruction performance of the proposed method.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2002.05a
• /
• pp.75-80
• /
• 2002

The purpose of this study is to conduct researches on the aspects of reconstruction and remodeling of low-rise, dilapidated apartment buildings in the provinces, using comparative methodologies, consequently coming up with the findings in the following. 1) Unlike the rebuilding projects in which the movement process tends to be made in a bulk (in a simultaneous manner), it turns out that when it comes to remodeling, it would be advisable to attempt moving the inhabitants as a group either by the size of their residence or by the building. 2) Given the peculiarities of the construction management mechanism, remodeling projects might seem disadvantageous on the part of the management on account of inadequate accumulation of information and experience. Hence, based on the impeccable assessment of the current status of the subject buildings from the phase of planning, its imperative to closely look into and take into consideration a variety of direct and/or indirect factors in advance of the implementation. 3) A series of comparative researches from the perspective of economical efficiency that remodeling projects appear profitable considering the overall costs including financial expenses, varied taxes, and so on that will be eventually brought forth during the reconstruction period, and all the more so when allowing for the consequential effects which they ought to have upon the natural and human resources, environmental and ecological condition, business potentials, etc. Amelioration to be desired on the basis of the findings above.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.16 no.4
• /
• pp.359-370
• /
• 1994

The reconstruction of major head and neck defects must be an integral part of the overall cancer treatment plan. The priorities of surgical treatment of head and neck tumor are 1) local tumor control, 2) relief of pain, 3) avoidance of difficult dressing, 4) provision of oral continence, and 5) ability to swallow and manage saliva. The recent advances in reconstructive surgery including the development of musculocutaneous flaps and microvascular free tissue transfer have allowed the surgical restoration of head and neck tumor defects that previously were not possible. These techniques have provided the opportunity to undertake larger, more aggressive resection while at the same time permitting functional rehabilitation. The timing of reconstruction demands on the nature of the resection, the ability of the ablative and reconstructive teams to coordinate efforts, the overall health of the patients, the patient's needs and wishes. So, we report to emphasize current methods for restoring major head and neck tumor defects after tumor ablation, reviewing for the reconstructive operations, postoperative complications, and postoperative sequelae etc, of patients from Jan, 1990 to Dec, 1993.

• Proceedings of the KSME Conference
• /
• 2008.11a
• /
• pp.1527-1532
• /
• 2008

45% of the sports accidents is the knee damage and the representative case is the damage of an Anterior Cruciate Ligament (ACL) and the Posterior Cruciate Ligament(PCL). Although the past different views of ACL reconstruction comes to an agreement, the disputes of PCL is remained yet. The most important engineering approach for these various surgery techniques is accurately to understand and to evaluate the fatigue behavior depending on the stress flow and the stress distribution under the allotted load and the cyclic load, which are caused by the graft fixing device, the proximal tibia of the PCL reconstructing structure. Therefore, this study is the basic research of these above facts. The current transtibial tunnel surgery using the cadaveric Achilles tendon grafts is chosen for the various PCL reconstruction. The relationships between the slippage, the extension ratio, and the slippage ratio by the heel bone fixing method and the soft tissue fixing method of the Achilles tendon were also defined. This research will be the essential data to help the resonable operating techniques for the next PCL reconstruction.