• Journal of Korean Physical Therapy Science
• /
• v.9 no.2
• /
• pp.151-157
• /
• 2002

This study examined the changes in body temperature through conductive heat applied to the body and clarified the influences of body fluid on the thermal effects. Body fluid was measured using the Segmental Bioelectrical Impedance Analysis method. The subjects consisted of 13 men and 14 women. TBW was 37.56 (4.35 L for men and 29.93 (3.12 L for women, with the former being significantly (p<0.01) higher. The amount of body fluid in the right and left legs was 6.46 (0.83 L and 6.39 (0.86 L for men and 4.78 (0.49 L and 4.78 (0.49 L for women, respectively, with men's values being significantly (p<0.01) higher than women's on both the right and left sides. The maximal change in the surface temperature was 33.93 (0.61(C at the start of a warm bath to 3407 (0.61(C after 14 min for men. In contrast, the maximal change was 33.38 (0.99(C at the start to 33.73 (0.86(C after 18 min for women. For the other sites, the maximal temperature in Depths 1 and 2 was attained earlier for men than for women. The decrease in body temperature after the end of warming was more remarkable for men. Men had fluid with a higher conductivity than women, indicating influences of body fluid on the changes in body temperature. There were few changes in body composition with a partial bath having a crossed effect, indicating that this is a safe therapeutic method for elderly people.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4A
• /
• pp.316-323
• /
• 2002

In this paper, we propose a counter-countermeasure (CCM) in a crossed array tracker for efficient target tracking under countermeasures (CM) operated by a target. The proposed CCM adepts two detection bands and uses the signal distribution characteristics to discriminate between the target and the CMs. To avoid wrong detection of a target position due to missing signal pulses, it predicts current target position based on previous target position. To evaluate the performance of the proposed CCM in a crossed array tracker, we perform numerical simulations for target signal extraction and target tracking under various conditions. The simulation results show that the proposed CCM removes the CM effect well and tracks the target efficiently.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.7 no.2
• /
• pp.119-131
• /
• 2005

The two dimensional behaviors of the existing upper tunnel and the ground at crossed area due to the excavation of a lower tunnel were studied experimentally, The model tests were conducted by changing the relative location of the existing upper tunnel and the lower tunnel. The results of the study show that a vertical earth pressure outside the loosened area was increased due to longitudinal arching effect same as a single tunnel. In case vertical distance between the upper and lower tunnel is 0.7 H and 1.0 H respectively (H is a height of the lower tunnel), vertical earth pressure increased in the loosened area behind the tunnel face. But when a vertical distance is 1, 3 H, ground behaviors appeared similarly to a single tunnel.

• Journal of the Korea Safety Management & Science
• /
• v.12 no.1
• /
• pp.199-205
• /
• 2010

The research proposes the three-factor random measurement models for estimating the precision about operator, part, tool, and various measurement environments. The combined model with crossed and nested factors is developed to analyze the approximate F test by degrees of freedom given by Satterthwaite and point estimation of precisions from expected mean square. The model developed in this paper can be extended to the three useful models according to the type of nested designs. The study also provides the three-step procedures to evaluate the measurement precisions using three indexes such as SNR(Signal-To-Noise Ratio), R&R TR(Reproducibility&Repeatability-To-Total Precision Ratio), and PTR(Precision-To-Tolerance Ratio), The procedures include the identification of resolution, the improvement of R&R reduction, and the evaluation of precision effect.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07a
• /
• pp.357-360
• /
• 2005

A novel wide viewing angle flexible liquid crystal display will be demonstrated. The crossed matrix-type micro-cell structure was adopted in this design. The LC domains were divided into four different tilted directions by the combination effect of pixel fringe field and crossed matrix type micro-cell. It can create four domains without rubbing process and form the cell gap without spacer. For flexible color fabrication, a novel inkjet printing technology is adopted. This cost effective wide viewing angle color flexible LCD technology can be a good solution for high performance flexible LCD.

• Journal of the Korean Society of Safety
• /
• v.10 no.3
• /
• pp.47-55
• /
• 1995

We got operational safety limit angle being able to affect operators or materials surrounding the center of vertical line of the hoist on working from the theoretical review and experimental result. Then we inferred the distance to about 1.2m-1.4m from the center which materials hanged on the hook were able to effect to the surround. Therefore, we got about $7^{\circ}$ to the inclined or crossed operational safety limit angle of the crane with 6m lift. Also, we developed heisting rope automatic vertical controller which could control this kind of dangerous operation. And we did experiments again after establishing the inclined or crossed operational safety limit to $7^{\circ}$. The result is satisfied.

• The Korean Journal of Applied Statistics
• /
• v.28 no.5
• /
• pp.1035-1046
• /
• 2015

Variance components models incorporate various random factors in the form of linear models. There are two experimental Layouts for the classification of factors under variance components models: nested classification and crossed classification. We consider two-way variance components models and investigate the effect of experimental Layout on the performance of model selection criteria AIC and BIC. The effect of experimental Layout is studied through a simulation study with various combinations of parameters in a systematic fashion. The simulation study shows differences in performance of model selection methods between the two classification. There is a particular tendency to prefer the smaller model than the true model when the variance component of a nested factor becomes relatively larger than a nesting factor that is persistent even when the sample size is not small.

• Asian-Australasian Journal of Animal Sciences
• /
• v.5 no.3
• /
• pp.419-426
• /
• 1992

After the virtual eradication of cattle during World War II, Papua New Guinea herds were rebuilt with Shorthorn and Aberdeen Angus cattle from Australia. These, and Red Sindhi and Sahiwal, imported in 1952, were considered unsuitable breeds. In 1954, Department of Agriculture, Stock and Fisheries imported three Brahman bulls and three heifers from Texas and in 1960 began importations of Afrikaner from Queensland. In Central Province, Brahmans were crossed with Angus and at Erap (Morobe) the hottest place in Papua New Guinea, Shorthorns were crossed with Afrikaners. In 1965, Brahman and Brahman-cross were sent to Erap. Records of breeding and growth rates were collected for use in upgrading in cattle of the basis of performance, not pedigree. The data are not ideal for genetic analysis, since no control groups were maintained. Birth weights (BWT), weaning weights (WWT) and calving intervals (CI) were analysed for the period 1969-1978. After exclusion of unsatisfactory data, 2,514 calf records were used, including both breeds from 1969 to 1973, but only Brahman-cross subsequently. Breed mean BWT ranged only from 30.6 to 33.8 kg. As Brahman content increased, BWT decreased and WWT increased; within a genotype, there was a negative maternal effect of high Brahman content on BWT and a positive effect on WWT which ranged from 138 to 174 kg. Afrikaner calves had heavier BWT but lighter WWT. As expected, bulls were heaviest, heifers lightest and mature cows bore and reared heavier calves. Calving interval (405 days, equivalent to 90% calving) was unaffected by breed but 4-year old cows averaged 423 days. Breed differences in BWT and WWT are consistent with the body of literature on performance of Brahmans and Afrikaners. Since cattle tick are not present and internal parasites are insignificant at Erap, the superiority of Brahmans indicates that they were better at utilizing the mediocre quality grazing of the Markham Valley or were more heat tolerant. Performance selection over ten years resulted in the virtual elimination of Afrikaners, with the final genotype approximately 9/16 Brahman, 3/8 Shorthorn and 1/16 Afrikaner.

• Wind and Structures
• /
• v.24 no.2
• /
• pp.95-118
• /
• 2017

The present study revealed comparison the pressure distribution on the surfaces of regular cross plan shaped building with angular cross plan shaped building which is being transformed from basic cross plan shaped building through the variation of internal angles between limbs by $15^{\circ}$ for various wind incidence angle from $0^{\circ}$ to $180^{\circ}$ at an interval of $30^{\circ}$. In order to maintain the area same the limbs sizes are slightly increased accordingly. Numerical analysis has been carried out to generate similar nature of flow condition as per IS: 875 (Part -III):1987 (a mean wind velocity of 10 m/s) by using computational fluid dynamics (CFD) with help of ANSYS CFX ($k-{\varepsilon}$ model). The variation of mean pressure coefficients, pressure distribution over the surface, flow pattern and force coefficient are evaluated for each cases and represented graphically to understand extent of nonconformities due to such angular modifications in plan. Finally regular cross shaped building results are compared with wind tunnel results obtained from similar '+' shaped building study with similar flow condition. Reduction in along wind force coefficients for angular crossed shaped building, observed for various skew angles leads to develop lesser along wind force on building compared to regular crossed shaped building and square plan shaped building. Interference effect within the internal faces are observed in particular faces of building for both cases, considerably. Significant deviation is noticed in wind induced responses for angular cross building compared to regular cross shaped building for different direction wind flow.

• Journal of the Korean Data and Information Science Society
• /
• v.19 no.4
• /
• pp.1059-1071
• /
• 2008

In a balanced factorial design with a nested factor where crossed factors as well as a nested factor exist simultaneously, powers of the rank transformed FR statistic for testing the main, nested and interaction effects are superior to those of the parametric F statistic. In heavy tailed distributions such as exponential and double exponential distributions, powers of the FR statistic show much higher level than those of the F statistic. Further powers of the F and FR statistic for testing the main effect show the highest level in an absolute size as compared with powers of the F and FR statistic for testing the nested and interaction effects. However powers of the FR statistic for testing the nested and interaction effects rather than the main effect are greater in a relative size than powers of F statistic for the all population distributions.