• 한국분무공학회지
• /
• 제22권4호
• /
• pp.185-189
• /
• 2017

In Korea, sales of passenger cars using diesel and LPG fuels were continuously increased in recent years. From now on 2030, the registrated vehicles will close in about twenty five million in Korea. From these reason, Investigation on the comparison of exhaust emission characteristics of passenger cars using LPG and Diesel fuel in variation of driving mode and ambient conditions were conducted in this study. Exhaust emission characteristics of test vehicles were measured and analyzed by using chassis dynamometer and emission analyzer. Also, test vehicles were selected on the diesel vehicle with 1.7L engine and LPG vehicle with 2.0L engine. In order to study on emission characteristics according to driving cycles, CVS-75, NEDC, US06, SC03, Cold-FTP and HWFET were applied and the test conditions were set up the cases of A/C on and hot start. From these results, it is revealed that the NOx emission of diesel vehicle was higher than that of LPG vehicle and the case of CO emission shows the opposite patterns. In the HC emission, the emission increasing patterns not showed but the NOx emission of diesel vehicle and CO emission of LPG vehicle were showed the variation patterns according to the various driving modes.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2012년도 제44회 KOSCO SYMPOSIUM 초록집
• /
• pp.269-271
• /
• 2012

To investigate emission characteristics of laminar premixed CH4/air flame, combustion experiments were conducted at three flow rates (5.3L/min, 10.6L/min, 15.5L/min) with changing the combustor pressure(-30Kpa-30Kpa). It was found that with increasing flow rate, NOx emission increased in high pressure condition, while decreased in low pressure condition; and the emission of CO decreased with increasing flow rate. For the influence of pressure, emission of NOx increased with increasing pressure regardless of flow rates, while CO emission decreased on the contrary.

• 설비공학논문집
• /
• 제15권1호
• /
• pp.40-49
• /
• 2003

This study has been conducted to identify and quantify the emissions of Volatile Organic Compounds (VOCs) from a new carpet. The carpet sample consists of polypropylene cushion and latex backing. The VOCs have been sampled on sorbent tubes and analyzed by thermal desorption unit and GC/MSD. For over 240 hours, concentration of VOCs has been measured in a small chamber made of stainless steel. With the measured data, emission factor and mass balance have been considered. The experiments have been conducted in accordance with ASTM D5116-97. The carpet has emitted a variety of VOCs, but in this study, 7 VOCs compounds have been considered： chlorobenzene, ethylbenzene, styrene, isopropylbenzene, bromobenzene, 2-chlorotoluene, and 1,2,3-trimethylbenzene. The results show that the concentrations of VOCs and the emission factors have exponentially decayed from relatively high level to low level with time. The gradients of the concentration of VOCs and emission factors are different for various components. It is found that styrene, 2-chlorotoluene are emitted more than others with higher concentrations.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2021년도 가을 학술논문 발표대회
• /
• pp.86-87
• /
• 2021

As non-road mobile pollutants such as construction equipment are emerging as the main cause of air pollutants emission, construction equipment regulations are gradually strengthening. Research was conducted by correcting the emission coefficient to calculate and predict air pollutant emissions of construction equipment, but it did not reflect site variables such as field and equipment conditions that affect actual emissions. This study derived an Artificial Neural Network emission prediction model based on the actual emission data of excavators and trucks measured at the site and proposed a platform to predict the emission of air pollutants at the site according to the working size and conditions. Through this, it is possible to establish an eco-friendly process plan using a model from the construction plan.

• 한국분무공학회지
• /
• 제22권1호
• /
• pp.8-12
• /
• 2017

Recently, manufacture and sales of passenger car with GDI (Gasoline Direct injection) were dramatically increased in Korea. In this study, investigation on the exhaust emission characteristics of GDI vehicles according to mileage were conducted by using chassis dynamometer and emission analyzer. Test cars selected 5 types with G4FD engine (1600 cc) and emissions of total 14 vehicles analyzed. Measurement and evaluation on emissions (CO, NOx, NMOG, $CO_2$) characteristics of GDI vehicles with mileages from 40,000 to 80,000 km in certification driving cycle (CVS-75) were carried out in this study. It is revealed that emission results of all test cars shows below emission standard, NMOG emission value of about 80,000 km doubled that of 40,000 km and emission increased by accumulated mileage. Also, increasing pattern of NOx emissions shows when the vehicle mileages was increased and $CO_2$ emission increasing trend obviously do not show according to mileages.

• 한국화재소방학회논문지
• /
• 제18권2호
• /
• pp.34-40
• /
• 2004

층류 비예혼합 분류 화염에서 다양한 주파수와 강도로 외부에서 유동장에 자극을 주었을 때 화염의 배출특성과 거동에 대해서 실험적으로 조사하였다. 먼저 일정한 관 공명 주파수에서 가진 강도를 가변시켜 난류화염 된 부상화염에서 질소산화물 배출 지수($EINO_x$)를 측정하였다. 또한, 가진 강도가 일정한 상태에서 주파수를 0 Hz에서 높은 주파수인 2 KHz까지 다양한 주파수 조건으로 가진된 한 경우에도 질소산화물의 배출지수를 측정하였다. 큰 가진 강도의 관공명 주파수로 가진된 경우 부상된 난류화염에서 $NO_x$ 배출 특성은 다음과 같이 크게 세 가지 형태의 특성을 보였다. Group I의 화염에서는 공간적인 섭동이 크며 비교적 화염길이가 길고 높은 $NO_x$ 배출 특성을 보였으며 Group II에서는 상대적으로 짧은 길이와 좁은 폭의 화염거동에 낮은 $NO_x$배출 특성을 보였다. Group III에서는 약간 긴 화염길이에 매우 큰 화염체적으로 상당한 높이까지 시ㆍ공간적으로 섭동이 큰 운동양태로 부상되는 거동과 가장 높은 $NO_x$ 배출 특성을 보였다.

• Journal of Power Electronics
• /
• 제18권3호
• /
• pp.871-878
• /
• 2018

In this paper, the conducted EMI reduction performances of active feed-forward current-sensing current-actuation (CSCA) and voltage-sensing current-actuation (VSCA) filters for a three-phase induction motor drive system are evaluated by experiments. For comparison purposes, the conducted EMI (CM emission, DM emission and total emission) of a three-phase induction motor drive with a conventional CM choke, a conventional CM choke in series with an active VSCA filter, and an active CSCA filter (where the CM choke was modified and used as a sensing current transformer) were compared to the case of a system without any filter inserted. Experimental results show that the active CSCA and VSCA filters can improve the CM reduction performance of the conventional CM choke by about 5 dB especially at low-frequencies. However, for DM comparisons, it shows that there is no different between cases with and without filters inserted.

• 한국전자파학회논문지
• /
• 제24권8호
• /
• pp.798-804
• /
• 2013

본 논문에서는 고주파 회로 모델링을 이용하여 전기자동차의 LDC로부터 방출되는 전도성 전자파 잡음을 시스템-레벨에서 분석하였다. 관련 전도 방출의 주요 원인은 LDC에서 사용하는 펄스폭 변조 방식의 100 kHz 스위칭 동작에 기인하며, 이러한 전도 방출은 공통-임피던스 결합 및 유도성 결합을 통해 AM/FM 주파수 대역에서의 무선주파수 간섭을 유발한다. 이러한 문제를 분석하기 위해 LDC를 구성하고 있는 MOSFET과 고압 커패시터, 고전압 케이블과 버스 바에 대한 기본 회로는 물론, 각 부분에서 존재하는 기생 성분 및 비선형 특성을 해석하여 LDC 전체를 포함한 시스템-레벨의 고주파 등가회로 모델을 제안하였다. 이러한 모델을 이용하여 시뮬레이션과 측정을 비교하여 유사성을 검증하였다. 향후 이러한 접근 방법이 전기자동차의 전자파 적합성 설계에 효과적으로 사용될 수 있을 것으로 기대한다.

• 한국전자파학회논문지
• /
• 제24권1호
• /
• pp.82-90
• /
• 2013

본 논문에서는 고주파 회로 모델링을 이용하여 전기자동차의 모터 구동 시스템으로부터 방출되는 전도성 전자파 노이즈를 시스템-레벨에서 분석하였다. 관련 전도 방출의 주요 원인은 모터 구동 시스템에서 사용하는 펄스폭 변조방식의 스위칭 동작에 기인하며, 이러한 전도 방출은 공통-임피던스 결합 및 유도성 결합을 통해 AM/FM 주파수 대역에서의 무선주파수 간섭을 유발한다. 이러한 문제를 분석하기 위해 모터 구동 시스템을 구성하고 있는 IGBT와 고압 커패시터, 인버터, 모터 및 고전압 케이블과 버스 바에 대한 기본 회로는 물론, 각 부분에서 존재하는 기생 성분 및 비선형 특성을 해석하여 모터 구동 시스템 전체를 포함한 시스템-레벨의 고주파 등가회로 모델을 제안하였다. 이러한 모델을 이용한 모터 구동시스템의 전도 방출 특성을 시뮬레이션하고, 측정하였으며, 비교적 큰 해석구조임에도 불구하고 두 결과가 비교적 잘 일치함을 확인하였다. 향후 이러한 접근방법이 전기자동차의 전자파 적합성 설계에 효과적으로 사용될 수 있을 것으로 기대한다.

• 한국공작기계학회논문집
• /
• 제10권5호
• /
• pp.9-16
• /
• 2001

Turning experiments are conducted to investigate characteristics of acoustic emission due to wear of the coated tool. The AE signals are obtained with a sensor attached to tool holder side. Tool states are identified with scanning electron microscopy and optical microscopy. It is demonstrated that the AE signals provide reliable informations about the cutting processes and tool states. Moreover, tool wear can be detected successfully using the AE-RMS.