• 한국물환경학회지
• /
• 제27권1호
• /
• pp.54-60
• /
• 2011

To evaluate the feasibility of electrodialysis for copper removal from industrial wastewater, the effect of operating parameters on the removal of copper was experimentally estimated. The limiting current density (LCD) linearly increased with the copper concentration and the flow rate. The time when the copper concentration of diluate reaches to 3 mg/L was linearly proportional to initial concentration of diluate, and the concentration of concentrate did not affect the removal rate. Increase in the flow rate gave a positive effect on the removal rate and became insignificant at flow rates greater than 2.4 L/min. The removal rate increased with the applied voltage. From the operation of the electrodialysis module used in this research, the flow rate of 2.4 L/min and the voltage corresponding to the 80~90% of LCD were found be the optimum operating condition for the copper removal from highly concentrated copper solutions.

• 한국농공학회지
• /
• 제40권3호
• /
• pp.83-92
• /
• 1998

Field experiment was performed from August 1996 to January 1998 to examine the applicability of constructed wetland system for wastewater treatment in rural area. The pilot plant was installed in Kon-Kuk University and the school building septic tank effluent was used as an influent to the treatment basin. Hydraulic loading rate was about 0.1 6$0.16^3/m^2$ day and theoretical detention time in the system was 1.38 days. The treatment basin was composed of sand and reed. The influent DO concentration was low and many cases close to zero, but effluent concentration was higher than the influent which implies that oxygen was supplied naturally. The average concentration of influent BOD was 126mg/L, and with average removal rate of 69 % the average effluent concentration was 4Omg/L which satisfied the effluent water quality standard for the system of interest. The average influent concentration of COD was 2Olmg/L and average effluent concentration was 75mg/L with average removal rate of 60%. The performance of BOD and COD tends to deteriorate in the low temperature, and appropriate action needs to be taken during the cold winter time for stable operation. The average influent concentration of SS was 5Omg/L, and effluent was 1 1mg/L with average removal rate of 76% which satisfied the effluent water quality standard for the system of interest. The results for the regulated components, SOD and SS, from the experiment showed that constructed wetland system can meet the effluent water quality standards. The average influent concentration of total phosphorus was 25.6mg/L and average effluent concentration was 7.8mg/L with average removal rate of 63%. Not like the performance of the above components, average nitrogen removal rate was only 11.2% which is not satisfactory. Although, nitrogen is not regulated at this moment, it can cause many environmental problems including eutrophication. Therefore, nitrogen removal efficiency should be improved for actual application. From the result of the field experiment, constructed wetland system was thought to be an appropriate alternative for wastewater treatment in rural area.

• 한국환경보건학회지
• /
• 제22권3호
• /
• pp.56-63
• /
• 1996

The results of the water purification studies using water parsley (Oenanthe javanica) were obtained as follows. The removal rate of nutrient salts increased with longer plant growth periods. The results of this study use the assumption, log(T+1) = $K(C_0-C)^A$, based on Prakish's Theory. The initial concentration was calculated from experimental data. A and K are closely related to the initial concentration. It is possible to model the concentration of residual salts, as time goes by, if concentration is constant. It was observed that water parsley neutralizes acid and alkali substances promptly. The maximum suitable neutralization period is 48 hours. But water parsley withered up in strong acid and alkali solutions within a week. The removal efficiency of Cd progresses in 2 steps, which are unrelated to the initial concentration of Cd. The first part of the curve shows the concentration rapid rate of Cd removal, followed by a levelling off. The removal rate of $NO_x-N$ in the sample water tank containing 0.5 ppm Cd was between 50~80% but the removal rate was less than 20% for the higher concentration. On the other hand, increased amounts of $PO_4-P$ in the sample water tank from the third day on suspected that $PO_4-P$ was desorbed from the water parsley. The accumulation efficiency of Cd in plant was increased in proportion to the initial concentration of Cd. The accumulation phenomenon was observed in the tanks more than 50~100 times.

• 한국물환경학회지
• /
• 제30권1호
• /
• pp.1-7
• /
• 2014

The purpose of this study was to investigate the nitrification characteristics of biological aerated filter (BAF) packed with ceramic media, especially focusing on nitrite build-up during nitrification. When increasing the nitrogen load above $1.63kgNH_4{^+}-N/m^3{\cdot}d$, ammonium removal efficiency decreased to less than 60% and the nitrite ratio ($NO_2{^-}-N/NO_x-N$) of higher than 75% was achieved due to the inhibitory free ammonia (FA, $NH_3-N$) concentration and oxygen limitation. FA inhibition, however, is not recommended strategy to promote nitrite build-up since FA concentration in the reactor is coupled with decreased ammonium removal efficiency. Nitrite ratio in the effluent was also affected by aeration rate and influent ammonium concentration. Ammonium oxidation was enhanced at a higher aeration rate regardless of influent ammonium concentration but, the nitrite ratio was dependent on both aeration rate and influent ammonium concentration. While a higher nitrite ratio was obtained when BAFs were fed with $50mgNH_4{^+}-N/L$ of influent, the nitrite ratio significantly decreased for a greater influent concentration of $200-300mgNH_4{^+}-N/L$. Taken together, aeration rate, influent ammonium concentration and FA concentrations kept in the BAF were found to be critical variables for nitrite accumulation in the BAF system.

• 한국작물학회:학술대회논문집
• /
• 한국작물학회 2017년도 9th Asian Crop Science Association conference
• /
• pp.170-170
• /
• 2017

The highly valued ornamental plant, Platycodon grandiflorum for. duplex was generated by petaloidy of a calyx of Platycodon grandiflorum. The present investigation was executed to explore the several factors having effects on the germination of pollens with a view to acquire the underlying data for the artificial crossing to cultivate the species of Platycodon grandiflorum for. duplex. Both low and high temperature impaired the germination of Platycodon grandiflorum for. duplex pollens. The good germination rate was observed at the temperature of $25^{\circ}C$. The types and concentrations of carbon sources induced the differences in germination rate. The germination rate increased with the increasing concentration of sucrose and glucose except for fructose. Sucrose and glucose showed the highest results at the concentration of 20%. While fructose demonstrated the similar tendency to sucrose and glucose, it reduced the germination rate at the concentration of 20%. The highest germination rate was observed at the concentration of 15%. The appropriate carbon course for germination of pollens of Platycodon grandiflorum for. duplex was glucose of which germination rate was twice as high as that of sucrose and fructose. The germination rate was reduced substantially when the pH was close to alkali, and the potential germination rate was obtained at pH 6. Boric acid enhanced the germination rate at a lower concentration than the higher concentration.

• 한국환경과학회지
• /
• 제17권1호
• /
• pp.97-105
• /
• 2008

This study examined the contaminated soils with an indicator of TPH using SVE (Soil Vapor Extraction) and biological treatments. Their results are as follows. Water content in the polluted soils slowly decreased from 15% during the initial experimental condition to 10% during the final condition. Purification of polluted soils by Bioventing system is likely to hinder the microbial activity due to decrease of water content. Removal rate of TPH in the upper reaction chamber was a half of initial removal rate at the 25th day of the experiment. The removal rate in the lower reaction chamber was 45% with concentration of 995.4 mg/kg. When the Bioventing is used the removal rate at the 14th day of the experiment was 53%, showing 7 day shortenting. Since the Bioventing method control the microbial activity due to dewatering of the polluted soil, SVE method is likely to be preferable to remove in-situ TPH. The reactor that included microbes and nutrients showed somewhat higher removal rate of TPH than the reactor that included nurtients only during experimental period. In general, the concentration showed two times peaks and then decreased, followed by slight variation of the concentration in low concentration levels. Hence, in contrast to SVE treatment, the biological treatment tend to show continuous repetitive peaks of concentration followed by concentration decrease.

• 한국양식학회지
• /
• 제12권3호
• /
• pp.229-236
• /
• 1999

in the present study, the zinc toxicity to larval development and seed attachment of the abalone, Haliotis discus hannai was obtained under continuous flow through system. The zinc concentration melted from zinc coating pipe for 7 months ranged from $89.00\pm2.55 \mu\textrm{g}/\ell to 15.23\pm2.58\mu\textrm{g}/\ell(Y=0.85M^2-19.71+109.96)$. Treatments were carried out with zinc concentration $0~160 \mu\textrm{g}/\ell$. The maximum and minimum of fertilization rate were $87.7\pm5.3%$ in control, $83.7\pm7.6%$ in zinc concentration $160\mu\textrm{g}/\ell$, respectively. The maximum and minimum of hatching rate were $87.5\pm4.5%$ in zinc concentration $10\mu\textrm{g}/\ell$, $79.3\pm5.6%$ in zinc concentration $160\mu\textrm{g}/\ell$, respectively. Both of the results were not significantly different (P>0.05). But the normality rate, setting rate and survival rate of abalone larvae at over zinc concentration TEX>$20\mu\textrm{g}/\ell$ decreased rapidly and showed significantly different from those of the other group(P<0.05).

• 설비공학논문집
• /
• 제12권2호
• /
• pp.113-119
• /
• 2000

An experimental study has been carried out in order to investigate on a particle deposition on a circular cylinder surface. The present study is focused on the particulate fouling occurring in a heat exchanger for a seawater desalinization, in a laminar flow over circular cylindrical tubes. The objective is to investigate how NaCl concentration influences the $SiO2$ particle deposition on the surface of a glass circular cylinder. The NaCl concentration was changed from 0 g/L to 40 g/L. As the experimental results of $SiO2$ particle which is deposited on the glass circular cylinder surface showed, particle deposition rate per unit time increases rapidly with the increase of NaCl concentration between 0 g/L and 15 g/L. After the maximum of particle deposition rate was found at the NaCl concentration of 15 g/L, particle deposition rate remains unchanged or decreases gradually with the NaCl concentration from 15 g/L to 40 g/L. Also the $SiO2$ deposition rate of particles does not have serious variations with the position at present glass surface.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2001년도 춘계학술대회 논문집
• /
• pp.152-157
• /
• 2001

This paper was studied on the characteristics of crevice corrosion prevention of SS 400 in marine environment. In NaCl solution, polarization behavior under the crevice corrosion was investigated. And Weight loss rate of SS 400 applied cathodic protection and non cathodic protection was measured according to the NaCl concentration. The main results obtained are as follows : The weight loss rate of Al-alloy galvanic anode was increased as the concentration of NaCl solution increased by 3.5% but the concentration increased over 3.5%, that of Al-alloy galvanic anode become decreased. The protective potential of SS 400 used Al-alloy galvanic anode becomes more cathodic polarization with increasing concentration of NaCl solution. Effects of oxygen on the weight loss rate of Al-alloy sacrificial anode for cathodic protection as the concentration of 3.5% NaCl solution become sensitive than that of 0% NaCl solution.

• 한국수정란이식학회지
• /
• 제7권1호
• /
• pp.13-19
• /
• 1992

This study were carried out to investigate the effective concentration of cryoprotective agents and sucrose by one-step straw method, and to determine the optimum thawing temperature and equilibration time of frozen porcine embryos. The porcine embryos foflowing dehydration by cryoprotective agents and a various concentration of sucrose were directly plunged into liquid nitrogen and thawed in 3$0^{\circ}C$ water. Survival rate was defined by FDA test. The results are sunnnarized as follows : 1. The survival rates of porcine embryos after ultrarapid frozen4hawing in the freezing medium with a various concentration of glycerol, DMSO and propanediol added 0.25M sucrose were higher survival rate than those of sucrose concentration of 0.50M. 2. The survival rates of porcine embryos after ultrarapid ftozen4hawing in the freezing medium added 0.25M and 0.SOM sucrose were higher survival rate than those of sucrose concentration of 0.75M and 1.00M. 3. The temperature thawed at 2$0^{\circ}C$ and 3$0^{\circ}C$ resulted in a significantly higher embryos survival rate after 72 hrs in culture than did at 35$^{\circ}C$. 4. The equilibration time on the survival rate of porcine embryos was attained after short period of time(2.5~5 min.) in the freezing medium higher than long period of time(10~20 min.).