• Progress in Medical Physics
• /
• v.6 no.2
• /
• pp.71-81
• /
• 1995

Consecutive brain 〔Tc-99m〕ECD SPECT studies before and after acetazolamide (Diamox) administration have been performed with patients for the evaluation of cerebrovascular hemodynamic reserve. However, the quantitaitve potential of SPECT Diamox imaging is limited as a result of degrading fractors such as finite detector resolution, attenuation, scatter, poor counting statistics, and methods of data analysis. Making physical measurements in phantoms filled with known amounts of radioactivity can help characterize and potentially quantify the sensitivities. However, it is often very difficult to make a realistic phantom simulating patients in clinical situations. By computer simulation, we studied the sensitivities of ECD SPECT before and after Diamox administration. The sensitivity is defined as ($\Delta$N/N)/($\Delta$S/S)$\times$100％, where $\Delta$N denotes the differences in mean counts between post-and pre-Diamox in the measured data, N denotes the mean counts before Diamox in the measure data, $\Delta$S denotes the differences in mean counts between post-and pre-Diamox in the model, and S denotes the mean counts before Diamox in the model. In clinical Diamox studies, the percentage changes of radioactivity could be determined to measure changes in radioactivity concentration by Diamox after subtracting pre-from post-Diamox data. However, the optimal amount of subtraction for 100％ sensitivity is not known since this requires a thorough sensitivity analysis by computer simulation. For consecutive brain SPECT imaging model before and after Diamox, when 30％ increased radioactivity concentrations were assingned for Diamox effect in model, the sensitivities were measured as 51.03, 73.4, 94.00, 130.74％ for 0, 100, 150, 200％ subtraction, respectively. Sensitivity analysis indicated that the partial voluming effects due to finite detector resolution and statistical noise result in a significant underestimation of radioactivity measurements and the amount of underestimation depends on the. ％ increase of radioactivity concentration and ％ subtraction of pre-from post-Diamox data. The 150％ subtraction appears to be optimal in clinical situations where we expect approximately 30％ changes in radioactivity concentration. The computer simulation may be a powerful technique to study sensitivities of ECD SPECT before and after Diamox administration.

• KIPS Transactions on Computer and Communication Systems
• /
• v.1 no.3
• /
• pp.143-150
• /
• 2012

A simulation methodology and corresponding program based on it is to be discussed for analyzing the effects of the networking operation of existing DHC system in connection with CHP system on-site. The practical simulation for arbitrary areas with various building compositions is carried out for the analysis of operational features in both systems, and the various aspects of thermal energy grids with connecting operation are highlighted through the detailed assessment of predicted results. The intrinsic operational features of CHP prime movers, gas engine, gas turbine etc., are effectively implemented by realizing the performance data, i.e. actual operation efficiency in the full and part loads range. For the sake of simplicity, a simple mathematical correlation model is proposed for simulating various aspects of change effectively on the existing DHC system side due to the connecting operation, instead of performing cycle simulations separately. The empirical correlations are developed using the hourly based annual operation data for a branch of the Korean District Heating Corporation (KDHC) and are implicit in relation between main operation parameters such as fuel consumption by use, heat and power production. In the simulation, a variety of system configurations are able to be considered according to any combination of the probable CHP prime-movers, absorption or turbo type cooling chillers of every kind and capacity. From the analysis of the thermal network operation simulations, it is found that the newly proposed methodology of mathematical correlation for modelling of the existing DHC system functions effectively in reflecting the operational variations due to thermal energy grids with connecting operation. The effects of intrinsic features of CHP prime-movers, e.g. the different ratio of heat and power production, various combinations of different types of chillers (i.e. absorption and turbo types) on the overall system operation are discussed in detail with the consideration of operation schemes and corresponding simulation algorithms.

• Journal of Intelligence and Information Systems
• /
• v.26 no.4
• /
• pp.87-109
• /
• 2020

Currently, thanks to the major stride made in developing wired and wireless communication technology, a variety of IT services are available on land. This trend is leading to an increasing demand for IT services to vessels on the water as well. And it is expected that the request for various IT services such as two-way digital data transmission, Web, APP, etc. is on the rise to the extent that they are available on land. However, while a high-speed information communication network is easily accessible on land because it is based upon a fixed infrastructure like an AP and a base station, it is not the case on the water. As a result, a radio communication network-based voice communication service is usually used at sea. To solve this problem, an additional frequency for digital data exchange was allocated, and a ship ad-hoc network (SANET) was proposed that can be utilized by using this frequency. Instead of satellite communication that costs a lot in installation and usage, SANET was developed to provide various IT services to ships based on IP in the sea. Connectivity between land base stations and ships is important in the SANET. To have this connection, a ship must be a member of the network with its IP address assigned. This paper proposes a SANET-CC protocol that allows ships to be assigned their own IP address. SANET-CC propagates several non-overlapping IP addresses through the entire network from land base stations to ships in the form of the tree. Ships allocate their own IP addresses through the exchange of simple requests and response messages with land base stations or M-ships that can allocate IP addresses. Therefore, SANET-CC can eliminate the IP collision prevention (Duplicate Address Detection) process and the process of network separation or integration caused by the movement of the ship. Various simulations were performed to verify the applicability of this protocol to SANET. The outcome of such simulations shows us the following. First, using SANET-CC, about 91% of the ships in the network were able to receive IP addresses under any circumstances. It is 6% higher than the existing studies. And it suggests that if variables are adjusted to each port's environment, it may show further improved results. Second, this work shows us that it takes all vessels an average of 10 seconds to receive IP addresses regardless of conditions. It represents a 50% decrease in time compared to the average of 20 seconds in the previous study. Also Besides, taking it into account that when existing studies were on 50 to 200 vessels, this study on 100 to 400 vessels, the efficiency can be much higher. Third, existing studies have not been able to derive optimal values according to variables. This is because it does not have a consistent pattern depending on the variable. This means that optimal variables values cannot be set for each port under diverse environments. This paper, however, shows us that the result values from the variables exhibit a consistent pattern. This is significant in that it can be applied to each port by adjusting the variable values. It was also confirmed that regardless of the number of ships, the IP allocation ratio was the most efficient at about 96 percent if the waiting time after the IP request was 75ms, and that the tree structure could maintain a stable network configuration when the number of IPs was over 30000. Fourth, this study can be used to design a network for supporting intelligent maritime control systems and services offshore, instead of satellite communication. And if LTE-M is set up, it is possible to use it for various intelligent services.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.9C
• /
• pp.895-904
• /
• 2007

This paper proposes a robust sub-optimal smart antenna in Code Division Multiple Access (CDMA) basestation. It makes use of the property of the Least Mean Square (LMS) algorithm and the Conjugate Gradient Method (CGM) algorithm for beamforming processes. The weight update takes place at symbol level which follows the PN correlators of receiver module under the assumption that the post correlation desired signal power is far larger than the power of each of the interfering signals. The proposed algorithm is simple and has as low computational load as five times of the number of antenna elements(O(5N)) as a whole per each snapshot. The output Signal to Interference plus Noise Ratio (SINR) of the proposed smart antenna system when the weight vector reaches the steady state has been examined. It has been observed in computer simulations that proposed beamforming algorithm improves the SINR significantly compared to the single antenna case. The convergence property of the weight vector has also been investigated to show that the proposed hybrid algorithm performs better than CGM and LMS during the initial stage of the weight update iteration. The Bit Error Rate (BER) characteristics of the proposed array has also been shown as the processor input Signal to Noise Ratio (SNR) varies.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.5
• /
• pp.40-52
• /
• 2010

A mobile ad hoc network is instant and heuristic, and it is also vulnerable and volatile. Since topology and route changes are frequent, no single routing protocol designed for a conventional network performs well. Some protocols suffer from significant performance degradation when the number of nodes increases, or when nodes become highly mobile. In this paper we investigate a way to adaptively select a routing protocol that fits to the real-time network conditions. The first phase of our study is to analyze the performances of two classes of routing protocols under various network scenarios. The second phase consists of constructing a routing protocol selection reference. All nodes continue to monitor the status of neighbor nodes and control packets exchanged. Then, the aggregated information is periodically compared against the protocol selection reference. The selected routing protocol is maintained throughout the network until the network property changes substantially. The performance of the proposed algorithm is verified by a set of computer simulations using the OPNET modeler. The experimental results show that selectively changing routing protocol adaptive to the network conditions greatly improves the efficacy of bandwidth utilization.

• Journal of KIISE:Computing Practices and Letters
• /
• v.6 no.4
• /
• pp.411-420
• /
• 2000

The performance of soft handoffs of CDMA mobile communication systems is potentially determined by several factors such as handoff-related system parameters (T_ADD, T_DROP, T_COMP, T_TDROP), mobile stations' mobility, service areas, capacity of base stations. Due to the importance of handoffs in mobile communications, several methods have been proposed and tested through computer simulations to prove the efficiency of proposed methods. Different assumptions on the above mentioned factors often produce different simulation results. Therefore, the credibility of a simulation result is directly determined by the objectivity of the assumptions made by the simulation. This paper proposes a new soft handoff method that controls handoff delay time based on a mobile station's speed, and compares it with the current method of CDMA systems. The simulation results showed that the new method is much more efficient for mobile stations that are free in their moving direction and space than for those restricted in their moving direction and space. In addition, the results showed that even the same handoff method may produces different simulation results depending on whether a service area is modeled as two-dimensional space or three-dimensional space. These results indicate the importance of suitable models of user mobility, especially the movement types and space allowed for mobile stations, which have been neglected in simulation studies of mobile communications.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.94-103
• /
• 2006

Ethernet passive optical network (EPON) has drawn many attention as a promising access network technology for FTTH because it can provide a high bandwidth with a low cost. Since the uplink bandwidth in the EPON system is shared by many users, it is necessary for an EPON system to have an efficient bandwidth allocation mechanism. To support QoS in EPON, the previous bandwidth allocation schemes employ strict priority queueing (SPQ). Since SPQ gives unlimited priority to higher service class, the QoS of lower service classes gets worse. In this paper, we propose Class Gated DBA (Dynamic Bandwidth Allocation) algorithm in which the bandwidth is requested / granted in a service class basis. To avoid the monopoly in bandwidth usage by higher classes the maximum bandwidth that is allocate to each service class is limited (fairness between services classes). In addition, to avoid the monopoly in bandwidth usage by some particular users, each ONU runs fairness bandwidth allocation algorithm within each service classes. Through computer simulations, it is verified that the proposed algorithm achieves a good level of QoS, and at the same time maintains a good level of fairness between both service classes and users.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.39 no.3
• /
• pp.51-58
• /
• 2002

The conventional code division multiple access(CDMA) detector shows severe degradation in communication quality as the number of users increases due to multiple access interferences(MAI). This problem thus restricts the user capacity. Various multiuser detection algorithms have been proposed to overcome the MAI problem. The existing detectors can be generally classified into one of the two categories : linear multiuser detection and subtractive interference cancellation detectors. In the linear multiuser detection, a linear transform is applied to the soft outputs of the conventional detector. In the subtractive interference cancellation detection, estimates of the interference are generated and subtracted out from the received signal. There has been great interest in the family of the subtractive interference cancellation detection because the linear multiuser detection exhibits the disadvantage of taking matrix inversion operations. The successive interference cancellation (SIC) and the parallel interference cancellation (PIC) are the two most popular structures in the subtractive interference cancellation detector. The SIC structure is very simple in hardware complexity, but has the disadvantage of increased processing delay time, while the PIC structure is good in performance, but shows the disadvantage of increased hardware complexity. In this paper we propose a mixed structure form of SIC and PIC in order to achieve good performance as well as simple hardware complexity. A performance analysis of the proposed scheme has been made, and the superior characteristics of the mixed structure are demonstrated by extensive computer simulations. 

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.7
• /
• pp.661-668
• /
• 2004

A novel method to reject the spurious signals which are occurred at Weaver-type low-IF transmitter was proposed in this paper. The spurious signals are generated by the gain and phase imbalances of I/Q channel or imperfect characteristics of 90$^{\circ}$ phase shifter in local oscillator for I/Q channel source. By deriving the gain and phase-based functions from RF spurious signal with the channel imbalance information, the lie channel imbalances were deduced as functions with magnitude and sign dependent on I/Q channel imbalance degree. The proposed method compensates the estimated I/Q channel imbalances by correlation values between the down-converted signal obtained by squaring the output signal itself using a simple mixer and the modified baseband signal. By comparing two signals after A/D conversion, the magnitude and sign of each type of imbalances can be determined separately and simultaneously. Based on the I/Q channel imbalance compensation, the spurious signals can be reduced by adjusting the gain and phase values of I or Q channel signal. The way to estimate the channel imbalances of the up-conversion mixer was presented and verified by using theoretical derivations and computer simulations.

• Journal of Broadcast Engineering
• /
• v.16 no.6
• /
• pp.986-995
• /
• 2011

In this paper, we propose a noise whitening decision feedback equalizer for single carrier frequency division multiple access (SC-FDMA) receivers. SC-FDMA has the same advantage as that of orthogonal frequency division multiple access (OFDMA) in which the multipath effect can be removed easily, and also solves the problem of high peak to average power ratio (PAPR) which is the main drawback of OFDMA. Although SC-FDMA is a single carrier transmission scheme, a simple frequency domain linear equalizer (FD-LE) can be implemented as in OFDMA, which can dramatically reduce the equalizer complexity. Moreover, some residual intersymbol interference in the output of the FD-LE can be further removed by an additional nonlinear decision feedback equalizer (DFE) in time domain, because the time domain signal is a digitally modulated symbol. In the conventional DFE, however, the noise is not white at the input of the decision device and correspondingly the decision is not optimum. In this paper, we propose an improved DFE scheme for SC-FDMA systems where a linear noise whitening filter is inserted before the decision device of the conventional DFE scheme. Through computer simulations, we compare the bit error rate performance of the proposed DFE scheme with the conventional equalizers.