• 대한토목학회논문집
• /
• 제31권2A호
• /
• pp.59-69
• /
• 2011

성능기반 내진 설계방법의 설계철학을 가지고 있는 비선형 정적 해석법(NSPs)은 최근 구조물의 지진해석방법으로서 그 사용성을 인정받고 있다. 비선형 정적 해석법을 통한 지진해석은 기존의 비선형 시간 이력법에 비해서 방법이 간단하며, 직관적으로 구조물의 지진해석을 수행할 수 있는 등의 장점으로 빌딩구조물의 지진해석법으로 널리 사용되고 있다. 하지만, 기본 진동모드에 의해서 구조물의 거동이 지배되지 않는 구조물의 경우에는 그 사용성에 대한 연구가 매우 제한적이다. 이를 개선하기 위한 고차모드의 기여분을 반영할 수 있는 비선형 정적 해석법으로 모드별 비탄성 정적해석법(Modal Pushover Analysis; MPA)이 제시되었고, 또한 이를 개선한 개선된 모드별 비탄성 정적해석법(Improved Modal Pushover Analysis; IMPA) 역시 소개되었다. 본 논문에서는 기존에 소개된 네가지 비선형 정적 해석법을 이용하여 국내에 설계/시공된 두 사장교의 지진해석 가능성을 알아보며, 각 방법의 장/단점을 분석 하여 비선형 정적 해석법의 응용가능성에 대해서 알아보았다.

• 한국기계가공학회지
• /
• 제21권7호
• /
• pp.71-76
• /
• 2022

This study describes an evaluation of the vibration-level reduction effect of natural rubber inserted between two aluminum blocks, in which the modal parameters are predicted using two different damping systems. A numerical model with two degrees of freedom was established for both the cases. One was an eigenvalue problem analysis using a state space method and general viscous damping, whereas the other was a method using hysteretic damping. The modal parameters obtained from these two approaches were compared with those obtained from the finite element method using a commercial package. As a result, the natural frequencies observed in the complex frequency response curve were consistently less than the average of four percents. The damping ratios also showed good agreement within a reasonable range. However, the hysteretic damping system showed a relatively larger difference for all modal parameters. This suggests that the analysis procedure makes it easier to predict the vibration transmission characteristics of the shape and configuration of any cushioning layer.

• 한국항공운항학회지
• /
• 제15권3호
• /
• pp.6-14
• /
• 2007

In this research, vibration reduction and aeroelastic stability of a composite hingeless rotor hub flexure with viscoelastic constrained layer damping treatment(CLDT) were investigated. The composite flexures with viscoelastic CLDT were applied to hingeless rotor system to improve the in-plane stability of the lead-lag motion causing resonance. The modal test was performed and dynamic properties(natural frequency and loss factor) were acquired. Also, complex eigenvalue analysis(SOLlO7) in the NASTRAN structural analysis module was performed and compared with results of the modal test. To insure aeroelastic stability, damping ratio analyses of the hingeless rotor system with CLDT were accomplished at hovering condition due to collective pitch angle changes. Satisfactory results of increasing structural damping and stability were obtained.

• Journal of Power Electronics
• /
• 제18권1호
• /
• pp.185-194
• /
• 2018

Interaction among multiple grid-connected inverters has a negative impact on the stable operations and power quality of a power grid. The interrelated influences of inverter inductor-capacitor-inductor filters constitute a high-order power network, and consequently, excite complex resonances at various frequencies. This study first establishes a micro-grid admittance matrix, in which inverters use deadbeat control. Multiple resonances can then be evaluated via modal analysis. For the active damping method applied to deadbeat control, the sampling frequency and the stable domain of the virtual damping ratio are also presented by analyzing system stability in the discrete domain. Simulation and experimental results confirm the efficiency of modal analysis and stable domain calculation in multi-inverter grid-connected systems.

• 한국소음진동공학회논문집
• /
• 제22권7호
• /
• pp.619-625
• /
• 2012

Since the fuel is always exposed to turbulent flow, the grid strap shows flow induced vibration characteristics that impact on the nuclear fuel soundness. The dynamic behavior of grids in nuclear fuels is quite complex, since two pairs of spring and dimple support are contacted with rods by friction in the limited space. This paper focuses on investigation of the grid strap(test fuel strap, TFS) vibration in one cell. TFS consists of a single spring and double dimples. To identify the grid strap vibration, modal analysis of the strap is performed using finite element method(FEM). Modal testing on a $5{\times}5$ grid structure without rods is performed. The modal testing results are compared to analytic results. In addition, random test considering rod effect is performed about a $5{\times}5$ grid with rods under real contact condition in the air. Finally, the strap vibration of a $5{\times}5$ fuel bundle in investigation of flow induced vibration(INFINIT) facility is measured in real fluid velocity condition without heating. It is shown that modal frequencies from the test are almost equal to those peak frequencies in the INFINIT test.

• Structural Engineering and Mechanics
• /
• 제11권1호
• /
• pp.71-87
• /
• 2001

A frequency domain response analysis is presented for building frames passively controlled by viscoelastic dampers, under harmonic ground excitation. Three different models are used to represent the linear dynamic force-deformation characteristics of viscoelastic dampers namely, Kelvin model, Linear hysteretic model and Maxwell model. The frequency domain solution is obtained by (i) an iterative pseudo-force method, which uses undamped mode shapes and frequencies of the system, (ii) an approximate modal strain energy method, which uses an equivalent modal damping of the system in each mode of vibration, and (iii) an exact method which uses complex frequency response function of the system. The responses obtained by three different methods are compared for different combinations of viscoelastic dampers giving rise to both classically and non-classically damped cases. In addition, the effect of the modelling of viscoelastic dampers on the response is investigated for a certain frequency range of interest. The results of the study are useful in appropriate modelling of viscoelastic dampers and in understanding the implication of using modal analysis procedure for building frames which are passively controlled by viscoelastic dampers against base excitation.

• Nuclear Engineering and Technology
• /
• 제49권7호
• /
• pp.1513-1523
• /
• 2017

Improvement of numerical analysis methods has been required to solve complicated phenomena that occur in nuclear facilities. Particularly, fluid-structure interaction (FSI) behavior should be resolved for accurate design and evaluation of complex reactor vessel internals (RVIs) submerged in coolant. In this study, the FSI effect on dynamic characteristics of RVIs in a typical 1,000 MWe nuclear power plant was investigated. Modal analyses of an integrated assembly were conducted by employing the fluid-structure (F-S) model as well as the traditional added-mass model. Subsequently, structural analyses were carried out using design response spectra combined with modal analysis data. Analysis results from the F-S model led to reductions of both frequency and Tresca stress compared to those values obtained using the added-mass model. Validation of the analysis method with the FSI model was also performed, from which the interface between the upper guide structure plate and the core shroud assembly lug was defined as the critical location of the typical RVIs, while all the relevant stress intensities satisfied the acceptance criteria.

• 대한기계학회논문집
• /
• 제10권5호
• /
• pp.689-697
• /
• 1986

본 연구에서는 3자유도(3방향의 병진운동만 고려) 고무마운트모형의 타당성을 검증하기 위하여, 먼저 고무자체의 물성치인 강성계수와 감쇠계수를 진동수와 초기변 형률에 따라 실험을 통해 구하였다. 질량행렬의 모든요소를 쉽게 구할 수 있는 간단 한 시험구조물을 제작하고 여기에 고무아운트를 부착하여 6자유도를 갖는 모의 엔진- 마운트계를 구성한 후 가진실험을 통해 얻은 오무드 매개변수들과 고무의 물성치를 이 용한 컴퓨터 시뮬레이션의 결과를 비교함으로써 고무아운트 모형의 타당성을 검증하였 다. 특히 본 연구에는 유압가진 실험으로부터 얻은 실험결과를 바탕으로 고무의 강 성계수를 주파수의 1차함수로 고려한 경우와 전진동수 영역에서 균일하다고 가정하는 경우를 비교하였다.

• Structural Engineering and Mechanics
• /
• 제6권4호
• /
• pp.377-394
• /
• 1998

Slit shear walls an reinforced concrete shear wall structures with purposely built-in vertical slits. If the slits are inserted with visco-elastic damping materials, the shear walls will become viscoelastic sandwich beams. When adequately designed, this kind of structures can be quite effective in resisting earthquake loads. Herein, a simple analysis method is developed for the evaluation of the stochastic responses of visco-elastic slit shear walls. In the proposed method, the stiffness and mass matrices are derived by using Rayleigh-Ritz method, and the responses of the structures are calculated by means of complex modal analysis. Apart from slit shear walls, this analysis method is also applicable to coupled shear walls and cantilevered sandwich beams. Numerical examples are presented and the results clearly show that the seismic responses of shear wall structures can be substantially reduced by incorporating vertical slits into the walls and inserting visco-elastic damping materials into the slits.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2009년도 춘계학술대회 논문집 특별세미나,특별/일반세션
• /
• pp.595-600
• /
• 2009

Passengers in a vehicle feel uncomfortable due to squeal noise. Squeal noise, a kind of self-excited vibration, is generated by the friction force between the disc and the pad of the automobile. In this paper, modal analysis of wheel brake system was performed in order to prediction of squeal phenomenon. It was shown that the prediction of system instability is possible by FEM. Finite element model of that brake system was made. Some parts of a real brake was selected and modeled. The normal mode analysis method performs analyses of each brake system component. Experiment of modal analysis was performed for each brake components and experimental results were compared with analytical result from FEM. The complex eigenvalue analysis results compared with braking test. The analysis results show good correlation with braking test for the squeal frequency at an unstable mode.