• Journal of Environmental Science International
• /
• v.12 no.10
• /
• pp.1131-1136
• /
• 2003

To examine whether salt stress would alter or not contractility of isolated rat aorta, under anesthesia with sodium pentobarbital(50 mg kg-1 i.p.), male Sprague Dawley rats(300-330 g) were subjected to 0, 50, and 150 mM of sodium chloride at 37$^{\circ}C$ for 60 min. where as the sham group was left at modified Krebs-bicarbonate solution. To measure contractile response of vascular ring preparation isolated from rat was determined in organ bath and was recorded on physiograph connected to isometric transducer. And the strip was checked for expression of heat shock protein(Hsp) by Western blotting. One, three and eight hours later, we measured vascular contractility of isolated rat aorta treated with KCI, phenylephrine from organ bath study. The dose-vascular responses of potassium chloride and phenylephrine showed a little augmentation by NaCl concentration in the strips exposed to NaCl for 8 hours. And the response of relaxation induced by nitroprusside and acetylcholine was not influenced by NaCl stress in isolated aorta ring for 8 hours, respectively. Expression pattern of Hsp 70 of vascular muscle in isolated rat aorta showed a little increase in 150 mM NaCl group at 8 hours after NaCl treatment but not at 3 hours, and Hsp 60 expression of rat aorta was markedly increased in 50 mM NaCl group at 8 hours after NaCl treatment. Taken together, NaCl induced dose-and time dependent accumulation of the Hsp but not affected contraction of rat aorta. These data suggest that short term high salt stress was not sufficient to induce hypertension of rat aorta.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.3
• /
• pp.456-464
• /
• 1997

The effect of the additives on the Zn-Ni alloy electrocrystallization from a chloride bath was investigated by means of electrochemical methodes, scanning electron microscopy and measurement of surface appearance, X-ray diffraction patterns. The additives tested were the surfactant of naphtalene-derivative, saccharin and aliphatic alcohol. The resistance of electrodeposit increased by adding the additives, whereas the effect of additives on resistance was different with current density. The nickel content of alloy deposit was increased by the addition of alcohol, while decreased by the surfactant. The surface roughness, appearance and morphology of deposit were also influenced by the type of additive. The fine, compact grains and good surface roughness could be obtained from the surfactant or alcohol -added bath, and the surfactant or saccharin improved the surface appearance.

• Korean Journal of Materials Research
• /
• v.25 no.12
• /
• pp.708-712
• /
• 2015

This study reports the effects of $H_2S$ gas concentration on the properties of $Cu_2ZnSnS_4(CZTS)$ thin films. Specifically, sulfurization process with low $H_2S$ concentrations of 0.05% and 0.1%, along with 5% $H_2S$ gas, was studied. CZTS films were directly synthesized on Mo/Si substrates by chemical bath deposition method using copper sulfate, zinc sulfate heptahydrate, tin chloride dihydrate, and sodium thiosulfate pentahydrate. Smooth CZTS films were grown on substrates at optimized chemical bath deposition condition. The CZTS films sulfurized at low $H_2S$ concentrations of 0.05 % and 0.1% showed very rough and porous film morphology, whereas the film sulfurized at 5% $H_2S$ yielded a very smooth and dense film morphology. The CZTS films were fully crystallized in kesterite crystal form when they were sulfurized at $500^{\circ}C$ for 1 h. The kesterite CZTS film showed a reasonably good room-temperature photoluminescence spectrum that peaked in a range of 1.4 eV to 1.5 eV, consistent with the optimal bandgap for CZTS solar cell applications.

• Textile Coloration and Finishing
• /
• v.32 no.2
• /
• pp.111-120
• /
• 2020

In this study, lignin/chlorinated poly(vinyl chloride)(CPVC) blended fibers have been produced for the development of low-cost carbon fiber. Carbon fiber manufacturing was accomplished through stabilization and carbonization process. The lignin/CPVC blended fibers were prepared by wet spinning method. Dimethylacetamid e(DMAc) and cychlohexanone in a ratio of 5:1(wt%) was employed as co-solvent. The ratio of lignin/CPVC was prepared at 0/10, 1/9, 2/8, 3/7, 4/6, and 5/5(wt%). The spinning solution was extruded at a rate of 0.1 to 0.4ml/min according to the blending ratio. The speed of the rollers was the same for all ratios(draw ratio=1). Analysis of fiber cross-section by scanning eletron microscopy(SEM) showed that as the lignin ratio increased in the same coagulation bath and distilled water, the pore size of the spinning fiber decreased. Therefore, the highest tensile strength of the blending fibers was 6.3±1.2MPa at the 5/5 ratio. The carbon fiber also showed the best tensile strength of 120.78±2.43MPa at 5/5 ratio.

• Journal of Surface Science and Engineering
• /
• v.51 no.1
• /
• pp.62-70
• /
• 2018

Sulfamate plating solution containing a small amount of chloride bath was fabricated to study the properties of the electrodeposited Ni thin films. Effects of the changes of current density and additive concentration on current efficiency, residual stress, surface morphology and microstructure of Ni thin films electrodeposited from Ni sulfamate-chloride baths were investigated. The current efficiency was measured to be more than about 95%, independent of the changes of current density and saccharin concentration in the baths. Residual stress of Ni thin film was appeared to be the compressive stress modes in the range of $5{\sim}30mA/cm^2$ current density. Maximum compressive stress was observed at the current density of $10mA/cm^2$. Compressive stress values of Ni thin/thick films were increased to be about -85~-100 MPa with increasing saccharin concentration from 0 to 0.0195 M(4 g/L). Surface morphology was changed from smooth to nodule surface appearance with increasing the current density. Smooth surface morphology of Ni thin films electrodeposited from the baths containing saccharin was observed, independent of the saccharin concentration. Ni thin/thick films consist of FCC(111), FCC(200), FCC(220), FCC(311) and FCC(222) peaks. It was revealed that the FCC(200) peak of Ni thin films is the preferred orientation in the range of $5{\sim}30mA/cm^2$ current density. The intensity of FCC(200) peak was gradually decreased and the intensity of FCC(111) peak was increased with increasing saccharin concentration in the baths.

• Resources Recycling
• /
• v.22 no.6
• /
• pp.55-63
• /
• 2013

In this study, a electrochemical-chemical combined dissolution technology was conducted by electro-generated chlorine to obtain ruthenium solution from ruthenium metal. To find out the optimum leaching conditions of ruthenium in chloride solution, this leaching process was carried out on the variation of pH, reaction time, temperature and applied voltage at the electro-generated chlorine system in the reaction bath. Also, ozone generator was used to obtain ruthenium(III) chloride solution to increase the leaching rate. The optimum condition was observed at pH 10.0, $40^{\circ}C$ within 1 hr of reaction time that more than 88% of ruthenium(III) chloride dissolved.

• The Korean Journal of Pharmacology
• /
• v.10 no.1 s.15
• /
• pp.47-52
• /
• 1974

The isolated rabbit gall bladder strips were prepared according to the technique described by Amer and Becvar (1969). The strips were placed in a bath containing 100 ml of Locke-Ringer solution maintained at $38^{\circ}C$. Oxygen was continuously bubbled through the solution. The tension of the muscle strip was initially adjusted to 0.7g. The contractile response was measured isometrically by a force-displacement transducer connected to a polygraph. The effect of a number of autonomic drugs were studied for their interaction with caerulein (Prof. V. Erspamer, F.I. 6934 Caerulein, Farmitalia, Italia), a gastrin or CCK.PZ like peptide, on isolated rabbit gall bladder strips. In this preparation caerulein produced contractions of CCK-PZ type, but the relative potency on a weight basis was 40 times that of CCK-PZ. The response of caerulein was not modified by either cholinergic or alpha or beta adrenergic blockade. However, the response of caerulein and of barium on the strips were prevented by papaverine or aminophylline. Isoproterenol, papaverine or aminophylline alone relaxed the preparation whereas caerulein, CCK-PZ, acetylcholine, serotonin, histamine or barium chloride contracted the preparation. In summary, it is concluded that caerulein on the gall bladder strip seems to act independently of the autonomic nervous system and mediated via mechanisms apparently similar to those involved in the action of barium chloride.

• Journal of the Korean Electrochemical Society
• /
• v.10 no.2
• /
• pp.82-87
• /
• 2007

New porous separators based on non-polyolefin materials including the blend of poly (vinyl chloride) (PVC)/poly (vinylidene fluoride-co-hexafluoropropylene) (P(VdF-co-HFP)/poly(methyl methacrylate) (PMMA), and the porous separator based on poly (vinylidene fluoride) (PVdF) were prepared by phase inversion method. The porosity and morphology were controlled with phase inversion rate, which is governed by the relative content of non-solvent and solvent in coagulation bath. To enhance tensile strength, the solvent pre-evaporation and uni-axial stretching processes were applied. The ionic conductivity was increased with increasing stretching ratio, and tensile strength was increased with increasing solvent pre-evaporation time and stretching ratio. The 200% stretched PVdF separator showed 56 MPa of tensile strength, and the ionic conductivity of the stretched PVdF separator was $8.6{\times}10^{-4}\;S\;cm^{-1}\;at\;25^{\circ}C$.

• Journal of Surface Science and Engineering
• /
• v.49 no.5
• /
• pp.416-422
• /
• 2016

We have investigated the effects of applied potential, deposition time and electrolyte types on shapes and physical properties of Cu dendrites by potentiostatic electrodeposition. Finer shape of dendrites was observed at less cathodic potential by 100mV than at the limiting current, due to 'effective overpotential'. The shape of copper dendrite is related to the deposition time, too. The dendrite depositing for 10 min showed the finest shape. The finer dendrite has the less apparent density and the larger specific surface area. Dendrite from chloride solution has the lowest density and the largest surface area among three plating solutions, sulfate, chloride and pyrophosphate.

• Journal of Pharmacopuncture
• /
• v.6 no.3
• /
• pp.49-55
• /
• 2003

This study was undertaken to define the effect of ChungSangSaWhaTang on the norepinephrine-induced arterial contraction and the mechanism of ChungSangSaWhaTang-induced relaxation. In order to investigate the effect of ChungSangSaWhaTang on contracted rabbit carotid arterial strips, transverse strips with intact or damaged endothelium were used for the experiment using organ bath. To analyze the mechanism of ChungSangSaWhaTang-induced relaxation, ChungSangSaWhaTang extract infused into contracted arterial strips induced by norepinephrine after treatment of indomethacin, $N_{\omega}$-nitro-L-arginine, or tetraethylammonium chloride. ChungSangSaWhaTang relax arterial strip with endothelium contracted by norepinephrine, but in the strips without endothelium, ChungSangSaWhaTang-induced relaxation was significantly inhibited. The endothelium-dependent relaxation induced by ChungSangSaWhaTang was decreased by the pretreatment of $N_{\omega}$-nitro-L-arginine, but it was not observed in the strips pretreated with indomethacin or tetraethylammonium chloride. We suggest that ChungSangSaWhaTang may inhibit agonist-induced contraction through the formation of nitric oxide in the vascular endothelial cells.