• 한국지반공학회논문집
• /
• 제16권3호
• /
• pp.99-106
• /
• 2000

피에조콘 관입 및 소산 시험이 Calibration Chamber 및 미니 피에조콘을 이용하여 수행되었다. 시험은 정규압밀 및 과압밀 점토에 대하여 정지토압 상태에서 실시되었으며 UI (filter element at cone tip), U2 (filter element above cone base) 두 종류의 피에조콘이 사용되었고 0.3cm/sec, 0.6cm/sec의 관입속도가 적용되었다. 오실로스코프를 사용하여 소산시험 초기 간극수압의 급격한 변화를 측정하였다. 시험결과로부터 관입속도, filter element 위치, 과압밀비가 피에조콘 관입 및 소산시험의 결과에 미치는 영향을 고찰하였으며 입도분포시험을 실시하여 관입시험 전후의 입도분포 치이를 고찰하였다.

• 한국항공운항학회지
• /
• 제15권4호
• /
• pp.17-23
• /
• 2007

This paper describes the flow and performance characteristics inside the post-chamber of the multi-port hybrid rocket motor. Using the computational fluid dynamics (CFD) technique, the non reactive compressible flow fields in the downstream of the fuel grain was numerically calculated. The motor performance obtained from computational results were in agreement with that conducted by the ground motor firing test. Besides, the flow field characteristics inside the post-chamber were discussed under different port numbers (1 port and 3 ports) of the fuel grain. The flow pattern showed that the performance of multi-port hybrid rocket motor having three grain ports is higher than that of the single-port one due mainly to the difference of incoming mass flow rate irrespective to the pressure field.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2002년도 제25회 KOSCI SYMPOSIUM 논문집
• /
• pp.223-229
• /
• 2002

Spark plug ionization signal could be useful in an internal combustion engine as a feedback signal for combustion diagnostics such as misfire detection, knocking detection and lambda control, but the signal has high level of cyclic fluctuation in an internal combustion engine due to residual gas, pressure, temperature, mixture composition in the spark gap. Because of this reason it is very difficult to apply ion signal to commercial engine control. In this Study, a correlation between A/F and spark plug ionization signal was studied in a constant volume chamber. Constant volume chamber with gas phase fuel(Propane) has homogeneous fuel composition , no mixture flow, same pressure and temperature on each test. The results show that mean chemi-ion signal has the highest correlation with A/F and intial pressure change has on effect on the thermal-ion signal and not on chemi-ion signal.

• 동력기계공학회지
• /
• 제1권1호
• /
• pp.22-34
• /
• 1997

Circumstances require improving diesel engine, and many studies have been done in constant volume chamber(CVC). Because the combustion mechanism of a diesel engine has many difficulties with non-homogeneous nature, there has been a limitation to analyzing the combustion mechanism with CVC. Studies are often given in a real engine, but also it has difficulties in modifying configuration of combustion chamber etc. To get more easy way for mote engine-like test, a rapid compression mechanism has been introduced. This study addresses to designing a rapid compression expansion machine(RCEM) driven by compressed air, and to applying it on IDI diesel combustion chamber which has a glow plug. RCEM is introduced first and its characteristics are tested, then spray/combustion characteristics of diesel spray impinging on a glow plug in RCEM combustion chamber are investigated. The results show active combustion in the system employing spray impinging on a glow plug so as to improve combustion efficiency.

• 동력기계공학회지
• /
• 제14권5호
• /
• pp.71-75
• /
• 2010

Leak detection technology is a challenging research until nowadays, because it has wide and various applications in industry. Furthermore pneumatic component reliability test based on ISO requires air leakage measurement. The conventional measurement methods need a complex operation and the calibration of leak detector. Tracing the history of our study, we proposed a new method for measurement of leak flow rate using isothermal chamber. In this study, propose a simulation model of isothermal chamber by infinitesimal flow -rate, such as a leak flow-rate. The effectiveness of the proposed simulation model is proved by simulation and experimental results. Base on the comparison results, proposed simulation model is good agreement with experimental results.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제50권6호
• /
• pp.307-313
• /
• 2001

A micro syringe which can be attached to the end of a micro intravascular endoscope for drug injection is fabricated and its characteristic is tested. The syringe consists of a drug chamber and an actuator chamber which are separated by a silicone rubber membrane. The drug chamber is filled with liquid drug by the membrance actuation caused by the vaporization and condensation of the working liquid in the actuator chamber. The liquid drug is ejected by the electrolysis of the working liquid. The membrane deflection by each actuation method has been measured. The liquid ejection image has been captured during the electrolysis of the electrolyte. Also, the successful operation of the micro syringe under the normal blood pressure was verified.

• 한국산학기술학회논문지
• /
• 제6권4호
• /
• pp.302-308
• /
• 2005

구조가 복잡한 챔버의 온도분포와 유속변화를 연구하였다. 압축성 혹은 비압축성 유체, 층류 혹은 난류의 유속변화를 모델링 할 수 있는 FLUENT 프로그램으로 모사실험을 하였다. 챔버의 구조는 매우 복잡하여 단순화한 구조를 표준 $\kappa-\varepsilon$ 모델과 RNG $\kappa-\varepsilon$ 난류 모델 모사 실험하였다. 평가지역의 온도편차가 적은 것이 중요하다. 본 연구에서 얻은 챔버 내부의 온도분포와 유속변화 자료를 챔버의 제어 알고리즘을 향상하는 제공하였다. 개선된 제어 알고리즘을 이용하여 실제계에 적용한 결과 평가지역의 온도편차가 매우 개선되었다.

• 한국화재소방학회논문지
• /
• 제31권1호
• /
• pp.50-57
• /
• 2017

본 논문은 분진 및 풍속에 따른 연기감지기 챔버의 응답특성에 관한 연구이다. 연기감지기가 실내에 적용됨으로 인해 화재의 조기감지 측면에서는 나아졌으나, 실내에서 발생되는 다양한 생활먼지 및 환경적인 요건 등에 의해 발생될 수 있는 부작동 및 오작동에 대한 연구는 미비한 편이다. 이에 본 연구에서는 다양한 분진 및 풍속에 따른 연기감지기의 실내적응성을 연구하기 위해 연기챔버의 형태 및 구조가 다른 4종류의 광전식연기감지기를 실험대상으로 하고, 플라이애시, 활석가루 그리고 섬유분진(흑채가루)을 실험시료로 하여 분진시험을 진행하였다. 또한 연기챔버 내의 오염도에 따른 응답특성을 관찰하기 위해 추가적으로 분진시험 풍속을 0.25 m/s, 0.5 m/s, 1.0 m/s로 설정하여 인가하였다. 실험결과 플라이애시 및 활석가루, 섬유분진의 경우 분진시험 기준풍속조건인 0.25 m/s에서는 분진인가 후 작동시험 및 부작동시험에서 모두 적합한 것으로 나타났다. 반면, 가혹풍속조건인 0.5 m/s 및 1.0 m/s에서는 플라이애시 및 활석가루의 경우 부작동시험에서 비화재보인 오작동이 나타났고, 섬유분진의 경우 작동시험에서 정상적으로 작동되지 않아 부작동이 발생하는 것으로 확인되었다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제45회 하계 정기학술대회 초록집
• /
• pp.273-273
• /
• 2013

Recently, Point-of-care (POC) testing microdevices enable to do the patient monitoring, drug screening, pathogen detection in the outside of hospital. Immunochromatographic strip (ICS) is one of the diagnostic technologies which are widely applied to POC detection. Relatively low cost, simplicity to use, easy interpretations of the diagnostic results and high stability under any circumstances are representative advantages of POC diagnosis. It would provide colorimetric results more conveniently, if the genetic analysis microsystem incorporates the ICS as a detector part. In this work, we develop a reverse transcriptase-polymerase chain reaction (RT-PCR) microfluidic device integrated with a ROSGENE strip for colorimetric influenza H1N1 virus detection. The integrated RT-PCR- ROSGENE device is consist of four functional units which are a pneumatic micropump for sample loading, 2 ${\mu}L$ volume RT-PCR chamber for target gene amplification, a resistance temperature detector (RTD) electrode for temperature control, and a ROSGENE strip for target gene detection. The device was fabricated by combining four layers: First wafer is for RTD microfabrication, the second wafer is for PCR chamber at the bottom and micropump channel on the top, the third is the monolithic PDMS, and the fourth is the manifold for micropump operation. The RT-PCR was performed with subtype specific forward and reverse primers which were labeled with Texas-red, serving as a fluorescent hapten. A biotin-dUTP was used to insert biotin moieties in the PCR amplicons, during the RT-PCR. The RT-PCR amplicons were loaded in the sample application area, and they were conjugated with Au NP-labeled hapten-antibody. The test band embedded with streptavidins captures the biotin labeled amplicons and we can see violet colorimetric signals if the target gene was amplified with the control line. The off-chip RT-PCR amplicons of the influenza H1N1 virus were analyzed with a ROSGENE strip in comparison with an agarose gel electrophoresis. The intensities of test line was proportional to the template quantity and the detection sensitivity of the strip was better than that of the agarose gel. The test band of the ROSGENE strip could be observed with only 10 copies of a RNA template by the naked eyes. For the on-chip RT-PCR-ROSGENE experiments, a RT-PCR cocktail was injected into the chamber from the inlet reservoir to the waste outlet by the micro-pump actuation. After filling without bubbles inside the chamber, a RT-PCR thermal cycling was executed for 2 hours with all the microvalves closed to isolate the PCR chamber. After thermal cycling, the RT-PCR product was delivered to the attached ROSGENE strip through the outlet reservoir. After dropping 40 ${\mu}L$ of an eluant buffer at the end of the strip, the violet test line was detected as a H1N1 virus indicator, while the negative experiment only revealed a control line and while the positive experiment a control and a test line was appeared.

• 한국추진공학회지
• /
• 제5권2호
• /
• pp.1-7
• /
• 2001

매우 높은 연소가스로부터 연소실을 보호하기 위하여 액체로켓에서는 재생냉각방법을 폭넓게 이용하고 있다. 재생냉각을 통한 로켓엔진의 냉각을 매우 효과적인 방법이지만, 이를 개발하기 위해서는 정확한 해석과정, 제작기술 등이 필요하다. 한다. 실제 소형 로켓엔진에 재생냉각을 이용한 엔진 냉각의 가능성을 확인하기 위하여 설계, 제작된 로켓으로 연소실험을 진행하였다. 실험에 사용한 연소실은 coolant passage 3 mm, 벽 두께 1 mm, stainless 304로 제작하였다. 최대연소압과 연소시간은 각각 400 psi와 60 sec이고, coolant 유량은 2 kg/s에서 0.12 kg/s까지 감소시키면서 실험하였다. 연소시험후 육안으로 검사한 결과 연소실에서 특별한 이상은 발견되지 않았다.