• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2002년도 추계총회 및 연구발표회 초록집
• /
• pp.21.1-21
• /
• 2002

• 한국전기전자재료학회논문지
• /
• 제25권12호
• /
• pp.955-960
• /
• 2012

We fabricated piezoelectric unimorph cantilever generators (UCG) using $Pb(Zr_{0.54}Ti_{0.46})O_3$ + 0.2 wt% $Cr_2O_3$ + 1.0 wt% $Nb_2O_5$ (PZCN) piezoelectric thick films, which were produced by a tape casting method. The PZCN thick films were tailored with same width and thickness but different lengths from 7.7 to 57.7 mm in order to evaluate optimized UCG for energy harvesting device applications. When the length of PZCN film was increased, the resonance frequency of UCG was slightly increased from 7 Hz to 8 Hz, which could be due to enlarged area of the highly stiff piezo-ceramic film. However, the output power was proportionally increased with the length of PZCT film and it reached 4.68 mW (1.221 $mW/cm^3$) when the film's length was 57.7 mm under 25 g of tip mass at 8 Hz, which is sufficient for micro-scale device applications.

• Bulletin of the Korean Chemical Society
• /
• 제29권1호
• /
• pp.29-30
• /
• 2008

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.613-617
• /
• 2002

The ceramic filters were developed using technology similar to that of quartz crystal and electromechanical filter. However, the key to this development involved the theoretical analysis of vibration modes and material improvements of piezoelectric ceramics. The primary application of ceramic filters has been for consumer-market use. Accordingly, a major emhpasis has involved mass production technology, leading to low-priced devices. A typical ceramic filter includes monolithic resonators and capacitors packaged in unique configurations. Nakazawa developed a double-mode resonator as two acoustically coupled single resonators. And he developed 10.7MHz crystal filters using multi-energy trapping mode of thickness shear vibration. He succeeded in realizing a two-pole band pass filter response without external inductance by splitting a dot electrode to creat coupled symmetric and antisymmetric vibration modes. Accordingly, the simulation for ceramic filter were important. So that, this paper were investigated the pass frequency of filter on the electrode length and thickness of ceramic.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.418-421
• /
• 2001

The ceramic filters were developed using technology similar to that of quartz crystal and electromechanical filter. However, the key to this development involved the theoretical analysis of vibration modes and material improvements of piezoelectric ceramics. The primary application of ceramic filters has been for consumer-market use. Accordingly, a major emhpasis has involved mass production technology, leading to low-priced devices. A typical ceramic filter includes monolithic resonators and capacitors packaged in unique configurations. Nakazawa developed a double-mode resonator as two acoustically coupled single resonators. And he developed 10.7MHz crystal filters using multi-energy trapping mode of thickness shear vibration. He succeeded in realizing a two-pole band pass filter response without external inductance by splitting a dot electrode to creat coupled symmetric and antisymmetric vibration modes. Accordingly, the simulation for ceramic filter were important. So that, this paper were investigated the pass frequency of filter on the electrode length and thickness of ceramic.

• Journal of Ceramic Processing Research
• /
• 제20권spc1호
• /
• pp.86-91
• /
• 2019

A solid-state route was used to prepare sodium titanium oxide (NTO, Na2Ti3O7) as a solar heat protecting material with an impressive solar reflectance (TSR = 94.3%) using a high refractive index rutile TiO2. The solar reflectance of the synthesized NTO was measured using UV-Vis-NIR spectrophotometer. Solar reflectance property of the synthesized compound depends on the calcination temperature. The solar reflectance property of the synthesized NTO powder was compared with commercial rutile TiO2. The compound synthesized at 900 ℃ for 24 hrs had remarkable solar reflectance 94.3% than that calcined below 900 ℃. Crystalline nature, structural property, morphology and optical properties of NTO powders were characterized and analyzed using XRD, FE-SEM, EDS and UV-Vis-NIR spectrophotometer. From the results, we guessed that NTO would be a suitable "solar heat protecting candidate" for energy-saving applications in coating industries.

• 한국전기전자재료학회논문지
• /
• 제34권2호
• /
• pp.90-98
• /
• 2021

Piezoelectric ceramic fiber composite (PCFC) was fabricated using a planar electrode printed piezoelectric ceramic fiber driven in transverse mode for small-scale wind energy harvester applications. The PCFC consisted of an epoxy matrix material and piezoelectric ceramic fibers sandwiched by interdigitated electrode (IDE) patterned polyimide films. The PCFC showed an excellent mechanical performance under a continuous stress. For the fabrication of PCB cantilever harvester, five -PCFCs were vertically attached onto a flexible printed circuit board (PCB) substrate, and then PCFCs were serially connected through a printed Cu circuit. The energy harvesting performance was evaluated applying an inverted structure, which imples its free leading edge located at an open end but the trailing edge at a clamped end, to enhance strain energy in a wind tunnel. The output voltage of the PCB cantilever harvester was increased as the wind speed increased. The maximum output power was 17.2 ㎼ at a resistance load of 200 ㏀ and wind speed of 9 m/s. It is considered that the PCB cantilever energy harvester reveals a potential use for wind energy harvester applications.

• 한국결정성장학회지
• /
• 제9권2호
• /
• pp.251-259
• /
• 1999

로울러 킬른 내의 이동현상에 대하여 전산모사를 수행하였다. 소결 공정에서 중요한 요소인 로울러 킬른 내의 온도분포와 속도장을 구하기 위하여 유한요소법을 이용하여 에너지 보존식과 운동량 보존식을 풀었다. 로울러 킬른 내에 세라믹 원료가 없을 경우에, 벽면의 열원으로부터 유입되는 공기로 빠르게 열전달이 이루어지게 되며 공기는 이 열의 대부분을 로울러 킬른 밖으로 전달하는 것을 알 수 있었다. 세라믹 원료가 있을 경우에, 세라믹 원료는 벽면으로부터 열을 받아 온도가 상승하게 되나 상대적으로 차가운 공기의 유동 때문에 인하여 공기로 많은 열을 빼앗기게 되는 것을 알 수 있었다. 자연대류에 의한 열전달로 인하여 소성대인 영역 5에서 세라믹 원료의 바닥과 윗면에서 온도 차이가 255K 정도 생겼다. 마지막으로 복사 열전달을 고려하였을 경우에 세라믹 원료 표면에서의 복사 열전달로 인하여 전도와 자연대류만 고려하였을 때보다 온도 차이가 45 K 정도 더 생겼다.

• 한국세라믹학회지
• /
• 제41권1호
• /
• pp.41-44
• /
• 2004

층상구조를 갖는 점토광물은 층상의 이온교환자리에 친소수성 유기물을 화학적으로 치환할 수 있어 도자기 소지의 친소수성 정도를 조절할 수 있다. 본 연구에서는 Montmorillonite를 이온교환법으로 dodecylamine, hexadecylamine과 반응시켜 유기물이 점토광물에 복합화된 유기-점토 복합체를 조조하였다. 유기물이 점토광물 구조에 치환된 위치 및 층상구조의 간격변화는 FT-IR과 WAXD로, 수식된 유기물의 양은 TG-DSC, C/S 기기를 사용하여 조사하였다. 분석을 통하여 유기물은 층상에 선택적으로 치환하여 층간격을 증가 (12${\AA}{\leftrightarro}16{\AA}$) 시키는 역할을 하였고, 비교적 친수성을 보이는 MMT가 첨가된 가소제로 인하여 소수성으로 변하고 있음을 발견하였다.

• 한국세라믹학회지
• /
• 제50권6호
• /
• pp.454-459
• /
• 2013

Recently, remote phosphors have been reported for application to white LEDs to provide enhanced phosphor efficiency compared with conventional phosphor-based white LEDs. In this study, a remote phosphor was produced by coating via screen printing on a glass substrate with different numbers of phosphor coating. The paste consists of phosphor, lowest softening glass frits, and organic binders. The remote phosphor could be well controlled by varying the phosphor content rated paste. After mounting the remote phosphor on top of a blue LED chip, CCT, CRI, and luminance efficiency were measured and values of 5300 K, 62, and 117 lm/W were respectively obtained in the 80 wt% phosphor with 3 coating layers sintered at $800^{\circ}C$.