• Journal of Positioning, Navigation, and Timing
• /
• v.8 no.2
• /
• pp.41-47
• /
• 2019

Recently, number of intentional jamming has increased significantly. If GNSS jammers are activated, user receivers can be largely influenced due to the vulnerable characteristic of the GNSS (Global Navigation Satellite System) signal. When the reception power of the jamming signal and that of the navigation signal are similar, the C/A (Coarse Acquisition) chip delay error can occur in the delay locked loop. To evaluate the jamming effect, a new measurement model is formulated based on previous research works. The new model explains how the jamming to signal ratio affects the ranging measurement accuracy and other parameters. To evaluate the validity of the newly formulated model, the experiment results of the previous research works under actual jamming environment are utilized. By evaluating the consistency of the carrier-to-noise ratio (C/N0) and the position error with the actual jamming environment, the validity of the newly formulated model is verified.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.6
• /
• pp.489-497
• /
• 1991

The error rate pquations of digital radio signals transmitted throught the Nakagami's m-distribution fading channel have been both for nondiversity reception and for diversity reception cases in the environmment of Gaussin noise. Using the derived equation. erro rate performance has been evaluated and represented in figures as a function of carrier to noise ratio, fading figure, and the power correlation coefficient between two diversity branches. By comparing the diversity reception case with nondiversity reception case. We could measure the amount of error rate performance improvenment of digital radiosignals in fanding enviroment.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.1
• /
• pp.64-72
• /
• 1986

The error rate equation fo DS-BPSK(Direct Sequence Binary Phase Shift Keying) signal transmitted through the nonlinear satellite transponder has been derived in the cochannel interference and downlink Gaussian noise environment. The input to the satellite transponder is the superposition of DS-BPSK signal with one interfere which is a cochannel wide-band PN signal. The error rate performance of DS-BPSK system has been evaluated and shown in figures in terms of carrier to interference power ratio(CIR), downlink signal to noise power ratio(downlink SNR) and process gain. In the analysis, it has been shown that the use of a hard limiter in DS-BPSK satellite system leads to the generation of narrow-band intermodulation products which is independent of the process gain. Also it is known that the error rate performance can be improved in the low levels (below 10dB) of CIR as the CIR increase. As the process gain varies from 10 to 100 the curve gives the about 10 dB gain in downlink SNR to maintain a fixed error rate.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.3
• /
• pp.292-299
• /
• 2015

An envelope elimination and restoration transmitter that uses a tri-level envelope encoding scheme is presented for improving the efficiency and linearity of the system. The proposed structure amplifies the same magnitude signal regardless of the input peak-to-average power ratio and reduces the quantization noise by spreading out the noise to the out-of-band frequency, resulting in the enhancement of power efficiency. An improved linearity is also obtained by providing a new timing mismatch calibration technique between the envelope and phase signal. Implementation in a 130 nm CMOS process, transmitter measurements on a 20-MHz long-term evolution input signal show an error vector magnitude of 3.7 % and an adjacent channel leakage ratio of 37.5 dBc at 2.13 GHz carrier frequency.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.22-31
• /
• 2015

Recently, 3rd Generation Partnership Project (3GPP) has developed device-to-device (D2D) communication to cope with the explosively increasing mobile data traffic. The D2D communication uses sidelink based on single carrier-frequency division multiple access (SC-FMDA) due to its low peak-to-average power ratio (PAPR). In addition, demodulation reference signal (DMRS) is designed to support multiple input multiple output (MIMO). In this paper, we propose the DFT-based channel estimation scheme for sidelink in D2D communication. The proposed scheme uses the 2-Dimensional Minimum Mean Square Error (2-D MMSE) interpolation scheme for the user moving at a high speed. We perform the system level simulation based on 20MHz bandwidth of 3GPP LTE-Advanced system. Simulation results show that the proposed channel estimation scheme can improve signal-to-interference-plus-noise ratio (SINR), throughput and spectral efficiency of conventional scheme.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.10
• /
• pp.1030-1035
• /
• 2003

In this paper, we compare the performance of IS-OFDM(interference suppressing orthogonal frequency division multiplexing) system with that of the conventional OFDM system. Each parallel branch symbol of IS-OFDM is multiplied by the orthogonal sequence and distributed into all sub-carriers. Then, each sub-carrier transmits information composed of the symbol components of all parallel branches in the given frame. The structure of IS-OFDM shows the frequency diversity characteristic. Therefore, IS-OFDM can be robust to the narrowband interference. BER performances are found in the narrow-band interference and a harmonic noise channels. When JSR(Jamming to signal ratio) increases from -10 dB to +10 dB in the constant interference bandwidth, IS-OFDM outperforms the conventional OFDM and the BER difference between IS-OFDM and OFDM is reduced as JSR increases. Also, the similar properly can be shown when interference bandwidth increases at the constant JSR. In the harmonic noise channel, we can find the good performance of IS-OFDM when the h-rate(harmonic noise bandwidth to signal bandwidth ratio) increases from 0.01 to 0.8. So, simulation results show that the IS-OFDM is more robust to the interference than the conventional OFDM.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.1
• /
• pp.166-172
• /
• 2001

A RF wideband receiver for INMARSAT-B satellite communications system was composed of low noise amplifier and high gain amplifier, The low noise amplifier used to the resistive decoupling circuit for input impedance matching and self-bias circuits for low noise. The high gain amplifier consists of matched amplifier type to improve receiver gain. The active bias circuit can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilization resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 60 dB in gain and less than 1.8:1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio which is input signal level -126.7 dB m at 1537.5 MHz is a 45.23 dB /Hz at a 1.02 kHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.3
• /
• pp.569-577
• /
• 1999

A wideband RF receiver for satellite mobile communications system was fabricated and evaluated of performance in low noise amplifier and high gain amplifier. The low noise amplifier used to the resistive decoupling and self-bias circuits. The low noise amplifier is fabricated with both the RF circuits and the self-bias circuits. Using a INA-03184, the high gain amplifier consists of matched amplifier type. The active bias circuitry can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilized resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 55 dB in gain, 50.83 dBc in a spurious level and less than 1.8 : 1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio is a 43.15 dB/Hz at a 1 KHz from 1537.5 MHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.4
• /
• pp.399-407
• /
• 2010

SC-FDMA system uses DFT-spreading method for reducing the PAPR of OFDM signal, which improves the power efficiency. Block type pilot is used in SC-FDMA system. However, there are ICI due to the inevitable phase noise and frequency offset that can be generated from the Doppler frequency and inaccuracy between the transceiver oscillators. This ICI definitely degrades the BER performance. To overcome this problem and estimate the channel efficiently, we like to propose ICI compensation algorithm for the SC-FDMA system with comb type pilot. SLM method is additionally included for the PAPR reduction when pilot is assigned in comb type. Finally, it is confirmed that the ICI due to the phase noise and frequency offset is efficiently compensated by the suggested algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.10
• /
• pp.1900-1911
• /
• 2015

In this paper, we introduce backscatter communication for power-limited sensors to enable long-range transmission in wireless sensor networks, and envision a way to avoid doubly near-far problem in wireless-powered communication network (WPCN) with this technology. In backscatter based WPCN, users harvest energy from both the signal broadcasted by the hybrid access point and the carrier signal transmitted by the carrier emitter in the downlink, and then transmit their own information in a passive way via the reflection of the carrier signal using frequency-shift keying modulation in the uplink. We characterize the energy-free condition and the signal-to-noise ratio (SNR) outage zone in backscatter based WPCN. Further, we propose backscatter based harvest-then-transmit protocol to maximize the sum-throughput of the backscatter based WPCN by optimally allocating time for energy harvesting and information transmission. Numerical results demonstrate that the backscatter based WPCN increases significantly the transmission range and diminishes greatly the SNR outage zone.