• Geomechanics and Engineering
• /
• 제12권4호
• /
• pp.675-688
• /
• 2017

The anchor block is a specially designed concrete member intended to withstand pullout or thrust forces from backfill material of an internally stabilized anchored earth retaining wall by passive resistance of soil in front of the block. This study presents small-scale laboratory experimental works to investigate the pullout capacity of a concrete anchor block embedded in air dry sand and located at different distances from yielding boundary wall. The experimental setup consists of a large tank made of fiberglass sheets and steel framing system. A series of tests was carried out in the tank to investigate the load-displacement behavior of anchor block. Experimental results are then compared with the theoretical approaches suggested by different researchers and codes. The appropriate placement of an anchor block and the passive resistance coefficient, which is multiplied by the passive resistance in front of the anchor block to obtain the pullout capacity of the anchor, were also studied.

• 수산해양기술연구
• /
• 제34권3호
• /
• pp.346-351
• /
• 1998

The purpose of this study is analyzing the performance of sea water cooling system under various refrigerant pipe length. In sea water cooling system, the increase of refrigerant pipe length cause increases of pressure drops. These pressure drops cause fresh gas in liquid pipe and increase specific volume in gas pipe outlet, so sea water cooling system capacity is decreased by decrease of refrigerant mass flow rate. Sea water cooling system capacity in refrigerant pipe length 70m is decreased more than 30% when compared with pipe length 10m and the decrease of the coefficient of performance is nearly 20%.

• 물과 미래
• /
• 제29권4호
• /
• pp.223-231
• /
• 1996

보다 효율적인 관로운영에 필수적인 통수능 변화 및 영향인자 산정을 위하여 국내 도송수강관에 대하여 124개의 Hazen Williams및 Darcy-Weisbach 마찰계수를 실측, 분석하였다. 그 결과 국내 도송수강관은 국외의 마찰계수 변화형태와 유사한 경향을 보이며 관경이 클수록 (Diameter>1100mm) 통수능은 관령에 많은 영향을 받으나 관경이 작을수록 관경과 관령에 동시에 영향을 받는다는 사실을 알았다. 또한 Hazen Williams의 C 값은 외국에 비해 약 5-10 정도 작은 것으로 나타났으며, 조도높이의 성장률은 약 0.41 mm/년으로 관의 통수능이 외국에 비해 빨리 저하한다는 사실이 밝혀져 그 원인 파악 및 통수능 산정기준을 재 검토해야 할 것으로 판단되었다. For the most efficient operation of water mains, 124 head losses in domestic water supply steel mains were measured to provide the values of friction coefficient and the variable affecting the deterioration rate of Hazen Williams' and Darcy-Weisbach's friction coefficient. The experimental results show that pipe age is governing the friction coefficient of large mains (Diameter > 1100 mm). On the other hands, pipe age and pipe diameter are affecting the variation of carrying capacity for small mains (Diameter < 1100 mm). The friction coefficient of water mains in foreign countries is higher than that in Korea by about 5 to 10 in Hazen Williams' C value. The growing rate of roughness height of domestic water main is about 0.41 mm/year which is higher than the average of United States of America. So further study is required to find out what causes the serious deterioration rate.

• 대한지하수환경학회지
• /
• 제6권4호
• /
• pp.180-187
• /
• 1999

일반적으로 비양수량은 쉽게 구해지지만 투수량계수를 구하려면 정규 양수시험을 시행하는데 많은 시간과 비용이 소요되기 때문에 비양수량 자료로부터 투수량계수를 추정하는 방법이 이용되기도 한다. 대개 Theis(1963). Brown (1963). Logan(1964)등이 유도한 해석적 방법이 이용되는데 이 방법들은 충적 대수층에서 영향반경 또는 저류계수등을 가정하여 대입하므로서 비양수량으로부터 투수량계수를 예측하는 것이 통상적이다. 그러나 암반 대수층이나 비균질 대수층에서 이렇게 구한 투수량계수는 실측된 투수량계수와 잘 맞지 않는다. Razack-Huntley(1991). Huntley-Steffey(1992). Mace(1997) 등은 비균질 충적대수층, 균열암반대수층. 용해성 석회암대수층 등에서 비양수량과 투수량계수의 관계식을 제시하였다. 본 연구에서는 제주도의 화산암 대수층에서 투수량계수와 비양수량 자료를 비교 분석한 바. 투수량계수의 대수값과 비양수량의 대수값 사이에 선형적인 관계가 성립(상관계수 0.951)하는 것을 확인 하였다. 또한 투수량계수의 $\pm$0.25 log cycle 범위내에 대부분의 자료가 포함되고 있다(96.6%).

• 한국농공학회지
• /
• 제31권2호
• /
• pp.104-115
• /
• 1989

In an effort to clarify the wetted patterns of sandy loam soil under trickle irrigation conditions, the distance of wetted zone, infiltration capacity and soil wetted patterns, etc. were measured by gypsum block as soil moisture sensor located every 5 cm vertically and horizontaly in the soil bin under the such conditions as a). irrigation rates set to 2, 4, 6, 8 liters per hour b). total amount of water applied fixed to 14.62 liters per soil bin c) the hearing force of soil measured by plate penetrometer ranging from 1.04 to 1.22kg/cm$_2$ The results can be summarized as follows ; 1. The wetted distance in horizontal direction(H), the wetted distance in vertical direction(D), the horizontal infiltration capacity (iH) and the vertical infiltration capacity(in)could by explained as a function of time t. 2. The horizontal wetted distance (H) is explained by an exponetial function H= a$.$ t where b was found ranging from 021 to 026 under surface trickle irrigation, which was considered a lotlower than the classical value of 0.5 and these measurements were indifferent to the increasing irrigation rates. 3. As for the surface trickle irrigation where horizontal infiltration capacity(iH) is explained as iH = A $.$ t h, the coefficient A increases with respect to irrigation rates within the limits of 0.89~1.34. 4. In terms of surface trickle irrigation of the ratio of Dm Which is maximum vertical wetted distance to Hm, which is maximum horizontal wetted distance, found to be within range of 1.0 to 1.21. It was also noted that the value of Dm decreses when irrigation rates increases while the value of Hm changes the opposite direction. 5. The optimum location of sensors from emitter for surface trickle irrigation should he inside of hemisphere whose lateral radius is 28~30cm long and vertical radius is 10~12cm long. The distance between emitters should be within 60cm long. 6. In the study of vertical wetted distance( D) where D= a $.$ tb, the exponential coefficient b ranged from 0.61 to 0.75 in surface trickle irrigation, and from 0A9 to 0.68 for subsurface trickle irrigation. These measurements showed an increasing tendency to with respect to irrigation rates. 7. In case of vertical infiltration capacity( in), where iD= A $.$ t 1-h, the coefficient A for surface trickle irrigation found to be within range of 0.16 to 0.19 and did not show any relationships with varying degree of irrigation rates. However, the coefficient was varying from 0.09 to 0.22 and showed a tendency to increase vis-a-vis irrigation rates for subsurface trickle irrigation, in contrast. 8. In the observation of subsurface trickle irrigation, it was found that Dm/Hm ratio was within 1.52 to 1.91 and showed a decreasing tendency with respect to increasing rates of irrigation. 9. The location of sensors for subsurface trickle irrigation follows same pattern as above, with vertical distance from emitter being 10~17cm long and horizontal 22~25cm long. The location of emitter should be 50 cm. 10.The relationship between VS which is the volume of wetted soil and Q which is the total amount of water when soil is reached field capacity could be explained as VS= 2.914Q0.91and the irrigation rates showed no impacts on the above relationship.

• 대한기계학회논문집B
• /
• 제21권5호
• /
• pp.713-723
• /
• 1997

Performance and heat transfer characteristics of an air conditioning system filled with hydro- carbon refrigerants are experimentally investigated. Single component hydrocarbon refrigerants (propane, isobutane, butane and propylene) and binary mixtures of propane/isobutane and propane/butane are considered as working fluids in the air conditioning system. Performances of each refrigerant are obtained at several compressor speeds and temperature levels of secondary heat transfer fluids. The cooling capacity and the coefficient of performance are obtained as test results. Heat transfer data of selected refrigerants are achieved from overall conductance measurement. Average heat transfer coefficients at different mass fluxes are shown and they are also displayed for different heat capacities of the system. Experimental results show that some hydrocarbon refrigerants have better characteristics than R22.

• 한국화재소방학회논문지
• /
• 제23권5호
• /
• pp.1-8
• /
• 2009

최근 건축물의 비약적인 발달에 따라 점차 초고층화 대형화 지하심층화 등 다양하게 변화하고 있다. 하지만 이러한 대형건축물은 화재 시 기존의 사양적인 설계로서는 인명의 피난안전을 확보할 수 없다. 따라서 이러한 대형건축물의 피난용량 확보를 위하여 재실자의 밀도를 정립하는 방안의 기초연구로서 대형할인마트를 대상으로 재실자밀도 실태조사를 실시하였다. 조사 결과로 0.30, 0.46, 0.42, 0.38 인/$m^2$로 조사되었다. 실태조사를 토대로 국내의 대형할인마트의 재실자밀도 정립에 관한 재실자밀도 값을 제시하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.950-952
• /
• 2000

Considering the effective distribution coefficient of Ni in Fe-Ni-Co invar alloy containing a little amount of carbon, we investigated on the thermal expansion coefficient(${\alpha}$). Fe-Ni-Co invar alloy had a large thermal expansion coefficient in as-casted compared with solution treated. The thermal expansion coefficient of Fe-Ni-Co alloy increased with the carbon content in both state of as-casted and solution treated. The effective distribution coefficient(Ke$\^$Ni/) of Ni was smaller than unity in alloy of not containing carbon, but is way larger than unity in alloy of containing carbon. It was considered that the homogeneity of Ni in primary austenite affected thermal expansion coefficient.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.407-426
• /
• 2008

The bentonite slurry has been used as the stabilize suspension for wet process bored pile construction in Thailand. The bentonite suspension has benefit on filtration in the sand layer, but it creates thick cake film along pile shaft and loose sedimentation at pile toe. The base grouting technique was widely used to rectify the soft base or loose sedimentation problem of bored pile. The base grouting technique was not increased only end bearing capacity, but was also more increase in skin friction capacity of the bored piles. The comprehensive researches on base grouting was carried out by installing PVC casing inside the shaft to allow the drilling through the pile base in order to collect the soil sample below the pile tip. The polymer based slurry recently was used to replace the bentonite slurry to overcome the thick cake film along pile shaft as well as loose sedimentation at pile toe. The extent research on polymer slurry by physical model was performed to verify the real behavior of polymer. The appropriate mixing ratio of polymer was proposed. The design skin friction coefficient, $\beta$ and end bearing coefficient, Nq, for sand layer base on fully instrumented tested pile were proposed. The application on remedial of the lose capacity bored pile with large displacement in Bangladesh was proposed and discussed.

• 한국전자파학회논문지
• /
• 제15권10호
• /
• pp.931-937
• /
• 2004

본 논문은 주파수 선택적 레일레이 페이딩(Frequency selective Rayleigh fading) 환경 하에서 수신 신호들 간에 상관이 존재할 때, OFDM(Othogonal Frequency Division Multiplexing) 다중 안테나 시스템의 채널 용량을 연구하였다. 송, 수신안테나를 각각 두 개 사용하였을 때, 채널 용량을 상관 계수의 함수로 closed-form 형태로 유도하였고, 각 안테나 당 평균수신 신호 전력이 동일할 때와 동일하지 않을 때 채널 용량에 미치는 영향을 분석하였다. 분석 결과 수신 신호의 상관 계수가 증가할수록 채널 용량이 감소하였고, 수신 신호 상관 계수가 약 0.7보다 클 때 채널 용량은 급격히 감소하였다. 그리고 각 안테나 당 평균 수신 신호 전력이 동일할 때 채널 용량은 최대가 됨을 알 수 있었다.