• Journal of Biosystems Engineering
• /
• v.38 no.2
• /
• pp.87-94
• /
• 2013

Purpose: Pineapple is now the third most important tropical fruit in world production after banana and citrus. Phytosanitary irradiation is recognized as a promising alternative treatment to chemical fumigation. However, most of the phytosanitary irradiation studies have dealt with physiochemical properties and its efficacy. Accurate dose calculation is crucial for ensuring proper process control in phytosanitary irradiation. The objective of this study was to optimize phytosanitary irradiation treatment of pineapple in various radiation sources using Monte Carlo simulation. Methods: 3-D geometry and component densities of the pineapple, extracted from CT scan data, were entered into a radiation transport Monte Carlo code (MCNP5) to obtain simulated dose distribution. Radiation energy used for simulation were 2 MeV (low-energy) and 10 MeV (high-energy) for electron beams, 1.25 MeV for gamma-rays, and 5 MeV for X-rays. Results: For low-energy electron beam simulation, electrons penetrated up to 0.75 cm from the pineapple skin, which is good for controlling insect eggs laid just below the fruit surface. For high-energy electron beam simulation, electrons penetrated up to 4.5 cm and the irradiation area occupied 60.2% of the whole area at single-side irradiation and 90.6% at double-side irradiation. For a single-side only gamma- and X-ray source simulation, the entire pineapple was irradiated and dose uniformity ratios (Dmax/Dmin) were 2.23 and 2.19, respectively. Even though both sources had all greater penetrating capability, the X-ray treatment is safer and the gamma-ray treatment is more widely used due to their availability. Conclusions: These results are invaluable for optimizing phytosanitary irradiation treatment planning of pineapple.

• Journal of ILASS-Korea
• /
• v.12 no.3
• /
• pp.131-137
• /
• 2007

This is an experimental study on characteristics of engine performance and discharged materials in common-rail type diesel engine. The bio-diesel fuel is mixed with the diesel fuel in common use at the ratio of 20% or 100%. The diesel fuel and blended fuel is irradiated by ultrasonic wave energy. The diese1 fuel, blended fuel, reformed diesel fuel and reformed blended fuel by ultrasonic wave energy are applied to the experimental engine individually. The results are compared with one of the diesel fuel in common use and analyzed.

• 한국생물공학회:학술대회논문집
• /
• 2000.11a
• /
• pp.123-126
• /
• 2000

Bio-electronics has been considered as one of the most appropriate candidates to overcome the frequently encountered problems in the development of future electronic devices. It has some advantages such as ultra fast electron transfer rate and high-energy efficiency compared with the silicon-based electronic devices. In silicon-based electronics, there are some of limitations of manufacturing process and physical problems. Bio-electronics can overcome the limitation and problem of silicon-based electronics. Bio-electronics has possible application areas as biosensor, biochip, bio-transistor and bio-computer. In the future, bio-electronics can substitute the silicon-based electronics.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.2
• /
• pp.23-28
• /
• 2007

Wood fuel must be dried before combustion to minimize the energy loss. Sawdust of Japanese red pine was dried in a direct contact thermal screw dryer to investigate the drying characteristics of sawdust as a raw material for bio-fuel. Average drying rate and energy efficiency was 1.4%/min and 69.23% at $100^{\circ}C$, respectively, and those at $120^{\circ}C$ was 2.1%/min and 71.03%, respectively.

• Journal of Biomedical Engineering Research
• /
• v.23 no.5
• /
• pp.405-412
• /
• 2002

The principle of Acupuncture effect on meridians is what physical stimulation does on general physiology so that is gets into new equilibrium from the fallen function state of human body. However, in western medicine, it is generally accepted that the action passageway of various kinds stimulation has been regarded as nerve-endocrine-immune system. Acupuncture effect has been regarded any action for all meridians as a respones by the stimulation. Western medicine doesn's accept treatment for transmission of the bio-energy. In this paper, we compared change of electric potential when an acupuncturist's bio-energy is passed on and when is not. As a result of clinics, the acupuncture effect is different as acupuncture method, when an acupuncturist's bio-energy is passed on the meridian and it isn's. It implies that acupuncture effect can complicately respond by simple acupuncture stimulus and transmission of bio-energy, on same meridian. We could confirm the relationship between an acupuncturist's energy transmission and acupuncture effect. Therefore, we could diagnosis the state of meridian using change of electric potential on the same meridian.

• Transactions of the Korean hydrogen and new energy society
• /
• v.22 no.2
• /
• pp.257-264
• /
• 2011

This study discribes performance of DEFC (Direct Ethanol Fuel Cell) utilized bio-ethanol based on fruit wastes. To produce the bio-ethanol, fruit wastes were treated at temperature $120^{\circ}C$ and 90minutes in acid pre-treatment. After pre-treatment was done, alcohol fermentation process was running. Initial alcohol concentration was 5%. Using the multi coloumn distillation system, more than 95% ethanol was distilled and each component of bio-ethanol was analyzed. In DEFC performance test, it was revealed that cell performance was much higher than that of ethanol. Comparing ethanol with mixed fuel (bio-ethanol (10%) + ethanol (90%)), the performance of ethanol was higher than that of mixed fuel. Even though the bio-ethanol from the fruit wastes is corresponded with transport ethanol standards, it thought that organic matter in bio-ethanol could be negative effect on fuel cell.

• Journal of Biomedical Engineering Research
• /
• v.38 no.5
• /
• pp.242-247
• /
• 2017

This study presents a bio-chemical energy harvesting system which can generate electric power from bioorganic substance contained in vermicompost. It produced electricity by inoculating microbial fuel cell(MFC) with earthworm-composted food waste. The generated electricity was converted into usable voltage level for mobile electronics through power conditioning circuits. The implemented prototype showed $200{\mu}W$ of maximum output electric power, which successfully supplied a beacon device which continuously transmitted data to nearby smartphone without a battery. The proposed system can help develop portable or bio-mimetic energy supply for sustainable use with further improvement.

• Transactions of the Korean hydrogen and new energy society
• /
• v.24 no.3
• /
• pp.249-254
• /
• 2013

The integrated gasification combined cycle (IGCC) system is well known for its high efficiency compared with other coal fueled power generation system. The aim of this study is to confirm the feasibility of using bio gas in coal feeding system and syngas recirculation system. The effects of using bio gas in the gasifier on the syngas composition were investigated through simulations using the Aspen Plus process simulator. It was found that these changes had an influence on the syngas composition of the final stream and bio gas can be used in a gasifier system.

• Macromolecular Research
• /
• v.15 no.2
• /
• pp.129-133
• /
• 2007

Significant progress has been realized in the design and synthesis of light emitting polymers that emit over the entire visible spectrum. However, up to seventy-five percent of charge recombination events can lead to triplet states that decay non-radiatively. Following the pioneering work in the field of small molecule organic light emitting devices, it has been found that solution processible iridium polymer complexes can be used to harness the wasted triplet energy. In this paper, new results with respect to the electrophosphorescence of solution processible tethered iridium polymer derivatives are presented. Furthermore, our approaches to the design of new high triplet energy conjugated polymer hosts are also reported.

• Journal of Korean Society on Water Environment
• /
• v.32 no.3
• /
• pp.303-309
• /
• 2016

This study aimed to assay the biological removal of TDS (total dissolved solids) from RO (reverse osmosis) rejected water. Following bio-sorption of TDS with AGS (aerobic granular sludge), the effects of TDS on biological nitrogen removal were examined. The bio-sorption of TDS after AGS treatment was confirmed by checking for TDS removal efficiency and surface analysis of microorganisms with SEM and EDS. Then, the effects of TDS on biological nitrogen removal and the denitrification efficiency were evaluated using the MBR reactor. According to the results, the bio-sorption of TDS with AGS was 0.1 mg TDS/mg AGS, and we confirmed that the microorganism surfaces had adsorbed the TDS. Biological nitrogen removal efficiency was measured at inhibiting denitrification at 4,000 mg/L of TDS-injected material. Based on this study, it is necessary to pretreat TDS-containing RO rejected water and to maintain TDS concentration lower than a specific value (≤4,000 mg/L), when considering biological nitrogen removal.