• Journal of Broadcast Engineering
• /
• v.8 no.2
• /
• pp.136-145
• /
• 2003

This paper proposes a DTV receiver using beamforming techniques to improve indoor and mobile reception. The proposed DTV receiver estimates the directions of arrival (DOAs) of incoming signals using Capon's DOA estimation method and generates an adaptive antenna beam pattern to the estimated DOA of the mainpath signal to Improve the channel condition. After beamforming, a following decision feedback equalizer (DFE) removes the remaining multipath components. The proposed receiver can be implemented with a conventional DTV receiver without anymodification. The performance of the proposed receiver is analyzed with modified Brazilian field test models, which include DOA information of Incoming signals. Simulation results show that the proposed receiver can satisfy the threshold of visibility (TOV) when input signal to noise ratio is slightly over 10 dB.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.7
• /
• pp.1271-1277
• /
• 2008

This paper proposes the code acquisition scheme on a MIMO channel for preamble search in a CDMA-MIMO uplink system. The multiple transmit/receive antennas are used for beamforming. The performance of a ML code acquisition technique based on transmit and receive beamforming is analyzed by considering rho detection probability. The acquisition performance and MAT for a MIMO code acquisition system are numerically evaluated. It is shown that multiple transmit antennas can give the code acquisition system a transmit beamforming gain and result in much better performance than a SIMO case.

• ETRI Journal
• /
• v.43 no.3
• /
• pp.389-399
• /
• 2021

In this paper, we propose one-bit feedback-based distributed beamforming (DBF) techniques for simultaneous wireless information and power transfer in interference channels where the information transfer and power transfer networks coexist in the same frequency spectrum band. In a power transfer network, multiple distributed energy transmission nodes transmit their energy signals to a single energy receiving node capable of harvesting wireless radio frequency energy. Here, by considering the Internet-of-Things sensor network, the energy harvesting/information decoding receivers (ERx/IRx) can report their status (which may include the received signal strength, interference, and channel state information) through one-bit feedback channels. To maximize the amount of energy transferred to the ERx and simultaneously minimize the interference to the IRx, we developed a DBF technique based on one-bit feedback from the ERx/IRx without sharing the information among distributed transmit nodes. Finally, the proposed DBF algorithm in the interference channel is verified through the simulations and also implemented in real time by using GNU radio and universal software radio peripheral.

• The Journal of the Acoustical Society of Korea
• /
• v.29 no.1
• /
• pp.24-33
• /
• 2010

This paper proposes a technique of sound beamforming that can generate high-directive sound beams, and this paper also presents applications of the proposed algorithm to multi-channel 3D sound systems. The proposed algorithm consists of two phases: first, optimum weights maximizing a sound pressure level ratio between the target and control acoustic regions are designed, and later, the directivity of the pre-designed sound beam is iteratively enhanced by modifying the covariance matrix. The proposed method was evaluated under various situations, and the results showed that it could provide more focused sound beams than the conventional methods.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.2
• /
• pp.451-456
• /
• 2016

Because GPS signals are weak, system jamming is a real and present danger. This can happen when the receiver is subjected to intentional or unintentional interference by a transmitter. If the jamming signal is strong enough, the receiver can be operated to take corrective action automatically. Current methods to protect GPS receiver from jamming condition are based on spatial filtering. In this paper, the beamforming as referred to in signal processing technique used in arrays for directional signal reception was suggested and analyzed for anti-jamming. In order to change the directionality of the array when receiving a jamming signal, a beamformer can control the signal at each sensor. Therefore, cutoff angle ${\theta}$ was measured in the opposite direction of the jammer. GPS signals are only processed when the antenna element is within inside the cutoff angle. As a result, GPS positioning can be used in condition under cutoff angle $30^{\circ}$.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.6
• /
• pp.812-819
• /
• 2012

Interference and jamming are becoming increasing concern to a radar system nowdays. AESA(Active Electronically Steered Array) antennas and adaptive beamforming(ABF), in which antenna beam patterns can be modified to reject the interference, offer a potential solution to overcome the problems encountered. In this paper, we've developed a planar active phased array radar system, in which ABF, target detection and tracking algorithm operate in real-time. For the high output power and the low noise figure of the antenna, we've designed the S-band TRMs based on GaN HEMT. For real-time processing, we've used wavelenth division multiplexing technique on fiber optic communication which enables rapid data communication between the antenna and the signal processor. Also, we've implemented the HW and SW architecture of Real-time Signal Processor(RSP) for adaptive beamforming that uses SMI(Sample Matrix Inversion) technique based on MVDR(Minimum Variance Distortionless Response). The performance of this radar system has been verified by near-field and far-field tests.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.765-767
• /
• 2011

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.11A
• /
• pp.861-869
• /
• 2011

In this paper, we propose coordinated scheduling and beamforming based on limited feedback to overcome the effects of inter-cell interference in multi-cell environment. The goal of this study is to improve a performance of cell-edge area significantly affected by the inter-cell interference and also to guarantee a performance of the entire system. Existing coordinated scheduling and beamforming based on the perfect channel state information generates an overhead for the channel state information feedback and exchange at the users and base stations, respectively. In this study, first we propose a novel codebook to obtain a null space of an interference channel efficiently which can be used to reduce the inter-cell interference. Using the proposed codebook, we propose coordinated scheduling and beamforming to improve the performance of cell-edge area and the entire system. Through the proportional fair scheduling, the performance of the proposed technique is shown as improvement of channel capacity for users located cell-edge area and entire system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.9A
• /
• pp.749-754
• /
• 2005

It is well-known that mobile communication systems are usually limited in their performance and capacity by three major impairments, which are multipath fading, delay spread and co-channel interference (CCI). OFDMA (OFDM-FDMA) system can cope with the multipath fading and delay spread easily due to the beneficial properties of OmM technology. Though OFDMA scheme avoids intra-cell interference using the orthogonality among subcarriers, the scheme contains difficulty of reducing co-channel interference. Therefore, in this paper, adaptive antenna techniques are deployed into OFDMA/TDD system to minimize the co-channel interference induced by adjacent cells and to enhance the uplink performance. For the improvement of downlink performance, we apply TxAA (Transmit Adaptive Array), a kind of transmit diversity technique, utilizing preamble symbols for training antenna may into OFDMA/TDD transmitter side. Simulation results show that the uplink and downlink performance under multipath Rayleigh fading channel improved 9dB and 7dB each compared with the case of single antenna system at target BER $10^{-3}$ .

• Journal of the Korean Institute of Intelligent Systems
• /
• v.21 no.4
• /
• pp.436-441
• /
• 2011

A TPMS is a wireless communication system designed to monitor its condition inside the pneumatic tires on various types of vehicles. These systems report the tire pressure information to the driver of the vehicle. While wireless communications is used to transmit the measurement data from TPMS sensors to a central processing unit in the vehicle, it suffers from the various interferences such as sensors of each tire or outside electrical equipments. Based on the conventional beamformer, a switching beamforming technique is proposed to minimize the interference and efficiently receive valid data. Moreover, in order to minimize the interference and reduce power consumption for communication, a system with unique Gold Code is presented for each tire. The performance of interference suppression is illustrated by computer simulations.