• Journal of the Korean Regional Science Association
• /
• v.37 no.4
• /
• pp.49-59
• /
• 2021

This study aims to identify the characteristics of the cancelled districts of housing redevelopment and housing reconstruction project. The subject of this study is 189 project districts(121 promoted districts, 68 cancelled districts). Both 121 promoted districts and 68 cancelled districts were analyzed by Decision Tree Analysis. The first separation of the release zone influencing factors was made by the Development Actors. In other words, the most important independent variable for determining the release zone influence factor was shown to be the presence or absence of propulsion actors. Of the 89 districts without propellers, 41 were lifted and 48 were promoted, and 9 out of 100 districts with propellers were lifted and 91 were promoted. The second separation of the impact factors on the zone was then made by Land Owners, and the probability of cancellation increased if the number of landowners was less than 468 and 37 out of 62 were removed. On the other hand, four out of 27 districts with more than 468 landowners were lifted and 23 districts were promoted. The third separation was made by the Average Land Assessment, and 35 zones were lifted below the standard of KRW 269.64 million/m² approximately KRW 8.91 million per pyeong, and two zones were lifted at higher official prices. In the second division, the number of landowners was 468 or more, and in node4, four areas were removed from areas with a public land area ratio of 29.43% or more, and no areas less were released. This study used SPSS Statistics 26 S/W for analysis.

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.5
• /
• pp.551-559
• /
• 2008

An experimental study was carried out to evaluate the potential of flotation process for the secondary clarifier of an activated sludge process. Flotation techniques, applied in this study, include electrofloation (EF) which generated fine bubbles smaller than $35{\mu}m$ in average and diffuser flotation (DF) which generated fine bubbles smaller than $55{\mu}m$ in average. The batch experiments were done with activated sludge displaying various characteristics. It was shown that the efficiency of solids/liquid separation was reduced as the diluted sludge volume index ($DSVI_{30}$) of activated sludge increased. The dependency, however, gradually decreased as the gas to solids (G/S) ratio increased. Thickening efficiency of EF was more than 2~10 times and DF process was more than 1.5~5 times as compared with gravity sedimentation (GS). Stable sludge blanket was maintained regardless of sludge settleability when the G/S ratio was 0.019 in the EF. On the other hand, Serious deterioration in the sludge blanket was observed in the DF depends on G/S ratio and sludge settleability. And For EF and DF, the suspended solids concentration of effluent was not nearly influenced on settleability of activated sludge and more clear than GS. A biological nutrient removal (BNR) process, combined with EF as a secondary clarifier was operated for three months. The mean MLSS (mixed liquid suspended solids) concentration in the reactor and mean solids concentration of return sludge were estimated to be 5,340 mg/L and 16,770 mg/L, respectively. The water quality of effluent was considerably stable and low value was accomplished, that was, standard suspended solids concentration $0.07{\pm}0.51mg/L$ and standard turbidity $1.44{\pm}0.56NTU$. The EF could be applicable for enhancement of efficiency of activated sludge system as well as improvement of the water quality of effluent.

• Journal of Advanced Navigation Technology
• /
• v.21 no.4
• /
• pp.365-370
• /
• 2017

This study analyze correlation between weekdays data and special days data of different power demand patterns, and builds a separate data set, and suggests ways to reduce power demand prediction error by using deep learning network suitable for each data set. In addition, we propose a method to improve the prediction rate by adding the environmental elements and the separating element to the meteorological element, which is a basic power demand prediction elements. The entire data predicted power demand using LSTM which is suitable for learning time series data, and the special day data predicted power demand using DNN. The experiment result show that the prediction rate is improved by adding prediction elements other than meteorological elements. The average RMSE of the entire dataset was 0.2597 for LSTM and 0.5474 for DNN, indicating that the LSTM showed a good prediction rate. The average RMSE of the special day data set was 0.2201 for DNN, indicating that the DNN had better prediction than LSTM. The MAPE of the LSTM of the whole data set was 2.74% and the MAPE of the special day was 3.07 %.

• Journal of the East Asian Society of Dietary Life
• /
• v.7 no.4
• /
• pp.460-467
• /
• 1997

The purpose of this study was to diagnose nutritional status of vitamin A in female university students. Total of 59 female students in Korea National University of Education, Home Economics Education department were recruited for this study. Retinol and :t major carotenoids in serum($\beta$-carotene, u-carotene, lycopene and lutein) were analyzed by HPLC. The isocratic separation was performed in a $\mu$ Bondapak$^{TM}$ $C_{18}$ stainless steel column with a solvent system of acetonitrile : methanol=85:15. The results of analysis were as follows: The average retinol concentration of 59 female students was 25.9$\mu\textrm{g}$/100$m\ell$. According to biochemical criteria for the assessment of vitamin A status, 18 of them belong to well-nourished and 6 students belong to adequate status. On the other hand, 8 students, 3 freshmen and 5 sophomore, were in critical vitamin A status. Retinol concentrations of junior and senior students were higher than those of freshmen and sophomore (P＜0.001). The average concentrations of serum $\beta$-carotene, lycopene, and lutein were 1.9, 5.4, and 41.4$\mu\textrm{g}$/100$m\ell$, respectively. Serum $\beta$-carotene concentration of senior was significant. higher than those of freshman, sophomore and junior(p＜0.001). Lycopene concentration of freshman was significant. lower than those of the other grades and that of senior was sig, higher than those of the other grades(p＜0.05). Lutein concentrations of junior and senior were significant. higher than those of freshman and sophomore(p＜0.001). The serum $\alpha$-carotene concentrations of the students were too low to analyze.e.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.6
• /
• pp.2132-2146
• /
• 1991

Extensive experiments were carried out to investigate the mass transfer and flow structures around a circular cylinder with annular fins in crossflow. The naphthalene sublimation method was employed to measure the circumferential and longitudinal variations of mass transfer from the circular cylinder between annular fins and H is the height of the fin from the cylinder surface. A remarkable enhancement of mass transfer due to the horseshoe vortices was observed near the corner junction between the annular fin and circular cylinder. The present results indicate that the local circumferential Sherwood number shows the higher values on the front stagnation point. The maximum augmentation of mass transfer rate at the center of cylinder is found near L/H-0.15 due to the separation bubble along the annular fins. The secondary flows, which are the corner vortices V2 and V3 near the end wall of the annular fin, are fairly predicted from the distributions of local Sherwood number in the spanwise direction. The average Sherwood number of overall surface at L/H=0.15 is larger 2.0 times than that of without annualr fins. The correlations of total average mass transfer rate with L/H and Re$_{L}$ can also be obtained.d.

• The Journal of Engineering Geology
• /
• v.30 no.3
• /
• pp.253-268
• /
• 2020

In this study, recharge rates are estimated using SWAT-K (a distributed hydrological model). The validity of the estimated recharge rates were evaluated by employing the baseflow separation method based on observed hydrological data. The exploitable groundwater is typically determined as the 10-year drought frequency recharge rate that is calculated by average recharge ratio multiplied by 10-year drought frequency precipitation. In practice, however, recharge rates typically decrease in line with precipitation; therefore, exploitable groundwater could be overestimated when average recharge rates are used without considering precipitation. To resolve this overestimation, exploitable groundwater was calculated by re-estimating recharge rates that consider precipitation intensity. By applying this method to the Uiwang, Gwacheon, and Seongnam sub-basins, the exploitable groundwater decreased by 55.5~77.6%, compared with recharge rates obtained using the existing method.

• Journal of Korean Society on Water Environment
• /
• v.21 no.5
• /
• pp.458-463
• /
• 2005

Considering the characteristics of a filtration bio-reactor equipped with a mesh filter module which can effectively maintain high concentration of biomass and enhanced solid-liquid separation performance, the hybrid process of filtration bio-reactor combined with coagulation was investigated to get improved filtration characteristics as well as water quality in this work. Two bio-reactors (Run-1 & Run-2) were operated under the following conditions: working volume of 25 L, continuous loading of a synthetic wastewater (BOD: 200 mg/L, T-N: 50 mg/L, T-P: 5 mg/L), where an appropriate amount of alum ($Al_2(SO_4)_3{\cdot}18H_2O$) was added once a day into the reactor (Run-2). In the system without using a alum (Run-1), the clogging of mesh filter module was observed two times through 85 days of whole operation. Meanwhile, the filter module did not clog even at higher MLSS concentration (6,000~12,000 mg/L) and the stable filtration (0.7 mid) was continued in the case of using a alum. Due to the stable formation of cake layers, BOD and SS were shown below 6 and 3 mg/L, respectively. T-P and pH of the effluent were changed because of the intermittent addition of the alum. In the case of Al/P=2.5, the average T-P removal efficiency per day was 85.2% and the average T-P concentration of the effluent was 0.3 mg/L. However, the removal efficiency of phosphate was influenced by pH in the reactor.

• Journal of Microbiology and Biotechnology
• /
• v.15 no.3
• /
• pp.461-465
• /
• 2005

Characteristics of biological $CO_2$ fixation by Chlorella sp. HA-1 were investigated in a semi-continuous and series reactor system using an internally illuminated photobioreactor to overcome shortcomings of physicochemical technologies such as adsorption and membrane separation. High $CO_2$ fixation rate was achieved in the semi-continuous reactor system, in which the dilution ratios of the culture medium were controlled. The average $CO_2$ fixation rate was maintained almost constantly when the dilution ratio increased by 0.1 increment from the initial value of 0.5. The total removal efficiency of $CO_2$ was enhanced by employing a series reactor system. The average $CO_2$ fixation rate increased until 4.013 g $CO_2\;day^{-1}$ in a series operation of four reactors, compared to 0.986 g $CO_2\;day^{-1}$ in a batch operation mode. The total $CO_2$ fixation rate was proportional to the number of reactors used in the series reactor system. In the series reactor system of semi-continuous operation, a large amount of $CO_2$ was removed continuously for 30 days. These results showed that the present reactor systems are efficient and economically feasible for a biological $CO_2$ fixation.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.1
• /
• pp.47-55
• /
• 2007

The waste water treatment facility at rural and mountainous region in catchment areas of dams should be small scale. The wastewater treatment facility of small scale has some specification as follows;1)simple process, 2)low maintenance cost, and 3)high removal efficiency. So, we developed the bioreactor which can be satisfied with the specification of small scale waste water treatment facility. The bioreactor consisted of the anoxic and oxic zone. The two zones were effectively separated by cone type baffle. By the effective separation through CTB, the nitrification and denitrification reaction occurred effectively. Therefore, the removal efficiency of total nitorgen (TN) increased compared to other types of baffle. And, we put into the bio activated media in oxic zone to increase the concentration and activity of microbiology. The media contained the components which were made of many kinds of the minerals to increase the activity of microbiology. Additionally, we observed that the phosphate removal efficiency increased by bio activated media. This is resulted from the coagulation-sedimentation reaction by mineral in components. The average removal efficiencies of TN and TP during Run 2 were 69 and 89% which were 4 and 25% higher than those during Run 1 without the MA, respectively. For BOD, COD, SS and TKN, the average removal efficiencies at Run 2 were slightly higher than those at Run 1. Therefore, we could maintain the high concentration and high activity of microbiology through bioreactor developed in this study. And the removal efficiency of TN and TP increased.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.4
• /
• pp.1058-1070
• /
• 1999

In this paper, we propose a control model which can control the burst input messages of the BSC(Base Station controller) in mobile communication systems more efficiently and reliably, by dividing the input messages characteristically and using multiprocessor system. Using M/M/c/K queueing model, we briefly analyze proposed model to get characteristic parameters which are required to performance improvement. On the base of the results, we compare our proposed model with the conventional one by using SLAM II with regard to the following factors : the call blocking rate of the input message, the distribution of average queue length, the utilization of process controller(server), and the distribution of average waiting time in queue. In addition, we modified our model which has overload control function for burst input messages, and analyzed its performance.