• Journal of ILASS-Korea
• /
• v.23 no.1
• /
• pp.30-35
• /
• 2018

The objective of this study is to predict numerically the effect of intake humidification on the injected diesel fuel spray characteristics in a compression ignition engine. In this work, Wave model and Ducowicz model were applied as the break-up model and evaporation model, respectively. The amount of water vapor for the humidification was changed from 0% to 30% of injected fuel mass. The number of applied meshes was generated from 49,000 to 110,000. At the same time, the results of this work were compared in terms of spray tip penetration, SMD and equivalence ratio distributions. It was found that the cylinder temperature and cylinder pressure were decreased with increasing water vapor mass by vaporization latent heat and specific heat, however, the difference was very small. So, the spray tip penetration was not different by water vapor mass. Also, higher equivalence ratio distributions were observed with increasing water vapor mass by the improvement of fuel atomization.

• Carbon letters
• /
• v.6 no.4
• /
• pp.227-233
• /
• 2005

Carbonization products C1, C2, C3, C4 and C5 were prepared by the carbonization of date pit in limited air, at 500, 600, 700, 800 and $1000^{\circ}C$, respectively. C1-V-600, C3-V-600, C1-V-1000 and C3-V-1000 were prepared by thermal treatment of C1 and C3 under vacuum at 600 and $1000^{\circ}C$. The textural properties were determined from nitrogen adsorption at 77 K and from carbon dioxide adsorption at 298 K. The surface pH, the FTIR spectra and the acid and base neutralization capacities of some carbons were investigated. The amounts of surface oxygen were determined by out-gassing the carbon-oxygen groups on the surface as $CO_2$ and CO. The adsorption of water vapor at 308 K on C1, C2, C3 and C4 was measured and the decomposition of $H_2O_2$ at 308 K was also investigated on C1, C2, C3, C4 and C5. The surface area and the total pore volume decreased with the rise of the carbonization temperature from 500 to $1000^{\circ}C$. The adsorption of water vapor is independent on the textural properties, while it is related to the amount of acidic carbon-oxygen groups on the surface. The catalytic activity of $H_2O_2$ decomposition does not depend on the textural properties, but directly related to the amount of basic carbon-oxygen complexes out-gassed as CO, at high temperatures.

• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.E4
• /
• pp.149-155
• /
• 2003

In this study. the amounts of the total precipitable water (TPW) in both global and regional scale are estimated from the MODIS instrument, which is on-board the EOS satellites, Terra and Aqua. The estimation is made from the five near-infrared spectral bands, using a technique employing ratios of water- vapor absorbing channels centered at 0.905, 0.936, 0.940 ${\mu}{\textrm}{m}$ with atmospheric window channels at 0.865 and 1.240 ${\mu}{\textrm}{m}$. Through analyses of monthly and eight-days mean TPW, one can monitor characteristics of seasonal variations as well as amount and distribution (i.e., water resources) of TPW at both global and local regions. Long-term monitoring of TPW is essential to understand the regional variations of water resources in East Asia.

• Proceedings of the Membrane Society of Korea Conference
• /
• 2004.05a
• /
• pp.166-169
• /
• 2004

Microfiltration membranes were prepared from aromatic polyethersulfone (PES) polymer, using aprotic solvent (N-methyl-2-pyrrolidone, NMP) and non-solvent additive (2-methoxy ethanol, 2-ME) by the phase inversion co-process of the vapor-induced phase inversion (VIPI) and the nonsolvent-induced phase inversion (NIPI). According to the change of the additive amount, the solvent amount and the relative humidity, membrane characterization was studied. The non-solvent additive in casting solution played an important role in membrane morphology. During the vapor-induced phase inversion, the relative humidity led to water sorption on the surface of casting dope at which pore formation was generated. The prepared membranes were characterized by scanning electron microscope observations, measurements of capillary flow porometer and pure water flux (PWP). Also the thermodynamic and kinetic properties of membrane-forming system were studied through coagulation value, light transmittance and viscosity.

• Journal of Advanced Marine Engineering and Technology
• /
• v.21 no.1
• /
• pp.26-36
• /
• 1997

Recently, the new refrigerating system, using non - fluorinated hydrocarbon refrigerants has to be developed for the agricultural fields. One of that kinds of systems is the cooling system using the water vapor and vacuum, in which the water evaporate at the low temperature under vacuum and absorb the large amount of the latent heat. If vapor with large amount of latent heat is removed from the system, the system is cooled accordingly. The characteristics of cooling under the vacuum was observed and measured using experimental apparatus, which is consisted of vacuum chamber, the ejectors, the pumps and the measurement apparatus. As the results of experiments, we know that the evaporation in the vacuum occurs vigorously when the materials to be cooled has more amounts of heat before cooling, and by which effects the materials can be cooled. The cooling vacuum system is more efficient than other methods when the agricultural products is chilled or dried.

• Journal of the Korean Chemical Society
• /
• v.51 no.6
• /
• pp.577-584
• /
• 2007

The purpose of this study is to suggest how to use the phase diagram for water to explain the evaporation and sublimation in the atmospheric condition. In principle, the phase diagram for water represents a one component system so it cannot be applied to the water contact with the air. When the liquid or solid phase of water exists in the air, always water vapor also exists in the air. In this case, we cannot present this state as a single point on the phase diagram because the pressure of the liquid or solid is different from that of the vapor in the air. However, since the saturation vapor pressure of liquid or solid is altered by negligible amount due to the presence of air, the evaporation and sublimation in the atmospheric condition can be explained using the vapor pressure line and sublimation line on the phase diagram.

• Journal of the Korean Wood Science and Technology
• /
• v.19 no.4
• /
• pp.52-61
• /
• 1991

In this paper, the difference of the property of absorption and desorption for five species in semi-steady state are studied. The species used are listed in Table 1 and the dimension of specimen was $8\times8{\times}T$(Tangential direction)cm and tested in various conditions. A change of average moisture content with time were measured in each cycles. The results obtained are summarized as follows. When the relative humidity in air was maximum or minimum, the distribution of moisture In wood of all specimens were illustrated by exponential curves of decrease or increased from lace 10 center of wood. From the consideration of coefficient of decrease(C), the amount of moisture change of spruce was larger than the others. The pheonomenon was considered no relation to the specific gravity in air dry, but the wood structures. The velocity of the absorption and desorption for species decreased in the order spruce(Picea sitchensis) neodobam(Fagus crenata), solsong(Tsuga heterophylla), meranti(Shorea sp.) and kaesoo(Cercidiphyllum japoicum). In case of constant temperature and water vapor pressure is changed. the amount of absorbed moisture was larger than that of constant water vapor pressure and temperature vaned. In this fact, it is considered that the property of sorption of wood is strongly influenced by vapor pressure gradient than temperature gradient.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.6
• /
• pp.56-66
• /
• 1998

The absorption process of water vapor in a liquid film is an important process in LiBr-Water absorption system. The composition of the gas phase, in which a non-absorbable gas is combined with the absorbate, influences the transport characteristics. In the present work, the absorption processes of water vapor into aqueous solutions of lithium bromide in the presence of non-absorbable gas are investigated. The continuity, momentum, energy and diffusion equations for the solution film and gas are formulated in integral forms and solved numerically. It is found that the mass transfer resistance in gas phase increases with the concentration of non-absorbable gas. However the primary resistance to mass transfer is in the liquid phase. As the concentration of non-absorbable gas in the absorbate increases, the interfacial temperature and concentration of absorbate in solution decrease, which results in the reduction of absorption rate. The reduction of mass transfer rate is found to be significant for the addition of a small amount of non-absorbable gas to the pure vapor, especially at the outlet of tube where the non-absorbable gas accumulates. At higher non-absorbable gas concentration, the decrease of absorption rate seems to be linear to the concentration of non-absorbable gas.

• International Union of Geodesy and Geophysics Korean Journal of Geophysical Research
• /
• v.23 no.1
• /
• pp.34-38
• /
• 1995

A diagnostic study on the summertime air mass thunderstorms occurring in the middle region of South Korea was made by analyzing the data of surface and upper air observations as well as the surface and upper level weather charts. The key parameters used in the present study are the amount of precipitable water below 850 hPa level, the vertical profiles of water vapor content and wind, and both the temperature difference and the equivalent potential temperature difference between 850 hPa and 700 hPa levels. It is found from this study that the summertime air mass thunderstorms in the middle region of South Korea can be classified into two distinct types, type I and type II. The thunderstorms of type I occur under the atmospheric conditions of high moisture content, low vertical wind shear in low levels, and conditional instability between 850 hPa and 700 hPa levels. On the other hand, the thunderstorms of type II occur under the atmospheric conditions of less moisture content, higher wind shear and conditional instability. Furthermore, our study suggests that atmospheric instability and the amount of water vapor below 850 hPa level are complementary in the development of air mass thunderstorms. The complementary nature between these two parameters may be an explanation for the thunderstorm development in the areas of low atmospheric water vapor content such as the plains of eastern Colorado.

• Korean Chemical Engineering Research
• /
• v.50 no.3
• /
• pp.398-402
• /
• 2012

The catalytic performance of some metal oxides in the vapor phase selective oxidation of $H_2S$ in the stream containing ammonia and water was investigated. Among the catalysts tested $Fe_2O_3/SiO_2$ was the most promising catalyst for practical application. It showed higher than 90% $H_2S$ conversion and very small amount of $SO_2$ emission over a temperature range of $240{\sim}280^{\circ}C$. The effects of reaction temperature, $O_2/H_2S$ ratio, amount of ammonia and water vapor on the catalytic activity of $Fe_2O_3/SiO_2$ were discussed to better understand the reaction mechanism. The $H_2S$ conversion showed a maximum at $260^{\circ}C$ and it decreased with increasing temperature over $280^{\circ}C$. With an increase of $O_2/H_2S$ ratio from 0.5 to 4, the conversion was slightly increased, but the selectivity to elemental sulfur was remarkably decreased. The increase of ammonia amount favored the conversion and the selectivity to elemental sulfur with a decrease in $SO_2$ production. The presence of water vapor decreased both the activity and the selectivity to sulfur, but increased the ATS selectivity.