• Korean Chemical Engineering Research
• /
• v.60 no.4
• /
• pp.606-612
• /
• 2022

Relatively high indoor CO₂ concentration (>1,000 ppm) has a negative impact on human health. In this work, indoor CO₂ adsorbent was developed by impregnating KOH or K₂CO₃ on commercial activated carbon, named as KOH/AC and K₂CO₃/AC. Commercial activated carbon (AC) showed relatively high BET surface area (929 m²/g) whereas KOH/AC and K₂CO₃/AC presented lower BET surface area of 13.6 m²/g and 289 m²/g. Two experimental methods of TGA (2,000 ppmCO₂, weight basis) and chamber test (initial concentration: 2,000 ppmCO₂, CO₂ IR analyzer) were used to investigate the adsorption capacity. KOH/AC and K₂CO₃/AC exhibited similar adsorption capacities (145~150 mg_CO2/g), higher than K₂CO₃/Al+Si supports adsorbent (84.1 mg_CO2/g_sample). Similarly, chamber test also showed similar trend. Both KOH/AC and K₂CO₃/AC represented higher adsorption capacities (KOH/AC: 93.5 mg_CO2/g K₂CO₃/AC: 94.5 mg_CO2/g_sample) K₂CO₃/Al+Si supports. This is due to the KOH or K₂CO₃ impregnation increased alkaline active sites (chemical adsorption), which is beneficial for CO₂ adsorption. In addition, the regeneration test results showed both K-based adsorbents pose a good regeneration and reusability. Finally, the current study suggested that both KOH/AC and K₂CO₃/AC have a great potential to be used as CO₂ adsorbent for indoor CO₂ adsorption.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2004.06a
• /
• pp.119-120
• /
• 2004

A study on the selective adsorption of uranium(VI) from a high concentration of chemical salts has tern peformed to investigate the uranium removal mechanisms and the application conditions of the electrosorption technique using the activated carbon fiber(ACF) as a good conductive electrosorption adsorbent. Electrosorption test were carried out using an electrochemical cell.(omitted)

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.11
• /
• pp.1180-1185
• /
• 2005

Iron sand, having iron as a major component, was applied in the treatment of synthetic wastewater containing Cu(II) or Pb(II). To investigate the stability of iron sand at acidic condition, dissolution of Fe and Al was studied with variation of solution pH ranging from 2 to 4.5. Iron concentration in the extracted solution was below the emission regulation of wastewater even at a strong acidic condition, pH 2. Although an important concentration of aluminum was extracted at pH 2, the dissolution greatly decreased above pH 3. This stability test suggests that application of iron sand has little problem in the treatment of wastewater above pH 3. Adsorption capacity of Cu(II) and Pb(II) onto iron sand was investigated in a batch and a column test. In case of Cu(II), rapid adsorption was noted, showing 50% removal within 2 hrs, and then reached a near complete equilibrium after 24 hrs. Adsorption was favorable at higher pH in each metal ion and showed a near complete removal above pH 6, indicating a typical cationic-type adsorption. From the adsorption isotherm obtained with variation of the concentration of each metal ion, the maximum adsorption capacity of Cu(II) and Pb(II) was identified as 2,170 mg/kg 및 3,450 mg/kg, respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.8
• /
• pp.663-672
• /
• 2009

In this studies, the adsorption test using Chlorella pyrenoidosa was conducted to examine the effect of Pb adsorption according to various immobilized methods such as Ca-alginate, K-carrageenan, and Polyacrylamide. From the results, the duration to need to reach adsorption equilibrium was delayed according to the immobilization. And, the higher adsorption capacity of immobilized Chlorella pyrenoidosa was represented in the higher concentration of Pb, the smaller amount of immobilizing agent, and the higher pH of solution. The maximum adsorption capacity of Pb was shown in the adsorption test using Chlorella pyrenoidosa immobilized with Ca-alginate even though it was sensitive pH. The adsorption results properly represented with Freundlich isotherm equations. And, pseudo second-order chemisorption kinetic rate equation was applicable to all the biosorption data over the entire time range. The FT-IR analysis showed that the mechanism involved in biosorption of Pb by Chlorella pyrenoidosa was mainly attributed to Pb binding of carbo-acid and amide group. Adsorbed Pb on immobilized Chlorella prenoidosa was easily desorbed in the higher concentration of desorbents(NTA, HCl, EDTA, $H_2SO_4,\;Na_2CO_3$). Among the several desorbents, NTA showed the maximum desoption capacities of Pb from Chlorella pyrenoidosa immobilized with Ca-alginate and K-carrageenan and EDTA was the most effective in Chlorella pyrenoidosa immobilized with polyacrylamide. The desoprtion efficiency in the optimum condition was 90.0, 83.0, and 80.0%, respectively.

• Asian Journal of Atmospheric Environment
• /
• v.4 no.3
• /
• pp.177-188
• /
• 2010

The use of an activated carbon (AC) system alone has the limitation that the pollutants are not eliminated but only transferred to another phase with the consumed AC becoming hazardous waste itself. Therefore, the present study investigated the feasibility of using a combined system of granular AC (GAC) with S-doped visible-light-induced $TiO_2$ (GAC/S-doped $TiO_2$) to clean monocyclic aromatic hydrocarbons (MAHs) with concentrations at $\leq$ 3 mg $m^{-3}$, using a continuous air-flow reactor. This study conducted three different experiments: an adsorption test of pure GAC and GAC/S-doped $TiO_2$; a long-term adsorptional photocatalytic (AP) activity test of GAC/S-doped $TiO_2$; and an AP activity test of GAC/S-doped $TiO_2$ under different conditions. For the AP activity test, three parameters were evaluated: various weights of GAC/S-doped $TiO_2$ (0.9, 4.4, and 8.9 g); various flow rates (FRs) (0.5, 1 and 2 L $min^{-1}$); and various input concentrations (ICs) of the target MAHs (0.1, 1, 2 and 3 mg $m^{-3}$). The adsorption efficiencies were similar for the pure GAC and GAC/S-doped $TiO_2$ reactors, suggesting that S-doped $TiO_2$ particles on GAC surfaces do not significantly interfere with the adsorption capacity of GAC. Benzene exhibited a clear AP activity, whereas no other target MAHs did. In most cases, the AP efficiencies for the target MAHs did not significantly vary with an increase in weight, thereby suggesting that, under the weight range tested in this study, the weights or FRs are not important parameters for AP efficiency. However, ICs did influence the AP efficiencies.

• Ecology and Resilient Infrastructure
• /
• v.3 no.3
• /
• pp.201-206
• /
• 2016

The purpose of this study is to find the regeneration method of filter media using physical and chemical treatment for restoration of phosphorus adsorption ability. The filtration material used in this study is called Adphos. In an experiment of heating treatment, re-used filter media is heated to a high temperature before the adsorption test. The results show that the $PO{_4}^{3-}-P$ adsorption capacity is in the range of 0.0021 - 0.0030 mg/g and the removal efficiency is in the range of 26.1 - 39.4%. In the experiment of acid or basic treatment, re-used filter media is exposed to a different pH condition before the adsorption test. The results show that the $PO_4^{3-}-P$ adsorption capacity is in the range of 0.0010 - 0.0066 mg/g and the removal efficiency is in the range of 15.8 - 87.1% after the acid treatments which have pH values of 1 - 5. However, after the basic treatments which have pH values of 8 - 11, the results show that the $PO{_4}^{3-}-P$ adsorption capacity is in the range of 0.0018 - 0.0034 mg/g and the removal efficiency is in the range of 26.7 - 48.0%. In an experiment of chemical treatment using NaCl, re-used filter media was exposed to a different NaCl concentration before the adsorption test. The results show that the $PO{_4}^{3-}-P$ adsorption capacity is in the range of 0.0036 - 0.0050 mg/g and the removal efficiency is in the range of 50.5 - 71.1%. In conclusion, chemical treatment using NaCl shows a high recovery probability of phosphorus adsorption ability of filter media.

• Journal of the Korean Vacuum Society
• /
• v.14 no.2
• /
• pp.69-77
• /
• 2005

Pumping performance of large cryosorption pumps of different types installed on the 60 $m^3$ test stand for developing and testing ion sources and beam line components of the NBI system was investigated. Hydrogen adsorption and desorption characteristics of the cryosorption panels were analyzed using the temporal change of the hydrogen spectrum obtained with short introduction of the hydrogen gas as cooling the panel, and simulations on the mutual influence between related parameters were also carried out.

• Journal of environmental and Sanitary engineering
• /
• v.15 no.1
• /
• pp.54-61
• /
• 2000

We studied the adsorption characteristics on the treatment process of heavy metal wastewater by using cuttle fish bones powder. When adding the 0.25% cuttle fish born powder in the heavy metal solution, $Fe^{3+}$ and $Pb^{2+}$ were high removed than other heavy metals as above 95%. In the solution which was adjusted to pH 5, 7 and 9, there was not observed the difference thing on the heavy metal removal rate. At test using plating wastewater treatment, adding 1%, 1.5% and 2% of the cuttle fish born powder, the heavy metal removal rate were as follows; Zn 12.5 - 37.5%, Mn 18.0 - 62.2%, Cd 36.8 -93.0%, Cu 51.4 - 97.4%, Cr 70.8 - 99.1%, Fe 87.2 - 99.3% and Pb 92.8 - 99.9%. When adding the 0.15% cuttle fish born powder and mixing for 20 minutes, the solution was happened the adsorption equability. Applied this results to the Freundlich＇s iso-thermal equation, we found the cuttle fish born＇s probability as a good adsorbent.

• Journal of environmental and Sanitary engineering
• /
• v.15 no.3
• /
• pp.62-69
• /
• 2000

In point of recycling wastes, batch test was conducted to examine the neutralization and Fe removal from laboratory wastewater using wastes. Oyster shell and slag had a buffer capacity to neutralize an acidic wastewater but tire rubber didn't. With increasing reaction time, dosage and agitation speed, Fe was well removed by wastes. As a result on the experiments of Freundlich isotherm, the adsorption intensities(1/n) were 0.32∼0.46 and the adsorption capacities(k) were 4.3∼4.6 for removing Fe from laboratory wastewater by wastes. In view of these results, it was estimated that wastes containing the similar compositions as these could utilize the neutralization and adsorption of heavy metals in laboratory wastewater.

• Carbon letters
• /
• v.28
• /
• pp.81-86
• /
• 2018

Empty fruit bunch (EFB) char was used to remove $NO_x$ and odorous substances. The physicochemical properties of the EFB chars were altered by steam or KOH treatments. The Brunauer-Emmett-Teller surface area and porosity were measured to determine the properties of the modified EFB chars. The $deNO_x$ and adsorption test for hydrogen sulphide and acetaldehyde were performed to determine the feasibility of the modified EFB chars. The KOH-treated EFB (KEFB) char revealed higher $deNO_x$ efficiency than with commercial activated carbon. The Cu-impregnated EFB char also had high $deNO_x$ efficiency at temperatures higher than $150^{\circ}C$. The KEFB char showed the highest hydrogen sulphide and acetaldehyde adsorption ability, followed by the steam-treated EFB char and untreated EFB char. Moreover, the product prepared by sulfonation of EFB char showed excellent performance for esterification of palm fatty acid distillate for biodiesel production.