• Journal of applied mathematics & informatics
• /
• v.24 no.1_2
• /
• pp.421-426
• /
• 2007

The problem of vertex labeling with a condition at distance two in a graph, is a variation of Hale's channel assignment problem, which was first explored by Griggs and Yeh. For positive integer $p{\geq}q$, the ${\lambda}_{p,q}$-number of graph G, denoted ${\lambda}(G;p,q)$, is the smallest span among all integer labellings of V(G) such that vertices at distance two receive labels which differ by at least q and adjacent vertices receive labels which differ by at least p. Van den Heuvel and McGuinness have proved that ${\lambda}(G;p,q){\leq}(4q-2){\Delta}+10p+38q-24$ for any planar graph G with maximum degree ${\Delta}$. In this paper, we studied the upper bound of ${\lambda}_{p,q}$-number of some planar graphs. It is proved that ${\lambda}(G;p,q){\leq}(2q-1){\Delta}+2(2p-1)$ if G is an outerplanar graph and ${\lambda}(G;p,q){\leq}(2q-1){\Delta}+6p-4q-1$ if G is a Halin graph.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.3A
• /
• pp.238-244
• /
• 2010

We propose a user selection method in multi-cell multiuser uplink system with the subspace interference alignment to maintain the high sum-rate capacity. The proposed method selects users whose interference to adjacent cells are strong and apply the subspace interference alignment to the users. The proposed method provides that the number of users performing the interference alignment reduces and the high total sum-rate is maintained. Simulation results exhibit the proposed method reduces the number of users who would decompose the channel for the subspace interference alignment by 50% when the required sum-rate is 90% of the maximal achievable sum-rate.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9A
• /
• pp.1005-1012
• /
• 2004

In this paper, we have analyzed minimum performance required for W-CDMA Handset from standard and Implemented the receiver for W -COMA Handset. We have derived the noise figure and IIP3 of receiver and determined the selectivity about adjacent channel and minimum performance for front-end stage. Before the Implementation, we have verified the performance using AOS simulator In conclusion, we have implemented the receiver for W-COMA Handset using the heterodyne architecture and performed measurement. Therefore, this paper wlll gIVe a guideline for design of the W -COMA Handset.

• Nuclear Engineering and Technology
• /
• v.52 no.11
• /
• pp.2479-2490
• /
• 2020

We performed experiments to measure a single-phase upward flow in a 5 × 5 rod bundle with spacer grids using a particle image velocimetry, focusing on the crossflow. The Reynolds number based on the hydraulic diameter and the bulk velocity is 10,000. The ratio of pitch between rods and rod diameter is 1.4 and spacer grid is installed periodically. The turbulence in the rod bundle results from the combination of a forced mixing and natural mixing. The forced mixing by the spacer grid persists up to 10D_h from the spacer grid, while the natural mixing is attributed to the crossflow between adjacent subchannels. The combined effects contribute to a sinusoidal distribution of the time-averaged stream-wise velocity along the lateral direction, which is relatively weak right behind the spacer grid as well as in the gap. The streamwise and lateral turbulence intensities are stronger right behind the spacer grid and in the gap. Based on these findings, we newly defined a modified mixing coefficient as the ratio of the lateral turbulence intensity to the time-averaged streamwise velocity, which shows a spatial variation. Finally, we compared the developed model with the measured data, which shows a good agreement with each other.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.1
• /
• pp.189-194
• /
• 2012

This paper is about frequency allocation of LTE Base Station(BS) in the spare band which is generated by DTV transition. In the case of frequency allocation of LTE BS in adjacent band with DTV channel 51 among the spare band, the guard bands that requires for no interference between LTE and DTV system were calculated. As a result, 5.5 MHz of guard band for LTE BS and 2 MHz of guard band for DTV receiver were suggested based on interference analysis between LTE BS and DTV BS, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.2
• /
• pp.65-70
• /
• 2004

This paper presents a novel linearization scheme for a nonlinear RF amplifier It is based on the amplitude modulation with envelope signal. The 3rd order distortion generator is composed of two FETs and it adopts a balanced structure for the purpose of main carrier cancellation. The amplitude and phase of the IM3 component can be controlled at RF band. This predistorter is implemented and tested at the KOREA PCS Tx. band (1840∼1870MHz). Experimental results of two-tone test show that the IM3 cancellation is achieved about 30-40 ㏈ for the wide dynamic range. The adjacent channel power ratio is improved by over 10 ㏈ at the broad-band CDMA signal with a peak to average power ratio of l0㏈, and this improvement is maintained through a wide range of output power levels.

• Journal of electromagnetic engineering and science
• /
• v.14 no.2
• /
• pp.68-73
• /
• 2014

A linear stacked field-effect transistor (FET) power amplifier (PA) is implemented using a $0.18-{\mu}m$ silicon-on-insulator CMOS process for W-CDMA handset applications. Phase distortion by the nonlinear gate-source capacitance ($C_{gs}$) of the common-source transistor, which is one of the major nonlinear sources for intermodulation distortion, is compensated by employing a PMOS linearizer with improved AM-PM. The linearizer is used at the gate of the driver-stage instead of main-stage transistor, thereby avoiding excessive capacitance loading while compensating the AM-PM distortions of both stages. The fabricated 836.5 MHz linear PA module shows an adjacent channel leakage ratio better than -40 dBc up to the rated linear output power of 27.1 dBm, and power-added efficiency of 45.6% at 27.1 dBm without digital pre-distortion.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.12
• /
• pp.1-7
• /
• 2015

In this paper, we propose a second-order fiber flexible comb filter based on a polarization-diversity loop(PDL). The proposed filter consists of a polarization beam splitter, four half-wave plates(HWPs), and three high birefringence fiber(HBF) segments. In the previous Solc-type second-order filter based on the PDL, HBF segments were fusion-spliced with a fixed angle offset between their principal axes with each other. But, the proposed filter implemented by inserting two HWPs between three HBF segments has a great flexibility in adjusting relative angular difference between the principal axes of two adjacent HBF segments. Owing to this flexibility, second-order transmission spectra, which had a channel spacing of ~0.8nm, could be interleaved by controlling the orientation angles of four HWPs. The output transmission spectra of the proposed filter were theoretically analyzed and experimentally verified.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.3
• /
• pp.433-437
• /
• 2015

We have designed and fabricated a low power and high linearity up down convertor for wireless repeaters using $0.35{\mu}m$ SiGe Bipolar CMOS technology. Repeater is composed of a wideband up/down converting mixer, programmable gain amplifiers (PGA), input buffer, LO buffer, filter driver amplifier and integer-N phase locked loop (PLL). As of the measurement results, OIP3 of the down conversion mixer and up conversion mixer are 32 dBm and 17.8 dBm, respectively. The total dynamic gain range is 31 dB with 1 dB gain step resolution. The adjacent channel leakage ratio (ACLR) is 59.9 dBc. The total power consumption is 240 mA at 3.3 V.

• KIEAE Journal
• /
• v.9 no.6
• /
• pp.65-72
• /
• 2009

Lighting for outdoor advertising is very common feature of building facades as they provide the information and commercial identification. As the interest of improving street beautification more widely, application of various lighting technologies has been develop for advertisement such as electric sign board and signage. Furthermore, the installation of higher sign luminance than needed has many negative consequences, including higher energy consumption and light pollution. There are now no standard for outdoor advertisements in terms of luminance, and installation of indiscreet outdoor advertisement without luminance consideration is becoming more commonplace. This study was to evaluate the luminous characteristics of outdoor advertising as a function of sign and building facade luminance, luminance ratio. Data were collected on 8 electric sign boards, 20 internally illuminated, externally illuminated, neon, and channel letter signs and 4 commercial areas. Photometric measurements were taken by CS-100(Minolta) and ProMetric-1400(Radiant Imaging) for various sign modes and sign design. Also luminance of building facades were analyzed according with CIE standard of maximum obtrusive light permitted for exterior lighting installations. The findings are as follows; (1) There were excessive luminance of electric sign boards that could affect adjacent building facade and night sky luminance. (2) Sings that are externally illuminated providing an inappropriate amount of light on to the outer surface of the sign caused higher building facade luminance and potential of unnecessary glare.