• Journal of Digital Contents Society
• /
• v.18 no.2
• /
• pp.365-371
• /
• 2017

IEEE 802.11 Wireless Local Area Network (WLAN) adopts Power Saving Mode(PSM) to save the power. Unlike existing PSM, this paper proposes a new scheme for the power saving of the Mobile Host(MH) when a MH performs the data transmission after the competition-based DCF(Distributed Coordination Function) and competition free-based PCF(Point Coordination Function). In this paper, The proposed scheme estimates the distance between the MH with the authority of data transmission and the Access Point(AP) and then adaptively controls the power of the MH considering the distance. Through the simulation result, we find that the proposed scheme consumes the smaller transmission power and has the similar success rate of packet transmission when it is compared to the existing scheme which uses the same power without the consideration of the distance.

• 전자공학회논문지 IE
• /
• v.43 no.2
• /
• pp.80-86
• /
• 2006

The wireless communication based on LDPC and adaptive spatial-subcarrier coded modulation using MQAM for orthogonal frequency division multiplexing (OFDM) wireless transmission by using instantaneous channel state information and employing multiple antennas at both the transmitter and the receiver. Adaptive coded modulation is a promising idea for bandwidth-efficient transmission on time-varying, narrowband wireless channels. On power limited Additive White Gaussian Noise (AWGN) channels, low density parity check (LDPC) codes are a class of error control codes which have demonstrated impressive error correcting qualities, under some conditions performing even better than turbo codes. The paper demonstrates OFDM with LDPC and adaptive modulation applied to Multiple-Input Multiple-Output (MIMO) system. An optimization algorithm to obtain a bit and power allocation for each subcarrier assuming instantaneous channel knowledge is used. The experimental results are shown the potential of our proposed system.

• ETRI Journal
• /
• v.19 no.3
• /
• pp.98-115
• /
• 1997

The architecture of the CDMA mobile system (CMS) is developed based on three function groups - service resource, service control, and service management groups. In this paper, the CMS architecture is discussed from the point of view of implementing these functions. The variable length packets are used for transmission. The synchronization clock signals are derived form the GPS receiver. The open loop and closed loop techniques are used for the power control. The internationally accepted signaling and network protocols are employed. The call control for the primary services in designed to provide efficient mobile telecommunication services. The softer handoff is implemented in one card. The mobile assisted handoff and the network assisted handoff are employed in the soft and hard handoffs. The authentication is based on the secret data which includes random numbers. The management functions, which include the location management, resource management, cell boundary management and OAM management, are implemented to warrant the system efficiency, maximum capacity and high reliability. The architecture ensures that the CMS is flexible and expandable to provide subscribers with economic and efficient system configuration. The dynamic power control, adaptive channel allocation. and dynamic cell boundary management are recommended for future work.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.5
• /
• pp.1729-1742
• /
• 2017

In designing System Protection Schemes (SPSs) in power systems, protecting transmission network against extreme undesired conditions becomes a significant challenge in mitigating the transmission line overloading. This paper presents an intelligent Special Protection and Control Scheme (SPCS) using of Differential Evolution with Adaptive Mutation (DEAM) approach to obtain the optimum generation rescheduling to solve the transmission line overloading problem in system contingency conditions. DEAM algorithm employs the attraction-repulsion idea that is applied in the electromagnetism-like algorithm to support the mutation process of the conventional Differential Evolution (DE) algorithm. Different N-1 contingency conditions under base and increase load demand are considered in this paper. Simulation results have been compared with those acquired from Genetic Algorithm (GA) application. Minimum severity index has been considered as the objective function. The final results show that the presented DEAM method offers better performance than GA in terms of faster convergence and less generation fuel cost. IEEE 30-bus test system has been used to prove the effectiveness and robustness of the proposed algorithm.

• Journal of Internet Computing and Services
• /
• v.17 no.4
• /
• pp.19-26
• /
• 2016

In this paper, the dynamic buffering based smart OTT platform was proposed, and analyzed for adaptive bit-rate video delivery with the optimization of HLS (HTTP Live Streaming). This platform consists of the software platform between sever and client which detects the bandwidth capacity, and adjusts the quality of the streaming for multiple bit-rates resolutions. In order to apply adaptive buffering, two buffers are added to the basic HLS player, and each buffer is responsible for constantly buffering a previous and the next channels relative to the current channel. This adaptive transmitting with smart OTT platform is superior to delivering a static video file at a single buffering, because the video stream of adaptive double buffers can be switched streaming according to client's available network speed. As a result, this proposed smart OTT can be cooperated to the application of HLS server with segmented H.265 MPEG-2 TS video & m3u8 files with its information based on the optimized transmission channel state of live and VOD, and applied to PLC transmission, too.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.196-198
• /
• 2002

This paper represents a new approach for the protective relay of power transmission lines using a Artificial Neural Network(ANN). A different fault on transmission lines need to be detected, classified and located accurately and cleared as fast as possible. However, The protection range of the distance relay is always designed on the basis of fixed settings, and unfortunately these approach do not have the ability to adapt dynamically to the system operating condition. ANN is suitable for the adaptive relaying and the detection of complex faults. The backpropagation algorithm based multi-layer perceptron is utilized for the learning process. It allows to make control to various protection functions. As expected, the simulation result demonstrate that this approach is useful and satisfactory.

• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.398-402
• /
• 2008

Cyclic prefix (CP) is one of the most important technique to OFDM system and is reducing inter-symbol interference (ISI) effects in high speed wireless mobile communication system. At the time varying channel condition, however, fixed CP length is not only increasing power consumption but also reducing data transmission rate. So in this paper, we propose the system that has adaptive CP length for high speed data transmission system. We don't control CP length of every symbol but adjust symbol interval depending on channel condition to CP reconstruction.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.12
• /
• pp.4819-4834
• /
• 2015

The spectral efficiency of cellular networks can be improved when proximate users engage in device-to-device (D2D) communications to communicate directly without going through a base station. However, D2D communications that are not properly designed may generate interference with existing cellular networks. In this paper, we study resource allocation and power control to minimize the probability of an outage and maximize the overall network throughput. We investigate three power control-based schemes: the Partial Co-channel based Overlap Resource Power Control (PC.OVER), Fractional Frequency Reuse based Overlap Resource Power Control (FFR.OVER) and Fractional Frequency Reuse based Adaptive Power Control (FFR.APC) and also compare their performance. In PC.OVER, a certain portion of the total bandwidth is dedicated to the D2D. The FFR.OVER and FFR.APC schemes combine the FFR techniques and the power control mechanism. In FFR, the entire frequency band is partitioned into two parts, including a central and edge sub-bands. Macrocell users (mUEs) transmit using uniform power in the inner and outer regions of the cell, and in all three schemes, the D2D receivers (D2DRs) transmit with low power when more than one D2DRs share a resource block (RB) with the macrocells. For PC.OVER and FFR.OVER, the power of the D2DRs is reduced to its minimum, and for the FFR.APC scheme, the transmission power of the D2DRs is iteratively adjusted to satisfy the signal to interference ratio (SIR) threshold. The three schemes exhibit a significant improvement in the overall system capacity as well as in the probability of a user outage when compared to a conventional scheme.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.167.2-167.2
• /
• 2011

Motions in nature, for example ocean wave, has been playing a significant role for generating electricity production in our modern life. This paper presents an innovative approach for electric power conversion of the vast ocean wave energy. Here, a floating-buoy wave energy converter (WEC) using hydrostatic transmission (HST), which is shortened as HSTWEC, is proposed and designed to enhance the wave energy harvesting task during all wave fluctuations. In this HSTWEC structure, the power take-off system (PTO) is a combination of the designed HST circuit and an electric generator to convert mechanical energy generated by ocean wave into electrical energy. Several design concepts of the HSTWEC have been considered in this study for an adequate investigation. Modeling and simulations using MATLAB/Simulink and AMESim are then carried out to evaluate these design concepts to find out the best solution. In addition, an adaptive controller is designed for improving the HSTWEC performance. The effectiveness of the proposed HSTWEC control system is finally proved by numerical simulations.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.3
• /
• pp.580-585
• /
• 2009

Real Time Locating Systems (RTLS) are used to track and identify the location of objects in real time using simple, inexpensive tags attached to or embedded in objects and readers that receive the wireless signals from these tags to determine their locations. A tag is powered an internal source such as a battery. The blink frequency of a tag affects the energy efficiency and the locating accuracy of RTLS. The mobility of a tag also affects the locating accuracy. In this paper, we introduce a RTLS tag design which improves the locating accuracy and the power efficiency. We propose an adaptive transmission-rate control algorithm using a motion sensor. By analyzing the signal pattern of the motion sensor, we can build a model to estimate the speed of the motion. Using this model, our algorithm can achieve better locating accuracy and lower power consumption than those of the conventional method. In our experiments, the number of transmission reduced as 40%, keeping similar locating accuracy.