• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1986년도 한국자동제어학술회의논문집; 한국과학기술대학, 충남; 17-18 Oct. 1986
• /
• pp.281-285
• /
• 1986

In this paper, the characteristics of disturbance torque of gimbal servo dynamics are studied, and the simulation methods of gimbal servo dynamics and INS error due to angular rate and linear acceleration of vehicle are proposed. In results of the simulation for a specific INS, it is estimated that INS velocity error due to gimbal servo dynamics is nearly proportional to square of vehicle acceleration.

• 한국운동역학회지
• /
• 제34권2호
• /
• pp.81-92
• /
• 2024

Objective: The purpose of this study was to analyze the impact acceleration, shock attenuation and biomechanical variables at various running speed. Method: 20 subjects (height: 176.15 ± 0.63 cm, weight: 70.95 ± 9.77 kg, age: 27.00 ± 4.65 yrs.) participated in this study. The subjects ran at four different speeds (2.5 m/s, 3.0 m/s, 3.5 m/s, 4.0 m/s). Three-dimensional accelerometers were attached to the distal tibia, sternum and head. Gait parameters, biomechanical variables (lower extremity joint angle, moment, power and ground reaction force) and acceleration variables (impact acceleration, shock attenuation) were calculated during the stance phase of the running. Repeated measures ANOVA was used with an alpha level of .05. Results: In gait parameters, decreased stance time, increasing stride length and stride frequency with increasing running speed. And at swing time 2.5 m/s and 4.0 m/s was decreased compared to 3.0 m/s and 3.5 m/s. Biomechanical variables statistically increased with increasing running speed except knee joint ROM, maximum ankle dorsiflexion moment, and maximum hip flexion moment. In acceleration variables as the running speed increased (2.5 m/s to 4.0 m/s), the impact acceleration on the distal tibia increased by more than twice, while the sternum and head increased by approximately 1.1 and 1.2 times, respectively. And shock attenuation (tibia to head) increased as the running speed increased. Conclusion: When running speed increases, the magnitude and increasing rate of sternum and head acceleration are lower compared to the proximal tibia, while shock attenuation increases. This suggests that limiting trunk movement and increasing lower limb movement effectively reduce impact from increased shock. However, to fully understand the body's mechanism for reducing shock, further studies are needed with accelerometers attached to more segments to examine their relationship with kinematic variables.

• 한국ITS학회 논문지
• /
• 제23권1호
• /
• pp.82-96
• /
• 2024

교통류에서는 거시적인 지표로 속도, 교통량, 밀도가 중요한 파라미터로 활용되고 있으며, 미시적인 지표로는 가속도와 차두거리가 중요한 파라미터로 활용되고 있다. 속도와 교통량은 현재 설치된 교통정보 수집장치로 수집이 가능하지만 가속도와 차두거리는 안전과 자율주행분야 등에 필요성이 있지만 현재 교통정보 수집장치로는 수집이 불가능한 실정이다. 객체인식 기법인 YOLO는 정확도와 실시간성이 우수하여 교통분야를 포함하여 다양한 분야에서 활용되고 있다. 본 연구에서는 YOLO를 활용하여 가속도와 차두거리를 측정하기 위해 측정 간격을 조밀하게 설정하여 간격별 차량의 속도 변화와 차량 간 통행시간 차이를 통해 가속도와 차두거리를 측정하는 모델을 개발하였다. 지점별 교통특성에 따라 가속도와 차두거리의 범위가 다름을 확인하였고, 측정률 확보를 위한 기준거리와 화면각도에 따른 비교분석을 수행하다. 측정간격은 20m, 각도는 직각에 가까울수록 측정률이 높아짐을 분석하였다. 이를 통해 교차로별 안전도 분석과 국내 차량행태모델 분석에 기여할 수 있을 것이다.

• 대한인간공학회:학술대회논문집
• /
• 대한인간공학회 1997년도 춘계학술대회논문집
• /
• pp.107-113
• /
• 1997

In this paper, an interfacing method to control rehabilitation assitance system with bio-signal is proposed. Controlling with EMG signals method has certain advantage on signal-collecting, but has some drawbacks in the function resolution of EMG signals because data-processing process is not efficient. To improve function-resolution and to increase the efficiency of EMG signal interfacing with rehabilitation assistance system, Multi-layer Perception which is highly effective with static signal and hidden-Markov model for dynamic signal resolving are fused together. In proposed method. The direction and average speed of the rehabilitation assitance system are controlled by the trajectory control and estimation of the moving direction result from the fused model. From the experiment, proposed GMM and 2-level MLP hybrid-classifier yielded 8.6% perception-error rate, improving function resolution. New acceleration control method constructed with 3 nested linear filter produced continuous acceleration paths without the information of destination point. Thus, the mass output caused by non- continuous acceleration-deceleration was eliminated. In the simulation, the necessary calculation, in the case of multiplication, was reduced by 11.54%.

• 한국소음진동공학회논문집
• /
• 제13권1호
• /
• pp.3-9
• /
• 2003

In an apartment building, the impact sound from upstairs has been regarded as a main source of noise causing discontentment among occupants. To set the optimum design for sound insulation. it is nesessary to suggest the useful tools or technique that predict the floor impact sound. The purpose of this study is to investigate the applicability of the theory of sound radiation. We measured the vibration acceleration levels on the interior structures and predicted the sound pressure level of the room by using them. The result show that the predicted value, in general, were in good agreement with the measured values within 5∼10% in error rate.

• 한국정밀공학회지
• /
• 제4권4호
• /
• pp.56-71
• /
• 1987

Determination of navigation variables (latitude, longitude, and altitude) near the earth's surface is termed 'Terrestrial Navigation'. The quantities that are measured inertially are the total acceleration (or the integral fo this acceleration over a fixed time interval) and the total angular rate (or the integral of this angular rate over the same time interval). These measurements when suitably compensated can be manipulated to yield the navigation variables. Hence, it is essential that the initial values of position, orientation and velocity are accurately set up during the initial alignment process. Initial alignment of gimballed inertial navigation system ( GINS) is accomplished by gyrocompassing techniques. These cannot be used, in the case of strapdown inertial navigation system(SDINS), where the inertial instruments are directly strapped down to a vehicle frame. The basic objective of this paper is the development of digital method for the determination of the initial axes erection of a SDINS from vibration and sway currupted data on the launch pad.

• Journal of information and communication convergence engineering
• /
• 제10권1호
• /
• pp.91-95
• /
• 2012

The photoplethysmography (PPG) signal measured from a mobile healthcare device contains various motion artifacts occurring from a patient’s movements. Recently, to reject the motion artifacts, the method of using an acceleration sensor was suggested, but such sensors are very expensive. Therefore, this study deals with a novel sensor device to replace the acceleration sensor, and evaluated the performance of the proposed sensor experimentally. In the results of the experiments, it is shown that the proposed sensor device can reconstruct the PPG signal despite the occurrence of motion artifacts, and also that the variation rate in heart rate analysis was 1.22%. According to the experimental results, the proposed method can be applied to design a low-cost device.

• 제어로봇시스템학회논문지
• /
• 제17권9호
• /
• pp.947-953
• /
• 2011

Radome aberration error causes degradation of miss distance as well as stability of high maneuver missile system with RF seeker. A study about radome compensation method is important in this kind of missile system design. Several kinds of methods showed good compensation performance in their paper. Proposed adaptive Particle filter estimates line of sight rate excluding the radome induced error. This paper shows effectiveness of adaptive Particle filter as compensation method of radome aberration error. Robust performance of this filter depends on external aiding measurement, target acceleration. Tuning of system error covariance can make this filter unsensitive against the error of target acceleration information. This paper demonstrates practical usage of adaptive Particle filter for reducing miss distance and increasing stability against disturbance of radome aberration error through performance analysis.

• Bulletin of the Korean Chemical Society
• /
• 제26권9호
• /
• pp.1321-1330
• /
• 2005

The use of ionic liquids as reaction media can confer many advantages upon catalytic reactions over reactions in organic solvents. In ionic liquids, catalysts having polar or ionic character can easily be immobilized without additional structural modification and thus the ionic solutions containing the catalyst can easily be separated from the reagents and reaction products, and then, be reused. More interestingly, switching from an organic solvent to an ionic liquid often results in a significant improvement in catalytic performance (e.g., rate acceleration, (enantio)selectivity improvement and an increase in catalyst stability). In this review, some recent interesting results which can nicely demonstrate these positive “ionic liquid effect” on catalysis are discussed.

• 한국자동차공학회논문집
• /
• 제6권4호
• /
• pp.1-8
• /
• 1998

In order to solve the conflict problem between the ride comfort and the road holding, the optimal design of shock absorber that minimizes the r.m.s. of sprung mass vertical acceleration and pitch rate with the understeer characteristics constraints in the high speed stability is proposed. The design of experiments and the nonlinear optimization algorithm are used together to obtain the optimal design of shock absorber. The second order regression models of the input variables(front and rear damping coefficients) and the output variables (ride comfort index and road holding one) are obtained by the central composite design in the design of experiments. Then the optimal design of shock absorber can be systematically adjusted with applying the nonlinear optimization algorithm to the obtained second order regression model. The frequency response analysis of sprung mass acceleration and pitch rate shows the effectiveness of the proposed optimal design of shock absorber in the sprung mass resonance range with the understeer characteristics constraints.