• Proceedings of the KIEE Conference
• /
• 1994.11a
• /
• pp.231-233
• /
• 1994

We have studied a properly of N-docosyl pyridinium(TCNQ) Langmuir-Blodgett film at room temperature with the $NO_2$ gas-detection characteristics. As a result, we have found that their conductivities were increased by 6 times at 5 layers(about $250{\AA}$ thickness) LB film. However, their reproducibility was not able to be measured at room temperature. Therefore, we must find their working temperature which was able to activate gas-detection characteristics. The $NO_2$ gas response experiments under 200 ppm concentration in $50^{\circ}C$ show that :here are increment of electrical conductivity by 8 times and 100 seconds of response time, and 200 seconds of recovery times at $60^{\circ}C$.

• Journal of the Korean Ceramic Society
• /
• v.26 no.3
• /
• pp.331-340
• /
• 1989

In this study, it was tried to deposit diamond films from a mixture of CH4 and H2 by the microwave plasma chemical vapor deposition(MWCVD). The MWCVD process was designed and set up from the 2.45GHz microwave generator. And the diamond film was successfully deposited on silicon wafers from the mixture of methane and hydrogen. The microstructures of the deposited diamond films were studied by using the following deposition variables : (a) methane concentration(0.6-10%), (b) reaction pressure(10-100torr), and (c) the substrate temperature(450-76$0^{\circ}C$).

• Journal of the Korean Society for Heat Treatment
• /
• v.23 no.5
• /
• pp.245-248
• /
• 2010

Sn doped $In_2O_3$ (ITO) and ITO/Ni/ITO (INI) multilayer films were deposited on the glass substrates with a reactive magnetron sputtering system without intentional substrate heating and then the influence of the Ni interlayer on the methanol gas sensitivity of ITO and INI film sensors were investigated. Although both ITO and INI film sensors have the same thickness of 100 nm, INI sensors have a sandwich structure of ITO 50 nm/Ni 5 nm/ITO 45 nm. The changes in the gas sensitivity of the film sensors caused by methanol gas ranging from 100 to 1000 ppm were measured. It is observed that the INI film sensors show the higher sensitivity than that of the ITO single layer sensors. Finally, it can be concluded that the INI film sensor have the potential to be used as improved methanol gas sensors.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.809-813
• /
• 2006

We have studied the optical properties of the biaxial film such as fast axis, retardance and the change of polarization state between crossed polarizer using dual rotating retarder polarimeter. We have developed a novel simulation model, which could explain well the experimental results, and found that it could be used to optimize the compensation film in LCD for improving wide-viewing property.

• Journal of the Korean Chemical Society
• /
• v.21 no.1
• /
• pp.3-15
• /
• 1977

Crystals of salicylaldehyde-4-morpholinothiosemicarbazone, $C_{12}H_{15}O_2N_3S$, are orthorhombic with space group Pna21. Unit-cell dimensions are a = 11.85(5), b = 15.45(5) c = 7.18(3)${\AA}$ with z = 4. Three-dimensional intensity data were collected from the multiple-film equi-inclination Weissenberg photographs taken with $CuK{\alpha}$ radiation. The intensities were estimated visually. The structure was solved by Patterson and Fourier methods and refined by the block-diagonal least-squares methods until the final R value becomes 0.11 for the 1064 observed independent reflections. The morpholine ring has a chair form. The rest atoms of salicylaldehyde-4-morpholinothiosemicarbazone molecule excluding morpholine ring and sulfur atom approximately lie on a plane. The hydroxyl group of the salicylaldehyde and the nitrogen atom of the thiosemicarbazone form an intramolecular hydrogen bond, $O-H{\cdot}{\cdot}{\cdot}N$, of 2.67${\AA}$. The short intermolecular distances all appear to be normal van der Waals contacts.

• Proceedings of the KIEE Conference
• /
• 1994.11a
• /
• pp.237-239
• /
• 1994

The $NO_2$ gas-detection characteristics were investigated using the functional organic Langmuir-Blodgett(LB) film of Tetra-3-hexadecyl-sulphamoylcopperphthalocyanine(HDSM-CuPc). A surface pressure of 30mN/m was obtained as a proper one for a film deposition. A deposited film status was confirmed by electrical and optical methods such as UV/visible absorption spectra and current-voltage(I-V) characteristics. The $NO_2$ gas response experiments under 200ppm concentration show that there is not increment of electrical conductivity in room temperature and is identified by UV/visible absorption spectra. But There are some increments of electrical conductivity in $160^{\circ}C$.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1474-1476
• /
• 2005

ZnO:Al(AZO) has been investigated for the photovoltaic cell or TCO(Transparent Conductive Oxide) of the display, because it has good electrical and optical properties. In this study, the ZnO:Al(AZO) thin film prepared on variation of substrate temperature by FTS(Facing Targets Sputtering) system. In case of TCO, because resistivity and roughness values affect the lighting of the OLED, their factors are very important. Therefore, in this paper, the electrical and optical properties of the AZO thin film were investigated with the deposition conditions and its roughness was investigated on variation of the substrate temperature. In results, AZO thin film deposited with the transmittance over 80% and the resistivity was reduced from $1.36{\times}10^{-3}$ [O-cm] to $4{\times}10^{-4}$ [O-cm] with increasing the substrate temperature from R.T to $200[^{\circ}C]$. Especially, we could obtain the resistivity $4{\times}10^{-4}$ [O-cm] of AZO thin film prepared at working pressure 1[mTorr], input current 0.4[A] and substrate temperature $200[^{\circ}C]$.

• 한국초전도학회:학술대회논문집
• /
• v.13
• /
• pp.72-72
• /
• 2003

• The Korean Journal of Ceramics
• /
• v.3 no.3
• /
• pp.187-190
• /
• 1997

The aluminum-magnesium (Al-Mg) aklloys have been proved to be an effective solvent for synthesis of cubic-phase boron nitride (cBN) from hexagonal-phase boron nitride (hBN) at the conditions of high pressures and high temperatures (HP/HT). Various kinds of hBN powders having different crystallinity have been tested for cBN synthesis with Al-Mg solvents. The conversion ratio from hBN to cBN and the shape of synthesized cBN crystals appeared to be affected strongly by chemical composition and added amount of Al-Mg solvents as well as crystallinity of BN powders. As the magnesium content increased in the Al-Mg solvents, the conversion ratio increased and the size of cBN crystals became larger. The crystal facets developed well in the specimens with solvents having high Mg content. It was observed that a hBNlongrightarrowcBN transformation occurred more easily in the specimens having well crystallized hBN powders. Amorphous BN having much $B_2O_3$ impurity exhibited a low threshold temperature for transformation to cBN, which was attributed to crystallization of amorphous BN to well crystallized hBN prior to transformation into cBN with help of $B_2O_3$.

• Journal of the Korean Ceramic Society
• /
• v.40 no.3
• /
• pp.279-285
• /
• 2003

Ferroelectric S $r_{0.9}$B $i_{2.1}$T $a_{1.8}$N $b_{0.2}$ thin films with 200 nm thicknesses were deposited on Pt/Ti $O_2$/ $SiO_2$/Si Substrates by a sol-gel method. In these experiments, Sr(O $C_2$ $H_{5}$)$_2$, Bi(TMHD)$_3$, Ta(O $C_2$ $H_{5}$)$_{5}$ and Nb(O $C_2$ $H_{5}$)$_{5}$ were used as precursors, which were dissolved in 2-methoxyethanol. After UV-irradiation and RTA processes, the remanent polarization value (2 $P_{r}$) of SBTN thin films with annealed at $650^{\circ}C$ was 8.49 and 11.94 $\mu$C/$\textrm{cm}^2$ at 3 V and 5 V, respectively.