• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.49 no.4
• /
• pp.45-54
• /
• 2012

Location-based services with GPS positioning technology as a key technology, but recognizing the current location through satellite communication is not possible in an indoor location-aware technology, low-power short-range communication is primarily made of the study. Especially, as Chirp Spread Spectrum(CSS) based location-aware approach for low-power physical layer IEEE802.15.4a is selected as a standard, Ranging distance estimation techniques and data transfer speed enhancements have been more developed. It is known that the distance measured by CSS ranging has quite a lot of noise as well as its bias. However, the noise problem can be adjusted by modeling the non-zero mean noise value by a scaling factor which corresponds to the change of magnitude of a measured distance vector. In this paper, we propose a localization system using the CSS signal to measure distance for a mobile node taken a measurement of the exact coordinates. By applying the extended kalman filter and least mean squares method, the localization system is faster, more stable. Finally, we evaluate the reliability and accuracy of the proposed algorithm's performance by the experiment for the realization of localization system.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.4
• /
• pp.63-70
• /
• 2011

In this paper, we proposed a method for estimating energy expenditure using the unfixed axis of the accelerometer. Most studies adopted waist-placement because of the fact that the waist is close to the center of mass of a whole human body. But we adopted pocket-placement, which is capable of using unfixed axis of sensor, that is more convenient than conventional methods. To evaluate the proposed method, 28 male subjects performed walking and running on a motor driven treadmill. All of subject put on the indirect calorimeter and fixed accelerometer, then data were simultaneously measured during exercise. The regression analysis was performed using the test group(n=20) and the regression equation was applied to the control group(n=8). A strong linear relationship between energy expenditure and unfixed accelerometer signal was found. Futhermore, the coefficient of determination was significantly reliable($R^2$=0.98) and showed zero of p-value. The error of energy expenditure estimation between indirect calorimeter and two types of accelerometer was 15.0%(fixed) and 17.0%(unfixed) respectively. These results show the possibilities that the unfixed accelerometer can be used in estimating the energy expenditure during exercise.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.11
• /
• pp.127-133
• /
• 2014

In order to protect information asset from various malicious code, Honeypot system is implemented. Honeypot system is designed to elicit attacks so that internal system is not attacked or it is designed to collect malicious code information. However, existing honeypot system is designed for the purpose of collecting information, so it is designed to induce inflows of attackers positively by establishing disguised server or disguised client server and by providing disguised contents. In case of establishing disguised server, it should reinstall hardware in a cycle of one year because of frequent disk input and output. In case of establishing disguised client server, it has operating problem such as procuring professional labor force because it has a limit to automize the analysis of acquired information. To solve and supplement operating problem and previous problem of honeypot's hardware, this thesis suggested hybrid honeypot. Suggested hybrid honeypot has honeywall, analyzed server and combined console and it processes by categorizing attacking types into two types. It is designed that disguise (inducement) and false response (emulation) are connected to common switch area to operate high level interaction server, which is type 1 and low level interaction server, which is type 2. This hybrid honeypot operates low level honeypot and high level honeypot. Analysis server converts hacking types into hash value and separates it into correlation analysis algorithm and sends it to honeywall. Integrated monitoring console implements continuous monitoring, so it is expected that not only analyzing information about recent hacking method and attacking tool but also it provides effects of anticipative security response.

• The Journal of the Convergence on Culture Technology
• /
• v.4 no.1
• /
• pp.193-200
• /
• 2018

This study is an experiential case study of cybercrime fraud that combines pharming and voice phishing in April 2017. Research on victims who have actually suffered in the study of crime or disaster is a very useful field in establishing crime prevention measures. This study is significant in that Korea is relatively poor in this kind of research. I got cyber fraud as a consequence of my loss of reasonable judgment due to mental confusion when a companion dog who was raised for 8 years was in a very dangerous situation with cystitis. Fortunately, I received all the damages in a quick report, but the period was eight months. It took too much time to get back all the damages, so I had to suffer another pain. Based on my experience, I suggest damage prevention measures. First, when a certain condition and a certain amount are transferred, the transaction is automatically stopped or a more strict confirmation procedure is added. Secondly, trafficking means to arrest the perpetrator without any harm to the victim is sought. Third, the victims of crime should be promptly reimbursed for damages or a system for lending their living funds to zero or lower interest rate.

• Korean Journal of Soil Science and Fertilizer
• /
• v.43 no.1
• /
• pp.8-15
• /
• 2010

The effect of soil salinity and soil-wetting by rise of water table on the growth of fruit trees was studied to obtain information for orchard establishment in the Saemangeum reclaimed tidal land. Survival ratio of trees was 85%for grape, 31%for fig, 15%for apple and pear, and near zero for peach and blueberry. Wet injury induced by water-logged or flooded condition, rather than salt injury(soil EC was lower than 3.0dS $m^{-1}$ during growing period) is thought to be more responsible for low survival ratio of fruit trees transplanted in Saemangeum area. During the summer raining season in the reclaimed areas, the soil salinity tends to be decreased by natural rainfall effect, and the rainfall acceptable capacity(RAC) of soils dramatically is reduced(10-24 mm) as rainfall is continued to occur. In spite of high hydraulic conductivity(121 cm $day^{-1}$) of soils across the area, low RAC of soils might be due to high soil saturation and elevated water table during summer raining season. Therefore, the installation of effective drainage system should be the primary factor determining successful establishment of orchard in the Saemangeum reclaimed tidal land.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.1
• /
• pp.44-52
• /
• 2016

Kelvin's (1887) theory that predicts position of ship wave crest can be applied only in deep water. Havelock's (1907) theory that predicts cusp locus angle can be applied in whole water depths but cannot predict the position of ship wave crest. In this study, using the linear dispersion fully, we develop the equations to predict ship wave crest in whole water depths and, using the developed equations, we predict cusp locus angle. We simulate ship wave propagation using FLOW-3D in the condition of Johnson's (1985) hydraulic experiment and find that the cusp locus angles predicted by the present theory are close to numerical results of FLOW-3D and hydraulic experimental data. We also simulate for various conditions and compare numerical results of distances between adjacent wave crests and values predicted by the present theory. For Froude number less than unity, the numerical results are close to the values predicted by the theory. For Froude number greater than unity, the constant value of $C_1$ which determines the distance between the ship and the first ship wave crest is almost equal to zero and the numerical results of distances between adjacent ship waves excluding the first ship are close to the values predicted by the theory.

• Journal of the Korean Magnetics Society
• /
• v.13 no.5
• /
• pp.204-210
• /
• 2003

Electron magnetic resonance (EMR) of paramagnetic Cr$^{3+}$, Mn$^{2+}$, and Fe$^{3+}$ impurity ions in ferroelectric LiNbO$_3$ and LiTaO$_3$ single crystals has been studied. The actual sites location of paramagnetic impurity ions in the crystals was suggested from the experimental results and zero field splitting parameters calculated by superposition model. It turns out that Cr$^{3+}$ ions in LiNbO$_3$ crystal have two resonance centers and enter both the Li$^{+}$ and Nb$^{5+}$ ions. Mn$^{2+}$ and Fe$^{3+}$ impurity ions in LiNbO$_3$ substitute for Nb$^{5+}$ ions. However, both Cr$^{3+}$ and Fe$^{3+}$ ions in LiTaO$_3$ crystal reside at Li$^{+}$ ions.$ +/ ions.+/ ions.

• Journal of Digital Contents Society
• /
• v.4 no.2
• /
• pp.211-221
• /
• 2003

The objective of this paper is performance analysis of the digital document image decimation algorithm which generates a value of decimated element by an average of a target pixel value and a value of neighbor intelligible element to adaptively reflect the merits of ZOD method and FOD method on the decimated image. First, a target pixel located at the center of sliding window is selected, then the gradient amplitudes of its right neighbor pixel and its lower neighbor pixel are calculated using first order derivative operator respectively. Secondly, each gradient amplitude is divided by the summation result of two gradient amplitudes to generate each local intelligible weight. Next, a value of neighbor intelligible element is obtained by adding a value of the right neighbor pixel times its local intelligible weight to a value of the lower neighbor pixel times its intelligible weight. The decimated image can be acquired by applying the process repetitively to all pixels in input image which generates the value of decimated element by calculating the average of the target pixel value and the value of neighbor intelligible element. In this paper, the performance comparison of proposed method and conventional methods in terms of subjective performance and hardware complexity is analyzed and the preferable approach for developing the decimation algorithm of the digital document image on the basis of this analysis result has been reviewed.

• Clean Technology
• /
• v.14 no.3
• /
• pp.171-175
• /
• 2008

The effect of the addition of $Al^{3+}$ dopant on the electrochemical characteristics of $Li_{4}Ti_{5}O_{12}$ was investigated. $Li_{4}Ti_{5}O_{12}$ is known as a 2ero-strain material, and $Li_{3.95}Al_{0.15}Ti_{4.9}O_{12}$ has been manufactured by solid-state reaction with high energy ball milling (HEBM). The samples were heated at 800, 900 and $1000^{\circ}C$ in electric furnace. The structural and surface structures were measured by XRD (X-ray diffraction) and SEM (scanning electron microscopy). Cut-off voltage of charge/discharge cycles was $1.0{\sim}3.0 V$ to investigate reversible capacity, cycle stability and plateau voltage. The reversible capacity of $Li_{3.95}Al_{0.15}Ti_{4.9}O_{12}$ was 138 mAh/g.

• Clean Technology
• /
• v.14 no.1
• /
• pp.61-68
• /
• 2008

There have been great attentions on polymer electrolyte membrane fuel cell (PEMFC) due to their advantageous characteristics such as zero emission of hazardous pollutant and high energy density. In this work, we evaluated degradation phenomena and stability of single cell performance via one dimensional single cell modeling. Here, CO poisoning on anode on anode was considered for cell performance degradation. Modeling results showed that the performance and stability were highly degraded with CO concentration in fuel gas. In addition, cell performance was reduced by slow oxygen reduction on cathode in long term operation. In order to overcome, it is required to increase ratio o#hydrogen in the fuel gas of anode and high Pt loading contained in the cathodic catalyst layer.