• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.15 no.1
• /
• pp.20-26
• /
• 2015

It is very difficult to design an underwater communication system because of multipath, Doppler effects, noise, and attenuation. These factors lead to errors in the communication performance and maximum propagation distance. In this study, we calculate the distance that can be realized using the direct-sequence code division multiple access (DS-CDMA) technique with direct-sequence spread spectrum (DSSS) in an underwater communication system considering only the attenuation and noise. We also compare the estimated and calculated propagation distances obtained for several different scenarios.

• Journal of KIISE:Information Networking
• /
• v.31 no.4
• /
• pp.375-383
• /
• 2004

As wireless mobile networks have been widely adopted due to their convenience for deployment, the research for improving their performance has been actively conducted. Since their throughput is restrained by the packet corruption rate not by congestion as in wired networks, however, network simulations for performance evaluation need to select the appropriate wireless channel model representing the behavior of propagation errors for the evaluated channel. The selection of the right model should depend on various factors such as the adopted frequency band, the level of signal power, the existence of obstacles against signal propagation, the sensitivity of protocols to bit errors, and etc. This paper analyzes 10-day bit traces collected from real sensor channels exhibiting the high bit error rate to determine a suitable sensor channel model. For selection, it also evaluates the performance of two error recovery algorithms such as a link layer FEC algorithm and three TCPs (Tahoe, Reno, and Vegas) over several channel models. The comparison analysis shows that CM(Chaotic Map) model predicts 3-time less BER variance and 10-time larger PER(Packet Error Rate) than traces while these differences between the other models and traces are larger than 10-time. The simulation experiments, furthermore, prove that CM model evaluates the performance of these algorithms over sensor channels with the precision at least 10-time more accurate than any other models.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.58-58
• /
• 2001

This paper shows a practical approach that is robust to the errors causing path-delay in mobile wireless location, and analyzes its performance by comparing with other methods. NLOS(non-line-of-sight) error and multipath are two big sources of positioning error in wireless location. Contrary to GPS(global positioning system), they result from the terrestrial propagation of a signal. Especially, since LOS(line-of-sight) path between a transceiver and a receiver is blocked by intermediate buildings and topography, NLOS causes a signal to be reflected and diffracted. This path-delay error is very localized, and so, it is not easy to be estimated and mitigated. To treat such localized error, therefore ...

• Journal of KIISE:Information Networking
• /
• v.30 no.6
• /
• pp.755-763
• /
• 2003

To improve performance over noisy wireless channels, mobile wireless networks employ forward error correction(FEC) techniques. The performance of static FEC algorithms, however, degrades by poorly matching the overhead of their correction code to the degree of the fluctuating underlying channel error. This paper proposes an adaptive FEC technique called FECA(FEC-level Adaptation), which dynamically tunes FEC strength to the currently estimated channel error rate at the data link layer. FECA is suitable for wireless networks whose error rate is high and slowly changing compared to the round-trip time between two communicating nodes. One such example network would be a sensor network in which the average bit error rate is higher than $10^{-6}$ and the detected error rate at one time lasts a few hundred milliseconds on average. Our experiments show that FECA performs 15% in simulations with theoretically modeled wireless channels and in trace-driven simulations based on the data collected from real sensor networks better than any other static FEC algorithms.

• Journal of Industrial Technology
• /
• v.21 no.A
• /
• pp.189-198
• /
• 2001

In recent years, the predominant part in telecommunications is mobile communications. The next generation network is extending today's voice-only mobile networks to multi-service networks. ATM Network is possible to carry such multi-media traffic and it will be expect to use wireless ATM for the future mobile access network. One of manly important aspects for the performance of wireless ATM is the Medium Access Control (MAC) protocol. The MAC protocol must be able to satisfyingly handle the different ATM services (CBR, VBR, ABR and UBR) with their radically different performance requirements. Additionally, the MAC protocol must be able to cope with the complex radio environment where fading, multi-path propagation interference and burst-errors further complicate the situation. In this paper, a dynamic slot allocation algorithm in wireless ATM is proposed for an efficient channel sharing/media access at the MAC layer. We use equivalent capacity in the allocation of slots for VBR traffic which is variable along the time. It is simple and effective slot allocation method for VBR service. In particular, we consider the slot allocation of a session consisted of several connections for requirement of multimedia traffic. Simulation shows that the cell loss ratio is reduced by re-allocation of extra slots in Mobile Terminal (MT).

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.42 no.2 s.302
• /
• pp.1-10
• /
• 2005

The current implementation of TCP for the Internet is not efficient when used for Mobile Ad hoc Networks (MANENTs). This is because TCP assumes that all packet losses are caused by congestion, whereas transmission errors are a main reason for packet losses in wireless networks. To remedy this situation and increase performance, we propose an end-to-end method of using propagation delays and the differences between propagation delays to distinguish the causes for packet losses. The proposed method has two characteristics: Firstly, it is energy-efficient because this solution is only initiated when a packet loss is detected. Secondly, our approach considers only the one way propagation delay and is more accurate in determining causes for packet losses than existing methods which consider round trip time. Petri net models of the proposed TCP and of the standard TCP have been built and simulations have been performed on them. Our simulation results show that the proposed approach increases throughput and reduces propagation delay compared with standard TCP.

• Journal of the Korea Society of Computer and Information
• /
• v.7 no.2
• /
• pp.95-100
• /
• 2002

By feedback channel, the decoder reports the addresses of corrupted macroblocks induced by transmission errors back to the encoder With these negative acknowledgements, the encoder can make the next frame having propagated errors by using forward dependency based on GOBs and MBs of the frame happening transmission errors. The encoder can precisely calculate and track the propagated errors by examining the backward motion dependency for each of four comer pixels in the current encoding frame until before-mentioned the next frame. The error-propagation effects can be terminated completely by INTRA refreshing the affected macroblocks. Such a fast algorithm further reduce the computation and memory requirements. The advantages of the low computation complexity and the low memory requirement are Particularly suitable for real-time implementation.

• Journal of Advanced Navigation Technology
• /
• v.17 no.5
• /
• pp.484-490
• /
• 2013

With the rapid development of wireless communication at VHF and UHF bands, there is an increasing need for the reliable propagation prediction tools. Therefore, the different propagation models that have been developed in many countries as well as korea has been trying to secure a model suitable for their geographical area but then it is giving us a different result when we compared it to measured values. In this paper, based on the measurements of DTV broadcasting services in domestic urban area, analysis and comparison of ITU-R P.1546 and BCAST models provide errors between measured and predicted values, and some points for improving SMI system has been proposed. As a result, P.1546 model provides the valid predicted data similar to measured data, but BCAST model has some problems of large deviation and higher prediction to measured data. In future, these problems and diffractions due to high buildings need to be studied further.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.3A
• /
• pp.383-390
• /
• 2000

In this paper, an adaptive power control algorithm in the DS/CDMA system is proposed. The currently used transmitter/receiver based on IS-95 and the radio propagation channel under mobile communication environments are modeled. Theses are the key features for the simulation to analyse the performance of power control. the distribution of the received SIR(signal to interference ratio)and the bit error probability are the required parameters for the performance analysis. Furthermore the influence of the power control command error on the above parameters are analyzed. By using the performance analysis of IS-95 and the occurrence of burst errors that is characteristic for wireless channels. the new power control algorithm is proposed. The proposed power control algorithm increases the SIR which results in a better service quality and an enhancement in the system capacity.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.8 no.4
• /
• pp.201-206
• /
• 2009

The third generation mobile communications system requiring the reliable multimedia data transmission has provided with the reliable voice, data and video services over the variable propagation environment. However the broadband wireless multiple access technologies cause Inter Symbol Interference (ISI) or Multiple Access Interference (MAI) to degrade the performance of W-CDMA (Code Division Multiple Access) system. Constant Modulus Algorithm (CMA) which is frequently used as the adaptive blind equalizers to remove the interfering signal has ill-convergence phenomenon without proper initialization. In this paper, new blind equalization method based on conventional CMA is proposed to improve the channel efficiency, and through computer simulation this is tested over the time varying fading environment of mobile communication system. Consequently, new blind equalization method into concatenated Kalman filter with CMA is verified better than conventional CMA through adopting minimum mean square errors and eye-pattern obtained from algorithm are compared.