• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.10A
• /
• pp.969-979
• /
• 2002

This paper proposes an novel method of minimizing Interference which causes data decision error in digital wireless communications. In this method, in order to suppress ISI which is caused by the phase difference between the transmitted and received signal phases, the transmitted and received signals are always kept orthogonal by compensating the transmitted signal for detecting the phase noise and the delay of the received signal was implemented by MOS circuits. To delay the phase of the signal, additive white Gaussian noise (AWGN) environment was used. The phase and delay of the signal transmitted through AWGN channel were compensated in the modulator of the transmitter and the compensated signal was demodulated using quasi-direct conversion receiver and QPSK demodulator. ISI suppression was achieved by keeping the orthogonality between the compensated transmitted signal and the receive signal. The error probability of data decision was compared. By simulation the proposed system was proved to be effective in minimizing the ISI.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.7B
• /
• pp.505-516
• /
• 2012

According to distribute of resource of macro cell and reduce distance between transmitter and receiver, Femto cell system is promising to provide costeffective strategy for high data traffic and high spectral efficient services in future wireless cellular system environment. However, the co-channel operation with existing Macro networks occurs some severe interference between Macro and Femto cells. Hence, the interference cancellation or management schemes are imperative between Macro and Femto cells in order to avoid the decrease of total cell throughput. First, we briefly investigate the conventional resource allocation and interference cancellation scheme between Macro and Femto cells. So we found that cell throughput and frequency reuse ware decreased Then, we propose an adaptive resource allocation scheme based on the distribution of Femtocell traffic in order to increase the cell throughput and also maximize the spectral efficiency over the FFR (Fractional Frequency Reuse) based conventional resource allocation schemes. Simulation Results show that the proposed scheme attains a bit similar SINR (Signal to Interference Noise Ratio) distribution but achieves much higher total cell throughput performance distribution over the conventional resource allocation schemes for FFR and future IEEE 802.16m based Femtocell network environment.

• Journal of Satellite, Information and Communications
• /
• v.6 no.2
• /
• pp.125-130
• /
• 2011

In this paper, there was compared to the performance of the Auto Correlation Feature of each code using Spreading code for improving the data transmission technology in T-DMB disaster broadcasting. Generally, wireless mobile communication environment such as DMB occur the Inter Code Interference and the Multi-Path Interference in the process of the identification of the transmitter from the receiver. To solve this problem, spreading code technology was able to improve the security property. Also, it will be able to use in many fields of signal processing, because to control a period of the code can be variable. Therefore, in this paper, we studied to compare the performance of excellent orthogonal Golay code, Kasami code and ZCD(Zero Correlation Duration) code.

• Transactions on Electrical and Electronic Materials
• /
• v.12 no.6
• /
• pp.253-257
• /
• 2011

This study was carried out to solve problems such as radio frequency band depletion, confusion risk, and security loss in existing visible wireless communication systems, and to determine the applicability of next-generation networks. A light-emitting diode (LED) light communication system was implemented with a controlling switching light module using the ATmega16 micro-controller. To solve the existing modulation effect and disturbance in visible light communication, an integrated interface was evaluated with a driving light module and analyzes its reception property. A transmitter/receiver using the ATmel's micro-controller, high-intensity white LED-6 modules, and infrared sensor KSM60WLM and visible sensor TSL250RD were designed. An experiment from the initial value of distance to 2.5 m showed 0.46 V of the voltage loss, and if in long distance, external light interference occurred and light intensity was lost by external impact and thus data had to be modified or reset repeatedly. Additionally, when we used 6 modules through the remote controller's lighting dimming, data could be transmitted up to 1.76 m without any errors during the day and up to 2.29 m at night with around 2~3% communication error. If a special optical filter can reduce as much external light as possible in the integrated interface, the LED for lighting communication systems may be applied in next generation networks.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.5
• /
• pp.863-870
• /
• 2019

In the GSM method for OWC-MIMO System, it is important to select an activation pattern set(: APS) for the performance optimization in the environment where mutual interference is high depending on the location of the transmitter and receiver. However, due to the high computational complexity, a high cost is paid in selecting the transmission APS. In this paper, we propose a method to reduce the candidate APS by pre-determining basic APS when generating candidate APS. The simulation results show that the proposed method has the same BER performance and reduce the computational complexity by 90% compared to the general GSM method in the high interfering environment.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.2A
• /
• pp.107-114
• /
• 2008

In wireless access systems, there has been much interest in enhancing the performance of orthogonal frequency division multiplexing OFDM) in a frequency selective fading channel. If the channel is static and is perfectly known to both the transmitter and the receiver, the water-filling technique with adaptive modulation is known to be optimal. However, for OFDM systems, this requires intensive traffic overheads for reporting channel side information on all subcarriers to the transmitter In this paper, we propose an adaptive modulation and coding scheme for bit-interleaved coded OFDM (BIC-OFDM) for downlink packet transmissions with reduced feedback information. To minimize the feedback information, we employ a rate adaptation method based on the OFDM symbol rather than on each subcarrier. To illustrate the performance gap between the optimal water-filling and the proposed scheme, we will compare cutoff rates for both schemes. It is shown that the loss is less than 2dB while the proposed scheme significantly reduces the feedback payloads. Also, the OFDM system in multiuser environment with subcarrier grouping is considered. It is shown that by exploiting multiuser diversity the throughput of the proposed scheme approaches the channel outage capacity as the number of users and the number of subcarrier groups increase.

• Journal of Broadcast Engineering
• /
• v.14 no.5
• /
• pp.561-572
• /
• 2009

In this paper, we propose an efficient layer-separable PES packetization and processing scheme for DVB-S2 satellite broadcasting service based on SVC video. Unlike the conventional single layer-based video coding such as MPEG-2, MPEG-4 and H.264, SVC can combine numerous number of video layers, which are aggregated to a single bitstream. Therefore, it is necessary to devise a new PES packetization scheme that can efficiently separate multiple video layers of SVC. In order to combine the layered characteristics of the SVC video and the robust channel coding capability of LDPC (Low Density Parity Check) of DVB-S2 for unequal error protection, we propose an efficient PES packetization in the transmitter side and PES packet processing scheme in the receiver side of DVB-S2. We prove the effectiveness of the proposed scheme in terms of processing speed and time delay required for processing of the separated layers of SVC video in the satellite broadcasting service.

• Journal of Korea Multimedia Society
• /
• v.14 no.6
• /
• pp.752-758
• /
• 2011

In this paper, we perform a research on a message delivery link based on visible light communication using illumination light-emitting diodes (LEDs) for car-to-car communications and the link transmission success probability is analyzed for the link. The message delivery system is modeled and the signal-to-noise ratio is calculated from the received optical power. Then, the link transmission probability is estimated from the calculated bit error rates (BERs). The message delivery system has optical links from an LED transmitter near the rear lamp of a car ahead to a receiver near the headlamp of a car behind, whose positions are assumed to follow the normal Gaussian distribution. The link transmission success probability is calculated considering the physical characteristics of the optical link. The car positions are generated according to the normal distribution and the bit error rates are calculated for all links. The link transmission success probability is defined. For the unoptimized optical car-to-car message delivery links, it is shown that the link transmission success probability is larger than 0.9 with the transmitted optical power of 400 mW and the semi-angle at half power of 30 degree.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.5
• /
• pp.445-453
• /
• 2016

This paper presents the implementation and design of the 1T-1R wireless HD video streaming systems over 28 GHz mmWave frequency using 3GPP LTE-TDD standard on NI USRP RIO SDR platform. The baseband of the system uses USRP RIO that are stored in Xilinx Kintex-7 chip to implement LTE-TDD transceiver modem, the signal that are transceived from USRP RIO up or down converts to 28 GHz by using self-designed 28 GHz RF transceiver modules and it is finally communicated HD video data through self-designed $4{\times}8$ sub array antennas. It is that communication method between USRP RIO and Host PC use PCI express ${\times}4$ to minimize delay of data to transmit and receive. The implemented system show high error vector magnitude performance above 25.85 dBc and to transceive HD video in experiment environment anywhere.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.5
• /
• pp.85-90
• /
• 2017

Indoor location-based services have been developed based on the Internet of Things technologies which measure and analyze users who are moving in their daily lives. These various indoor positioning technologies require separate hardware and have several disadvantages, such as a communication protocol which becomes complicated. Based on the fact that a reduction in signal strength occurs according to the distance due to the physical characteristics of the transmitted signal, RSSI technology that uses the received signal strength of the wireless signal used in this paper measures the strength of the transmitted signal and the intensity of the attenuated received signal and then calculates the distance between a transmitter and a receiver, which requires no separate costs and makes to implement simple measurements. It was applied calculating the value for the average RSSI and the RSSI filtering feedback. Filtering is used to reduce the error of the RSSI values that are measured at long distance.It was confirmed that the RSSI values through the average filtering and the RSSI values measured by setting the coefficient value of the feedback filtering to 0.5 were ranged from -61 dBm to - 52.5 dBm, which shows irregular and high values decrease slightly as much as about -2 dBm to -6 dBm as compared to general measurements.