• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.2
• /
• pp.111-116
• /
• 2016

This paper proposes a high-frequency (MHz) LLC resonant converter for a capacitor coupling wireless power transfer (CCWPT). The CCWPT uses electric field in the coupling capacitor between the transmitter and receiver electrodes with a dielectric layer. Given that capacitance is very small and the impedance is large, transferring power with a simple series resonance is difficult. Therefore, the high frequency (MHz) and high Q factor LLC converter is proposed to reduce the impedance of the coupling capacitance and to obtain a high output voltage. This paper deals with the operation analysis of the proposed LLC converter and a theoretical capacitance estimation. The operation and features of the proposed CCWPT LLC converter is verified with a 4.2 W prototype for charging mobile devices.

• The KIPS Transactions:PartC
• /
• v.12C no.4 s.100
• /
• pp.597-602
• /
• 2005

In this study, file size for measurement and the service system's billing data were submitted to a comparative analysis by performing a verification test on the billing system of three major mobile communication services providers, based on the wireless Internet service packet. As shown in the result of the verification test, there were some differences in the billing data due to transmission overhead, according to the network quality that is affected by the wireless environment of mobile operators. Consequently, the packet analysis system was proposed as a means of applying consistent packet billing to all service providers being compared. If the packet analysis system is added to supplement the current billing system various user requirements can be met. Billing by Packet among mobile operators and differentiated billing based on the content value are available, since the packet data can be extracted through protocol analysis by service, and it can be classified by content tape through traffic data analysis. Furthermore, customer's needs can be satisfied who request more information on the detailed usage, and more flexible and diverse billing policies can be supported like application of charging conditions to the non-charging packet handling. All these services are expected to contribute to the popularization of the wireless Internet service, since user complaints about the service charge could be reduced.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.4
• /
• pp.415-424
• /
• 2004

Cooling the electronic equipment is one of the major focal points of the design process and the key to successful product launch. The two-phase loop thermosyphone which is a good candidate among many available options was investigated fur cooling of the high power amplifiers. The system is composed of evaporator which contains 6 parallel cold plates, fan cooled condenser, gas-liquid separator, and interconnecting tubes. Experiments were performed for several refrigerant charging values, hs and as a experiment result, the optimum charging value fur this system was proposed. In order to optimize the system design, the operating cycle pressure and inlet/outlet temperatures of evaporator and condenser are measured and analyzed. The effect of the three parameters such as flow rate and temperature of condenser cooling air, and thermal load on the evaporator are investigated. The lower the operating pressure and the cycle temperatures are also better to prevent the leakage of the system. The system invesigated in this paper can be directly used for cooling of a real unmanned wireless communication station.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.5
• /
• pp.60-70
• /
• 2011

Vehicle location detection and wireless communication method have be designed along the same lines as GPS, CDMA and WLAN, which is based upon the selecting factors such as state-of-art technology trend, accuracy, stability, and economic feasibility, in order to select the optimum method of information communication networks for integrated "Transportation-Power-Facilities" on the electric bus. In addition, the key features of each alternative for an efficient linkage have been review and the integration methodology for linking among Transportation Charging Center, Transportation(ITS, BIS) Center and smart Grid Center has been drawn up based on a technical level of difficulty of each alternative, political and administrative difficulties, and expense justification.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2024.01a
• /
• pp.269-270
• /
• 2024

최근 드론 산업의 규모가 커지면서 드론을 다양한 분야에 활용하려는 노력이 커지고 있다. 대규모 환경 모니터링, 재난 관리 등에 사용되기 위해서는 장시간 연속 비행이 필요하지만 드론의 배터리 용량 문제로 인해 사람이 직접 배터리를 교체해 주지 않으면 장시간 비행이 어렵다. 본 논문은 드론이 배터리 충전을 위해 자율적으로 착륙해 충전 후 이륙하는 가로등을 활용한 자율 충전 스테이션'을 제안한다. 단순한 무선 충전이 아닌 드론이 자율 비행을 통해 스테이션에 착륙하고 스테이션의 초음파 센서를 통해 착륙이 감지되면 스테이션의 송신부에서 전력을 공급해 드론의 무선 충전이 가능하다. 또한 스테이션의 구조를 원뿔형으로 만들어 드론이 스테이션의 중앙에 정확히 안착되도록 하였다. 자율 드론 충전 스테이션을 통해 배터리 용량 문제를 새로운 방식으로 해결할 수 있고, 업무에 필요한 인력을 최소화함으로서 드론 관제, 환경 모니터링 등 드론을 활용하는 다양한 분야에 도움을 줄 수 있을 것이다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.5
• /
• pp.521-524
• /
• 2015

This letter presents a selective wireless power transfer architecture using a reconfigurable multi-port amplifier. The proposed wireless power transfer architecture is composed of a phase shifter part controlled by FPGA, two class-E power amplifiers, a four-port power combiner and two coil loads. Depending on the phase control of FPGA, the power ratio of outputs at the two coil loads becomes 1:1, 2:0 and 0:2. The manufactured system has delivered 1W DC power to loads at 125 kHz. The total DC-to-DC conversion efficiency shows more than 40 % including PA efficiency of 79 %.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.11
• /
• pp.1615-1621
• /
• 2014

A wireless tram which runs without catenary and instead uses batteries installed in the tram has been recently researched actively. This paper presents a new method maximizing absorption of regenerative energy of a wireless tram and extending life cycle of the energy storage device in the wireless tram by applying line-optimized charging and discharging scenario. Energy efficiency and life cycle of energy storage system (ESS) are highly dependent on the characteristic of operating conditions. For example, frequent charge and discharge with high power cause the problems that decrease the battery life cycles. Hybrid energy storage system (HESS) is combination of two ESSs which have complementary characteristics to each other. HESS can provide even better functionality and performance than the battery only ESS due to the synergy effect of two ESSs. This paper also provides a power distribution strategy and driving scenarios which increase the life cycle and energy efficiency of the HESS consisting of a battery and an ultra-capacitor. The developed strategy was tested and verified by a hardware-in-the-loop-simulation (HILS) system which emulates the a wireless tram.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9B
• /
• pp.1381-1389
• /
• 2010

The smart grid technology is expected to significantly improve energy efficiency by dynamic power supply. One of its application is the Vehicle-to-Grid(V2G) that utilizes an electric vehicle's battery as a household storage battery. Meanwhile, a lot of researches are recently investigated in the area of wireless energy transfer technology because of its convenience and safety in charging a battery. With the wireless energy transfer infrastructure a wireless magnetic induction communication technique can help the dynamic power supply of the smart grid more efficient. In this paper, we propose a wireless magnetic induction communication sion cowhich includes data transmission and location-aware functions. We expect the sion cohelp the smart grid to control power supply more efficiently. We also developed its test-bed and evaluated the performance.

• Journal of electromagnetic engineering and science
• /
• v.19 no.1
• /
• pp.48-55
• /
• 2019

Unmanned aerial vehicles (UAVs) using communications, sensors, and navigation equipment will play a key role in future warfare. Currently, UAVs are monitored to prevent misfire and accidents, and the conventional method adopted uses wires for data transmission and power supply. The repeated connection and disconnection of cables increases maintenance time and harms the connector. For convenience and stability, a wireless power transfer system to power UAVs is needed. Unlike other wireless power transfer (WPT) applications, the size of the receiving coils must be small, so that the WPT systems can be embedded inside space-limited UAVs. The small size reduces the coupling coefficient and transfer efficiency between the transmitting and the receiving coils. In this study, we propose a toroidal-shaped coil for a WPT system for UAVs with high coupling coefficient with minimum space requirements. For validation, conventional coils and the proposed toroidal-shaped coil were used and their coupling coefficient and power transfer efficiency were compared using simulated and measured results. The simulated and measured results were strongly correlated, confirming that the proposed WPT system significantly improved efficiency with negligible change in the space requirement.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.207-209
• /
• 2015

Recently, with the economy and the information communication technology developed, the smartphone market grows continuously. The market outlook on the wireless rechargeable technology grows rapidly so that the market size is increased about six times bigger than that of the last year, and it will grow about 18 billion dollars in 2014. Because of that, as the interest on this area out focused, many kinds of technology and new product are being exploited in this field. Participants of this study were 76 mobile users in Gyeongnam and Jeonbuk province in accordance with convenience sampling. Most of the respondents about 88 percent, the wireless charger may be answered to be able to explain what it is. Also, about 70 percent of the respondents, is time to replace the future of smart phone, answered by selecting a product in consideration of the wireless charging. Based on these findings, several theoretical and practical implications were suggested.