• Korean Journal of Optics and Photonics
• /
• v.6 no.1
• /
• pp.16-20
• /
• 1995

We have studied the spectral narrowing characteristics of the tunable Ti:sapphire laser pumped by the second harmonic generation of Nd:YAG laser. Ti:sapphire laser has uniform excitation distribution by both-side end pumping. We have controlled the angle of grating linearly and achieved the continuous selection of wavelength in the broad range from 705 to 835 nm. The output energy of $380{\mu}J$ at 790 nm. the spectral linewidth of $0.13cm_{-1}$ and the beam divergence of 1.2 mrad have been obtained. The wavelength range with power more than 50% of maximum output was 730-825 nm.825 nm.

• Journal of KIISE:Information Networking
• /
• v.31 no.2
• /
• pp.123-130
• /
• 2004

Routing and wavelength assignment(RWA) problem is an important issue in optical transport networks based on wavelength division multiplexing(WDM) technique. It is typically solved using a combination of linear programming and graph coloring, or path selection based graph algorithms. Such methods are either complex or make extensive use of heuristics. In this paper we propose a novel and efficient approach which basically obtains the maximum edge disjoint paths (EDPs) for each source-destination demand pair. And those EDPs obtained are stored in Lookup Table and used for the update of weight matrix. Routes are determined in order by the weight matrix for the demand set. The comprehensive computer simulation shows that the Proposed algorithm uses similar or fewer wavelengths with significantly less execution time than bounded greedy approach (BGA) for EDP which is currently known to be effective in practice.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.5
• /
• pp.57-62
• /
• 2020

The millimeter wave that uses the spectrum in the 30GHz~300GHz band has a shorter wavelength due to its high carrier frequency, so it is suitable for Massive MIMO systems because more antennas can be equipped in the base station. However, since an RF chain is required per antenna, hardware cost and power consumption increase as the number of antennas increases. Therefore, in this paper, we investigate antenna selection schemes to solve this problem. In order to solve the problem of high computational complexity in the exhaustive search based antenna selection scheme, we propose a approach of applying deep learning technology. An best antenna combination is predicted using a DNN model capable of classifying multi-classes. By simulation tests, we compare and evaluate the existing antenna selection schemes and the proposed deep learning-based antenna selection scheme.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.5
• /
• pp.141-147
• /
• 2021

In this paper, in order to improve the utilization of hyperspectral large-capacity data feature information by reducing complex computations by dimension reduction of neural network inputs in embedded systems, the band selection algorithm is applied in each subset. Among feature extraction and feature selection techniques, the feature selection aim to improve the optimal number of bands suitable for datasets, regardless of wavelength range, and the time and performance, more than others algorithms. Through this experiment, although the time required was reduced by 1/3 to 1/9 times compared to the others band selection technique, meaningful results were improved by more than 4% in terms of performance through the K-neighbor classifier. Although it is difficult to utilize real-time hyperspectral data analysis now, it has confirmed the possibility of improvement.

• Journal of Pharmaceutical Investigation
• /
• v.37 no.6
• /
• pp.377-395
• /
• 2007

Near infrared(NIR) spectral data have been used for the noninvasive analysis of various biological samples. Nonetheless, absorption bands of NIR region are overlapped extensively. It is very difficult to select the proper wavelengths of spectral data, which give the best PCR(principal component regression) models for the analysis of constituents of biological samples. The NIR data were used after polynomial smoothing and differentiation of 1st order, using Savitzky-Golay filters. To find the best PCR models, all-possible combinations of available principal components from the given NIR spectral data were derived by in-house programs written in MATLAB codes. All of the extensively generated PCR models were compared in terms of SEC(standard error of calibration), $R^2$, SEP(standard error of prediction) and SECP(standard error of calibration and prediction) to find the best combination of principal components of the initial PCR models. The initial PCR models were found by SEC or Malinowski's indicator function and a priori selection of spectral points were examined in terms of correlation coefficients between NIR data at each wavelength and corresponding concentrations. For the test of the developed program, aqueous solutions of BSA(bovine serum albumin) and glucose were prepared and analyzed. As a result, the best PCR models were found using a priori selection of spectral points and the final model selection by SEP or SECP.

• Journal of Biosystems Engineering
• /
• v.23 no.6
• /
• pp.571-582
• /
• 1998

The PLS(Partial Least Square) and ANN(Artificial Neural Network) were introduced to develop the soluble solids content prediction model of apples which is followed by making a subsequent selection of photosensor. For the optimal PLS model, number of factors needed for spectrum analysis were increased until the convergence of prediction residual error sum of squares. Analysis has shown that even part of the overall wavelength with no pretreatment may turn out better performing. The best PLS model was found in the 800 to 1,100nm wavelength region without pretreatment of second derivation, having $R^2$=0.9236, bias= -0.0198bx, SEP=0.2527bx for unknown samples. On the other hand, for the ANN model the second derivation led to higher performance. On partial range of 800 to 1,100nm wavelengh region, prediction model with second derivation for unknown samples reached $R^2$=0.9177, SEP=0.2903bx in contrast to $R^2$=0.7507, SEP =0.4622bx without pretreatment.

• Journal of the Optical Society of Korea
• /
• v.20 no.5
• /
• pp.557-562
• /
• 2016

In this paper, for the first time, the transmission performances of long-haul 100-Gb/s direct detection optical OFDM (DDO-OFDM) and coherent optical OFDM (CO-OFDM) wavelength division multiplexing (WDM) systems are compared by simulation. It provides specific guides for system parameter selection to get a high-performance and cost-effective OFDM WDM system. Specifically, the comparison involves three aspects: launched power is investigated to achieve better system performance; laser linewidth is numerically investigated to choose cost-effective laser; system dispersion tolerances with different laser linewidths are analyzed to further reveal the advantages and disadvantages of these two detecting methods, direct detection and coherent detection, in long-haul OFDM WDM system.

• Current Optics and Photonics
• /
• v.7 no.5
• /
• pp.518-528
• /
• 2023

As an effective means of remotely detecting the spectral information of the object, the spectral calibration for the Savart polarization interference imaging spectrometer (SPIIS) is a basis and prerequisite of information quantification, and its experimental calibration scheme is firstly proposed in this paper. In order to evaluate the accuracy of the spectral information acquisition, the linear interpolation, cubic spline interpolation, and piecewise cubic interpolation algorithms are adopted, and the precision of the quadratic polynomial fitting is the highest, whose fitting error is better than 5.8642 nm in the wavelength range of [500 nm, 820 nm]. Besides, the inversed value of the spectral resolution for the monochromatic light is greater than the theoretical value, and the deviation between them becomes larger with the wavelength increasing, which is mainly caused by the structural design of the SPIIS, together with the rationality of the spectral restoration algorithm and the selection of the maximum optical path difference (OPD). This work demonstrates that the SPIIS has achieved high performance assuring the feasibility of its practical use in various fields.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.4
• /
• pp.370-379
• /
• 2014

Recently, the interest in optical network with multifiber link is continuing to rise since the network traffic has been growing exponentially. However, growing traffic in network leads to increasing the energy consumption of the network equipment. In this paper, we propose a dynamic routing and wavelength assignment (RWA) algorithm based on V-like cost function and layered graph to improve energy efficiency in IP over WDM network with multifiber link. The V-like cost function is used to decide the fiber cost according to the number of used wavelengths. The layered graph with multifiber link is used to select the energy efficient route and wavelength. The proposed RWA algorithm is compared and analyzed with conventional algorithm in view of average power consumption and blocking probability through OPNET modeler.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.525-525
• /
• 2013

Low temperature plasma diagnosis is one of the big issues in laboratory scale or processing industry. One of the most powerful techniques of plasma diagnostics is the use of the scattering of electromagnetic radiation from the plasma. Electron temperature and density are important parameters for understanding the information of plasmas in the plasma processing industry. Laser scattering experiments on plasma can provide a substantial amount of information about plasma parameters such as the electron density ne, the electron temperature Te, and the neutral density nn and temperature Tn. Thomson scattering spectroscopy is used several method, in accordance with detector type. Commonly, Thomson scattering is used several notch filter to separate expanded wavelength. Since using a spectrometer with surface relief grating or notch filter, the system of the measurement will be complicated and bigger. In this study, using VPHG (Volume Phase Holographic Grating) in order to install the simple and cheap system. VPHG has the advantage of the system installation, because it can be Transmission Type. The diffraction efficiency and dispersion angle of VPHG is higher than the surface relief grating relatively. For a wavelength and bandwidth selection, Using a slit or mask to select a rejection wavelength instead of notch filter.