• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.1
• /
• pp.23-31
• /
• 2015

In this paper, we design a SSD(simultaneous single band duplex) system using RF cancellation and digital cancellation. And then, we analyze performance of the SSD system using pre-distorter with HPA non-linearity. Also, we analyze digital cancellation performance of the SSD system using pre-distorter with HPA non-linearity. Additionally, digital cancellation cancels residual self-interference. In linear conditions, digital cancellation can cancel self-interference of 40dB. Therefore, the SSD system has good BER performance because most of self-interference is canceled. But, in HPA non-linearity conditions, digital cancellation cancels residual self-interference of 25dB. In this conditions, self-interference is greater than desired signal. Therefore, bit informations of distant station can not be received. But, we confirm that if the proposed system uses pre-distorter then bit information of distant station can be received by HPA non-linearity compensation. Also, we confirm that even though the proposed system uses pre-distorter, if HPA non-linearity increases then digital cancellation performance is degraded by imperfect compensation of HPA non-linerity.

• Journal of Korea Multimedia Society
• /
• v.12 no.10
• /
• pp.1407-1417
• /
• 2009

Today is the Information age which Internet service acts a most important Information Source. So the Power Line Communication has been achieved to offer Internet service for Last-Mile area. And Research is achieved to frequence range from 30MHz to 80MHz for High-speed communication service. But, Power Line is not suitable for communication, So, electric wave is generated from flow of communication information. And the electric wave is interfered with Wireless Communication Service using the same frequence range. In this paper, a Notch Filter for reduce of interference between Power Line Communication and Wireless Communication Service is proposed. The proposed emulator is developed using TMS320C6416T DSP board of Texas Instruments.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1994.06a
• /
• pp.802-805
• /
• 1994

There are strong ocean wave interference with big amplitude very low frenqencies are similar to the ship's hydrodynamic signals. To detect ship's hydrodynamic field will be faced various natural hydrodynamic interferences which are radom and the prior knowlege of which are not know. This paper proposes to use the adaptive noise cancelling principle and used the model of adaptive wave canceller to eliminate the ocean wave interfrence and detect the ship's hydrodynamic signals. Computer simulation results shown that signal to noise ratio can be raised from several to ten times. It shows the fact that this mathod can detect the ship's hydrodynamic signals from the strong ocean wave interferences while it is difficult for the old methods.

• Journal of KSNVE
• /
• v.10 no.6
• /
• pp.941-948
• /
• 2000

Active noise control is an approach to reduce the noise by utilizing a secondary noise source that destructively interferes with the unwanted noise. In general, active noise control systems rely on multiple sensors to measure the unwanted noise field and the effect of the cancellation. This paper develops an approach that utilizes a single sensor. The noise field is modeled as a stochastic process, and an adaptive algorithm is used to adaptively estimate the parameters of the process. Based on these parameter estimates, a canceling signal is generated. Oppenheim assumed that transfer function characteristics from the canceling source to the error sensor is only a propagation delay. This paper proposes a modified Oppenheim algorithm by considering transfer characteristics of speaker-path-sensor This transfer characteristics is adaptively cancelled by the proposed adaptive modeling technique. Feasibility of the proposed method is proved by computer simulations with artificially generated random noises and sine wave noise. The details of the proposed architecture. and theoretical simulation of the noise cancellation system for three dimension enclosure are presented in the Paper.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.12
• /
• pp.1181-1189
• /
• 2013

In this paper, a retrodirective anatenna array system is proposed and the possibility of actively cancelling electromagnetic waves based on this system is investigated. When a rectrodirective array system receives an electromagnetic wave, it can send waves in the direction of the incoming signal without prior knowledge of the direction. In applications to cancellation of radar signals, the system can generate and send signals to the radar so that it cancels the radar signals that are reflected back to the radar. In such a system, isolation between the input and output ports is a key factor that determines the effectiveness of cancellation. In this work, a dual-conversion mixer system is proposed to maximize the isolation. Since this minimizes the difference between the direction of reflection of radar signals and the transmission of cancellation signals, the effectiveness of cancellation is maximized. Experimental results for a metallic plate and metallic cylinder shows as much as 29-dB reduction in reflection for a $2{\times}2$ retrodirective array based on proposed dual-conversion mixer system, which verifies the proposed method of active cancellation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.4
• /
• pp.418-425
• /
• 2014

This paper presents a Ku-Band Doppler Radar System to measure respiration and heart rate. It was measured by using simultaneous radar and ECG(Electrocardiogram). Arctangent demodulation without dc offset compensation can be applied to transmitted I/Q(In-phase & Quadrature-phase) signal in order to improve the RMSE(Root Mean Square Error) about 50 %. The power leaked to receiving antenna from the transmitting antenna is always generated because of continuously opening the transceiver of CW(Continuous Wave) Doppler radar. As the output power increase, leakage power has an effect on the SNR(Signal-to-Noise Ratio) of the system. Therefore, in this paper, leakage cancellation technique that adds the signal having the opposite phase of the leakage power to the leakage power was implemented in order to minimize the decline of receiver sensitivity. By applying the leakage cancellation techniques described above, it is possible to measure the heart rate and respiration of the human at a distance of up to 35 m. the heart rate of the measured data at a distance of 35 m accords with the heart rate extracted from the ECG data.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.12
• /
• pp.2391-2395
• /
• 2009

Active control schemes which modify the excitation to correct for any of the nonideal characteristics of the SPMSM is described. Especially, because of design limitations(size and cost) in automobile, the back-EMF of SPMSM can't be perfectly designed with sinusoidal wave and iron core of stator is saturated so that torque ripple is unavoidable. An active cancellation method of the pulsating torque components which would otherwise be generated using the classic sinusoidal current excitation is illustrated.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2008.11a
• /
• pp.212-213
• /
• 2008

Ultrasonic fiber sensor is more cost-effective than optical fiber sensor using light. However, optical fiber lines are separately used for sensing. Thus, if it is applied for huge system, it is need many lines of the sensor systems. To overcome this point, novel ultrasonic sensor systems considering wave cancellation and modulation were newly developed. By using this schema, reference-free sensor system can be developed. By using ultrasonic waves of different excitation frequencies, multiple input-signal output sensor system was also developed by applying spectrum analyses. Using the array type sensor system, the leakage of liquid and its evaporation can be monitored successfully.

• Journal of KSNVE
• /
• v.2 no.2
• /
• pp.107-116
• /
• 1992

An adaptive signal processing technique is implemented for the active noise cancellation of the plane acoustic wave propagating in a duct. To avoid the instability caused by the acoustic feedback from the control speaker to the detect microphone, an off-line modeling of the acoustic feedback plant is done using the FIR filter. Auxiliary path required for the filtered-x LMS algorithm is modeled as well. Before going into the experiments, a simulation is carried out under the same conditions with experiments. The simulation shows that the longer the length of the adaptive filter is, the better the results are achieved. Experiments have been carried out at lower audio frequency range (50 - 400Hz), and the results are in good agreements with those of simulation study. As a results of this adaptive noise control, around 50dB is reduced for a pure tone noise, and for a bandlimited noise with the bandwidth of 316Hz, a maximum of 30dB noise reduction is attained.

• Journal of KSNVE
• /
• v.9 no.3
• /
• pp.600-606
• /
• 1999

A reactive type acoustic filter is developed based on the phase cancellation effect which is occurring in the plane wave propagation through the two paths where the cross sectional areas are reversely changing. The theory is experimentally validated by the use of a cylindrical duct and an inserted hollowed cone of which vertex part is eliminated. Noise attenuation and the filtered frequency are dependent on the area variation and the effective length of the filter. Experimental comparison shows that the filtered frequencies of 1st and 2nd mode are lower than the analytical prediction due to the mass loading effects, and the 3rd mode is in good agreement. The proposed filter can be applied as an in-duct noise filter for improving the sound quality in a narrow space for various industrial applications.