• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.1
• /
• pp.79-86
• /
• 2019

In order to measure the filtration characteristics of a cotton ball shape filter, the experiments of suspended solids(SS) surrogate material selection and filtration performance have been carried out in this study. Between the two materials of powdered activated carbon(PAC) and powdered red-clay, PAC is more suitable surrogate material in terms of experimental criteria and particle size distribution in the non-point source pollutants removal system. As a result of the filtration experiments with the cotton ball shape filter, the initial headloss was about 8 cm, and the headloss slightly increased over filtration time. The Kozeny-Carman equation was used to analyze the changes of pressure and porosity during the filtration. The initial porosity was calculated as 0.945 and it decreased to 0.936 at the end of design filtration time. As the filtration continued, the SS concentration of the filtered water gradually increased and the SS removal rate gradually decreased. When the SS target removal efficiency is assumed to be 80%, the cumulative SS removal capacity is expected as $28.8kg/m^2$. This means the volume loading rate of the cotton ball shape filter can be $115m^3/m^2$ when the typical SS concentration of non-point source water pollution is assumed as 250 mg/L.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.4
• /
• pp.775-784
• /
• 2000

Nitrate dry deposition fluxes were directly measured using knife-leading-edge surrogate surface (KSS) covered with greased strips and a water surface sampler (WSS). The average gaseous flux ($8.3mg/m^2/day$) was much higher than the average particulate one ($3.0mg/m^2/day$). The best fit gas phase mass transfer coefficient (MTC) of $HNO_3$ was obtained by linear regression analysis between measured gaseous flux containing nitrogen compounds and measured ambient $HNO_3$ concentration. The result showed that the MTCs of $HNO_3$ were approximately two times higher than those of $SO_2$. Especially, during the ozone action day, measured gaseous fluxes containing nitrogen compounds were much higher than those ones calculated as the product of measured ambient $HNO_3$ concentration and gas phase MTC of $HNO_3$, which is calculated from MTC of $SO_2$ using Graham's diffusion law. This result indicated that other nitrogen compounds except $HNO_3$ contributed to gaseous flux containing nitrogen compounds into the water surface sampler. The theoretical calculations suggest the contributions of nitrous acid ($HNO_2$) and PAN to the gaseous dry deposition flux of nitrogen containing compounds to the WSS.

• Journal of Korean Society of Water and Wastewater
• /
• v.12 no.3
• /
• pp.118-124
• /
• 1998

To use chlorine residual as an surrogate parameter of the water quality change during the transportation in the water distribution system(WDS), the correct prediction model of chlorine residual must be established in advance. This paper shows the procedure and the result of applying the water quality model to the field WDS. To begin with, hydraulic model was calibrated and verified using fluoride as an tracer. And chlorine residual was predicted through simulation of water quality model. This predicted value was compared with the observed value. With adjusting the bulk decay coefficient(kb) and the wall decay coefficient(kw) according to the pipewall environment, the predicted chlorine residual can represent the observed value relatively well.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.6
• /
• pp.806-808
• /
• 2004

A gas chromatography/mass spectrometric assay method has been developed for the simultaneous determination of icing inhibitors, ethylene glycol monomethyl ether and diethylene glycol monomethyl ether in ground water contaminated with JP-8. Ethylene glycol monobutyl ether and ethylene glycol monoethyl ether were used as the internal standard and surrogate, respectively. 100 mL of ground water was extracted twice with 20 mL of methylene chloride. The extract was concentrated to dryness, dissolved with 100 ${\mu}$L of methanol and analyzed by GC-MS (SIM). The use of an Innowax column gave the peaks good chromatographic properties, and the extraction of these compounds from samples gave recoveries of about 50% with small variations. The method detection limits of the target compounds were in a range of 0.5-0.8 ng/mL in ground water.

• Journal of Korean Society on Water Environment
• /
• v.21 no.5
• /
• pp.470-476
• /
• 2005

The Korean Water Quality Index (K-WQI) was applied to the rivers located in the watershed of Daecheong Lake to assess the status of river water quality, and propose potential target constituents for better water quality management in the watershed. The estimated K-WQI value for each river was varied from 70 to 90, and Youngdongcheon showed the worst score while Mujunamdeachen showed the best score. The total nitrogen (TN) and total coliform bacteria were identified as the most significant constituents that degrade the K-WQI values in the rivers. The correlation coefficients (r) were determined between K-WQI and the delivered specific load ($kg/km^2/yr$) of BOD, TN, and TP to justify potential target constituents that have a great influence on the improvement of K-WQI values. The results showed that TN (r=-0.86) and TP (r=-0.85) have a strong negative relationships with K-WQI, but BOD have almost no effect. This implies that BOD, the surrogate parameter for organic pollutants, is no more a feasible water quality variable for the water quality management in the study site.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.381-381
• /
• 2020

자료동화(Data Assimilation) 기법은 실시간 수문학적 예측에 있어 정확도 향상을 위해 필수적인 과정이다. 가장 대중적으로 사용되는 기법들 중 하나가 모델 상태변수와 매개변수를 동시에 업데이트할 수 있는 이중 앙상블 칼만 필터(Dual Ensemble Kalman Filter)이다. 이 방법은 정확도 개선 및 적용의 용이성 때문에 많은 연구 분야에서 사용되어져 왔지만, 앙상블을 생성하는 과정에서 상당시간이 소요되는 단점이 존재한다. 본 연구에서는 상태변수와 매개변수를 동시에 업데이트 하면서 홍수 예측의 정확성을 보장할 뿐만 아니라, 앙상블 생성에 있어 계산 효율을 크게 향상시킬 수 있는 기법을 제안한다. Polynomial Chaos Expansion(PCE) 기법을 사용하여 앙상블 칼만 필터를 모방(mimic)할 수 있는 새로운 대체필터(Surrogate Filter)를 개발하는 것을 목표로 한다. 구체적으로 대체필터를 구성하기 위한 다양한 필터를 설계하였다. 첫째 시간에 대해서 PCE가 변화하지 않는 '불변 필터'(즉, 전체 예측기간에 대해 하나의 필터를 사용하여 자료동화할 수 있는 대체필터)와, 매 시간마다 PCE가 변화하는 '시변 필터'(즉, 예측하는 매 시간마다 새로운 필터를 생성해야 하는 대체필터)를 설계하여 적용성, 정확성, 예측성 등을 비교하였다. 또한, PCE의 하이퍼 매개변수를 최적화하기 위한 최적의 프레임 워크가 제안되어, 대체필터를 구축하는 데 효율을 높이고 PCE의 과적합(overfitting) 현상을 피할 수 있도록 하였다. 본 연구에서 제안된 기법은 기존 단일 및 이중 앙상블 칼만 필터(EnKF)의 결과와 비교 검증하였으며, 그 결과는 다음과 같다. (1) 대체필터의 대부분은 원래 EnKF와 비슷한 정도의 불확실성을 설명할 수 있음; (2) 모든 대체 필터는 선행시간이 짧은 경우의 예측에 있어 우수한 결과를 제공하며, 시변 필터가 불변 필터보다 더 정확한 예측 결과를 제공함; (3) 대체필터는 원래 앙상블 칼만필터보다 최대 500배 빠른 속도로 성능을 향상시킬 수 있음. 제안된 대체필터는 자료동화를 수행하는 기존필터와 비슷한 정도의 정확성, 매우 향상된 효율성을 보장함을 확인할 수 있었다.

• Environmental Engineering Research
• /
• v.21 no.2
• /
• pp.171-179
• /
• 2016

This study analyzes guidelines to select optimum number of grids to represent behavior of a given water system appropriately. The EFDC model was chosen as a 3-D hydrodynamic and water quality model and salt was chosen as a surrogate variable of pollutant. The model is applied to an artificial canal that receives salt water from coastal area and fresh water from a river from respective gate according to previously developed gate operation rule. Grids are subdivided in vertical and horizontal (longitudinal) directions, respectively until no significant changes are found in salinity concentrations. The optimum grid size was determined by comparing errors in average salt concentrations between a test grid systems against the most complicated grid system. MSE (mean squared error) and MAE (mean absolute error) are used to compare errors. The CFL (Courant-Friedrichs-Lewy) number was used to determine the optimum number of grid systems for the study site though it can be used when explicit numerical method is applied only. This study suggests errors seem acceptable when both MSE and MAE are less than unity approximately.

• Journal of Korea Water Resources Association
• /
• v.54 no.3
• /
• pp.167-179
• /
• 2021

In order to characterize the mixing process of confluence for understanding the impacts of a river on the other river, it has been crucial to analyze the spatial mixing patterns for main streams depending on various inflow conditions of tributaries. However, most conventional studies have mostly relied upon hydraulic or water quality numerical models for understanding mixing pattern analysis of confluences, due to the difficulties to acquire a wide spatial range of in-situ data for characterizing mixing process. In this study, backscatters (or SNR) measured from ADCPs were particularly used to track sediment mixing assuming that it could be a surrogate to estimate the suspended sediment concentration. Raw backscatter data were corrected by considering the beam spreading and absorption by water. Also, an optical Laser diffraction instrument (LISST) was used to verify the method of acoustic backscatter and to collect the particle size distribution of main stream and tributary. In addition, image-based spatial distributions of sediment mixture in the confluence were monitored in various flow conditions by using an unmanned aerial vehicle (UAV), which were compared with the spatial distribution of acoustic backscatter. As results, we found that when acoustic backscatter by ADCPs were well processed, they could be proper indicators to identify the spatial patterns of the three-dimensional mixing process between two rivers. For this study, flow and sediment mixing characteristics were investigated in the confluence between Nakdong and Nam river.

• 수도
• /
• v.24 no.4 s.85
• /
• pp.79-87
• /
• 1997

In an effort to prevent the formation of DBPs from disinfection and the microbial regrowth in distribution systems, the ozonation followed by biological filtration process in drinking water treatment train has been recently developed as an alternative process to reduce effectively water-born organic matter as precursor. There are, however, insufficient for the consistent information and data about the relation between ozone dosage based on organic surrogate parameter, TOC or DOC and effect of ozonation on BDOC formation. This study is to review critically for the effect of ozonation on biodegradability on the basis of published technical papers including the output from author's research laboratory. It truned out that : 1. ozonation in the presence of organic matter has a tendancy to increase in BDOC content, 2. the rate of BDOC formation was maximum below 1mg $O_3/mg$ DOC of ozone dose, but about maximum content of BDOC was obtainable at the range from 1.5mg $O_3/mg$ DOC to 2mg $O_3/mg$ DOC, 3. from above 1mg $O_3/mg$ DOC, the rate of BDOC formation became slow down, 4. from above 2mg $O_3/mg$ DOC, BDOC formation was quantitatively negligible, In conclusion, it needs further systematic study and research concerned to biodegradability and treatability by ozonation in terms of organic characteristics and experimental conditions because it was hard to find out the consistent experimental data comparable each other that were performed by numbers of research authors.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.2
• /
• pp.165-172
• /
• 2018

As an approach for estimation of the droplet size in the molten salt-liquid metal extraction process, a droplet formation experiment at room temperature was conducted to evaluate the applicability of the Scheele-Meister model with water-mercury system as a surrogate that is similar to the molten salt-liquid metal system. In the experiment, droplets were formed through the nozzle and the droplet size was measured using a digital camera and image analysis software. As nozzles, commercially available needles with inner diameters (ID) of 0.018 cm and 0.025 cm and self-fabricated nozzles with 3-holes (ID: 0.0135 cm), 4-holes (ID: 0.0135 cm), and 2-holes (ID: 0.0148 cm) were used. The mercury penetration lengths in the nozzles were 1.3 cm for the needles and 0.5 cm for the self-fabricated nozzles. The droplets formed from each nozzle maintained stable spherical shape up to 20 cm below the nozzle. The droplet size measurements were within a 10% error range when compared to the Scheele-Meister model estimates. The experimental results show that the Scheele-Meister model for droplet size estimation can be applied to nozzles that stably form droplets in a water-mercury system.