• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 The 6th International Symposium of East Asian Resources Recycling Technology
• /
• pp.537-541
• /
• 2001

For the development of reformation material of soft ground using the LD slag, the relation to the particle condition of LD slag and the pH behavior of slag dissolution water, extraction properties of slag, and origination of white water were investigated. When the LD slag is mixed with sea water, the pH of solution ranged between 9.47 and 10.0. On the other hand, when mixed with distilled water, the pH was about 10.4 to 12.1. For the as-received slag and the aged slag in sea water, a pH of 11.5 to 12.0 was observed when the particle size was less than 0.5mm. For the reoxidized slag in seawater, the pH of the solution was lower than 9.5 when the particle size was bigger than 0.075mm. For the aged slag and reoxidized slag, the pH of the solution remained constant when the addition ratio of sea water to the slag was higher than 500 times. The main elements dissolved from the slag were Ca and Mg ions. When the pH went over 9.0, the white water started to font which was caused by the CaCO$_3$and Mg(OH)$_2$.

• 설비공학논문집
• /
• 제6권3호
• /
• pp.175-181
• /
• 1994

This paper deals with the correlation of absorption rate in absorber and evaporation rate in evaporator. The evaporator consists of a copper tube of 10mm dia, and 600mm long and chilled water flowing through the tube is fed by the chilled water circulator. The flowrate of LiBr-water solution in the absorber plays a significant role in determining the magnitude of the heat transfer rate from chilled water to refrigerant There exists a flowrate of solution which has a maximum value of heat transfer. It is interesting to note that the absorption rate of absorber increases with increasing the heat transfer rate of the evaporator. Also, absorption rate increases with evaportation rate, and the ratio(the former/the other) depends on the inlet temperature of LiBr-water solution in the absorber. The heating capacity in the absorber is higher than the refrigerating capacity in the evaporator.

• 한국화재소방학회논문지
• /
• 제15권2호
• /
• pp.6-12
• /
• 2001

본 연구의 목적은 NaBr(30%, w/w)을 첨가한 물소화제의 냉각효과를 연구하는 것이다. 고온체로는 탄소강과 테프론을 사용하였다. 실험에서 고온체 표면의 온도범위는 7$0^{\circ}C$~116$^{\circ}C$이며 액적의 크기는 2.6mm이다. 실험결과 고온체 내부의 온도는 재질에 관계없이 순수한 물의 경우가 NaBr 수용액보다 낮게 나타났으며, 테프론의 경우가 탄소강보다 온도 변화가 크게 나타났다. 또한 제질에 관계없이, 평균 열유속은 순수한 물의 경우가 NaBr 수용액 보다 크게 나타났으며, 겉보기 증발시간은 순수한 물의 경우가 NaBr 수용액보다 짧게 나타났다.

• 한국막학회:학술대회논문집
• /
• 한국막학회 2002년도 제10회 하계 Workshop
• /
• pp.59-101
• /
• 2002

PVDF is good material for a hollow fiber membrane with high porosity and excellent hydrophobicity. Asymmetric PVDF hollow fiber membranes were prepared by the Loeb-Sourirajan phase inversion method. Asymmetric PVDF hollow fiber membranes could be controlled in pore size and porosity using various additives(LiCl, ZnCl$_2$) and internal coagulants (water, EtOH/water, and DMAc/water mixture). $CO_2$removal efficiency of asymmetric PVDF hollow fiber membranes was 1.2 times high than that of commercialized PP hollow fiber membranes at MEA 5wt% solution. $CO_2$flux of asymmetric PVDF hollow fiber membranes was 2.5 times higher than that of commercialized PP hollow fiber membranes. $CO_2$removal efficiency and absorption rate of asymmetric PVDF hollow fiber membranes were 30 times higher than those of packed column at absorbent $H_2O$. $CO_2$flux of asymmetric PVDF hollow fiber membranes at MEA 5wt% solution was 48 times higher than that of pure water. In the case of MEA 5wt% solution used as an absorbent, the $CO_2$absorption rate and removal efficiency of PVDF hollow fiber membrane were 2.3 times higher than that of a packed column.

• 한국환경보건학회지
• /
• 제17권2호
• /
• pp.95-101
• /
• 1991

Lead acetate solution were intraperitoneally injected to rats of average body weight 220g to cause lead poisoning. Antidotes were orally administered using catheter to the rats and the urine was collected after 24 hours. ALA in the urine were determined by U. V. spectrophotometer. Antidotes used in this experiment were the water extracts of scutellaria radix and D-penicillamine solution. ALA in the urine was determind by Wada method. It was found that ALA content in the urine was decreased after oral administration of water extracts of scutellaria radix and D-penicillamine solution. In this study it is believed that water extract of suctellaria radix could be used as an excellent antidate in lead poisoning.

• 한국의류학회지
• /
• 제11권3호
• /
• pp.25-32
• /
• 1987

The purpose of this study is to investigate optical behaviour of coloring matter of gromwell -extracted by water, acetic acid/methanol, and the other solvents. The results were as following: UV, VIS spectra of the solution of coloring matter of gromwell extracted by water at below $80^{\circ}C$ did not reveal in the range of the visible light wavelength and coloring matter of gromwell decomposed to blue particle at $95^{\circ}C$. The solution extracted by acetic acid/methanol was tinged with reddish purple and its spectra shifted to the longer wavelength according to increase of the solvent temperature. The color of the solution extracted by water became extinct as time went by, but that extracted by acetic acid/methanol kept up original color. In case of dried gromwell, extraction by acetic acid/methanol was easier than by water, and variation of spectra did not appear but showed hypochromic shift.

• 한국안전학회지
• /
• 제12권3호
• /
• pp.38-44
• /
• 1997

6063-T5 alloys are tested in laboratory air, water and 3% NaCl solution to investigate the effects of corrosive environment on the retardation behavior through single overload fatigue test. Also, the fatigue crack propagation and the crack closure behavior are studied. The results obtained in this experimental study are summarized as follows. 1) Behaviors of fatigue crack growth retardation are observed in water and 3% NaCl solution as they do in air. The number of delay cycles and the size of affected region by single overload decrease greatly in water and 3% NaCl compared with those in air. 2) In fractographic results, the overload marking by single overload appear remarkably in air, but indistinctly in water and 3% NaCl solution. 3) The effect of crack closure on crack propagation is most remarkable in the beginning of crack propagation. With crack propagation, the crack closure level and its effect decrease greatly.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2002년도 춘계학술대회논문집
• /
• pp.41-47
• /
• 2002

A model of simultaneous heat and mass transfer process in absorption of refrigerant vapor into a lithium bromide solution of water-cooled vertical plate absorber was developed. The model can predict temperature and concentration profiles as well as the absorption heat and mass fluxes, the total heat and mass transfer rates and the heat and mass transfer coefficients. Besides, the effect of operating condition on absorption mass flux has been investigated, with the result that the absorption mass flux is increased as the inlet cooling water temperature decreases, the system pressure increases and the inlet solution concentration increases. And among the effects of operating parameters on absorption mass flux, the effect of inlet solution concentration is dominant.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제9권3호
• /
• pp.57-62
• /
• 2001

Falling film heat transfer analyses with aqueous lithium bromide solution were performed to investigate the transfer characteristics of the copper tubes. Finned (knurled) tube and a smooth tube were selected as test specimens. Averaged generation fluxes of water and the heat flux were obtained. As the film flow rate of the solution increased, the generation fluxes of water decreased for both tubes due to the fact that the heat transfer resistance increased with the film thickness. The effect of the enlarged surface area at the knurled tube was supposed to be dominant at a small flow rate. The generation fluxes of water increased with the increasing degree of tube wall superheat. Nucleate boiling is supposed to occur at a wall superheat of 20K for a smooth tube, and at 10K for a knurled tube. The increased performance of the knurled tube was supposed to mainly come from the effect of the increased heating surface area.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 1992년도 수공학연구발표회논문집
• /
• pp.479-489
• /
• 1992

A mathematical model for a long range water supply planning is develoted as a dynamic capacitated facility location problem, in which operation costs and two types of fixed costs are considered. The fixed costs are for water supply systems such as dams and reservoirs and for water conveyance systems of waterways or conduits from each water supply points. A Spreadsheet model is developed to support the efficiency of user interface and to implement a heuristic solution procedure. The proposed solution procedure utilizes SOLVER tool and it has been applied to a system with fictitious data but with reality and applicability in mind. As a result of the mathematical analysis, not only the most economic construction timings of surface water supply facilities and distribution systems but also the most economical water supply operating patterns are identified.