• 한국물환경학회지
• /
• 제27권2호
• /
• pp.228-234
• /
• 2011

The goal of water quality management on stream and watershed is to focus not on discharged loads management but on a water quality management. Discharged loads management is not goal of water quality management but way for perform with total maximum daily loads management. It is necessary to estimate the relation between non-point source with stromwater runoff (NPSSR) and water quality to select a watershed where it is required to manage NPSSR for water quality improvement. To evaluate the effects of NPSSR on stream's water quality, we compare the aspects of water quality in dry and wet seasons using flow duration curve analysis based on flow rate variation data by actual surveying. In this study we attempt to quantify the variation characteristic of water quality and estimate the Inflow characteristic of pollution source with water quality and flow rate monitoring on 10 watersheds. We try to estimate water quality and flow rate by regression analysis and try again regression analysis with each high and low water quality data more than estimations. An analysis of relation between water quality and flow rate of 10 watersheds shows that the water quality of the Nonsan and the Ganggyeong streams had been polluted by NPSSR pollutants. Other eight streams were important point source more than NPSSR. It is wide variation range of $BOD_5$ also high average concentration of $BOD_5$. We have to quantify water quality variation by cv1 in wet season and cv365 in dry season with comparing the estimate of high water quality and low water quality. This method can be used to indicator for water quality variation according to flow rate.

• 한국분무공학회지
• /
• 제9권4호
• /
• pp.1-8
• /
• 2004

Breakup characteristics of liquid sheets formed by the impingement of two water jets, such as a breakup length and a breakup wavelength of sheet, were investigated as increasing the injection velocity up to 30m/s and the ambient gas pressure up to 4.0MPa. While round edged orifices formed a laminar sheet which has no waves on the sheet when the injection velocity is low, sharp edged orifices formed a turbulent sheet which has impact waves irrespective of the injection velocity. Thus we compared the differences of breakup characteristics between them. The results showed that the aerodynamic force significantly affects the breakup of laminar sheet when the gas based Weber number is higher than unity, It was also found that the turbulent sheets have three breakup regimes, i.e. expansion regime, wave breakup regime and catastrophic breakup regime according to the gas based Weber number.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2004년도 제22회 춘계학술대회논문집
• /
• pp.173-179
• /
• 2004

Breakup characteristics of liquid sheets formed by the impingement of two water jets, such as a breakup length and a breakup wavelength of sheet, were investigated as increasing the injection velocity up to 30m/s and the ambient gas pressure up to 4.0㎫. While round edged orifices formed a laminar sheet which has no waves on the sheet when the injection velocity is low, sharp edged orifices formed a turbulent sheet which has impact waves irrespective of the injection velocity. Thus we compared the differences of breakup characteristics between them. The results showed that the aerodynamic force significantly affects the breakup of laminar sheet when the gas based Weber number is higher than unity. It was also found that the turbulent sheets have three breakup regimes, i.e. expansion regime, wave breakup regime and catastrophic breakup regime according to the gas based Weber number.

• Journal of Mechanical Science and Technology
• /
• 제17권4호
• /
• pp.562-570
• /
• 2003

This experimental study concerns the characteristics of vortex flow in a concentric annulus with a diameter ratio of 0.52, whose outer cylinder is stationary and inner one is rotating. Pressure losses and skin friction coefficients have been measured for fully developed flows of water and of 0.4% aqueous solution of sodium carboxymethyl cellulose (CMC), respectively, when the inner cylinder rotates at the speed of 0～600 rpm. Also, the visualization of vortex flows has been performed to observe the unstable waves. The results of present study reveal the relation of the bulk flow Reynolds number Re and Rossby number Ro with respect to the skin friction coefficients. In somehow, they show the existence of flow instability mechanism. The effect of rotation on the skin friction coefficient is significantly dependent on the flow regime. The change of skin friction coefficient corresponding to the variation of rotating speed is large for the laminar flow regime, whereas it becomes smaller as Re increases for the transitional flow regime and. then, it gradually approach to zero for the turbulent flow regime. Consequently, the critical (bulk flow) Reynolds number Re$\_$c/ decreases as the rotational speed increases. Thus, the rotation of the inner cylinder promotes the onset of transition due to the excitation of Taylor vortices.

• Journal of Mechanical Science and Technology
• /
• 제15권7호
• /
• pp.941-950
• /
• 2001

A study of counter-current two-phase flow in narrow rectangular channels has been performed. Two-phase flow regimes were experimentally investigated in a 760mm long and 100mm wide test section with 2.0 and 5.0mm gap widths. The resulting flow regime maps were compared with the existing transition criteria. The experimental data and the transition criteria of the models showed relatively good agreement. However, the discrepancies between the experimental data and the model predictions of the flow regime transition become pronounced as the gap width increased. As the gap width increased the transition gas superficial velocities increased. The critical void fraction for the bubbly-to-slug transition was observed to be about 0.25. The two-phase distribution parameter for the slug flow was larger for the narrower channel. The uncertainties in the distribution parameter could lead to a disagreement in slug-to-churn transition between the experimental findings and the transition criteria. For the transition from churn to annular flow the effect of liquid superficial velocity was found to be insignificant.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2005년도 학술발표회(1)
• /
• pp.802-803
• /
• 2005

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2005년도 학술발표회(1)
• /
• pp.824-825
• /
• 2005

• Journal of Forest and Environmental Science
• /
• 제33권2호
• /
• pp.97-104
• /
• 2017

Investigation was carried out on response of Tetrapleura tetraptera (Schum. and Thonn.) to soil, water and light with the view of its domestication and introduction to different ecological regions. The experiment was arranged in a factorial experiment of $3{\times}3{\times}3$ in a completely randomized design (CRD) with three replicates. The factors were: soil textural class (Loamy sand, Sand and Sandy clay loam), watering regime (daily, twice a week and once a week) and light intensity (100%, 75% and 50%). Soil textural classes had significant influence on collar diameter, stem height, number of leaflets, root/shoot ratio and relative growth rate of Tetrapleura seedlings. Seedlings grown on loamy sand recorded the highest mean value- 2.28 mm for collar diameter, stem height- 12.9 cm, number of leaflets- 19.9, chlorophyll b- $0.34mg\;mL^{-1}$, leaf relative water content- 27.4% and relative growth rate- $0.037mg\;g^{-1}\;day^{-1}$. Watering regime had significant influence on the collar diameter of Tetrapleura. Seedlings watered daily recorded the highest mean value- 2.25 mm for collar diameter. Light intensity significantly influenced collar diameter and root/shoot ratio. Seedlings exposed to 100% light intensity recorded higher mean value for collar diameter- 2.28 mm and root/shoot ratio- 1.481 cm. The interaction between soil textural class and light intensity significantly affected collar diameter, stem height and number of leaflets. Higher mean value for collar diameter (2.47 mm) stem height (13.25 cm) and number of leaflets (21.16) were recorded while the interaction between soil textural class, light intensity and watering regime was significant for only number of leaflets. Tetrapleura exhibited some level of tolerance to different soil texture, drought and light intensity. Therefore, Tetrapleura has the potentials to be raised in different ecological zones characterized by difference in soil, rainfall and amount of sunshine.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2017년도 학술발표회
• /
• pp.518-518
• /
• 2017

4대강 사업 이후, 하천변의 환경에 많은 영향과 변화가 있었다. 그 중에서도 하천을 포함한 수변환경의 식생 변화에 가장 큰 영향을 주는 수문학적 조건이 변화하였고, 이에 따른 식생 천이가 지속적으로 발생할 것이기 때문에 그 영향을 분석하는 것이 시급한 과제이다. 이에 따라서, 본 연구의 목적은 수문학적 조건에 따른 하천변의 식생조건의 변화를 분석하는 것으로서, 수문학적 조건의 정량화를 위한 연침수확률(IEPs) 개념을 새로이 제시하고 이에 따른 수변환경과 식생의 변화를 한강에 위치한 비내섬을 대상으로 고찰하였다. 연구 결과에 따라서 P=0.08 이나 그 이하의 IEPs를 가진 구역은 식생 교란이 일어나거나 또는 친수성 식물로서 천이될 것으로 나타났다. 따라서, 하천과 유량에 대한 주무기관이 하천환경에 대해서도 관리업무를 통하여 하천보호를 수행하여야 할 것으로 판단된다.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1997년도 추계학술발표회논문집(1)
• /
• pp.546-551
• /
• 1997

This paper presents a prediction of critical heat flux (CHF) in bubbly flow regime using dry-spot model proposed recently by authors for pool and flow boiling CHF and existing correlations for forced convective heat transfer coefficient, active site density and bubble departure diameter in nucleate boiling region. Without any empirical constants always present in earlier models, comparisons of the model predictions with experimental data for upward flow of water in vertical, uniformly-heated round tubes are performed and show a good agreement. The parametric trends of CHF have been explored with respect to variations in pressure, tube diameter and length, mass flux and inlet subcooling.