• Journal of Advanced Marine Engineering and Technology
• /
• 제18권1호
• /
• pp.73-80
• /
• 1994

The water ejector is a low pressure high flow rate volumetric pump. It utilize the energy of a low mass flow, high velocity stream to induce a large mass flow, low velocity stream. In addition, it has a very good resistances to cavitation compared to the other type of pumps, and the maintenance cost is practically nil. There has been enormous energy loss to supply the upper part water of dam which has large potential energy as mere irrigation water in domestic multipurpose dam. The new type of energy saving system which developed through the present study can economizes over 950,000 kWh per year by mixing the upper part water of dam with the waste water by the large water ejector. This paper estimates the economical efficiency of the new type of irrigation water pumping system, and further more, represents the change of performance characteristics of large water ejector, which was adapted to this system, according to the fluctuation of upper water level that seasonally changes.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 The 6th International Symposium of East Asian Resources Recycling Technology
• /
• pp.555-559
• /
• 2001

A by-product, waste sludge water produced from ready mixed concrete(remicon) factories may affect our environmental contamination if it is discharged without proper waste disposal. In Korea, all waste sludge water has been recycled in the way of mixing water of remicon, but the quality of the concrete then produced can be deteriorated, so it might cause slump loss or irregular compressive strength. In this study, waste sludge water is divided into two parts, remicon sludge and residual water in order to make it's property more stable. Then, the remicon sludge and high-alkaline residual water were used as admixture and alkali activator respectively. In this paper we research about quality of with remicon sludge and residual water and performed the fundamental properties of cement matrix mixed with remicon sludge and residual water.

• 한국축산식품학회지
• /
• 제38권2호
• /
• pp.325-337
• /
• 2018

This study was conducted to evaluate the effects of pre and post-rigor marinade injections on some quality parameters of Longissimus dorsi (LD) muscles. Three marinade formulations were prepared with 2% NaCl, 2% NaCl+0.5 M lactic acid and 2% NaCl+0.5 M sodium lactate. In this study marinade uptake, pH, free water, cooking loss, drip loss and color properties were analyzed. Injection time had significant effect on marinade uptake levels of samples. Regardless of marinate formulation, marinade uptake of pre-rigor samples injected with marinade solutions were higher than post rigor samples. Injection of sodium lactate increased pH values of samples whereas lactic acid injection decreased pH. Marinade treatment and storage period had significant effect on cooking loss. At each evaluation period interaction between marinade treatment and injection time showed different effect on free water content. Storage period and marinade application had significant effect on drip loss values. Drip loss in all samples increased during the storage. During all storage days, lowest CIE $L^*$ value was found in pre-rigor samples injected with sodium lactate. Lactic acid injection caused color fade in pre-rigor and post-rigor samples. Interaction between marinade treatment and storage period was found statistically significant (p<0.05). At day 0 and 3, the lowest CIE $b^*$ values obtained pre-rigor samples injected with sodium lactate and there were no differences were found in other samples. At day 6, no significant differences were found in CIE $b^*$ values of all samples.

• 대한기계학회논문집B
• /
• 제38권10호
• /
• pp.797-805
• /
• 2014

본 연구의 목적은 해수 흡입구를 고려한 초공동 수중운동체 캐비테이터의 항력과 양력특성 및 해수 흡입유로의 입구에서 압력손실에 대해 예측하는 것이다. 흡입구 직경과 유로에서의 속도, 흡입구의 곡률반경 및 캐비테이터의 받음각이 미치는 영향에 대해 유동해석을 수행하였다. 연구 결과 직경비가 커지면, 항력계수와 압력손실계수가 감소하며, 속도비가 증가할 때 항력계수와 양력계수는 감소하고 압력손실계수는 증가한다. 해수 흡입구에 곡률을 주면 항력계수와 양력계수에는 영향을 미치지 않지만, 압력손실계수가 크게 감소한다. 캐비테이터의 받음각은 항력계수와 압력손실계수에 미소한 영향만을 주나, 양력계수를 크게 변화시킨다. 초공동 수중운동체 설계 시 본 연구 결과를 반영할 수 있다.

• 한국음향학회지
• /
• 제21권3호
• /
• pp.213-220
• /
• 2002

해수중에서 음파는 수심, 음속구조 및 해저지질 등의 영향을 받으면서 전파한다. 특히 천해의 경우 해수중의 음속구조는 시공간적으로 심하게 변동하고 있고, 해저지질도 공간적으토 다양하게 분포한다. 황해에 있어서 저주파 음파전파의 계절변동을 조사하기 위하여 황해의 중앙부분에 위치하는 동일한 정선에서 봄철, 여름철, 가을철 등 서로 다른 계절에 저주파 광대역 음원을 이용하여 음파 전파실험을 실시하였다. 그리고 이 때에는 수중음파 전락환경을 파악하기 위하여 해수중 음속구조를 측정하였다. 이 논문에서는 황해에 있어서 음속구조 및 음파 전달손실의 측정결과에 관하여 고찰하였고, 음파 전달손실의 계절변동을 조사하였다. 그 결과 여름철에 측정된 전달손실은 봄철 및 가을철에 측정된 전달손실보다 크게 나타났고, 가을철에 측정된 전달손실은 봄철에 측정된 전달손실보다 다소 작게 나타났다. 그리고 계절에 의한 전달손실의 차이는 주파수 및 전파거리의 증가와 함께 증가하였다.

• Journal of Periodontal and Implant Science
• /
• 제26권1호
• /
• pp.230-243
• /
• 1996

Root surface exposure due to gingival recession after periodontal surgery, dentin exposure after root planing elicit pain response when exposed to mechanical, heat, chemical or osmotic stimulation. Especially, patients treated with periodontal surgery, show high frequency and there have been reports showing the 1 out of 7 patients have dentin hypersensitivity. There have been many studies on the clinical effects of various materials on the treatment of dentin hypersensitivity. but, none could provide absolute clinical efficacy. In this study, 45 teeth from 30 patients, who had had periodontal surgery and showed dentin hypersensitivity after surgery were chosen for the experimental group and they were illuminated with laser, 15teeth were chosen for the control group and they were not exposed to laser. After this dentin hypersensitivity was elicited by tactile, compressed air, cold water and then, the degree was evaluated using NRS(Numerical Rating Scale). And during LLLT(Low Level Laser Therapy) semiconductor laser using Gallium - Arsenide as a diode was illuminated for 180 seconds at a frequency of 7(500Hz). This therapy was done 10 times, and each time the changes in dentin hypersensitivity was evaluated using NRS. The results were as follows : 1. After treat with LLLT on dentin hypersensitivity due to periodontal surgery, 22.2% showed total loss of dentin hypersensitivity, 60.0% showed loss of tactile dentin hypersensitivity, 48.8% showed loss of compressed air dentin hypersensitivity, 22.2% showed loss of cold water dentin hypersensitivity. 2. As a result of clinical evaluation of dentin hypersensitivity using NRS, there was significant increase in improvement of dentin hypersensitivity in the experimental group compare to the control group(P<0.05). And there was almost no natural loss of dentin hypersensitivity in the control group. 3. In comparison of the stages of evaluation, there was significant difference in between experimental and control group. after the second visit(P<0.05), and the difference increased with each visit.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2011년 춘계학술대회논문집
• /
• pp.269-274
• /
• 2011

A CFD analysis was performed to examine the inner channel blockage of dual-cooled fuel which has being developed for the power uprate of a pressurized water reactor (PWR). The dual-cooled fuel consists of an annular fuel pellet($UO_2$) and dual claddings as well as internal and external cooling channels. The dual-cooled annular fuel is different from a conventional solid 려el by employing an internal cooling channel for each fuel pellet as well as an external cooling channel. One of the key issues is the hypothetical event of inner channel blockage because the inner channel is an isolated flow channel without the coolant mixing between the neighboring flow channels. The inner channel blockage could cause the Departure from Nucleate Boiling (DNB) in the inner channel that eventually causes a fuel failure. This paper presents the CFD simulation of the flow through the side holes of the bottom end plug for the complete entrance blockage of the inner channel. Since the amount of coolant supply to the inner channel depends on largely the pressure loss at the side hole, the pressure loss coefficient of the side hole was estimated by the CFD analysis. The CFD prediction of the loss coefficient showed a reasonable agreement with an experimental data for the complete blockage of both the inner channel entrance and the outer channel. The CFD predictions also showed the decrease of the loss coefficient as the outer channel blockage increases.

• Asian-Australasian Journal of Animal Sciences
• /
• 제29권1호
• /
• pp.100-108
• /
• 2016

In this study, a survey was conducted to both evaluate the consumers' general attitudes for purchasing and storing the raw chicken and determine the thawing practices used for defrosting frozen chicken at home. About 75% of the consumers indicated purchasing chicken meat at least once a week or more. Furthermore, the majority (82.16%) of those who stored at least a portion of the raw chicken stated freezing the raw chicken meat at home. Freezing the chicken meat was considered to have no effect on the quality by 43.49% of the consumers while 56.51% thought that freezing had either negative or positive effects on the quality. The survey study indicated that top five most commonly used thawing practices included thawing on the kitchen counter, thawing in the refrigerator, thawing in the warm water, thawing in the microwave, and thawing under tap water. In addition, an experimental study was conducted to determine the effects of these most commonly used thawing practices on some quality characteristics of the chicken meat including pH, drip loss, cooking loss, color analysis and textural profile analysis. Although, $L^*$ value for thawing on the kitchen counter was the lowest, after cooking, none of the thawing treatments have a significant effect on the color values. Thawing in the microwave produced the highest drip loss of 3.47% while the lowest drip loss of 0.62% was observed with thawing in the refrigerator. On the other hand, thawing in the microwave and refrigerator caused the lowest cooking loss values of 18.29% and 18.53%, respectively. Nevertheless, there were no significant differences among textural parameter values of the defrosted and then cooked samples using the home based thawing practices, indicating similar quality characteristics among the samples.

• Fisheries and Aquatic Sciences
• /
• 제25권4호
• /
• pp.214-230
• /
• 2022

Loss and damage have become a vital contemporary issue in climate change studies and actions in developing countries. However, studies are scant on this in the fisheries sector around the world. In Bangladesh, there is no study on the loss and damage in fisheries dependent communities. This study assesses economic and non-economic loss and damage to coastal shrimp farms due to cyclone Bulbul in Gabura Union of Shyamnagar Upazila, Satkhira district, using a mixed method approach. Results show that all shrimp farms' dependent communities are affected by cyclone Bulbul to some extent. About 14%, 57%, and 29% of the farms were totally, heavily and moderately damaged due to farm inundation and dyke damage. The estimated mean loss and damage per shrimp farm was worth USD 4,633. Around 31% and 72% of the farms' fencing nets and traps were lost, which was worth USD 333 per farm. There were also loss and damage to other resources such as houses, solar panels, livestock and agricultural crops where the estimated mean loss and damage per household was worth USD 3,170. This study reported that the rich shrimp farmers encountered proportionately more economic loss and damage than their poor counterparts. However, this does not mean that the poor suffered less. The current study found a range of non-economic loss and damage in different aspects of the shrimp farmers' household members such as unbearable mental pain, deterioration of health, physical injuries, disabilities, etc. and access to services (e.g., inadequate food, lack of safe drinking water, lack of medical facilities, disruption of education systems), social infrastructure (e.g., damage of roads and markets) and disturbance of cultural functions. The findings suggest that urgent short- and long-term actions may be taken to save the aquaculture farms and dependent livelihoods from economic and non-economic loss and damage to cyclones in future.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2007년도 춘계학술대회A
• /
• pp.102-107
• /
• 2007

The steel impeller placed in a water pump has been studied with the aim to understand corrosion phenomena on the surface responsible for reducing the pumping efficiency of water inside cooling system. This preliminary experiment includes a period (around 1 month) observation with a powered microscope and weight measurements. The experiments are carried out at different conditions of water and mixtures of water and coolants, based on the water contents of 25%, 50%, 75%, and 100% water (pure tap water). From the visual results of microscopy, most of the steel surface is fitted and clear rusty or corrosion phenomena are noticeable as time goes. In addition, the weight loss of the sample specimen submerged in the water is linearly increased, whereas those in the mixtures of water initially gain weight and become almost constant.