• Proceedings of the KIEE Conference
• /
• 1987.11a
• /
• pp.499-503
• /
• 1987

The electrical characteristics of Epoxy Robin vary with temperature. In this study, the variation of the electric characteristics of Epoxy Resin with various hardening temperature was studied. Epoxy Resin used as samples are Epotohto YD-128 of Diglycidyl Ether of Bisphenol A (DGEBA) series and hardener, Goodmide G-240. It's mixing rate is 3 to 1. Hardening temperature was varied from 25[$^{\circ}C$] to 50[$^{\circ}C$] by 5[$^{\circ}C$]. During the hardening progress, illumination, resistivity and the internal temperature of material which were dependet on the variety of hardening temperature were measured. The electrical properties of hardened samples were examined by means of X-ray diffraction, tan $\delta$ test, TG-DTA analysis and treeing test. On this basis, optimal hardening temperature in insulation characteristics was examined.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2008.05a
• /
• pp.517-520
• /
• 2008

Recently, use of adhesive bonding technology is increased to achieve the multi-material design for lightweight structure in automobile industry. In this paper, the fracture strength of adhesive has been studied with the single lap shear test conducted at different temperatures. The joint specimens are made from Al 5052 and SPRC 440 bonded with structural epoxy adhesive. The operating temperature has been considered up to $150[^{\circ}C]$ and the single lap shear test has been conducted with 5mm/min tensile rate. Fracture strength of adhesive bonded joint has been decreased with increase of operating temperature. The fracture strength at the $100[^{\circ}C]$ was shown about half of that at room temperature.

• Proceedings of the SAREK Conference
• /
• 2008.11a
• /
• pp.310-315
• /
• 2008

In this study, experimental study on the heating performance of a $CO_2$ heat pump water heater with a variation of operating conditions such as refrigerant charge amount, outdoor temperature, compressor frequency, EEV opening and water mass flow rate. Based on the test results, the optimum charge amount was 1800 g. At the water mass flow rates of 75, 85, 95 kg/hr, the water heating temperature was 62, 67, $74^{\circ}C$ and COP was 2.6, 2.8, 3.0, respectively. Besides, the water mass flow rate and compressor frequency were varied to maintain above the water heating temperature of $60^{\circ}C$ with the decrease of outdoor temperature. So, The compressor frequency increased beyond 65 Hz and the water mass flow rate was 45 kg/hr at the outdoor temperature of $-13^{\circ}C$, 65 kg/hr at $-8^{\circ}C$, 75 kg/hr at $-3^{\circ}C$ and 85 kg/hr at 2, $7^{\circ}C$. As the outdoor temperature decreased, the heating COP decreased by 2.5-39.8%.

• Korean Journal of Materials Research
• /
• v.3 no.2
• /
• pp.197-204
• /
• 1993

Abstract The effects of the hole size and the specimen width on the fracture behavior of several fabric composite plates are experimentally investigated in tension. Tests are performed on plain woven glass/ epoxy, plain woven carbon/epoxy and satin woven glass/polyester specimens with a circular hole. It is shown in this paper that the characteristic length according to the point stress criterion depends on the hole size and the specimen width. An excellent agreement is found between the experimental results and the analytical predictions of the modified failure criterion. The notched strength increase with an increase in the damage ratio, which is explained by a stress relaxation due to the formation of damage zone. When the unstable fracture occurred, the critical crack length equivalent for the damage zone is about twice the characteristic length. The critical energy release rate $G_c$ is independent of hole size for the same specimen width. The variation of $G_c$ according to the material system, fiber volume fraction and specimen width relates to the notch sensitivity factor. $G_c$ increases with a decrease in the notch sensitivity factor, which can be explained by a stress relaxation due to the increase of damage zone.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.143.1-143.1
• /
• 2012

We attempt to investigate the main reason of the asymmetrical light curves of contact and near-contact eclipsing binary base on the hypothesis that cool spot was produced on late type star while hot spot was produced from transferred material from their companion star hitting surface. We select 7 eclipsing binary systems which showed asymmetric light curves and mass transfer. Period variation and mass transfer rate were obtained from O-C diagram. Radial velocity curves and light curves of those 7 eclipsing binary system were adopted from available literature in order to obtain the absolute dimension. For four contact eclipsing binary system (AD Phe, EZ Hya, AG Vir and VW Boo), their component stars belonged to spectral type G to K was fitted by cool spot model. While the other two near-contact systems (RT Scl and V1010 Oph) and one contact system (SV Cen) was fitted by cool spot model. The densities of the materials are adopted from stellar model which calculate by stellar structure code. The calculated spot temperature turns out to agree with the photometric solution but there are no correlate between period variation rate and type of spot.

• The Korea Journal of Herbology
• /
• v.32 no.6
• /
• pp.41-48
• /
• 2017

Objectives : This study was designed to estimate the antioxidative and neuroprotective effects of Torreyae Semen hot water extracts (TS). Methods : Torreyae Semen was extracted by hot water for 2 hours with a temperature of 105 degrees. Polyphenols and total flavonoid were measured and LC-MS/MS was used to certificate anticipated antioxidative compounds. The antioxidant activities of TS were measured as scavenging effects of 1,1-Diphenyl-2-picrylhydrazyl (DPPH) and Nitrite Oxides (NO). Cell viability and proliferation rate was measured MTT assay. The toxicities to thymocytes and splenocytes were evaluated by the proliferation rate of primary cultured cells of 7 weeks, male Balb/c mice. The antioxidant activities of TS on C6 mouse glioma cells were measured by the analysis of total glutathione contents variation. The neuroprotective effects against oxidative stresses were measured by MTT assay. Results : Polyphenols of TS was $92.00{\pm}1.24{\mu}g/mg$, and total flavonoids was $0.36{\pm}0.14{\mu}g/mg$. TS includes gallocatechin, epigallocatechin, gallocatechin gallate and epigallocatechin gallate. TS included gallocatechin, epigallocatechin, gallocatechin gallate, epigallocatechin gallate. TS showed DPPH and NO scavenging effects as dose-dependent manner at the concentrations of $0-10mg/m{\ell}$. In MTT assay, TS shows no significant toxicity to C6 cells, primary cultured thymocytes and splenocytes of Balb/c mice. TS increased the level of total glutathiones. TS increased cell viabilities of C6 cells against oxidative stresses such as $H_2O_2$, sodium nitroprusside (SNP), Rotenone at the concentrations of $0-0.063mg/m{\ell}$. Conclusions : TS shows the antioxidant and neuroprotecitive effects in these experiments.

• Resources Recycling
• /
• v.11 no.4
• /
• pp.44-50
• /
• 2002

Characteristics on the sulfuric acid leaching of zinc and manganese from the spent zinc-carbon battery powders obtained by cushing and magnetic separation, were investigated with the variation of sulfuric acid concentration, reaction temperature, stir-ring speed and solid/liquid ratio. The sample powders were composed of Zn metal, ZnO, $MnO_2$ and $Mn_2$$O_3$. and it was found that the selective leaching of zinc was difficult in this system. At the condition of S/L ratio 1:10, IM H$_2$$SO_4$, $60^{\circ}C$ and 200 rpm, leaching rate of Zn and Mn are 92% and 35% respectively. The concentration of Zn and Mn in the leaching solution are 19.5 g/l, 7.8 g/l and pH of that solution is 0.75. It was confirmed at reducing agent should be added to increase e leaching rate of manganese with sulfuric acid.

• Food Science and Biotechnology
• /
• v.15 no.5
• /
• pp.773-777
• /
• 2006

Growth of Bacillus cereus was assessed during the storage of seasoned soybean sprouts at 0,5, 10, and $15^{\circ}C$. No lag time in its growth curve was observed and thus the specific growth rate of B. cereus in the exponential growth phase was estimated for bootstrapped microbial count data. The distribution of the specific growth rate could be explained by the BetaGeneral distribution function, and temperature dependence was described by the Ratkowsky square root model. The temperature dependence of the growth could be successfully incorporated into the differential equation of microbial growth to predict the B. cereus count on the seasoned soybean sprouts under fluctuating temperature conditions. Safe shelf lives with different probabilities to reach $10^5\;CFU/g$ were presented at four different temperatures, considering the variation in initial contamination and specific growth rate by the Monte Carlo method and 2-step bootstrapping, respectively. Safe shelf lives defined as the time with a probability of less than 0.1% of reaching the critical limit, were 13.4, 5.2, 3.6, and 2.8 days at 0, 5, 10, and $15^{\circ}C$, respectively.

• Journal of Ocean Engineering and Technology
• /
• v.12 no.2 s.28
• /
• pp.111-120
• /
• 1998

Laboratory settling experiments (column, recirculating flume) were conducted for further understanding of the physical processes of cohesive sediment transport. \In still water experiments, the growth rate of flocculation is dependent upon the initial suspended concentration. Consequently, the settling velocity increases with concentration of flees. In flocculation settling regime, the exponent n in the settling velocity, $w_s=kC^n$, for Nakdong estuary mud was obtained empirically. The exponents were found to be 1.33, and 1.06 for the initial suspended concentrations of 1 g/i and 3 g/t, respectively. In flowing water, experiments for the median settling velocity with Nakdong mud in a recirculating flume were conducted. Settling velocity was found to depend much more strongly on the current velocity than initial concentrations. The temporal variation of suspended concentration increases as current velocity decreases.

• Journal of Food Hygiene and Safety
• /
• v.10 no.2
• /
• pp.111-131
• /
• 1995

Quality changes of sausages in refrierated storage for 60 days were investigated. Nine types of sausages produced in Korea were stored at 4$^{\circ}C$(3~5$^{\circ}C$), and then chemical, microbiological, and sensory characteristics were evaluated on every 10 days. The proximate analysis showed considerable variation in fat (23.97%, 17.10~30.20%) with less variation in moisture (51.96%, 48.10~56.30%) and protein (12.96%, 11.40~13.95%), pH value decreased over time averaging from 6.31 to 6.22 with no significant difference. Water activity was consistent over refrigerated storage averaging 0.95. Volatile basic nitrogen (VBN) values were still within 20 mg% though VBN for all types significantly increased over time (p<0.05). Thiobarbituric acid (TBA) values were well below 1.0 though TBA showed significant differences among storage periods (p<0.05). Standard plate counts (SPCs) significantly increased during storage (p<0.05) while coliform group was not counted in all cases. SPCs reached 104 CFU/g in two types after 50 days' storage and were below 105 CFU/g in all types after 60 days' storage. Instrumental texture analysis showed that springiness, adhesiveness, and hardness signficantly decreased over time (p<0.05) while no change was observed in external color. significantly decreased over time the 60-day storage period (p<0.05) while cohesiveness, chewiness and gumminess did not change. Lightness, redness and yellowness of the internal Hunter color significantly decreased over time (p<0.05) while no change was observed in external color. Sensory profile showed that flavor, taste, texture and overall acceptable after 60 days' storage at 4$^{\circ}C$. However, the shelf-life of the samples should be decided in the consideration of the growth rate other spoilage flora coupled with the bacterial growth after 50 days' storage.