• Title/Summary/Keyword: VHF Antenna

Search Result 72, Processing Time 0.03 seconds

Improvement of Short Range Performance of Meteor Burst Path with Buried Antenna (지하 매설형 안테나를 이용한 근거리 유성 버스트 통신의 특성개선)

  • 김병철;김기채;이무영
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.9 no.6
    • /
    • pp.788-801
    • /
    • 1998
  • Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed ; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antennal beam width to cover entire hot-spot region in the space and, by compensating effective burst length throughcutting down man-made noises introduced by antennal. Based on the analysis, we are developed a small-opening-cavity antennal, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antennal exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antennal under same testing condition.

  • PDF

Development of a New Vehicle Detector Combining CW Radar and Magnetometer Techniques (CW 레이다와 자계기술을 복합한 새로운 차량검지기 개발)

  • 정재영;김인석
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.10 no.4
    • /
    • pp.564-581
    • /
    • 1999
  • This paper introduces a new, small, low cost, robust and quick replaceable pavement-based vehicle detector using CW radar, magnetometer, and UHF small antennal techniques. The detector has been developed for a replacement of loop detectors having wide surface areas, for a more accurate operation under all weather conditions, and for no algorithmic change of the existing traffic information system. The detected vehicle information is sent by a small helical antenna embedded in a plastic material and received by a 5/8 $\lambda$ long GP antenna for signal processing. In a relatively good weather condition, the detector operates at 24 GHz. But in a heavy rain condition, magnetometer is activated by automatic switching.

  • PDF

Designing a Wideband Antenna Using Diplexer Matching Network for Tactical Vehicles (다이플렉서 정합구조를 이용한 전술차량형 광대역 안테나 설계)

  • Cho, Ji-Haeng;Dong, Moon-Ho
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.29 no.9
    • /
    • pp.661-667
    • /
    • 2018
  • Tactical communication radio systems that employ software defined radios(SDRs) have been developed for achieving high-speed data transmissions and voice communications. Such systems possess multiband and multichannel features, and can potentially replace several existing radio systems. This paper proposes a design for wideband antennas by incorporating a diplexer matching network for tactical vehicles. The proposed antenna design includes two radiators(upper and lower) and a diplexer matching network connected to the end of the feed line such that the LC matching networks are interleaved in the lower radiator and spring mount. By employing the diplexer matching network, the designed antenna can perform wideband impedance matching for the fifty ohm feed line. The designed LC networks aid in varying the effective electrical length of the antenna according to the operation frequency. The primary objective behind adjusting the electrical length is to vary the current distribution above and below the LC networks. The proposed antenna was fabricated and tested in an open site. The obtained evaluation results show that the designed antenna can achieve a relative bandwidth of 190% with a VSWR value of 3.5:1, and can attain good antenna gains over VHF and UHF bands.

A Study on optimal ERP and HAAT of antenna for the 8-VSB DTTB (8-VSB DTTB의 최적 ERP와 안데나 HAAT에 관한 연구)

  • 김선미;박근희;류광진;김영곤;노순국;박창균
    • Proceedings of the IEEK Conference
    • /
    • 2001.06a
    • /
    • pp.365-368
    • /
    • 2001
  • 현재 운용중인 NTSC송신시스템을 근거로 가까운 장래에 설치되어 운용될 8-VSD DTV전송시스템의 재원을 설계한다. 먼저 아나로그 NTSC와 디지털 8-VSH DTV의 지상파 방송의 경우 최적의 수신전계를 유지할 수 있는 조건을 검토하고, Longley-Rice의 전계강도 산출법을 이용해서 수신을 위한 최소한의 전계강도의 임계값을 산출한다 8-VSH DTV전송은 NTSC 6MHz대역에서 HDTV가 가능하도록 19.39Mbps의 데이타를 고속으로 전송하는데 그 목표fmf 두고 있으므로 무엇보다 송 · 수신점 사이의 전계강도의 최적화는 중요한 문제이므로 8-VSB DTV전송은 NTSC 서비스 커버리지에 비하여 확장되거나 효율적이어야만 한다. 본 연구에서는 산출결과 NTSC가 8-VSH DTV와 동일한 서비스 커버리지를 유지하기 위하여 NTSC VHF에서 DTV UHF로 전환시 필요한 송신출력과 NTSC UHF에서 DTV UHF로의 전환시 필요한 송신출력을 산출한다.

  • PDF

A Study on the construction of Broad-Band Twisted-Wire Quadrature Hybrid (광대역 Twisted-Wire Quadrature Hybrid 회로구성에 관한 연구)

  • 박정기;김성진
    • Journal of the Korean Institute of Telematics and Electronics
    • /
    • v.17 no.6
    • /
    • pp.78-85
    • /
    • 1980
  • A symmetrical 3-dB quadrature hybrid circuits, consisting mainly of bifilar pair of taitoted wires, is described. A cascade of two such hybrid circuits can achieve an octave bandwidth hybrid circuit with a small coupling loss. Since the proposed type is simple, compact, and low In cost 1 its applicarion may be preferred to the more common coaxial line or printed -circuit type hybrid version in the frequency region below 1 GHz. This study provides a design method for a hybrid circuit mixing two different antenna signals for the anti - ghosting of television signal.

  • PDF

The distance and polarization characteristics of electromagnetic wave radiated at needle-to-plane electrodes in Air and complex dielectric (공기 및 복합유전체 갭에서의 방사전자파의 거리 및 편파특성)

  • 김충년;이현동;박광서;박원주;이광식;이동인;이동헌
    • Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
    • /
    • 2000.11a
    • /
    • pp.241-245
    • /
    • 2000
  • In this paper, VHF(30~230[MHz]) electromagnetic waves radiated from partial discharge(PD) at two-type electrodes in air are measured and the peculiar patterns of their spectra are reported. Also, the polarization and distance characteristics of electromagnetic wave rediated by PD, were investigated. In case of epoxy insulator in inserted, the noise level of radiated electromagnetic waves is 0.6~6.2[dB] higher than the case in air at below 90[MHz]. The frequency spectrum distribution of radiated electromagnetic waves appears different in the whole frequency range according to the arrangement of antenna.

  • PDF

A Study on the 3D Characteristics of Lightning in KOREA (한반도내 낙뢰의 3차원 특성에 관한 연구)

  • Woo, J.W.;Kwak, J.S.;Kang, Y.W.;Kwon, D.J.;Moon, J.D.
    • Proceedings of the KIEE Conference
    • /
    • 2006.07c
    • /
    • pp.1556-1557
    • /
    • 2006
  • Since 1996, KEPCO has been operating a wide range lightning detection system, LPATS, and been accumulating relative application technics and statistical analysis skills. So, KEPRI already has its own basis to develope more accurate advanced detection technology and references to do comparative study. For Three-dimensional imaging of lightning channels, UHF/VHF antenna systems were installed at 2 sites. The distance between two sites is about 30 km. In this paper, we would like to introduce about our system and its results.

  • PDF

A Design of UHF Sensor using Partial Discharge Measurement in GIS (부분방전 측정용 UHF센서의 설계)

  • Park, K.S.;Kim, J.B.;Song, Y.P.;Kim, D.S.
    • Proceedings of the KIEE Conference
    • /
    • 2002.11a
    • /
    • pp.28-30
    • /
    • 2002
  • The PD in GIS leads to a charge transfer and a voltage drop across the discharge area. They cannot be measure directly but we can measure electromagnetic wave made by PD. In generally, compared with VHF band, electromagnetic waves of UHF band have a low noise therefore, we can detect the real defect with several pC in GIS using UHF method. In this paper, the U-slot microstrip patch antenna for measuring PD signal in GIS is presented. the proposed UHF sensor are designed to have large band characteristics and unaffected structure for GIS operation.

  • PDF

UHF Narrow Band Type Partial Discharge Diagnosis Method for the Internal Insulation Performance Verification of the Gas Insulated Switchgear (가스절연 개폐장치의 내부절연 성능검증을 위한 UHF 협대역 부분방전 진단법)

  • Song Won-Pyo;Kim Jung-Bae;Kim Min-So;Jung Jae-Ryong;Park Seung-Jae;Ko Heui-Suk
    • The Transactions of the Korean Institute of Electrical Engineers C
    • /
    • v.54 no.9
    • /
    • pp.414-420
    • /
    • 2005
  • A method for partial discharge diagnosis based on UHF narrow band type for GIS has been developed and calibrated. In generally, PD cannot be directly measured under on-line condition, but we can indirectly measure the electromagnetic wave made by PD using the high-frequency antenna. Compared with VHF band, electromagnetic waves of UHF band have a low influence for external noise in high-voltage substation. Therefore, we can detect the real abnormality with several pC in GIS using UHF narrow-band type method. For the case of no internal VHF sensor for GIS of the domestic substation, it has applied to use the external UHF sensor attached in spacer in GIS of existing substation. In this paper, we firstly described the technique of partial discharge measurement using frequency analysis and phase analysis in UHF band. Secondly, we presented the results of sensitivity test, the relationship of dBm-pC and diagnosis result of the cause of PD source by phase analysis. And then, we report the diagnosis result of partial discharge on the real GIS in domestic substation. These results make above method applicable for measurement of quantity and cause of PD for real operation GIS in high-voltage substation.

Implementation of Modular 3-Band RF for Disaster Voice Communication (재난음성통신을 위한 Modular 3-Band RF 개발)

  • Park, Jin-Hee;Lee, Soon-Hwa
    • The Journal of the Institute of Internet, Broadcasting and Communication
    • /
    • v.13 no.6
    • /
    • pp.23-28
    • /
    • 2013
  • Because characteristics of diversity, large-scale and unpredictability of disaster are very difficult to make predict of disaster, rapid disaster response activity is important to reduce damage from disaster. Therefore emergency communication technology is essential to information sharing between field personnel in the field. Because the heterogeneous radios defined as some of 100MHz VHF, 400MHz UHF, and 800MHz emergency communication RF band are used in Korea, the field personnels need to have multiple radios. In order to use one radio per personnel, radio voice intercommunication is very necessary. We study on modular 3-Band RF to communicate between heterogeneous radios through single multi-band antenna and verify scalable of the number of equipped radios.