• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.3A
• /
• pp.157-165
• /
• 2003

The purpose of this paper is to analyze the performance requirements of wireless systems on ultra wide band, which is set by FCC(Federal Communications Commission). Normally the calculation of performance requirements is used in the standard form of each communication systems, but there is no standard in the wireless systems on Ultra WideBand. Therefore, I derive each system parameters through the analysis of new system performance on the basis of the method of Indoor Communication Systems. Additionally, I compare the conditions that are given by FCC with resolution of the performance by domestic law.

• Journal of the Optical Society of Korea
• /
• v.16 no.3
• /
• pp.288-291
• /
• 2012

We designed an ultra-wide band-pass filter applicable to microwave reflectometry for KSTAR (Korea Superconducting Tokamak Advanced Research) and to microwave photonics. The proposed ultra-wide band-pass filter exhibits a metamaterial structure characterized by a wide band, low insertion loss, and high skirt selectivity. The proposed filter is applied to enhance the linearity of reflectometry at the output of a VCO (voltage controlled oscillator). The pass-band of the proposed filter is observed at 18~28 GHz, and the out-of-band rejection is below 20 dB. Further, we constructed an unwrapped negative phase of S(2, 1) to verify the characteristics of the metamaterial. The under- and upper-band at lower limits of the pass-band are left- and right-handed, respectively. The group delay of the filter is less than 0.5 ns.

• Smart Media Journal
• /
• v.8 no.4
• /
• pp.85-90
• /
• 2019

The Ultra-Wide Band sensor is widely used as a wireless indoor localization technology with frequency bands in the GHz range. Meanwhile, in museums, not only the real-time location of visitors but also information on visit route and duration time is required for patrons' behavior analysis. In this paper, the analysis system based Ultra-Wide Band radar for visitor's viewing behavior is introduced and experimented in the real environment. We built the system in National Museum of Korea, and its 22 Ultra-Wide Band radar sensors receive the real-time location of their visitors: this analyzes the visit route and visit time for patrons.

• Journal of Communications and Networks
• /
• v.5 no.4
• /
• pp.290-302
• /
• 2003

Ultra wide band (UWB) radio has recently attracted increased attention due to its expected unlicensed operation, and potential to provide very high data rates at relatively short ranges. In this article we briefly describe some main candidate multiple access and modulation schemes for UWB communications, followed with their power spectral density calculation and properties. We also present some illustrative capacity results, and provide a discussion of the impact of network topology on multiple access capacity.

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.529-532
• /
• 2003

본 논문은 UWB(Ultra Wide-band) 통신 시스템에서 효과적인 신호 검출 알고리즘을 제안한다. UWB 통신 시스템은 차세대 통신 시스템으로 각광 받고 있는 기술로써, 매우 낮은 파워의 송신 신호를 사용한다. 그로 인해 잡음 및 다중 경로 환경하에서 신호 검출 알고리즘이 시스템 성능에 매우 중요한 부분으로 작용한다. 제안된 알고리즘은 신호 검출 성능을 높이기 위해, 신호의 정확한 위치를 잡는 Tracking과정에서 사용되는 DLL 구조를 활용하여 보다 세밀한 신호 탐색이 가능하다. 실험 결과 신호 위치를 기준으로 신호길이의 1/3 내에서 신호를 검출할 확률이 AWGN 15dB 이하에서 30% 정도 높아짐을 확인하였다.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.2
• /
• pp.213-219
• /
• 2015

In this paper, we present a low-profile ultra-wide band half-wavelength loop antenna for UAV (Unmanned Aerial Vehicle) applications. The proposed antenna has an ultra-wide band using self-complementary principle. Also, the ground was located between radiators for reducing height of the antenna using image theory. Dimensions of proposed antenna have $0.20{\lambda}_L{\times}0.14{\lambda}_L{\times}0.16{\lambda}_L$ (${\lambda}_L$ is the free-space wavelength at lowest frequency). Measured -10 dB bandwidth was ultra-wide band as more than 50 : 1(over 0.3 GHz ~15 GHz). The radiation patterns of the antenna was omnidirectional like monopole antennas. Moreover, we tried the antenna mounted on under a fuselage of a scaled UAV. As a result, the proposed antenna on the UAV maintained ultra-wide band and omnidirectional radiation patterns at all frequencies.

• Journal of IKEEE
• /
• v.22 no.3
• /
• pp.793-799
• /
• 2018

An improved design of Ultra Wide Band(UWB) Bow-Tie antenna, which can control an enhanced wide stop-band, is presented. The mutually coupled slot-pair improves and controls the rejection band. The UWB antenna is composed of an electromagnetically coupled Bow-Tie patch and a parasitic ground patch, whose working frequency is extended to full UWB range in this work. By adding slot-pairs on the main patch and optimizing, they can give any requested wide rejection bands and sharp skirt characteristics, as is often required for UWB antennas and multi-band antennas. All the parameters are precisely calculated by an adequate optimization method. The Particle Swarm Optimization(PSO) technique is appropriately adopted. The proposed design and method is proved to give and control the sharp-skirt wide stop-band to UWB Bow-Tie antennas.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.442-445
• /
• 2003

The use of a single UWB antenna which covers a wide range of frequencies is very desirable for future wireless communications system. In this paper, we propose a novel wide band printed elliptic monopole antenna for UWB(Ultra wide Band). Wideband planar monopole disc antenna have been recently studied. The proposed antenna can cover UWB frequencies from 3.5GHz to 12GHz. it is determined from 10dB return loss. The antenna consists of the printed elliptical monopole disc with microstrip-line feed. Elliptic disc of antenna and ground height operate important to matching. The results of measurement are almost similar to those of simulation.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 1994.04a
• /
• pp.43-48
• /
• 1994

A wide band design method of an electromagnetic wave absorber using exponentially tapered ferrite which has very wide band frequency characteristics is proposed and discussed. The wide band electromagnetic wave absorber can be designed by the proposed equivalent material constants method for the regions varying spatially in the shape of ferrite. Furthemore the wide band ferrite electromagnetic wave absorbers with taper which have not only excellent reflectivity frequency characteristics but also the band width of 30MHz to 2150 or 2450MHz under the tolerance limits of -20dB reflectivity were designed.

• Journal of the Korean Institute of Navigation
• /
• v.18 no.2
• /
• pp.151-158
• /
• 1994

A wide band design method of an electromagnetic wave absorber using exponentially tapered ferrite, which has very wide band frequency characteristics, is proposed and discussed. The wide band electroma-gnetic wave absorber can be designed by the proposed equivalent material constants method for the re-gions varying spatially in the shape of ferrite. Futhermore, the wide band ferrite electromagnetic wave absorber with taper, which have not only exce-llent reflectivity frequency characteristics but also the band width of 30MHz to 2150 or 2450MHz under the tolerance limits of -20dB reflectivity, were designed.