• The Korea Journal of Herbology
• /
• v.23 no.3
• /
• pp.27-32
• /
• 2008

Objectives : In this paper, we describe that $^1H-NMR$ spectroscopy may be superior to the conventional HPLC for the quantitative analysis of hesperidin from Citrus unshiu. Methods : $^1H-NMR$ spectra (400 MHz) were recorded in $DMSO-d_6$ using a Varian UNITY Inova AS 400 FT NMR spectrometer. One hundred milligram of powdered Citrus unshiu was weighed out and mixed with 1 ml of $DMSO-d_6$ with sonication for 30 min (room temperature). The extracts were filtrated through a 0.45 ${\mu}m$ PVDF filter and 0.5 ml of filtrated extract used for quantitative $^1H-NMR$ measurement (added 1 mg of dimethyl terephthalate as internal standard). The quantity of hesperidin was calculated by the ratio of the intensity of the compound to the known amount of internal standard. For HPLC analysis, the half gram of plant material was extracted with 60 ml of MeOH for 2 hours. The extracts were made 100 ml volume and analyzed by a Waters HPLC system using a YMC ODS column. The total flow rate was 1.0 ml/min with a sample volume 10 ${\mu}l$ and UV detection at 280nm. Results : The contents of hesperidin in Citrus unshiu was determined $5.33{\pm}0.06$% in the quantitative $^1H-NMR$ method and $5.15{\pm}0.12%$ in HPLC method. Using the quantitative $^1H-NMR$ the contents of hesperidin can be determined in much shorter time than the conventional HPLC measurements. Conclusions : From those results, the advantages of quantitative $^1H-NMR$ analysis are that can be analyzed to identify and quantify, and no reference compounds required for calibration curve. Besides, it allows rapid and simple quantification for hesperidin with an analysis time for only 10 min without any pre-purification steps.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.28 no.10
• /
• pp.652-657
• /
• 2015

We have investigated the properties of Al-doped ZnO (AZO) thin films as functions of atomic layer deposition (ALD) oxidants. AZO transparent conducting oxides (TCOs) layer was deposited by ALD with adding trimethylaluminum (TMA) and diethylzinc (DEZn). AZO films were deposited at low temperature with $H_2O$ and $O_3$ as oxidants. Electrical, optical and structural properties of AZO thin films were investigated by 4-point probe, Hall effect measurement, UV-VIS, and AFM. Microstructure and atomic bonding states were investigated by HRXRD and XPS. The resistivity of AZO films grown using $H_2O$ was lower than the films grown using $H_2O$ and $O_3$, by approximately two orders of magnitude. The differences in oxygen vacancy peak intensity of AZO films were correlated to the optical and electrical properties.

• Journal of Biosystems Engineering
• /
• v.35 no.6
• /
• pp.420-425
• /
• 2010

We produced a basic system of sterilization of nutrient solution based on the characteristics of coated filter with the visible light-reactive titanium oxide photocatalyst according to the findings of the first stage. We developed a model system with a proper number and arrangement of filter elements, the visible light-reactive titanium oxide photocatalyst according to findings from the basic performance test. Main results of this study were as followers; The ceramic filters showed the best performance of sterilization of nutrient solution. The visible light-reactive titanium oxide photocatalyst sterilized more effectively the nutrient solution under the sunlight than UV light. The sterilization performance by passing repeatedly through a few filter was more efficient than that by treating simultaneously with a large number of filters. The filter with 15ppi in pore size, 20 mm in thickness, and 3 layers in titanium oxide coating was desirable in the intensity and sterilization performance.

• The Korean Journal of Physiology and Pharmacology
• /
• v.19 no.4
• /
• pp.373-382
• /
• 2015

Fura-2 analogs are ratiometric fluoroprobes that are widely used for the quantitative measurement of [$Ca^{2+}$]. However, the dye usage is intrinsically limited, as the dyes require ultraviolet (UV) excitation, which can also generate great interference, mainly from nicotinamide adenine dinucleotide (NADH) autofluorescence. Specifically, this limitation causes serious problems for the quantitative measurement of mitochondrial [$Ca^{2+}$], as no available ratiometric dyes are excited in the visible range. Thus, NADH interference cannot be avoided during quantitative measurement of [$Ca^{2+}$] because the majority of NADH is located in the mitochondria. The emission intensity ratio of two different excitation wavelengths must be constant when the fluorescent dye concentration is the same. In accordance with this principle, we developed a novel online method that corrected NADH and Fura-2-FF interference. We simultaneously measured multiple parameters, including NADH, [$Ca^{2+}$], and pH/mitochondrial membrane potential; Fura-2-FF for mitochondrial [$Ca^{2+}$] and TMRE for ${\Psi}_m$ or carboxy-SNARF-1 for pH were used. With this novel method, we found that the resting mitochondrial [$Ca^{2+}$] concentration was $1.03{\mu}M$. This $1{\mu}M$ cytosolic $Ca^{2+}$ could theoretically increase to more than 100 mM in mitochondria. However, the mitochondrial [$Ca^{2+}$] increase was limited to ${\sim}30{\mu}M$ in the presence of $1{\mu}M$ cytosolic $Ca^{2+}$. Our method solved the problem of NADH signal contamination during the use of Fura-2 analogs, and therefore the method may be useful when NADH interference is expected.

• Textile Coloration and Finishing
• /
• v.11 no.3
• /
• pp.15-22
• /
• 1999

This study investigated the mordanting effect of natural mordants such as camellia ash, bean chaff ash and pyrolignite of iron(Iron(II) Acetate) on silk fabrics dyed with green tea extracts. Experimental variables include the conditions of extraction and dyeing, and types of natural mordants. Inorganic ion contents In natural mordants were analysed by Induced Coupled Plasma Atomic Emission Spectrometer. In the ash Al, Fe, Si and Mn were in % unit, Cr and Ni were detected in ppm unit, and in the aqueous extracts of the ash all the metal ions were in ppm unit. On the other hand, fairly high content of Al(2.13% ) in camellia ash extract and Fe(7.91% ) in the aqueous extracts of pyrolignite iron were detected. The absorbance intensity of green tea extracts in UV-Visible spectrum increased with the temperature and time of extraction. The maximum absorption wavelength of the extracts appeared at 272.5nm and 210.5nm. The US values of silk fabrics dyed with green tea extracts were increased with temperature and time of dyeing. Surface color of silk fabric dyed with green tea extracts was 9.1YR, but it was changed from 7.9YR to 7.5YR by camellia ash extract and 7.4YR to 6.4YR by bean chaff ash extract with increase in mordant concentration. Pre-mordanted and post-mordanted fabrics with pyrolignite of iron were changed from 1.4YR to 1.1R and 7.2P to 4.2P, respectively.

• Elastomers and Composites
• /
• v.41 no.1
• /
• pp.49-56
• /
• 2006

The waste tire powder is modified with allylamine in the presence of ultraviolet radiation and the influence of surface modification on the thermal and rheological properties of polypropylene/waste tire powder composites was investigated. X-ray diffraction studies of PP/waste tire powder composite without compatibilizer, such as maleic anhydride-g-polypropylene (MA-PP), shows the increase in peak intensity of ${\beta}$ crystalline peaks, whereas it completely disappears in the presence of the MA-PP. Differential scanning calorimetry results further supported the above fact. The melt viscosities and storage modulus of the composites with modified waste tire powder show higher value than that of composites with unmodified powder and it is attributed to the interaction between amine group on modified powder surface and maleic anhydride of MA-PP.

• Journal of the Semiconductor & Display Technology
• /
• v.21 no.2
• /
• pp.15-18
• /
• 2022

The ultraviolet-C emitting praseodymium doped yttrium phosphate (YPO₄:Pr³⁺) powder was synthesized by conventional solid-state reaction. The electroluminescence device was fabricated by simple screen-printing method using the synthesized YPO₄:Pr³⁺ powder, especially, polyvinylidene fluoride as an insulating layer was applied on the printed YPO₄:Pr³⁺ powder for stable performance of the electroluminescence. The electroluminescence properties were investigated under alternating current power system of 400 Hz. The device starts to emit at 350 V, which showed the ultraviolet-C emission peaking at the 233, 245, 264, 273 nm attributed to electronic transition of the Pr³⁺ ions. The electroluminescence intensity was increased as increasing the operating voltage and the device revealed stable performance up to 600 V due to the polyvinylidene fluoride serve as a protective layer.

• Journal of Microbiology and Biotechnology
• /
• v.32 no.9
• /
• pp.1195-1208
• /
• 2022

Silver nanoparticles (AgNPs) have potential applications in medicine, photocatalysis, agriculture, and cosmetic fields due to their unique physicochemical properties and strong antimicrobial activity. Here, AgNPs were synthesized using actinobacterial SL19 strain, isolated from acidic forest soil in Poland, and confirmed by UV-vis and FTIR spectroscopy, TEM, and zeta potential analysis. The AgNPs were polydispersed, stable, spherical, and small, with an average size of 23 nm. The FTIR study revealed the presence of bonds characteristic of proteins that cover nanoparticles. These proteins were then studied by using liquid chromatography with tandem mass spectrometry (LC-MS/MS) and identified with the highest similarity to hypothetical protein and porin with molecular masses equal to 41 and 38 kDa, respectively. Our AgNPs exhibited remarkable antibacterial activity against Escherichia coli and Pseudomonas aeruginosa. The combined, synergistic action of these synthesized AgNPs with commercial antibiotics (ampicillin, kanamycin, streptomycin, and tetracycline) enabled dose reductions in both components and increased their antimicrobial efficacy, especially in the case of streptomycin and tetracycline. Furthermore, the in vitro activity of the AgNPs on human cancer cell lines (MCF-7, A375, A549, and HepG2) showed cancer-specific sensitivity, while the genotoxic activity was evaluated by Ames assay, which revealed a lack of mutagenicity on the part of nanoparticles in Salmonella Typhimurium TA98 strain. We also studied the impact of the AgNPs on the catalytic and photocatalytic degradation of methyl orange (MO). The decomposition of MO was observed by a decrease in intensity of absorbance within time. The results of our study proved the easy, fast, and efficient synthesis of AgNPs using acidophilic actinomycete SL19 strain and demonstrated the remarkable potential of these AgNPs as anticancer and antibacterial agents. However, the properties and activity of such particles can vary by biosynthesized batch.

• Korean journal of food and cookery science
• /
• v.18 no.6
• /
• pp.644-654
• /
• 2002

Brown color characteristics and antioxidizing activities were investigated for Doenjang under different processing conditions. Doenjang A was prepared directly from Meju and saline solution whereas Doenjang B was Prepared after separating soy sauce by soaking for 45 days. Both Doenjangs were aged for up to 180 days. Antioxidizing activity was studied in relation to the brown color characteristics using fat-soluble extract and water-soluble extract of Doenjang. The intensity of brown color was higher in the water-soluble Doenjang extract than the fat-soluble Doenjang extract. In the UV-VIS scanning spectra, water-soluble Doenjang extracts showed significant changes as the aging proceeded, but fat-soluble Doenjang extract did not. Antioxidizing activity of fat-soluble Doenjang extract increased as the aging period extended; however, no significant difference was detected in the water-soluble extract. Overall, Doenjang A showed higher contents of amino acids, reducing sugar, brown color, and antioxidizing activity, and the antioxidizing ability was higher in water-soluble Doenjang extract rather than in the fat-soluble Doenjang extract.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.18 no.4
• /
• pp.304-309
• /
• 2015

To evaluate the degree of contamination caused by oil spill accident in the sea, the in-situ sensors which are based on the scientific method are needed in the real site. The sensors which are based on the fluorescence detection theory can provide the useful data, such as the concentration of oil. However these kinds of sensors commonly are composed of the ultraviolet (UV) light source such as UV mercury lamp, the multiple excitation/emission filters and the optical sensor which is mainly photomultiplier tube (PMT) type. Therefore, the size of the total sensing platform is large not suitable to be handled in the oil spill field and also the total price of it is extremely expensive. To overcome these drawbacks, we designed the fluorimeter for the oil spill detection which has compact size and cost effectiveness. Before the detail design process, we conducted the experiments to measure the excitation and emission spectrum of oils using five different kinds of crude oils and three different kinds of processed oils. And the fluorescence spectrometer were used to analyze the excitation and emission spectrum of oil samples. We have compared the spectrum results and drawn the each common spectrum regions of excitation and emission. In the experiments, we can see that the average gap between maximum excitation and emission peak wavelengths is near 50 nm for the every case. In the experiment which were fixed by the excitation wavelength of 365 nm and 405 nm, we can find out that the intensity of emission was weaker than that of 280 nm and 325 nm. So, if the light sources having the wavelength of 365 nm or 405 nm are used in the design process of fluorimeter, the optical sensor needs to have the sensitivity which can cover the weak light intensity. Through the results which were derived by the experiment, we can define the important factors which can be useful to select the effective wavelengths of light source, photo detector and filters.