• Electrical & Electronic Materials
• /
• v.8 no.4
• /
• pp.458-463
• /
• 1995

The optical and electrical properties of $C_{22}$-Quinolinium(TCNQ) Langmuir-Blodgett films have been studied depending on the annealing temperatures. The optimal properties were investigated using UV/visible(300-800[nm]) absorption spectra and FTIR(Fourier-transformed- infrared) absorption measurements. The electrical properties were investigated in a frequency range of 10[Hz]-13[MHz]. The UV/visible absorption spectra at room temperature show that there are four characteristic peaks at 320, 380, 494 and 678[nm]. These absorption peaks decrease very rapidly above the annealing temperature of 180[.deg. C], which is due to a structural change of TCNQ. The FTIR absorption measurements strongly support the result of the UV/visible absorption spectra, because the absorption peak of TCNQ- at 2181[$cm^{-1}$ /] also decreases above 140[.deg. C]. The frequency-dependent dielectric constant shows that there is a dielectric dispersion near 1[MHz] which is due to an orientational polarization of the molecules inside the film. The overall frequency-dependent dielectric constant is higher near 80[.deg. C]. It may be due to a softness of the alkyl chains.s.

• Journal of Pharmaceutical Investigation
• /
• v.26 no.2
• /
• pp.83-89
• /
• 1996

A reverse-phase HPLC method to determine DL-Carnitine Hydrochloride in pharmaceutical preparation is described. UV absorption derivatives of DL-Carnitine Hydrochloride were formed with p-Bromophenacyl Bromide in an essentially quantitative manner using crown ether as catalyst. The DL-Carnitine-bromophenacyl ester absorbed UV radiation strongly at 254nm, allowing the detection of as small a quantity as 12.5ng of DL-Carnitine Hydrochloride. A linear defection range was $5\;{\times}\;10-8 \;{\sim}\;5\;{\times}\;10-7M$ of DL-Carnitine Hydrochloride. And the linear regression at various drug concentration was =0.999 (n=10). The DL-Carnitine Hydrochloride in pharmaceutical preparation was successfully derivatized and separated from other constituents by reverse phase HPLC with detection at 254 nm.

• The Korean Journal of Food And Nutrition
• /
• v.7 no.4
• /
• pp.332-337
• /
• 1994

The antioxidant activity of solvent extracts isolated from barley leaves was investigated by measuring peroxide value. The fractions of methanol extract obtained from preparative TLC was also studies, with UV-Visible spectrum, total phenol contents and hydrogen donating ability(HDA) The antioxidant activity of various solvent extracts was, in decreasing order, methanol> ethyl ether> methylene chloride $\geq$ ethyl acetate $\geq$acetone> hexane. The antioxidant activity of the fractions of methanol extract was, in decreasing order, fraction 2> fraction 3> fraction 1 and their activity was all superior to that of tocopherol at 500 ppm level. All fraction(1, 2 and 3) exhibited a strong UV absorption at 280 m which would be specifically produced by phenolic compound. UV absorption at 280 m of fraction 2 was greater than those of fraction 1 and 3. In the visible spectrum of these fractions, the maximum .absorption wavelengths of fraction 1, 2 and 3 were 660, 460 and 460 m, respectively. Antioxidant activity of barley leaves seemed to be due to the flavonoids containing phenolic group by UV spectrum and total phenol content.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.2
• /
• pp.597-600
• /
• 2012

Polyynes were formed by laser ablation of a graphite target in deionized water ($H_2O$ and $D_2O$) and various organic solvents such as acetonitrile, n-hexane, and c-hexane and were identified by analyzing ultraviolet (UV) absorption and Raman spectra. We assigned the major UV absorption peaks that coincided with the electronic transitions corresponding to linear polyyne chains. The UV absorption peak intensities of a polyyne solution decreased as the holding temperature of the solution increased. Also, the absorption spectra of polyynes obtained by laser ablation of a graphite target at different volume fractions of $H_2O$ and $D_2O$ were examined.

• Fisheries and Aquatic Sciences
• /
• v.15 no.4
• /
• pp.361-363
• /
• 2012

We investigated ultraviolet (UV) absorption materials from Russian seaweeds. First, the UV absorptivities of five seaweeds Gloiopeltis fucatas, Mazzaella sp., Mastocarpus pacificus, Laminaria cichorioides, Saccharina japonica were evaluated by a UV spectrometer. Of these seaweeds, Gloiopeltis fucatas and Mazzaella sp. showed high levels of UV absorption. Column chromatography of active 50% aqueous ethanol extracts from Gloiopeltis fucatas and Mazzaella sp. resulted in the purification of two known compounds. Spectroscopic techniques identified their structures as shinorine and palythine. These materials exhibited UV absorptive capabilities at wavelengths of 333 and 320 nm, respectively. These results suggest that Gloiopeltis fucatas and Mazzaella sp. may be useful as natural cosmeceutical sources.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1993.11a
• /
• pp.137-140
• /
• 1993

Electrical properties and thermal annealing effects of $C_{22}$-quinolium(TCNQ) Langmuir-Blodgett(LB) films were studied. Typical current-voltage(I-V) characteristics along the perpendicular direction chow an anomalous behavior of breakdown near the electric-field strength of $10^{6}$V/cm. To see the thermal influence of the specimen, current was measured as a function of temperature(20∼$180^{\circ}C$). It shows that the current increases about 4 orders of magnitude near 60∼$70^{\circ}C$ and remains constant far a while up to ∼$150^{\circ}C$ and then suddenly drops. Such increase of current near 60∼$70^{\circ}C$ seems tn be related to a softness of alkyl chains. Besides the electrical measurements, UV/visible absorption(300∼800 nm) of the thermally annealed sample was measured to see the internal-structure change. It is found that there are four characteristic peaks. At 494 nm, the optical absorption of the thermally annealed specimen at $60^{\circ}C$ starts increase and stays almost constant upto∼ $140^{\circ}C$. And eventually it disappears above $180^{\circ}C$. After heat treatment of the specimen up to $150^{\circ}C$, Uv/visible absorption was measured while cooling.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.36 no.4
• /
• pp.259-263
• /
• 2010

We measured and compared the partition coefficients and absorption levels of preservative phenoxyethanol (PE), antimicrobial ethylhexylglycerin (EG) and UV-filters widely used in cosmetic products and more specifically evaluated the relative absorption level of PE depending on various packaging materials. The resulting partition coefficients of 11 UV filters in relation to PE and EG displayed EG with a relatively higher partition coefficients. The partition coefficients of Tinsorb M and Solaveil CT434 were also high. Among the UV-filter ingredients with EG absorption levels exceeding 40 % were Gransil PSQ, UV Titan M 160 and Micro $TiO_2$ MT 100 TV, whereas Gransil PSQ and Scadder showed PE absorption levels above 40 %. In addition, we confirmed that PE had displayed an absorption level of 7 ~ 8 % as a result of 1 month-long exposure to packaging material polyoxymethylene. This extensive research illustrates the possibility of producing the most potent preservative contents based on studying the relative compatibility between UV-filters and preservatives and selecting the adequate preservatives to be used. Furthermore, preservative level can also decline with passage of time depending on the type of packaging material used.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.1
• /
• pp.25-31
• /
• 2006

Many amethysts of different origins such as South America, Aftrica, and Asia were compared. According to ICP-AES analysis, the colorizing elements were Fe, Cr, Cu, and Co. Amethysts from South America showed higher concentrations of the elements. UV- VIS analysis showed that both natural and synthetic amethysts were characterized by the higher absorption at 350 nm and 550 nm wavelength. The natural amethysts had lower permeability than that of the synthetic amethysts. According to FT-IR analysis, the synthetic amethysts were distinguished from the natural amethysts in that they had a typical absorption band of $3543cm^{-1}$. The amethyst from South America showed strong absorption bands of $3584cm^{-1}\;and\;3435cm^{-1}$, and African amethyst had absorption bands of $3299cm^{-1}\;and\;3196cm^{-1}$. $3381cm^{-1}$ absorption band was shown strongly for Asian origins.

• The Bulletin of The Korean Astronomical Society
• /
• v.41 no.2
• /
• pp.40.2-40.2
• /
• 2016

The attenuation of starlight by dust in galactic environments is investigated through models of radiative transfer in a spherical, clumpy interstellar medium (ISM). We show that the attenuation curves are primarily determined by the wavelength dependence of absorption rather than by the underlying extinction (absorption+scattering) curve; the observationally derived attenuation curves cannot constrain a unique extinction curve unless the absorption or scattering efficiency is specified. Attenuation curves consistent with the Calzetti curve are found by assuming the silicate-carbonaceous dust model for the Milky Way (MW), but with the $2175{\AA}$ bump suppressed or absent. The discrepancy between our results and previous work that claimed the Small Magellanic Cloud dust to be the origin of the Calzetti curve is ascribed to the difference in adopted albedos; we use the theoretically calculated albedos whereas the previous ones adopted empirically derived albedos from observations of reflection nebulae. It is found that the model attenuation curves calculated with the MW dust are well represented by a modified Calzetti curve with a varying slope and UV bump strength. The strong correlation between the slope and UV bump strength, as found in star-forming galaxies at 0.5 < z < 2.0, is well reproduced if the abundance of the UV bump carriers is assumed to be 30-40% of that of the MW-dust; radiative transfer effects lead to shallower attenuation curves with weaker UV bumps as the ISM is more clumpy and dustier. We also argue that some of local starburst galaxies have a UV bump in their attenuation curves, albeit very weak.

• Journal of the Korean Applied Science and Technology
• /
• v.2 no.2
• /
• pp.47-53
• /
• 1985

Correlation among the wax-pigment composites which is base vehicles for the crepas was investigated in terms of fadeness. The base wax synthesized and pigments are compounded with petroleum lubricant and exposed under carbon arc individually. The yellowing phenomenon was appeared on the reference papers coated with the spindle oil which was then exposed. The papers were again extracted with distilled water and pH of them were ranged between 6.2-6.5. Color difference from Adam-Nickerson equation, ${\vartriangle}E$ of base wax is 0.15 and that of spindle oil are varied from 0.66 to 15.62. Since the main components of the petroleum lubricant are aromatic hydrocarbons which have absorptions characteric of UV ranging from 240 to 280 nm, fadeness characteristics of the composites are largely depend upon the change of molecular structure of spindle oil by absorbing UV. Thus the spindle oil having the following physical properties has the better resistance of fadness and is recommended to use in compounding the base wax-pigment composites: ${\cdot}$ main component: paraffinic hydrocarbon ${\cdot}$ pour point: below - $15^{\circ}C$ ${\cdot}$ UV absorption characteristics: ${\lambda}max.$ : 268-290nm ${\cdot}$ absorbancy: below 0.1(0.03ml of sample/50ml of $CHCl_3$)