• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.8 s.99
• /
• pp.797-802
• /
• 2005

In this paper, we design a UHF band RFID tag antenna which is conjugate matched to an impedance of a chip and also mountable on conductive materials. The proposed tag antenna is very compact($50{\times}30{\times}4mm$) with a modified PIFA shape. The proposed tag antenna has an advantage of easy matching to various chip input impedances. The performance of the antenna is evaluated by monitoring RCS in the reader direction. The RCS of the designed tag is $-10.2\;dBm^2$ when the chip is shorted and is $-21\;dBm^2$ when the chip impedance is a complex conjugate of the antenna impedance.

• Proceedings of the KIEE Conference
• /
• 2008.10b
• /
• pp.215-216
• /
• 2008

In this paper, we describe a UHF-band CMOS fractional-N frequency synthesizer using a ring - type VCO. It has been designed using $0.18{\m}m$ CMOS technology. First, The newly designed charge-pump circuit includes an OTA for matching between the upper current and the lower current In addition, a ring - type VCO is also used for small chip sire. The simulation results show that the designed circuit has a phase noise of -109.53dBc/Hz at 1MHz offset and consumes 19.4mA from a 1.8V supply. The lock time is less than 30usec and the chip size is $0.45mm{\times}0.5mm$.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.1963-1966
• /
• 2004

An ultra wide band ultra-high frequency (UHF) signal processing module was designed for on-line UHF partial discharge (PD) monitoring systems for gas-insulated switchgears (GIS). Major advantage of the unit is an improved PD detection sensitivity through minimizing the effect of surrounding interference signals. The detection sensitivity of the unit was <-60 dBm that is sufficient to detect UHF PD signals as low as 1 pC. Precise detection of PD occurred in the GIS, due to internal defects, is possible by using the signal processing unit.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.5
• /
• pp.819-826
• /
• 2020

The UHF band wind profiler radars of the Korea Meteorological Administration (KMA), which produces the vertical profile of the wind, need to be calibrated for better performance. The capabilities of the radar in detecting even light precipitation were used for the calibration of which reference takes the hourly series of ground rainfall rate measured by a rain gauge at the radar site. This calibration must be renewed regularly according to the methodology implemented in this work since errors occur on the wind vectors in the clear sky without reflectivity calibration. Comparing the wind by wind profiler with that by radiosonde, the optimal radar constant contributed to the improvement of wind accuracy.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.2
• /
• pp.43-49
• /
• 2008

In this paper, new directional couplers for T/R switch of UHF RFID applications are proposed to overcome TX-to-RX leakage problem. The proposed method can remove TX-to-RX leakage caused by both imperfect isolation characteristic of the conventional directional coupler and the mismatch of antenna impedance. Two directional couplers are implemented using distributed elements and lumped elements respectively for the verification. The varactor tuneable circuits for compensation of the antenna mismatch is also proposed. The measurement result shows excellent TX-to-RX leakage suppression, more than 45dB in 910MHz.

• Proceedings of the KIEE Conference
• /
• 2002.07c
• /
• pp.1649-1651
• /
• 2002

Ultra-wide bandwidth (UWB) detection method has been widely used as a front end detection scheme for the ultra-high frequency (UHF) partial discharge (PD) monitoring systems. A broad-band video detector module was developed and characterized for the UHF UWB PD detection systems. The useable bandwidth of the module is more than 2 GHz and it is optimized for 50-ohm systems. The detection sensitivity and dynamic range of the module were characterized by using a known ns-width RF pulses of GHz range. The dynamic range is more than 6-decades and the module can detect pulsed RF signals down to 1 nW. The detector module can eliminate expensive equipment such as high speed oscilloscopes and radio frequency (RF) spectrum analyzers. Therefore, it enables one to use slow speed data acquisition systems for the PD monitoring at the UHF range. The detector module was used to detect real PDs of about <3 pC. The module converts the UWB PD signals into a low-bandwidth video signal with a high signal-to-noise ratio.

• Journal of the Korea Society for Simulation
• /
• v.17 no.4
• /
• pp.99-112
• /
• 2008

In the passive UHF (860-960MHz) RFID communications, which consists of a set of readers and tags, the readers normally interrogate the tag by using the backscatter mechanism. (i.e., tag response). In practical RFID environment, where multiple readers or tags exist; the interference causes collisions. This paper proposes a centralized arbitration scheme for avoiding the collision problems among multiple readers. The proposed centralized arbitration scheme is modeled in software environments, and is verified with simulation results. Simulated performance is focused on completion time, utilization and response time, and the simulation results show that our proposed scheme provides satisfactory performance grade.

• Proceedings of the KIEE Conference
• /
• 2004.05b
• /
• pp.128-131
• /
• 2004

An ultra wide band ultra-high frequency (UHF) signal processing module was designed for on-line UHF partial discharge (PD) monitoring systems for gas-insulated switchgears (GIS). Major advantage of the unit is an improved PD detection sensitivity through minimizing the effect of surrounding interference signals. The detection sensitivity of the unit was <-60 dBm that is sufficient to detect UHF PD signals as low as 1 pC. Precise detection of PD occurred in the GIS, due to internal defects, is possible by using the signal processing unit.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.10a
• /
• pp.172-175
• /
• 2000

본 논문에서는 무선마이크용 특정소출력무선기기의 송수신단을 설계하고 제작하여 특성을 측정하였다. 무선마이크용 특정소출력무선기기의 주파수 대역 740.000~752.000MHz를 사용하였고, 점유주락수대폭의 허용치 200kHz, 최대주파수편이 $\pm$75kHz를 만족하도록 설계하였다. PLL Synthesized, 주파수 변조, Dual Conversion 방식을 사용하였으며 Compander Type은 2:1이다. 설계된 무선마이크 시스템의 출력은 10mW이하이고, 50-20,000Hz의 주파수 응답을 가지며 Hi-fi Audio를 전송할 수 있다. 송수신단의 Total Harmonic Distortion 은 1.5% 이하이다.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2006.07a
• /
• pp.695-695
• /
• 2006