• Nuclear Engineering and Technology
• /
• v.32 no.2
• /
• pp.108-127
• /
• 2000

Hot leg break LBLOCA(Large Break LOCA) had a potential to be a containment maximum pressure accident in YGN3&4, which was induced from excessive conservatism in the CE analysis methodology of mass and energy release. This study conducted mass and energy release experiment for the hot leg break LBLOCA during post blowdown with an integral test facility, SNUF(Seoul National University Facility). This facility simulated YGN 3&4 with volume ratio of 1/1140 based on Ishii's three level scaling. Experiment showed that SI(Safety Injection) water refilled cold leg first and core later. SI water was vaporized in the core, which resulted in the repressurization of reactor. This increase of pressure drove the water in cold leg to flow up half height of U tubes. However, since the water was drained back soon, the release through the SG side broken section by evaporation was negligibly small. This study also provided experimental assessment of RELAP5 results by KAERI for the release through the SG side broken section.

• Journal of Magnetics
• /
• v.16 no.2
• /
• pp.88-91
• /
• 2011

Steam generator tubes (SGTs) in nuclear power plants (NPPs) are a boundary between the primary side generating heat by nuclear fission and the secondary side generating electric power by a turbine. The water inside the SGT is high temperature and high pressure. Therefore, defects and magnetic phases (MPs) are partly produced in non-magnetic SGT by high stresses and temperatures. This causes trouble regarding the safety of SGTs but it is difficult to detect the MP using the conventional eddy current technique (ECT). In particular, a circumferential defect (CD) and circumferential magnetic phase (CMP) cannot detected by ECT. Consequently, a new method is needed to detect CDs and CMPs in SGT. A new U-type yoke with two types of coils was designed and the reactance signal by the CMPs and CDs in the SGT material was simulated.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09b
• /
• pp.1271-1272
• /
• 2006

The vacuum infiltration method is one of the composite producing methods. There are several parameters in composite production by vacuum infiltration. One of them is particle size of reinforcement in particulate reinforced composites. In this study, MgO powder and Al were used as reinforcement and matrix respectively. MgO powders with different size and amount to give same height were filled in quartz tubes and liquid metal was vacuum infiltrated into the MgO powder under same vacuum condition and for same time. Infiltration height was measured and microstructure and fracture behavior of composite were investigated. It has been found that infiltration height and fracture strength were increased with particulate reinforcement sizes. It has also been determined that molten metal temperature facilitates infiltration.

• Journal of the Korean Ceramic Society
• /
• v.44 no.5 s.300
• /
• pp.141-143
• /
• 2007

Nanotubes and microtubes of ferroelectric lead zirconate titanate (PZT) were synthesized by means of a simple and convenient process called a template-wetting process. Nanoporous alumina and macroporous Si were used as template materials to fabricate the corresponding tubes. For the improvement of the wetting properties of the wetting solution, the PZT solution was mixed with a polymer. The polymer was removed completely during annealing. The grain growth processes of the PZT nanotubes during baking and furnace annealing were examined by means of field emission electron microscope (FE-SEM) and X-ray diffractometry (XRD).

• Proceedings of the KSPS conference
• /
• 2005.11a
• /
• pp.51-54
• /
• 2005

This paper analyzes the vocal tract area estimation algorithm used as a part of a speech analysis program to help deaf children correct their pronunciations by comparing their vocal tract shape with normal children's. Assuming that a vocal tract is a concatenation of cylinder tubes with a different cross section, we compute the relative vocal tract area of each tube using the reflection coefficients obtained from linear predictive coding. Then, obtain the absolute vocal tract area by computing the height of lip opening with a formula modified for children's speech. Using the speech data for five Korean vowels (/a/, /e/, /i/, /o/, and /u/), we investigate the effects of the sampling frequency, frame size, and model order. We compare vocal tract shapes obtained from deaf and normal children's speech.

• Proceedings of the PSK Conference
• /
• 2003.10b
• /
• pp.220.1-220.1
• /
• 2003

A sensitive and selective liquid chromatographic method for the determination of carvedilol in human plasma was developed and validated. Analytes were separated on a XTerra C18 column with acetonitrile-methanol-30 mM KH$_2$PO$_4$ (pH 2.5) (20 : 20 : 60, v/v/v), as mobile phase. One mL plasma were pipetted into glass tubes and spiked with 0.05 mL of internal standard solution. After adding 7 mL of diethyl ether, the plasma sample was then shacked for 15 min. A centrifuged upper layer was back-extracted with 150 uL of 0.05 M sulfuric acid. (omitted)

• Proceedings of the Korean Geotechical Society Conference
• /
• 1999.10a
• /
• pp.271-278
• /
• 1999

Soil filters are commonly used to protect the soil structures from eroding and piping. When filters are clogged by fine particles which are progressively accumulated, these may lead to buildup of excessive pore pressures also leading to instability in subsurface infrastructure. A filter in the backfill of a retaining wall, a filter adjacent to the lining of a tunnel, or a filter in the bottom of an earth dam can be clogged by transported fine particles. This causes reduction in the permeability, which in turn may lead to intolerable decreases in their drainage capacity. In this thesis, the extent of this reduction is addressed using results from both experimental and theoretical investigations. In the experimental phase, the permeability reduction of a filter is monitored when an influent of constant concentration flows into the filter (uncoupled test), and when the water flow through the soil-filter system to simulate an in-situ condition (coupled test), respectively. The results of coupled and uncoupled test are compared with among others. In the theoretical phase of the investigation, a representative elemental volume of the soil filter was modeled as an ensemble of capillary tubes and the permeability reduction due to physical clogging was simulated using basic principles of flow in cylindrical tubes. In general, it was found that the permeability was reduced by at least one order of magnitude, and that the results from the uncoupled test and theoretical investigations were in good agreement. It is observed that the amount of deposited particles of the coupled test matches fairly well with that of the uncoupled test, which indicates that the prediction of permeability reduction is possible by preforming the uncoupled test instead of the coupled test, and/or by utilizing the theoretical model.

• Journal of Astronomy and Space Sciences
• /
• v.29 no.3
• /
• pp.245-251
• /
• 2012

Since the development of surface magnetic features should reflect the evolution of the solar magnetic field in the deep interior of the Sun, it is crucial to study properties of sunspots and sunspot groups to understand the physical processes working below the solar surface. Here, using the data set of sunspot groups observed at the ButterStar observatory for 3,364 days from 2002 October 16 to 2011 December 31, we investigate temporal change of sunspot groups depending on their Z$\ddot{u}$rich classification type. Our main findings are as follows: (1) There are more sunspot groups in the southern hemisphere in solar cycle 23, while more sunspot groups appear in the northern hemisphere in solar cycle 24. We also note that in the declining phase of solar cycle 23 the decreasing tendency is apparently steeper in the solar northern hemisphere than in the solar southern hemisphere. (2) Some of sunspot group types make a secondary peak in the distribution between the solar maximum and the solar minimum. More importantly, in this particular data set, sunspot groups which have appeared in the solar southern hemisphere make a secondary peak 1 year after a secondary peak occurs in the solar northern hemisphere. (3) The temporal variations of small and large sunspot group numbers are disparate. That is, the number of large sunspot group declines earlier and faster and that the number of small sunspot group begins to rise earlier and faster. (4) The total number of observed sunspot is found to behave more likewise as the small sunspot group does. Hence, according to our findings, behaviors and evolution of small magnetic flux tubes and large magnetic flux tubes seem to be different over solar cycles. Finally, we conclude by briefly pointing out its implication on the space weather forecast.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.6
• /
• pp.113-131
• /
• 1998

The objective of the present study is to investigate the characteristics of the dividing flow in the laminar flow region. Using glycerine water solution(wt43%) for Newtonian fluid and the polymer of viscoelastic fluid(500wppm) for non-Newtonian fluid, this research investigates the flow state of the dividing tube in steady laminar flow region of the two dimensional dividing tube by measuring the effect of Reynolds number, dividing angle, and the flow rate ratio on the loss coefficient. In T- and Y-type tubes, the loss coefficients of the Newtonian fluid decreases in constant rate when the Reynolds number is below 100. The effect of the flow rate ratio on the loss coefficients is negligible. But when the Reynolds number is over 100, the loss coefficient with various flow rate ratios approach an asymptotic value. The loss coefficient of the non-Newtonian fluid for different the Reynolds number shows the similar tendency of the Newtonian fluid. And when the Reynolds number is over 300, the loss coefficient is approximately 1.03 regardless of flow rate ratio or the dividing angle. The aspect ratio does hardly influence the reattachment length and the loss coefficient of both Newtonian and non Newtonian fluid. The loss coefficient decreases as the Reynolds number increases. The loss coefficient of Newtonian fluid is larger than that of non-Newtonian fluid.

• Asian-Australasian Journal of Animal Sciences
• /
• v.27 no.5
• /
• pp.717-725
• /
• 2014

The objective of the study was to determine the effects of animal related factors on bruising in slaughter cattle, creatine kinase (CK) and beef quality. Three hundred and twenty one cattle from three breeds (108 Bonsmara, 130 Beefmaster and 83 Brahman) were used in this study. The animals were grouped as follows: Group 1 (16 months old), Group 2 (18 months old) and Group 3 (24 months old). At exsanguinations, blood samples for CK determination were collected using disposable vacutainer tubes. Muscularis longissimus thoracis et lumborum (LTL) was collected 24 h after slaughter to determine the colour ($L^*$, $a^*$, and $b^*$) and ultimate pH ($pH_u$) of beef. Breed, sex and age had significant effects (p<0.05) on bruising score, CK levels and beef quality. Bonsmara breed had the highest (80%) bruising score percentage, CK ($705.3{\pm}80.57U/L$) and $pH_u$ ($6.3{\pm}0.05$) values while the Bonsmara had the highest $L^*$ ($24.8{\pm}0.78$) $a^*$ ($17.5{\pm}0.53$) and $b^*$ ($12.8{\pm}0.53$) values. Higher CK levels were also observed in winter compared to summer, spring and autumn respectively. Therefore, animal factors (sex, breed and animal age at slaughter) contribute to the development of bruises and have an effect on the levels of CK and meat quality. It was also concluded that there is no significant relationship between meat parameters (L,* $a^*$, and $b^*$) and CK levels.