• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.419-420
• /
• 2008

In this study, high quality (Al,N)-codoped p-type ZnO thin films were obtained by DC magnetron sputtering. The film on buffer layer grown in 80% $N_2$ ambient shows highest hole concentration of $2.93\times10^{17}cm^{-3}$. The films show hole concentration in the range of $1.5\times10^{15}$ to $2.93\times10^{17}cm^{-3}$, resistivity of 131.2 to 2.864 $\Omega$cm, mobility of 3.99 to 31.6 $cm^2V^{-1}s^{-1}$. The films on Si show easier p-doping in ZnO than those on buffer layer. The film on Si shows the highest quality of optical photoluminescence (PL) characteristics. The donor energy level $(E_d)$ of (Al,N)-codoped ZnO films is about 50 meV and acceptor energy level $(E_a)$ is in the range of 63 to 71 meV. It will help to improve p-type ZnO films.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.348-349
• /
• 2007

This paper describes the electrical characteristics of polycrystalline (poly) 3C-SiC thin film diodes, in which poly 3C-SiC thin films on n-type and p-type Si wafers, respectively, were deposited by APCVD using HMDS, Hz, and Ar gas at $1180^{\circ}C$ for 3 hr. The schottky diode with Au/poly 3C-SiC/Si(n-type) structure was fabricated. Its threshold voltage ($V_d$), breakdown voltage, thickness of depletion layer, and doping concentration ($N_D$) values were measured as 0.84 V, over 140 V, 61nm, and $2.7\;{\times}\;10^{19}\;cm^3$, respectively. The p-n junction diodes fabricated on the poly 3C-SiC/Si(p-type) were obtained like characteristics of single 3C-SiC p-n junction diodes. Therefore, poly 3C-SiC thin film diodes will be suitable microsensors in conjunction with Si fabrication technology.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.19 no.5
• /
• pp.38-44
• /
• 2015

In this paper, the vibration control effect of the Exo-type damping system was investigated by applying the Kagome dampers to 15-story and 20-story frame structure apartment. A new Exo-type damping system composed of the dampers and supporting column was proposed in the previous work and numerical analysis were performed to investigate the effects of optimum stiffness ratio between controlled structure and supporting column, the size of damper and yield ratio of the damper. The numerical analysis results of a structure with Exo-type damping system up to the third story showed that the stiffness ratio should be higher than 7.0 and the damper device yield ratio be at least 8.0% ($V_{damper}/V_{base\;shear$) to effectively reduce the base shear and the maximum drift of the uppermost story. When the Exo-type damping system was installed up to the fifth story, the stiffness ratio should be higher than 2.5 and damper device yield ratio needs to be at least 3.5% ($V_{damper}/V_{base\;shear$) for obtaining the target performance.

• Preventive Nutrition and Food Science
• /
• v.3 no.4
• /
• pp.303-308
• /
• 1998

Influence of amylose content on formation and characteristics of enzyme-resistant starch (RS) was investigated by scanning electron microscopy, X-ray diffractometry and differential scanning calorimetry. RS yield increased up to 36.1 % as the amylose content of corn starch increased. Starch granules of Amyulomaize V and Ⅶ were more rounded and smaller than those of regular corn ; some were elongated and had appendages. After autoclaving -cooling cycles, the granular structure disappeared and a continous spongy-like porous network was visible in regular corn starch ; the granular structure was stillevident in parts in Amylomaize V and Ⅶ starches. In all isolated RS residues , the porous structures were no longer visible and more compact formations predominated. While regular corn starch showed an A-type X-ray profile, Amylomaize V and Ⅶ starches exhibited a combination of B- and V-types. Regular corn starch lost most of its crystallinity during autoclaving , but the crystallinity was still left in Amylomaize starches as diffuse or poor B-types. All RS residues showed the presence of poor B-type regardless of amylose contents. Transition temperatures and enthalypy of native starches were a little higher in Amylomaize V and Ⅶ starches than those of regular corn starch . Regardless of amylose contents, all RS residues exhibited an endothermic transition over a similar temperature range (135 $^{\circ}C$~169$^{\circ}C$), with a mean peak temperature of ~154$^{\circ}C$, which is generally foud for retrograded amylose crystallities. Higher transition temperature, enthalypy, and RS yield of AMylomaize V and Ⅶ starches were related granular stability shown by the microscopic and crystallographic studies.

• The Journal of Korean Society of Virology
• /
• v.26 no.2
• /
• pp.251-258
• /
• 1996

The V3 loop, a hypervariable domain of envelope glycoprotein, has an essential role in viral infectivity and has a major epitope for type-specific neutralizing antibody. In order to investigate genetic diversity of V3 region of gp120 of human immunodeficiency virus type 1 (HIV-1) isolated from Korean patients, DNA sequences encoding the C2 to V3 region were amplified by nested polymerase chain reaction (PCR) from uncultured peripheral blood mononuclear cells obtained from 15 HIV-1 seropositive patients and nucleotide sequences were determined. All nucleotide sequences from fifteen patients were compared with 8 distinctive subtypes (A-H) and another subtype O. Phylogenetic analysis was carried out with PHYLIP ver 3.5 (Dnapars) program. Of the 15 isolates, 14 HIV-1 subjects were clustered with subtype B, while one was clustered with subtype C. Intra-subtype B distance at the nucleotide and deduced amino acid level were maximum 17.7% and 37.0%, respectively. Intra-patient distance at the nucleotide and deduced amino acid level were maximum 7.3% and 17.8%, respectively. Analysis of the nucleotide sequences revealed that Korean types have relatively well conserved sequences. These findings could be useful for assessing the source of infection and developing an AIDS vaccine.

• Journal of Embryo Transfer
• /
• v.23 no.4
• /
• pp.239-243
• /
• 2008

This study was conducted to investigate the effects of type of the sugar supplemented to the extender on the vigor, viability and intact acrosomal rates of frozen-thawed dog spermatozoa. The ejaculated semen was diluted with TRIS-citric acid extender containing 200mM TRIS, 73mM citric acid, 6% (v/v) glycerol, 20% (v/v) egg yolk, 1% (v/v) antibiotics (streptomycin/penicillin), 44 mM sugar, which was either glucose, fructose or glucose-fructose combination, and distilled water to make the final volume of 100ml. Extended semen samples were cooled at $4^{\circ}C$ for an hour, packaged in 0.25ml straws, equilibrated for 10 minutes in liquid nitrogen vapor, and frozen in liquid nitrogen. Samples were thawed by placing straws into $37^{\circ}C$ water for 120 seconds. After thawing, vigor, viability and intact acrosomal rates of frozen-thawed semen were compared according to type of sugar. No significant differences were observed between glucose and fructose groups. In addition, combination of the 2 sugars also did not show any significant differences in the vigor, viability and intact acrosomal rates. In conclusion, glucose and fructose were equally efficient as sugar supplements for freezing extender.

• Journal of the Korean Chemical Society
• /
• v.50 no.3
• /
• pp.208-215
• /
• 2006

A simply prepared graphite, pencil-type working electrode was utilized to monitor fenitrothion concentrations, using the cyclic voltammetry (CV) and square-wave (SW) stripping voltammetry methods. The optimum conditions for analysis were sought. A very low detection limit was obtained compared to that obtained when other common voltammetry methods are used. The optimal parameters of the pencil-type electrode were found to be as follows: a pH of 3.7, a frequency of 500 Hz, an SW amplitude of 0.1 V, an increment potential of 0.005 V, an initial potential of -0.9V, and a deposition time of 500 sec. The analytical detection limit was determined to be 6.0 ngL-1 (2.16410-11 molL-1) fenitrothion at SW anodic and CV, and the relative standard deviation at the fenitrothion concentration of SW anodic 10 ugL-1 was 0.30% (n = 15) under the optimum conditions. Analysis was directly conducted through in-vivo real-time assay.

• Journal of the Architectural Institute of Korea Structure & Construction
• /
• v.35 no.7
• /
• pp.139-146
• /
• 2019

This study examined the effect of various arrangement methods for forming peripheral closed hoops in the jacket section on the axial behavior of section enlargement strengthening columns. Four types of peripheral closed hoops arranged in the jacket section were prepared as follows: 1) Closed connection of prefabricated bar units (column P); 2) V-clip installation across the overlapped legs of channel-type bars (column V); 3) Use of glass fiber mesh for an alternative of steel bars (column F); and 4) combination of prefabricated bar units and glass fiber mesh (column PF). The V-clip is designed to form the closed hoops in the jacket section using the overlapped channel-type bars, preventing the opening of the channel bar legs. The glass fiber mesh is to examine the feasibility to apply for closed hoops in the jacket section as an alternative for steel bars, considering the easy construction. In the jacket section of all the strengthened columns, V-ties were arranged for supplementary ties, avoiding the interruption of the existing column. The axial stiffness and strength of the strengthened columns were insignificantly affected by the arrangement methods of closed hoops in the jacket section. The axial ductility ratio of the strengthened columns P, V, and PF was enhanced more than twice of that measured in the non-seismic existing column. However, the column F exhibited a lower ductility than the other strengthened columns because of the fracture of the mesh at the ultimate strength of the column. The V-clip approach was favorable to enhance the ductility of the strengthened column, preventing the opening of the legs of channel-type bars.

• Journal of Preventive Medicine and Public Health
• /
• v.54 no.2
• /
• pp.86-95
• /
• 2021

Objectives: This study investigated associations between perceptions of coronavirus disease 2019 (COVID-19) and the prevalence of posttraumatic stress disorder (PTSD) in workers at hospitals designated to treat COVID-19, as well as the difference in the magnitude of these associations by occupational type and previous Middle East respiratory syndrome coronavirus (MERS-CoV) experience. Methods: The participants were workers at hospitals designated to treat COVID-19 who completed a questionnaire about their perceptions related to COVID-19, work experience during the previous MERS-CoV outbreak, and symptoms of PTSD ascertained by the PTSD Checklist for the Diagnostic and Statistical Manual of Mental Disorders. Participants' characteristics were compared using the chi-square test. Multivariable logistic regression was performed to evaluate the associations between perceptions and the prevalence of PTSD, stratified by occupational type and previous MERS-CoV experience. Results: Non-medical personnel showed stronger associations with PTSD than medical personnel according to general fear (odds ratio [OR], 6.67; 95% confidence interval [CI], 1.92 to 23.20), shortages of supplies (OR, 1.29; 95% CI, 1.07 to 1.56), and issue-specific fear (OR, 1.29; 95% CI, 1.05 to 1.59). Those with prior MERS-CoV quarantine experience were more prone to PTSD than those without such experience in terms of general fear (OR, 1.70; 95% CI, 1.22 to 2.37), shortages of supplies (OR, 1.24; 95% CI, 1.10 to 1.40), and issue-specific fear (OR, 1.21; 95% CI, 1.06 to 1.38). Conclusions: During the COVID-19 pandemic, non-medical personnel tended to have higher odds of being categorized as having PTSD. Workers with prior MERS-CoV experience were more susceptible than those without such experience. These findings suggest the need for timely interventions to manage human resources for a sustainable quarantine system.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.36 no.4
• /
• pp.408-412
• /
• 2023

In this paper, in order to analyze high electrical insulation and cooling performance using mineral oil, the liquid insulating oil was changed in electrode shape and distance between electrodes to compare and analyze electrical characteristics according to equal electric field, quasi-equivalent electric field, and unequal electric field. As a result, the breakdown voltages were 36,875 V and 36,875 V in the form of sphere-sphere and plate-plate electrodes with equal electric fields. The breakdown voltage was 31,475 V in the sphere-plate electrode type, which is a quasi-equilibrium field, and the breakdown voltage was 28,592 V, 27,050 V, and 22,750 V in the needle-needle, sphere-needle, and needle-plate electrode types, which are unequal fields. Through this, it is possible to know the difference in breakdown voltage according to the type of electric field. The more equal the field, the higher the breakdown voltage, and the more unequal field, the lower the breakdown voltage. The difference in insulation breakdown voltage could be seen depending on the type of electric field, the insulation breakdown voltage was higher for the more equal electric field, and the insulation breakdown voltage was lower for the more unequal electric field. Also, it was confirmed that the closer the distance between the electrodes, the higher the insulation breakdown voltage, the higher the insulation breakdown current, and the insulation breakdown voltage and the insulation breakdown current were proportional.