• International Journal of Highway Engineering
• /
• v.15 no.3
• /
• pp.85-92
• /
• 2013

PURPOSES: The purpose of this paper is to estimate expected effects on traffic operational and economic aspects of 2+1 roads application in Korea. METHODS : Micro simulation study using VISSIM 5.0 was used to analyze the operation efficiency of 2+1 roads compared to two-lane highways and four-lane highways. Some scenarios for various traffic volumes were set up in order to analyze the effect of 2+1 roads under various traffic situations. Also imaginary road networks were set up for each type of roads. The MOEs to measure the operation efficiency were selected with average travel speed and delay. For analyzing economic effect of 2+1 roads, construction cost of a specific imaginary 2+1 road was compared to construction cost of a four-lane highway with same conditions. RESULTS: The results of study show that a 2+1 road is more effective with 19 percents higher average travel speed and 39 percents lower average delay than a two-lane highway. In the economic analysis, construction costs to construct a 2+1 road are saved as approximately 26.4~40.7 percents when compared to construction of four-lane highway. CONCLUSIONS: It can be concluded that 2+1 roads can improve the traffic operational level of service for two-lane highways and 2+1 roads can be applied as an effective design alternative for higher-volume two-lane highways in Korea.

• Journal of Korean Society of Transportation
• /
• v.11 no.3
• /
• pp.67-82
• /
• 1993

The effects of passing lanes on traffic flow on rural two-lane highways have been investigated in this research. Field study results were compared with the computer simulation model, TRARR, TRARR model appears to be in good agreement with field study results except that average speed and distribution of platoon sizes showed a small amount of discrepancy, which is believed to be caused by too large a headway definition of 6 second for a vehicle platoon. Using the TRARR model, 4 situations including the existing condition, installation of passing lanes, improvement of design speed, and expansion to a four lane highway were evaluated. Traffic volume levels of 500,1000, and 1500 vph and truck composition of 20 and 40% were also considered making a total of 24 computer runs. It is concluded in this research that the installation of passing lanes is the most effective method to improve traffic operation on two-lane high ways except the alternative of four lane highway expansion.

• International Journal of Highway Engineering
• /
• v.16 no.1
• /
• pp.49-56
• /
• 2014

PURPOSES : This study was done to model the headway distribution of rural two lane roads. METHODS : Time headway data for the various level of traffic volumes was measured in twelve sites. Based on the time headway data, existing seven mathematical models were evaluated and selected by comparing graphically the measured and theoretical distributions and conducting the Chi-square test. RESULTS : The results show that both the Schul model and Composite Model were the most appropriate models of the models. Based on the measured time-headway distributions, this study proposed a new headway distribution model by the shift of the Schul model. CONCLUSIONS : The shifted Schul model has the ability to describe time headway distirbutons for random, intermediate, and constant-headway states.

• Journal of Korean Society of Transportation
• /
• v.9 no.1
• /
• pp.5-18
• /
• 1991

Two-Lane, two-way roads account for approximately 92% of total road length in Korea and accomplish the majority of regional transport activities. Nevertheless not too many research have been made on two-lane roads particularly efficiency related topics such as capacity and travel time studies. In this study a full scale data collection was conducted using video equippments on rural two-lane roads to determine capacity Passenger Car Equivalents(PCE) and Level of Service criterion. Various PC programs were utilized to reduce traffic data and Walker ME? and Headway Method were employed to determine PCE's for heavy vehicles. The reseach has shown that capacity and PCE's for two-land two-way roads in Korea are 3200 pcph and 1.1∼1.9 resectively. In addition percent time delay was used as the basis of developing Level of service criterion on two-lane roads in Korea.

• Journal of Korean Society of Transportation
• /
• v.31 no.2
• /
• pp.3-10
• /
• 2013

Two-lane roads that occupy more than a half of rural highways in Korea have operational problems such as traffic congestion problems due to relatively high traffic volume and safety problems due to overtaking risks in two-lane highways. To solve these problems, a 2+1 road pattern that enables to improve traffic safety and operational efficiency of two-lane highways has been applied in Europe. In this study, in-depth applicability of 2+1 roads to Korean rural highways was investigated based on review results of the successful experience of European 2+1 roads. Then, given the Korean two-lane highway conditions, the service traffic volumes for Korean 2+1 roads was estimated. The analysis results showed that 17,000 veh./day might be the maximum traffic volumes for Korean 2+1 roads.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.5
• /
• pp.124-134
• /
• 2011

To make popular the NEV(Neighborhood Electric Vehicles) uses, it must be considered the supply of infrastructure and the political decision for NEV. However, the guidelines of infrastructure for NEV are not prepared. The guidelines of infrastructure for NEV should be performed in many research and case. The purpose of this study is to reveal the influence of NEV on the two-lane highway traffic flows by TWOPAS simulation model. The main items to check the influence are Average Travel speed, Percent Time Spent Following and Total Delay. The scenario were setup by traffic volume. And the NEV percentages are changed from 1% ~ 30%. The scenario 1 which traffic volume are 650veh/h and the scenario 4 which traffic volume are 2,600veh/h are less influenced by NEV, compare to scenario 2, scenario 3. Because the scenario 1 is more free to make passing other cars and Scenario 4 is fully saturated with existing traffic volumes. The urban two-lane highway which has much traffic volume and the rural two-lane highway which has little traffic volume has affinity for NEV than the other two-lane highway.

• International Journal of Highway Engineering
• /
• v.14 no.2
• /
• pp.131-143
• /
• 2012

The past researches on roadway segment safety estimation focused on intersections, which are the primary traffic accident regions. The past researches on roadway segments, However, analyzed the effects of certain factors on the traffic accident occurrence rate by organizing the individual geometric structures of the roads, and there is still a dearth of researches on the development of a traffic accident estimation model for rural roadway segments. Therefore, this research focused on rural two-lane and multilane roadway segments and developed traffic accident estimation models through the application of statistical techniques. This is required to explain such high frequency of zero counts in the traffic accident data. In this research, it was found that the Hurdle model is more suitable than the Poisson or negative binomial-regression model for explaining the excess zeros case. In addition, main variables were chosen to estimate their effects on traffic accident occurrence at rural roadway segments, and the safety at such rural roadway segments was estimated. In this research, it was assumed that there are different factors that affect the safety at two-way lane and multilane roadway segments, and a traffic accident estimation model was developed by dividing the two-way lane and multilane roadway segments.

• Proceedings of the KOR-KST Conference
• /
• 1998.09a
• /
• pp.141-151
• /
• 1998

Provision of Passing Sight Distance (PSD) is an important component in two-lane highway design and has a critical impact on capacity of highway and safety of drivers. Many models have been developed to estimate PSD reasonably. However, each of them has a number of shortcomings for reflecting the real traffic conditions. This paper introduces a revised model that reflects the characteristics of the passing maneuver. The changes in passing sight distances under different assumptions about acceleration and vehicle length, which are related to vehicle types, are presented. The results obtained by the revised model are compared with those obtained from the existing models. There is an important link between geometric design decisions which determine the available sight distance and the quality of service which the road provides. In this paper, we examine one aspect of this relationship. That is to determine whether the passing sight distance is provided by improving horizontal alignment for a specific roadway section or passing may be restricted to save the road construction cost. To do so, a simple method for estimating traffic delay in no-passing is introduced.

• Journal of Korean Society of Transportation
• /
• v.26 no.2
• /
• pp.47-56
• /
• 2008

Two-Lane Highway of Korea is important, Because it has the largeest portion of all roads of Korea. But it has only one lane for one direction. So, If Delays are happened by low-speed vehicles, high-speed vehicles should over-take through the other side of the road. This over-takings can generate the high possibility of traffic accidents and the severity of traffic accidents by over-takings is very high. Because it generates a head-on collision. But the level of Service that indicates the operation states of Two-Lane Highway is defined as a conception that explains the operation conditions of traffic safety etc. Whencalculating the Level of service. It is considered by only delays. So, in this paper, first, this author wants to present the calculation of delay-time by Total-Delay Rate. Second, by multiplying this delay-time by the costs of delays wants to present the method of calulates the total delay costs. Third, to consider the traffic accidents, After predicting the number of traffic accidents, As multipling this by the average of costs of traffic accidents. want to present the method to calculate Total traffic accidents costs. Forth, present the operation costs.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.9 no.3
• /
• pp.75-88
• /
• 1989

The state-of-art knowledge of highway performance analysis model was developed in this research and a computerized process named GUCAM(Geometric-specific User Cost Analysis Model) was established to facilitate the computational procedure. A comparison of GUCAM was made to HIAP program using a case study of widening two-lane rural highway into four-lane rural. The comparison indicated that GUCAM was more realistic and sensitive to the highway geometric features by virtue of the new methodology for the distribution of highway curves and grades. However, the model still remains insensitive to improvements at isolated locations such as specific grades or curves. Further research is required to straighten out this problem.