• 동력기계공학회지
• /
• 제11권4호
• /
• pp.12-17
• /
• 2007

Recently, many small and medium size diesel vehicles have been equipped with turbocharger and EGR system to get high performance and reduce $NO_x$ emissions but its application to heavy-duty diesel engine is not common yet. In this work, the simulation model for EURO-3 engine was developed using WAVE and then its performance and emission level were verified by comparing with experimental results. The possibility of current EURO-3 engine equipped with LPL EGR system which would be satisfied the EURO-5 regulation are examined. ESC 13 mode was chosen as the primary engine test mode, and the injection timing and fuel quantity were changed to compensate the lost engine performance caused by EGR. The system developed in this study shows that the current EURO-3 engine could satisfy EURO-5 $NO_x$ regulation by applying LPL EGR.

• 대한조선학회논문집
• /
• 제61권1호
• /
• pp.8-18
• /
• 2024

The present study concerns reduced order modeling of a marine diesel engine, which can be used for outlier detection in status monitoring and carbon intensity index calculation. Principal Component Analysis (PCA) is introduced for the reduced order modeling, focusing on the feasibility of detecting and treating nonlinear variables. By cross-correlation, it is found that there are seven non-linear data channels among 23 data channels, i.e., fuel mode, exhaust gas temperature after the turbocharger, and cylinder coolant temperatures. The dataset is handled so that the mean is located at the nominal continuous rating. Polynomial presentation of the dataset is also applied to reflect the linearity between the engine speed and other channels. The first principal mode shows strong effects of linearity of the most data channels to show the linearity of the system. The non-linear variables are effectively explained by other modes. second mode concerns the temperature of the cylinder cooling water, which shows small correlation with other variables. The third and fourth modes correlates the fuel mode and turbocharger exhaust gas temperature, which have inferior linearity to other channels. PCA is proven to be applicable to data given in binary type of fuel mode selection, as well as numerical type data.

• 에너지공학
• /
• 제11권2호
• /
• pp.90-98
• /
• 2002

본 연구는 선회유동과 연소인자가 9.4L인 터보과급 디젤엔진의 성능과 배기가스특성에 미치는 영향을 실험적으로 고찰하였다. 일반적으로 디젤엔진의 연소과정에서 선회유동은 분사되고 있는 연료와 흡칩공기의 혼합을 촉진시켜 줌으로써 엔진성능을 향상시키는데 매우 중요한 인자가 된다. 특히 터보과급 디젤엔진에서는 실린더내의 고온.고압가스로 인하여 연비와 NO$_{x}$ 농도는 서로 상반관계를 가지므로 적절한 용량의 과급기선정으로 흡.배기시스템, 분사시스템 및 연소실의 설계 등을 고려할 필요가 있다. 본 연구의 결과로서, 정상유동실험을 통하여 선회비가 증가함으로써 평균유량계수가 감소하고, 반면에 걸프 펙터가 증가함을 알 수 있었다. 또한 엔진실험을 통하여 흡기포트의 선회비 2.43, 분사시기 BTDC 13$^{\circ}$ CA, 압축비 16, 리앤트란트 5$^{\circ}$형 연소실, 노즐분공경 $\Phi$0.28*6 및 과급기 GT40(압축기 A/R 0.58, 터빈 A/R 1.19)의 적용인자가 최적의 성능 및 배기가스를 만족시킬 수 있었다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2005년도 춘계학술대회
• /
• pp.243-247
• /
• 2005

This paper describes an on-going national R&D program for the development of a gas turbine/fuel cell hybrid power generation system and related R&D activities. The final goal of this program is to develop a 200kW-c1ass gas turbine/fuel cell hybrid power generation system and achieve high efficiency over $60\%$ (AC/LHV). In the first phase of the development, a sub-scaled 60kW-class hybrid system based on the 50kW-class microturbine and the 5kW SOFC will be developed for the purpose of concept proof of the hybrid system. Core components such as the microturbine and the SOFC system are being developed and parallel preparation for system integration is being carried out. Before the core components are assembled in the final system. operating characteristics of a hybrid system are investigated from a simulated system where a turbocharger (microturbine simulator) and a modified fuel cell burner test facility (fuel cell simulator) are employed. The 60kW demonstration unit will be built up and operated to provide the valuable information for the preparation of the final full scale 200kW hybrid system.

• 항공우주시스템공학회지
• /
• 제6권2호
• /
• pp.35-41
• /
• 2012

A reciprocating engine installed on a normal category airplane shall be effectively cooled by air flown through the engine compartment. A airplane powerplant designer has to design cooling air inlets, baffles, seals, and outlets to maintain cylinder head temperatures and oil temperature under the limits, and show compliance with appropriate airworthiness standard. In this study, cooling designs of the installed engine and compliance requirements applicable to the cooling designs were reviewed, and engine cooling flight test results were evaluated for design changes. Engine cooling certification test will be conducted in a next step.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 1999년도 유체기계 연구개발 발표회 논문집
• /
• pp.33-40
• /
• 1999

Upgrade development of a high pressure ratio centrifugal compressor in marine engine turbochargers is presented. A new matched operating point at increased speed of rotation was determined through system cycle analysis using the exisitng test data of turbine performance. Under some severe restrictions for geometric parameters, the state-of-the-art methods of both aerodynamic design and CFD analysis were applied, in which only an impeller, a vaned diffuser and some part of casing wall were modified. Prototype hardware was fabricated and assembled for system performance tests. Excellent performance in pressure ratio and efficiency was obtained over whole speed region. Reduced surge and choke margin was, however, observed at design speed of rotation.

• 대한기계학회논문집B
• /
• 제36권2호
• /
• pp.217-224
• /
• 2012

비도로용 차량의 경우 대부분 디젤엔진을 사용하여 엔진의 특성상 PM과 NOx의 배출이 많은 단점이 있다. 승용 및 상용 디젤 차량의 경우 CRDI 및 후처리 장치를 적용하였고 후처리 장치로 DOC/DPF를 장착함으로써 PM은 약 90% 이상 저감 가능하다. 상반관계인 NOx는 EGR 사용을 통해 1차적으로 NOx 배출량을 감소시키고 LNT, LNC, Urea-SCR 등의 DeNOx 시스템으로 NOx의 배출량을 보다 현저히 저감시켜 배기규제를 만족시키고 있다. 본 연구에서는 tier 4 interim 배기규제를 만족하기 위해 56kW급 오프로드 차량으로 연구를 진행하였다. NOx의 감소를 위해 WGT와 전자 제어방식의 HPL EGR 시스템을 적용하였고 CO와 THC, PM 배출가스를 줄이기 위해 DOC와 DPF를 사용하였다. EGR 시스템을 적용하기 위해 각 조건에 대한 기본 실험을 실시하여 EGR map을 작성하였다. 작성된 map을 NRTC 모드에서 시험하여 map의 적용성을 검증하고 tier 4 interim 배기규제 만족여부를 파악하였다.

• 해양환경안전학회지
• /
• 제29권6호
• /
• pp.697-703
• /
• 2023

최근 대기오염으로 인한 환경오염을 줄이고자 국제 산업계의 노력의 일환으로 국제해사기구(IMO)의 규제 발효등으로 이어지고 있다. IMO는 EEXI,EEDI,CII 등 선박에서 나오는 대기오염을 줄이기 위해 각종 규제를 발효시키고 선박에서 소모되는 전력을 줄여 에너지를 절약하는 방안을 추진하고 있다. 선박에서 사용되는 전력의 대부분은 전동기가 차지한다. 선박에 설치된 전동기 중 큰 부하를 차지하는 기관실 송풍기는 수요와 관계없이 정속운전으로 운전하기 때문에 주파수제어를 통한 에너지절감을 기대할 수 있다. 본 연구에서는 발전기의 과급기에 연소공기를 공급하는 발전기 송풍기의 전동기 주파수를 제어하여 에너지 절감에 대한 실효성을 입증하였다. 송풍기 주파수 입력에 따른 과급기출구 온도의 출력 데이터를 기반으로 시스템을 모델링하고, 과급기 출구온도를 목표값으로 하여 주파수를 제어하는 PI 제어계를 형성하여 과급기 설계기준 출구온도를 유지하면서 송풍기의 주파수 제어를 통해 연간 15,552kW 전력소모량을 절감하였다. 송풍기 팬 주파수 제어를 통한 에너지절감액의 유효성은 하계(4월~9월) 및 동계(3월~10월) 기간동안 검증하였으며 이를 토대로 실습선의 연간 6,091천원의 유류비 절약과 이산화탄소 8.5Ton, SOx 2.4kg, NOx 7.8kg의 대기오염물질 저감을 달성하였다.

• 동력기계공학회지
• /
• 제13권4호
• /
• pp.11-17
• /
• 2009

This paper deals with the effects of pulsating flow on volumetric efficiency, which may be generated during the gas exchange procedure, due to piston motion, valve event on intake and exhaust stroke and unsteady flow of turbocharger of a three-cylinder four stroke turbo-charged diesel engine. Consequently, volumetric efficiency affects significantly the engine performance; torque characteristics, fuel economy and further to emission and noise level. As the expansion ratio became larger the engine speed varies and torque increases, the pressure pulsation in an exhaust gas pipe acts as an increasing factor of intake air charging capacity totally. The phase and amplitude of pressure pulsation in the intake system only affects volumetric efficiency favorably, if it is well matched and tuned effectively to the engine. Thus, to verify the exact phase and amplitude of the pressure variation is the ultimate solution for the air-flow ratio assessment in the intake stroke. Some experimental results of pressure diagrams in the intake pipe and gas-flow of turbine in-outlet are presented, under various kinds of operating condition.

• 동력기계공학회지
• /
• 제15권6호
• /
• pp.11-15
• /
• 2011

This study investigated the symptoms of the a reduction in output while driving on the road, or increasing of fumer out exhaust gas on inclined road while working air-conditioner in summer. Notice how the experiment in 2010, the Ministry of Environment(Chapter No. 2010-46), and how the vehicle emissions inspection was carried out. 2500cc Diesel cars used in the study were used and compare to output of engine, exhaust gas, inhalation temperature measurement Inhalation of cold air has not been supplied to all agencies when comparing the results when cold air intake temperature of the supply air-conditioning switch range control from 1 to 4, the temperature drops $98^{\circ}C$ to $78^{\circ}C$. At the momentum of switch level 4, output from 63ps to 66ps after the connection has increased 9.6 percent, the highest concentration of exhaust emissions were reduced by 42.8%. This research can contribute in part to the reduction of exhaust directly supply into the cooling air intake line, doing the output of diesel cars in the summer. In addition, construction equipment and machinery that are currently being used excluding the engine's intercooler cooling of the supply line via a separate output in the summer and help reduce exhaust emissions is expected.