• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.950-955
• /
• 2004

Slip displacement is brought into focus to study the tube fretting wear that occurs on the contact by the springs. An oscillating tube was in contact with plate support springs. The contact condition was varied as normal force 5 N, and gaps of 0.1 and 0.2 mm in the experiment. The oscillation range of the tube was also varied as 0.2, 0.3, 0.4 and 0.7 mm. Formulas for predicting the slip displacement range were derived in terms of the vibration amplitudes measured during the tube oscillation. It was found that the slip displacement in transverse direction was much higher ($720{\sim}33000$ times) than that in axial one. This resulted in the severer wear on the contact suffered from transverse slip.

• 비파괴검사학회지
• /
• 제35권6호
• /
• pp.381-388
• /
• 2015

The speed and oscillation directions of elastic waves propagating in the [ab0] direction of a silicon single crystal were obtained by solving Christoffel's equation. It was found that the quasi waves propagate in the off-principal axis, and hence, the directions of the phase and group velocities are not the same. The maximum deviation of the two directions was $7.2^{\circ}$. Two modes of the pure transverse waves propagate in the [110] direction with different speeds, and hence, two peaks were observed in the pulse echo signal. The amplitude ratio of the two peaks was dependent on the initial oscillating direction of the incident wave. The pure and quasi-transverse waves propagate in the [210] direction, and the oscillation directions of these waves are perpendicular to each other. The skewing angle of the quasi wave was calculated as $7.14^{\circ}$, and it was measured as $9.76^{\circ}$. The amplitude decomposition in the [210] direction was similar to that in the [110] direction, since the oscillation directions of these waves are perpendicular to each other. These results offer useful information in measuring the crystal orientation of the silicon single crystal.

• 한국구조물진단유지관리공학회 논문집
• /
• 제15권1호
• /
• pp.209-214
• /
• 2011

본 연구에서는 효과적인 풍력발전기 블레이드의 상태 모니터링을 위하여 대표적 손상형태 중 하나인 로터의 질량 불균형으로 인한 이상상태를 감지할 수 있는 기법을 제안하였다. 이를 위하여 수평축 3-블레이드 풍력발전기를 대상으로, 블레이드 1개의 질량을 증가시키면서 로터의 질량 불균형 조건을 구현한 후 전체 풍력발전기에 대한 동력학 시뮬레이션을 수행하였다. 질량 불균형이 발생하면 부가질량에 의한 원심력에 의하여 나셀의 로터 회전축에 대한 횡방향 진동이 발생하고, 부가 질량의 크기가 커질수록 나셀 횡방향 진동의 진폭이 거의 선형적으로 증가함을 알 수 있었다.

• 소음진동
• /
• 제4권3호
• /
• pp.365-375
• /
• 1994

Periodic longitudinal vibrations of a video and audio tape and the like used for transducing pictures and sounds may be induced by self-excited vibrations which are caused by frictions against the heads and guides, and their eccentricity, noncircularity or irregularity. It is important to analyze the longitudinal vibration of a tape because it causes distortions of a reproduced signal. It is difficult to measure directly the longitudinal vibration. In this paper a method estimating longitudinal vibration using impulse responses in the transverse direction is presented. And, the parameters boundary domain where the transverse and longitudinal vibration can be decoupled is introduced. In the domain where the both vibrations are decoupled, analytic methods using frequency characteristics and transient responses of the transverse vibration, respectively, are presented. The time domain method predicted more exactly the instantaneous phase of the longitudinal vibration than frequency domain method did.

• 한국해양공학회지
• /
• 제2권1호
• /
• pp.46-58
• /
• 1988

The experimental investigations on the motion characteristics of a marine riser both in air and water were performed. The static deflections and natural frequencies of the riser in air including the effect of static offset, were obtained from the experiment. These results were compared with those of theoretical prediction by using a simple asymptotic formula. In order to investigate the nonlinear motion characteristics of the riser subject to nonlinear viscous drag and large displacement, the forced oscillation tests both in air and water were performed. In the forced oscillation tests in air, it was found that the transverse motion due to geometrical nonlinearity grows when the amplitude of in-line oscillation exceeds a certain critical value, say, order of 1-2 diameters. The planar motions of the riser in water due to vortex shedding and the geometrical nonlinearity were described. Some of these results were also compared with those of theoretical analysis, which uses a numerical perturbation technique based on the derived linear asymptotic solutions, and found to be generally in good agreement.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2003년도 추계 학술대회논문집
• /
• pp.126-131
• /
• 2003

A series of computational simulations have been carried out for supersonic flows in a scram jet engine with and without a cavity. Transverse injection of hydrogen, a simplest form of fuel supply, is considered in the present study with the injection pressure varying from 0.5 to 1.5 MPa. The corresponding equivalence ratios are 0.167 - 0.50. The work features detailed resolution of the flow dynamics in the combustor, which was not typically available in most of the Previous studies. In particular, oscillatory flow characteristics are captured at a scale sufficient to identify the underlying physical mechanisms. Much of the flow unsteadiness is related not only to the cavity, but also to the intrinsic unsteadiness in the flowfield. The interactions between shock waves and shear layer may cause a large excursion of flow oscillation. The role of the cavity and injection pressure are examined systematically.

• 천문학회보
• /
• 제44권1호
• /
• pp.53.2-53.2
• /
• 2019

$H{\alpha}$ surges (i.e. cool/dense collimated plasma ejections) may act as a guide for a propagation of magnetohydrodynamic waves. We report a high-resolution observation of a surge observed with 1.6m Goody Solar Telescope (GST) on 2009 August 26, from 18:20~UT to 18:45UT. Characteristics of plasma motions in the surge are determined with the normalizing radial gradient filter and the Fourier motion filter. The shape of the surge is found to change from a 'C' shape to an inverse 'C' shape after a formation of a cusp, a signature of reconnection. There are apparent upflows seen above the cusp top and downflows below it. The upflows show rising and rotational motions in the right-hand direction, with the rotational speed decreasing with height. Near the cusp top, we find a transverse oscillation of the surge, with the period of ~2 min. There is no change of the oscillation phase below the cusp top, but above the top a phase change is identified, giving a vertical phase speed about 86kms-1. As the height increases, the initial amplitude of the oscillation increases, and the oscillation damping time decreases from 5.13 to 1.18min. We conclude that the oscillation is a propagating kink wave that is possibly excited by an x-point oscillation.

• 대한물리의학회지
• /
• 제12권2호
• /
• pp.91-101
• /
• 2017

PURPOSE: The aim of this study was to verify the effect of trunk strengthening exercise using oscillation by comparing trunk muscle thickness, as well as balance of healthy adults during exercises performed with an oscillatory device and non-oscillatory device. METHODS: Twenty-two participants were randomly assigned to one of two groups: the trunk strengthening exercise using oscillation (TSEO) group (n=11) or the trunk strengthening exercise using non-oscillation (TSEN) group (n=11). Subjects in all groups performed the exercises three days per week for 6 weeks. All subjects performed four types of exercises: pull over, seated twist, power push, and diagonal power plank. Trunk muscle thickness of the rectus abdominis (RA), internal oblique (IO), external oblique (EO), transverse abdominis (TrA), and multifidus (MT) were measured with an ultrasonography. The balance ability were evaluated using the Romberg test with eyes open, eyes closed, one-leg standing test (OLST), and limits of stability (LOS). All tests were performed before the intervention, as well as after 6 weeks and 8 weeks of exercises. RESULTS: There was a significant difference of RA, IO, TrA, and MT according to the main effect of the time (p<.05). There was a significant difference of IO and LOS according to interaction effect between the time and group (p<.05). CONCLUSION: As intended, the cyclic forces induced by the oscillating device did increase trunk muscle thickness. However, the effect was limited and significant only for the IO muscle. Combining trunk strengthening exercise with oscillation appears to be more effective in improving dynamic balance.

• 대한조선학회논문집
• /
• 제43권3호
• /
• pp.322-330
• /
• 2006

Numerical calculations are carried out for flow past a circular cylinder forced oscillating normal to the free-stream flow at a fixed Reynolds number equal to 185. The cylinder oscillation frequency ranged from 0.8 to 1.2 of the natural vortex-shedding frequency, and the oscillation amplitude extended up to 20% of the cylinder diameter. IBM (Immersed Boundary Method) with direct momentum forcing was adopted to handle both of a stationary and an oscillating cylinder Present results such as time histories of drag and lift coefficients for both stationary and oscillating cases are in good agreement with previous numerical and experimental results. The instantaneous wake patterns of oscillating cylinder with different oscillating frequency ratios showed the synchronized wakes pattern in the lock-in region and vortex switching phenomenon at higher frequency ratio than the critical frequency ratio.

• Ocean Systems Engineering
• /
• 제1권4호
• /
• pp.355-372
• /
• 2011

Based on the fully nonlinear velocity potential theory, the liquid sloshing in a three dimensional tank under random excitation is studied. The governing Laplace equation with fully nonlinear boundary conditions on the moving free surface is solved using the indirect desingularized boundary integral equation method (DBIEM). The fourth-order predictor-corrector Adams-Bashforth-Moulton scheme (ABM4) and mixed Eulerian-Lagrangian (MEL) method are used for the time-stepping integration of the free surface boundary conditions. A smoothing scheme, B-spline curve, is applied to both the longitudinal and transverse directions of the tank to eliminate the possible saw-tooth instabilities. When the tank is undergoing one dimensional regular motion of small amplitude, the calculated results are found to be in very good agreement with linear analytical solution. In the simulation, the normal standing waves, travelling waves and bores are observed. The extensive calculation has been made for the tank undergoing specified random oscillation. The nonlinear effect of random sloshing wave is studied and the effect of peak frequency used for the generation of random oscillation is investigated. It is found that, even as the peak value of spectrum for oscillation becomes smaller, the maximum wave elevation on the side wall becomes bigger when the peak frequency is closer to the natural frequency.