• Archives of Pharmacal Research
• /
• 제11권2호
• /
• pp.81-86
• /
• 1988

The transfer of cupric sulfate across the rat small intestine in vitro was studied by perfusion method using the segments of everted rat small intestine. Copper transport was approximately propotional to the metal concentration in the mucosal solution and no difference was observed in the metal transport among rat duodenum, jejunum and ileum. It was suggested from these results that copper transport across the rat small intestine would occur by passive diffusion. The effect of various chelating agents on copper transport across the rat small intestine n vitro and its uptake by the intestine were also studied. Copper transport was greatly enhanced in the presence of EDTA and NTA. Copper uptake decreased to a greater extent in the presence of EPTA and NTA.

• 한국지반공학회논문집
• /
• 제27권1호
• /
• pp.35-40
• /
• 2011

하저 또는 해저 퇴적오염물질 처리 및 제거는 준설과 매립에 의해 활발히 진행되었다. 그러나 준설과 매립은 준설과정에서 발생하는 퇴적오염물질의 교란, 매립지 선정문제, 고비용 공사비 등으로 인한 많은 제약이 따르고 있다. 이러한 문제로 인해 협소한 지역의 퇴적오염물질에 대해서는 오염물질의 용출 저감을 위한 현장 캡핑이 근래 들어 많이 사용되고 있다. 현장 캡핑에 따른 오염물질 이동에 관해서는 분자확산에 의한 영향이 지배적으로 해석되어 왔으나, 근래 들어 보다 정확한 모사를 하기 위하여 이류-확산을 복합적으로 해석할 필요성이 제기되었다. 퇴적물은 초기 함수율이 높은 슬러지(sludge)상태로 비교적 적은 상재하중과 자중에 의한 압밀이 발생하고, 압밀 과정에서 발생한 간극수 흐름의 변화는 오염물질의 이류에 의한 이동에도 영향이 미친다. 본 연구에서는 기존의 연구에서 수행된 압밀 과정에서 오염물질의 이동뿐만 아니라 압밀 후 간극비의 감소에 따른 오염물질 이동의 변화에 대하여 분석하고자 한다.

• Nuclear Engineering and Technology
• /
• 제41권4호
• /
• pp.381-390
• /
• 2009

This article provides selects of outstanding problems in computational neutron transport, with some suggested approaches thereto, as follows: i) ray effect in discrete ordinates method, ii) diffusion synthetic acceleration in strongly heterogeneous problems, iii) method of characteristics extension to three-dimensional geometry, iv) fission source and $k_{eff}$ convergence in Monte Carlo, v) depletion in Monte Carlo, vi) nuclear data evaluation, and vii) uncertainty estimation, including covariance data.

• 한국의류학회지
• /
• 제24권6호
• /
• pp.810-818
• /
• 2000

The purpose of this study was to analyze the effect of geometrical structure on the moisture transport properties of nonwoven batting materials. Two types of nonwovens were used such as single and double layered nonwovens. Steady and dynamic state water vapor transport properties were measured by absorption, evaporation and cobaltous chloride method respectively. The results of this study were as follows: 1) Geometrical structure affected water vapor evaporation, but there were no differences between single and double layered nonwovens in moisture absorption. Thickness and air permeability were influencing factor on water vapor transport rate. 2) Directionality of double layered nonwoven was observed both in steady and dynamic state moisture transport. There were differences between upper and lower layer of double layered nonwoven both in moisture absorption rate and color change by cobaltous chloride method. 3) In dynamic state of water vapor transport rate, single layered nonwoven reached more rapidly at the established relative humidity. It was confirmed that geometrical structure affected water vapor evaporation and hydrophilicity of fiber affected moisture absorption because there were much more water vapor transport rate by evaporation than absorption within the same period of time.

• 한국전기전자재료학회논문지
• /
• 제14권3호
• /
• pp.251-256
• /
• 2001

Bi-2223 tapes have been developed for low-field power applications at liquid nitrogen temperature. When the Bi-2223 tapes are used in an application such as a power transmission cable or a power transformer, they are supplied with an AC transport current simultaneously. AC loss taking into account such real applications is a crucial issue for power applications fo the Bi-2223 tapes to be feasible. In this paper, the transport losses for different AC current levels and arrangements of the neighboring tapes have been measured in a 1./5 m long Bi-2223 tape. The significant increase of the transport losses due to neighboring tape's AC currents is observed. An increase of the transport losses caused by a decrease of the Bi-2223 tape's critical current is a minor effect. The measured trasprot losses could not be explained by a dynamic resistance loss based on DC voltage-current characteristics in combination with the neighboring tape's AC currents.The trasport losses do not depend on the frequency of the neighboring tape's AC currents but is arrangements in the range of small current especially.

• Membrane and Water Treatment
• /
• 제3권4호
• /
• pp.243-252
• /
• 2012

Tri-n-butyl phosphate (TBP) was used as carrier for the transport of Golden yellow and Cibacron LSG dyes through a hexane bulk liquid membrane. The transport efficiency of dyes by TBP was investigated under various experimental conditions such as pH of the feed phase (dyes solution), concentration of the receiving phase (NaOH solution), concentration of TBP in membrane, rate of stirring, effect of transport time, type of solvent, dye concentration in feed phase, effect of temperature.. The maximum transport dyes occurs at ratio of 1:1 TBP-hexane At pH 3.0 0.1 (feed phase) the transport dyes decreased. At high stirring speed (300 rpm) the dyes transport from the feed phase to the strip phase was completed within 60 minutes at $27^{\circ}C$. Under optimum conditions: Feed phase 100 mg/L dyes solution at pH 1.0 0.1, receiving phase 0.1 mol/L NaOH solution, membrane phase 1:1 TBP-hexane , Stirring speed 300 rpm and temperature $27^{\circ}C$, the proposed liquid membrane was applied to recover the textile effluent.

• 한국해양환경ㆍ에너지학회지
• /
• 제5권1호
• /
• pp.19-29
• /
• 2002

본 논문에서는 운송시간과 운송비용으로 구성되는 희생량 모델과 각 운송경로별 CO₂배출량을 고려한 수출입 컨테이너화물의 운송경로 선택에 관하여 고찰한다. 먼저 부산항을 이용하는 수출입 컨테이너화물의 물동량과 운송경로별 분담, 국내외 CO₂배출량 현황, 희생량 모델, 수출입 컨테이너화물의 시간가치에 대하여 간단히 살펴본다. 그리고 서울에서 발생한 수출입 컨테이너화물을 부산항으로 운송하는 경우를 가정하고 희생량 모델을 이용하여 계산한 각 운송경로별 희생량에 기초한 운송경로의 선택에 대하여 고찰한다. 또한 화물의 운송에 의하여 발생하는 CO₂배출량을 고려하여 결정한 환경부하 희생량을 추가한 희생량 모델을 이용한 운송경로의 선택에 대해서도 고찰한다. 본 연구의 결과, 희생량 모델에 기초한 컨테이너화물의 운송경로 선택이 수출입 컨테이너화물의 국내 수송 현황을 잘 나타내고 있는 것을 확인하였다. 또한 연안운송의 운송분담율을 높이기 위해서는 운송시간의 단축이 가장 효과적인 것을 확인하였다.

• 센서학회지
• /
• 제25권5호
• /
• pp.310-319
• /
• 2016

Three types of gap sensors, a capacitive gap sensor, an eddy current gap sensor, and a Hall effect gap sensor are described and evaluated through experiments for the purpose of precise gap sensing for micrometer scale movement, and a novel type of differential hall effect gap sensor is proposed. Each gap sensor is analyzed in terms of resolution and environment dependency including temperature dependency. Furthermore, a transport system for AMOLED deposition is introduced as a typical application of gap sensors, which are recently receiving considerable attention. Based on the analyses, the proposed differential Hall effect gap sensor is found to be the most suitable gap sensor for precise gap sensing, especially for application to a transport system for AMOLED deposition. The sensor shows resolution of $0.63mV/{\mu}m$ for the overall range of the gap from 0 mm to 2.5 mm, temperature dependency of $3{\mu}m/^{\circ}C$ from $20^{\circ}C$ to $30^{\circ}C$, and a monotonic characteristic for the gap between the sensor and the target.

• Bulletin of the Korean Chemical Society
• /
• 제35권5호
• /
• pp.1559-1561
• /
• 2014

• 한국해양공학회지
• /
• 제10권1호
• /
• pp.100-107
• /
• 1996

In this paper, we report the results of the experimental study on the flow and the mass transport around a square harbor driven by a tidal effect. The model harbor is composed of a uniform water-depth with a straight breakwater. The harbor is connected to the outer ocean by an entrance region having the same shape as the harbor. We investigated two cases, one having another breakwater in the place between the entrance region and the outer ocean, and the other without it, The surface and bottom flow patterns of the model container are visualized by using light particles and dye, respectively. It was shown that the inner harbor and the entrance region have well-organized, large vortical residual flows, and the material transport between the entrance and outer region is however significantly different for two cases; when the breakwater is built between the two regions, the transport is far better than that without it, which is clearly contrary to our common sense that the breakwater would block the dispersion of the materials between the harbor and the outer ocean.