• Journal of Power Electronics
• /
• v.14 no.5
• /
• pp.1008-1027
• /
• 2014

An electric scooter with a V-belt continuously variable transmission (CVT) driven by a permanent magnet synchronous motor (PMSM) has a lot of nonlinear and time-varying characteristics, and accurate dynamic models are difficult to establish for linear controller designs. A PMSM servo-drive electric scooter controlled by a novel hybrid modified recurrent Legendre neural network (NN) control system is proposed to solve difficulties of linear controllers under the occurrence of nonlinear load disturbances and parameters variations. Firstly, the system structure of a V-belt CVT driven electric scooter using a PMSM servo drive is established. Secondly, the novel hybrid modified recurrent Legendre NN control system, which consists of an inspector control, a modified recurrent Legendre NN control with an adaptation law, and a recouped control with an estimation law, is proposed to improve its performance. Moreover, the on-line parameter tuning method of the modified recurrent Legendre NN is derived according to the Lyapunov stability theorem and the gradient descent method. Furthermore, two optimal learning rates for the modified recurrent Legendre NN are derived to speed up the parameter convergence. Finally, comparative studies are carried out to show the effectiveness of the proposed control scheme through experimental results.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.17 no.1
• /
• pp.19-23
• /
• 2009

This paper focuses on vehicle fuel economy improvement using D-Range neutral control of automatic transmission. The system objected to reducing of fuel consumption during idle. Usually, turbine of conventional auto transmission is mechanically linked to wheel during idling condition. Therefore speed ratio of torque converter is zero for that period. This causes needless power loss by the torque converter slip. To improve this inefficiency automobile makers develops electronically-controlled D-range neutral control system. The D-range neutral control system minimizes slip on the torque converter by shifting gear to a neutral position during vehicle stoped with D-range gear position. However there's insufficient study about the effect of D-range neutral control system on vehicle fuel economy. In this paper, researches are performed on effect of D-range neutral control system on vehicle fuel economy by experiment with two different vehicle. And it is also estimated the effect on vehicle fuel economy using computer simulation. As a result, 1.8% of LA-4 mode fuel economy improvement can be achieved in a vehicle by D-range neutral control system.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.14 no.3
• /
• pp.285-289
• /
• 2004

Recently, due to the high development of the internet, needs for multimedia streams such as digital audio and video is increasing much more. In case of transmitting multimedia streams using the User Datagram Protocol (UDP), it may cause starvation of TCP traffic on the same transmission path, thus resulting in congestion collapse and enormous delay because UDP does not perform TCP-like congestion control. Because of this problem, diverse researches are being conducted on new transmission schemes and protocols intended to efficiently reduce the transmission delay of real-time multimedia streams and perform congestion control. The TCP-friendly congestion control schemes can be classified into the window-based congestion control, which uses the general congestion window management function, and the rate-based congestion control, which dynamically adjusts transmission rate by using TCP modeling equations and the like. In this paper, we suggest the square-root congestion avoidance algorithm with the hybrid TCP-friendly congestion control scheme which the window-based and rate-based congestion controls are dealt with in a combined way. We apply the proposed algorithm to the existing TEAR. We simulate the performance of the proposed TEAR by using NS, and the result shows that it gives better improvement in the stability needed for providing congestion control than the existing TEAR.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.3 no.4
• /
• pp.433-445
• /
• 2014

Single phase voltage source converter (VSC) is an important power electronic converter (PEC), including single-phase voltage source inverter (VSI), single-phase voltage source rectifier (VSR), single-phase active power filter (APF) and single-phase grid-connection inverter (GCI). As the fundamental part of large scale PECs, single-phase VSC has a wide range of applications. In the paper, as first, on the basis of the concept of the discontinuous pulse-width modulation (DPWM) for three-phase VSC, a new DPWM of single-phase VSR is presented by means of zero-sequence component injection. Then, the transformation from stationary frame (abc) to rotating frame (dq) is designed after reconstructing the other orthogonal current by means of one order all-pass filter. Finally, the presented DPWM based single-phase VSR is established analyzed and simulated by means of MATLAB/SIMULINK. In addition, the DPWMs presented by D. Grahame Holmes and Thomas Lipo are discussed and simulated in brief. Obviously, the presented DPWM can also be used for single-phase VSI, GCI and APF. The simulation results show the validation of the above modulation algorithm, and the DPWM based single-phase VSR has reduced power loss and increased efficiency.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.4
• /
• pp.53-60
• /
• 2011

In Wireless Sensor Networks, IEEE 802.11 happen unnecessary energy consume because of packet transmission using maximum power between sensor node. The BASIC scheme is to use maximum transmission power for RTS-CTS and minimum required transmission power so as to high energy efficiency for DATA-ACK. However BASIC scheme may degrade network throughput with collision of ACK packet by node in carrier sensing zone and may result in higher energy consumption than when using IEEE 802.11 without power control. Existing PCM(Power Control MAC) scheme is to use DATA packet transmission method by periodically maximum power level so as to sensing DATA packet transmit in carrier sensing zone of transmission node, and this method can avoid collision of ACK packet. This paper present problem by energy efficiency of PCM scheme, and design some more improved PCM scheme.

• 대한공업교육학회지
• /
• v.33 no.1
• /
• pp.233-248
• /
• 2008

Stream Control Transmission Protocol(SCTP) is a new transport protocol that is known to provide improved performance than Transmission Control Protocol(TCP) in multi-homing environment that is having two and more IP addresses. But currently single-homed computer is used primarily that is having one IP address. To identify whether mean transfer time for SCTP is faster that for TCP in single-homed environment considering packet loss, we make up real testbed regulating the bandwidth, delay time and packet loss rate on router and observe the transfer time. We write server and client applications to measure SCTP and TCP mean transfer time by C language. Analysis of these experimental results from the testbed implementation shows that mean transfer time of SCTP is not better than performance of TCP in single homed environment exceptional case. Main reasons of performance are that SCTP compared to TCP stops transmitting data by timeout and data transmission is often delayed when SACK congestion happens. The result of study shows that elaborate performance tuning is required in developing a new SCTP module or using a implemented SCTP module.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.7
• /
• pp.3176-3183
• /
• 2011

Traffic and congestion control in the wireless sensor network is an important parameter that decides the throughput and QoS (Quality of Service). This paper proposes a transmission rate priority-based traffic control scheme to serve digital contents streaming in wireless sensor networks. In this paper, priority for transmission rate decides on the real-time traffic and non-real-time with burst time and length. This transmission rate-based priority creates low latency and high reliability so that traffic can be efficiently controlled when needed. Traffic control in this paper performs the service differentiation via traffic detection process, traffic notification process and traffic adjustment. The simulation results show that the proposed scheme achieves improved performance in delay rate, packet loss rate and throughput compared with those of other existing CCF and WCA.

• Proceedings of the KSR Conference
• /
• 2008.11b
• /
• pp.1370-1378
• /
• 2008

In the system necessary for safety such as the train control system, to make train control information be sent correctly is very important. In the case of the system such as RF-CBTC(Radio Frequency-Communication Based Train Control), sometimes failure in correctness of train controlling information may happen because the information is sent throughout wireless transmission between on-board system of a train and wayside transmitter, and then, it is exposed to noises. Of RF-channel interference, there are various forms. Under the environment of mobile telecommunications, adjacent-channel interference and Co-channel interference are in trouble, and under the environment of the wireless LAN, inter-symbol interference is in trouble. Also, the system of the cellular CDMA mobile telecommunication is affected on the RF-channel interference such as Doppler effect, multi-cell interference, and other users' intervention. In this paper, we analyzed the effect of the train control information related to fading, intervention and other noises made in the underground interval and explained the transmission characteristics numerically. Furthermore, we calculated the mean of the error terms by increasing users in the system of the cellular CDMA. As the method for decrease the error term of sent information, we represented the way adjusting the arrangement of antennas, and we did the model related to the system of RF-CBTC in which the location of an antenna is calculated with really measured value of the transmission characteristics and the way confirming reliability of the wireless transmission.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.47 no.4
• /
• pp.63-70
• /
• 2010

In IEEE 802.11e system providing differentiated services, there exist some problems as follows; collision probability increase due to the increase in the number of nodes by employing CSMA/CA transmission mode, transmission speed declining tendency towards the worst of it, which is caused by different transmission mode and decrease of TCP transmission rate as the result of the link occupancy by UDP when TCP shares the link with UDP by the TCP’s flow control characteristic. In this thesis, the initial minimum and maximum CW are set differently according to the number of connected nodes in the network to avoid collisions and TXOP is adjusted according to the channel state, in which ACs with low priority but better channel state will get gradually more chances to transmit leading to optimal channel capacity. Also, by allowing higher priority for ACK frames which control the TCP transmission, the flow control becomes better because that reduces the channel occupancy by UDP flow, and by this, fair transmission is obtained from the result of the more fair transmission and active resource allocation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.2B
• /
• pp.44-52
• /
• 2005

This paper proposes a neural network prediction model to improve the valid packet transmission rate for the QoS(Quality of Service) of multimedia transmission. The Round Trip Time(RTT) and Packet Loss Rate(PLR) are predicted using a neural network and then the transmission rate is decided based on the predicted RTT and the PLR. The suggested method will improve the transmission rate since it uses the rate control factors corresponding to time of data is being transmitted, while the conventional one uses the transmission rate determined based on the past informations. An experimental set-up has been established using a Linux PC system, and the multimedia data are transmitted using UDP protocol in real time. The valid transmitted packets are about 5% higher than the one in the conventional TCP-Friendly congestion control method when the suggested algorithm was applied.