• Bulletin of the Society of Naval Architects of Korea
• /
• v.12 no.2
• /
• pp.35-42
• /
• 1975

This paper investigates the distribution of stress and its behavior at the Root Toe in fillet welding joint. Furthermore, the stress components and principal stresses in the fillet welds are calculated by the finite element method. The distribution of stresses obtained numerically by means of the finite element method is also compared with the experimental results of two dimensional photoelasticity. A Cover plate type and Center block type of fillet welds are used as models for the numerical calculations covering the variations of 2 W/M(thickness of main plate/thickness of cover plate)=1 through 2W/M=4. The results obtained in these studies are summarized as follows; 1) When W2/M values become small, the stress concentration factors of the Root are larger than of the Toe in a C-type. Its critical value is 2W/M=3.00. However, no critical value exists in a T-type. 2) For 2W/M Values being avove 3.5 in a C-type and above 4.0 in a T-type, $K_R$ and $K_{\tau}$ become 1. 3) According to the differences of 2W/M values, the differences in stress become increasing in the Root but become decreasing in the Toe. These differences, however, disappear as the free boundary surface is approached. 4) The stress concentration factors of both the Root and Toe obtained by means of the finite element method have somewhat lower values than obtained by the photoelasiticity. But their principal stress directions coincide in either method. 5) It proves beneficial to employ the finite element method for two-dimensional plane stress analysis in front fillet welding joint.

• Physical Therapy Rehabilitation Science
• /
• v.7 no.1
• /
• pp.35-40
• /
• 2018

Objective: The purpose of this study was to investigate the immediate effect of applying self-myofascial release (SMR) to the plantar fascia using a foam roller on hamstring and lumbar spine superficial back line (SBL). Design: Randomized controlled trial. Methods: Thirty-one healthy adults agreed to the method and purpose of the study. Selection and exclusion criteria were screened, and baseline measurements for the Toe Touch test and passive straight leg raise (PSLR) test were obtained. The participants were then randomly assigned to the SMR group or the sham group. After group assignment, the SMR group rolled the surface of the foot from the heel to the metatarsal head using a foam roller for 5 minutes. The sham group received passive mobilization of the ankle joint in the supine position. Afterwards, the Toe Touch test and the passive straight leg-raise test were re-assessed. Results: In the SMR group, the Toe Touch test results showed significant improvement (p<0.05). Left and right PSLR test results showed a significant increase (p<0.05). In the sham group, there was no significant difference between pre and post-test results. The SMR group showed a significant difference in the PSLR test and Toe Touch test compared to the sham group (p<0.05). Conclusions: The results of this study showed that SMR on the plantar fascia was immediately effective for improving the flexibility of the SBL of the lumbar spine and hamstring.

• Physical Therapy Rehabilitation Science
• /
• v.7 no.1
• /
• pp.41-47
• /
• 2018

Objective: To investigate the effect of performing three different toe touch (TT) task condition on the activities of four different muscles using surface electromyography (sEMG) in healthy young adults. Design: Cross-sectional study. Methods: A total of 20 healthy young adults (6 males, 14 females) voluntarily participated in this study. All subject randomly performed three different TT task conditions as follows: general toe-touch (GTT) task, one side toe touch (TT) task during weight bearing, and one side foward toe touch (FTT) task during weight bearing. The muscle activities of erector spinae (ES), gluteus maximus (GM), hamstring (HAM), tibialis anterior (TA) muscles during the TT task were measured using sEMG. Subject performed each of the three conditions three time in random order and mean values were obtained. Results: With the trunk flexion period, the TT and FTT showed significantly greater muscle activity in the GM, HAM and TA compared to the GTT task (p<0.05). The TT position showed significantly greater HAM muscle activity than the GTT position. The dominant and nondominant ES muscle activity was significantly greater in the FTT compared to the GTT position (p<0.05). The dominant GM, HAM, and TA was significantly greater in the TT and FTT compared to the GTT position (p<0.05). Although the dominant ES was significantly greater in the TT and FTT compared to the GTT position (p<0.05), the dominant GM muscle activity was signifcantly greater in the TT compared with the GTT position (p<0.05). Conclusions: These findings may be applicable within the clinical field for selective trunk and lower extremity muscle activation and basic biomechanics purpose.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.11
• /
• pp.2114-2118
• /
• 2010

The purpose of this study was to analyze bradykinesia of toe tapping movement in patients with Parkinson's disease (PD) as compared to those of normal subjects. 39 PD patients (age: $65.5{\pm}11.2$ yrs, H&Y stage:$2.3{\pm}0.5$), 14 eldelry subjects with comparable mean age ($65.0{\pm}3.9$ yrs) and 17 healthy young subjects ($24.1{\pm}2.1$ yrs) participated in this study. Angular velocity during repetitive toe tapping movement was measured in both feet using a gyro sensor system. Suggested quantitative measures of bradykinesia were root-mean-squared (RMS) angular velocity, RMS angle, peak power and total power which were derived from the angular velocity signal. ANOVA showed that all measures were significantly different among three groups (p<0.001). Subsequent post-hoc test revealed that all measures in PD patients were significantly smaller than in healthy elderly and healthy young subjects (p<0.02). All measures were significantly correlated with UPDRS scores(r=-0.689~-0.825). These results suggest that the developed system can be used as quantitative measures of the lower limb bradykinesia in PD patients.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.12
• /
• pp.1810-1814
• /
• 2017

This paper develops an approach to the algorithm of Gait pattern Analysis and step measurement with Multi-Pressure Sensors. The process of gait consists of 8 steps including stance and swing phase. As 3 parts of foot is supporting most of human weight, multiple pressure sensors are attached on the parts of foot: forefoot, big toe, heel. As 3 parts of foot is supporting most of human weight, multiple pressure sensors are attached on the parts of foot: forefoot, big toe, heel. normal gait proceed from heel, forefoot and big toe over time. While normal gait proceeds, values of heel, forefoot and big toe can be changed over time. So Each values of pressure sensors over time could discriminate whether it is normal or abnormal gait. Measuring Device consists of non-inverting amplifiers and low pass filter. Through timetable of values, normal gait pattern can be analyzed, because of supported weight of foot. Also, the peak value of pressure can judge whether it is walking or running. While people are running, insole of shoes is floating in the air on moment. Using this algorithm, gait analysis and step count can be measured.

• Korean Journal of Applied Biomechanics
• /
• v.20 no.4
• /
• pp.381-386
• /
• 2010

This study examined the changes in the walking pattern during level walking under low illumination conditions. Fourteen male subjects ($22.1{\pm}2.21$ years, $174{\pm}3.74\;cm$, $68.86{\pm}10.81\;kg$) with normal vision and no disabilities were enrolled in this study. All experiments were performed on a level walkway with three conditions: normal walking (preferred & low speed) and walking with low illumination. 3D motion capturing system was used for acquisition and analysis of the walking motion data with a sampling frequency of 120Hz. The walking speed, normalized jerk(NJ) at the center of mass(COM), wrist and heel, knee and elbow joint angle, ratio of the knee joint angle to elbow joint angle and the toe clearance on stance phase were used to compare the differences in walking pattern between the two illumination conditions, The results showed that the walking speed and joint angles decreased in low illumination, whereas the NJ and toe minimum clearance increased. In low illumination, most variables were similar to effects of low speed walking, but toe clearance was different from the effects of low speed. These results can be used as primary data for examining the changes in the level walking pattern of young adults under low illumination. Further study will be needed to compare these results in young adults with those in the elderly.

• Journal of Korean Medicine Rehabilitation
• /
• v.29 no.4
• /
• pp.143-149
• /
• 2019

The purpose of this study is to report the effect in treating a patient with delayed union of 4th toe distal phalanx fracture with a combination of Korean Medicine treatment. We treated the patient with acupuncture, cupping, pharmacopuncture, moxibustion and herbal medicine, from March 3, 2018 to June 25, 2018 (total 33 times). The numeric rating scale (NRS), X-ray were applied as outcome measures. After complex Korean medicine treatment was carried out, delayed union of 4th toe distal phalanx fracture was improved and pain was reduced. This result shows that Korean medicine treatment may be an effective option for delayed union. Further clinical studies are needed to clarify the effect of Korean medicine treatment on delayed union.

• Journal of Korean Foot and Ankle Society
• /
• v.23 no.1
• /
• pp.18-23
• /
• 2019

Purpose: This study compared and analyzed the risk factors that affect a wound healing group and healing failure group. Materials and Methods: From 2010 to 2018, 39 patients who had suffered a single toe amputation were evaluated retrospectively. The patients were divided into two groups (wound healing group and healing failure group - within at least 3 months following the amputation). Regarding the possible risk factors, age, gender, Wagner and Brodsky classifications, duration of diabetes mellitus, whether the patient had peripheral arterial occlusive disease (PAOD) or cardiovascular disease, body mass index, HbA1c, total cholesterol, estimated glomerular filtration rate (eGFR), blood urea nitrogen (BUN), smoking, and alcohol were investigated. Results: The mean duration of diabetes mellitus was 140 months in the healing group and 227 months in the healing failure group, and the duration of diabetes was significantly longer in the failure group (p=0.009). A significant difference in eGFR was observed between the two groups ($59.17mL/min/1.73m^2$ in the healing group and $31.1mL/min/1.73m^2$ in the failure group) (p=0.022). Sixteen patients with PAOD were found, all 10 patients in the healing failure group were PAOD patients. Conclusion: To reduce the additional complications in single toe amputation patients, the underlying disease and appropriate treatment are the most important factors. In addition, a more proximal level of amputation also should be considered in cases of patients with PAOD, high BUN and low eGFR, and patients with long-term diabetes.

• Journal of Information Technology Services
• /
• v.20 no.3
• /
• pp.41-56
• /
• 2021

New drug discovery and development research enable clinical treatment that saves human life and improves the quality of life, but the possibility of success with new drugs is significantly low despite a long time of 14 to 16 years and a large investment of 2 to 3 trillion won in traditional methods. As artificial intelligence is expected to radically change the new drug development paradigm, artificial intelligence new drug discovery and development projects are underway in various forms of collaboration, such as joint research between global pharmaceutical companies and IT companies, and government-private consortiums. This study uses the TOE framework and the Value-based Adoption Model, and the technical, organizational, and environmental factors that should be considered for the acceptance of AI technology at the level of the new drug research organization are the value of artificial intelligence technology. By analyzing the explanatory power of the relationship between perception and intention to use, it is intended to derive practical implications. Therefore, in this work, we present a research model in which technical, organizational, and environmental factors affecting the introduction of artificial intelligence technologies are mediated by strategic value recognition that takes into account all factors of benefit and sacrifice. Empirical analysis shows that usefulness, technicality, and innovativeness have significantly affected the perceived value of AI drug development systems, and that social influence and technology support infrastructure have significant impact on AI Drug Discovery and Development systems.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.5A
• /
• pp.665-672
• /
• 2008

In the study herein, the fatigue test was conducted on the fillet welds of the load carrying cruciform joint, which is frequently used in the steel structures such as bridges, ships, etc. In addition, the fatigue strength was analyzed with respect to the different post-weld treatment. The treatment methods used include Toe Grinding, TIG Dressing, and Weld Profiling. The fatigue test was under constant amplitude with repeated load for these test specimens. In the load carrying full penetration fillet welded joints, regardless the conduction of the post-weld treatment or not, they all secured the fatigue strength of category "F", which exceeds the fatigue design specifications of BS Code. In the comparison of the fatigue strength upon the post-weld treatment, the fatigue strength tends to increase according to the order: Toe Grinding, TIG Dressing, and Weld Profiling.