• Journal of the Korean Society of Radiology
• /
• v.16 no.6
• /
• pp.681-686
• /
• 2022

In this study, a scintillation resin for 3D printing was fabricated with 1.0 wt% of PPO organic scintillator, 5.0 wt% of MMA, and commercial acrylic resin. Using the scintillation resin, 3D-shaped plastic scintillator radiation sensors were successfully fabricated quickly and inexpensively with a commercial 3D DLP printer. The 3D printed plastic scintillator has a good dose-output linearity of R-square 0.998 was obtained in the range of 1 to 10 nA of beam current of the 45 MeV proton beam. The developed 3D plastic scintillator has low light output, so there is a limit to its use in low-dose-rate gamma-ray or X-ray dosimetry. However, it was confirmed that the tissue equivalent material could be usefully used for measuring high energy or high dose rates radiation, such as proton beams and ultra-high dose rate beams.

• Journal of the Korean Society of Radiology
• /
• v.17 no.6
• /
• pp.1001-1007
• /
• 2023

Dose limits are not applied to medical radiation exposure therefore justification and optimization should be essential for protecting radiation. This study explores methods to reduce exposure dose undergoing general radiation exam by bolus(tissue equivalent material) with keeping image quality. Hand PA projection with 50 kVp, 5 mAs, SID 100 cm, and 8×10 inch is referred by covered bolus of thickness 0, 3, 5, 8, and 10 mm for evaluation entrance dose and SNR. The entrance dose (μGy) to the hand by bolus thickness was 125.41±0.288, 106.85±0.255, 104.97±0.221, 91.68±0.299, and 90.94±0.106 showing a significant reduction in radiation exposure depending on if the bolus was used and bolus thickness. The SNR of the image was 13.997, 13.906, 12.240, 12.538, and 12.548 at each bolus thickness, showing no significant difference. It was confirmed that if appropriate thickness and size of bolus is used depending on the type of radiological imaging exam and the body site, a significant radiation dose reduction effect can be achieved without deteriorating image quality.

• Journal of Biomedical Engineering Research
• /
• v.44 no.1
• /
• pp.85-91
• /
• 2023

Stress urinary incontinence (SUI) occurs when abdominal pressure increases, such as sneezing, exercising, and laughing. Surgical and non-surgical treatments are the common methods of SUI treatment; however, the conventional treatments still require continuous and invasive treatment. Laser have been used to treat SUI, but excessive temperature increase often causes thermal burn on urethra tissue. Therefore, the optimal conditions must be considered to minimize the thermal damage for the laser treatment. The current study investigated the feasibility of the laser irradiation condition for SUI treatment using non-ablative 980 nm laser from a safety perspective through numerical simulations. COMSOL Multiphysics was used to analyze the numerical simulation model. The Pennes bioheat equation with the Beer's law was used to confirm spatio-temporal temperature distributions, and Arrhenius equation defined the thermal damage caused by the laser-induced heat. Ex vivo porcine urethral tissue was tested to validate the extent of both temperature distribution and thermal damage. The temperature distribution was symmetrical and uniformly observed in the urethra tissue. A muscle layer had a higher temperature (28.3 ℃) than mucosal (23.4 ℃) and submucosal layers (25.5 ℃). MT staining revealed no heat-induced collagen and muscle damage. Both control and treated groups showed the equivalent thickness and area of the urethral mucosal layer. Therefore, the proposed numerical simulation can predict the appropriate irradiation condition (20 W for 15 s) for the SUI treatment with minimal temperature-induced tissue.

• Clinics in Shoulder and Elbow
• /
• v.19 no.1
• /
• pp.51-58
• /
• 2016

The arthroscopic rotator cuff repair is now considered a mainstream technique with highly satisfactory clinical results. However, concerns remain regarding healing failures for large and massive tears and high revision rate. In recent decades, various repair strategies and construct configurations have been developed for rotator cuff repair with the understanding that many factors contribute to the structural integrity of the repaired construct. The focus of biomechanical test in arthroscopic repair has been on increasing fixation strength and restoration of the footprint contact characteristics to provide early rehabilitation and improve healing. These include repaired rotator cuff tendon-footprint motion, increased tendon-footprint contact area and pressure, and tissue quality of tendon and bone. Recent studies have shown that a transosseous tunnel technique provides improved contact area and pressure between rotator cuff tendon and insertion footprint, and the technique of using double rows of suture anchors to recreate the native footprint attachment has been recently described. The transosseous equivalent suture bridge technique has the highest contact pressure and fixation force. In this review, the biomechanical tests about repair techniques of rotator cuff tear will be reviewed and discussed.

• The Journal of the Convergence on Culture Technology
• /
• v.8 no.3
• /
• pp.15-23
• /
• 2022

This study is a non-equivalent control group quasi-experimental design to test the effectiveness of educational programs on human tissue donation for nursing students to change the perception of human tissue donation. The subjects of the study were 75 nursing students located in U city, 38 in the experimental group and 37 in the control group. The data were analyzed using SPSS/WIN 23.0. The average age was 22.39±0.75 years old, women 84.2% and there was no difference in general characteristics and prior data between the two groups. Knowledge (F=-8.921, p<).001, Attitude (F=-5.414, p<).001, perception of death (F=-3.075, p=).004) showed a significant difference, and the educational intervention of nursing students developed to promote human tissue donation showed a positive effect on human tissue donation. When programs to be applied to educational institutions that train not only medical personnel but also experts in other fields must be developed, the establishment and stability of the human tissue donation culture will be solidified. It is also suggested that health care campaigns and education in public educational institutions should be conducted together.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.11
• /
• pp.5299-5304
• /
• 2012

MRI signals are significantly reduced by the magnetic field inhomogenity result from human body itself being consisted of various materials like air, fat, muscle, bone and blood vessels. In this study we used silicon which is tissue equivalent to compensate wound body shapes. Objects were eight adults who do not have any special symptoms. Feet were scanned because of their complicated structures and consequently signal reduction occurs a lot. Thirty images were acquired from the middle of arcus pedis longitudinalis including five distal phalanges parallel to the line connecting metatarsal bone and phalanges. SNR data from bones and soft tissues were compared before and after sticking silion between toes and paired t test was performed. It was came out that SNR data from bone and soft tissue were both significantly higher after applying silicon on both T1 and T2 weighted images and it was statistically meaningful having positive corelation. As a result, this study dramatically increases SNR without affecting object by increasing the object volume inside the surface coil.

• Journal of Radiation Protection and Research
• /
• v.22 no.1
• /
• pp.47-58
• /
• 1997

The conversion coefficients of effective dose per unit air kerma and equivalent dose per unit fluence were calculated by MCNP4A code for antero-posterior(AP) and postero- anterior(PA) incidence of broad, unidirectional beams of photons into anthropomorphic MIRD phantom. Calculations have been performed for 20 monoenergetic photons of energy ranging from 0.03 to 10 MeV. The conversion coefficients showed a good agreement with the corresponding values given in the draft publication of joint task group of ICRP and ICRU within 10%. The deviations may arise from the differences of geometry in the MIRD phantom and the ADAM/EVE phantoms, and the differences in the codes and cross-section data used. Inclusion of a specific oesophagus model results in effective dose slightly different(5% at most) from the effective doses obtained by adopting the equivalent doses for the thymus or pancreas. Deletion of the ULI from the remainder organ appeared not to be significant for the cases of photon dosimetry covered in this study.

• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2002.09a
• /
• pp.90-93
• /
• 2002

In particle radiotherapy, a shape of the beam to conform the irradiation field is statically defined by the compensator, collimator and potal devices at the outside of the patient body. However the target such as lung or liver cancer moves along with respiration. This increases the irradiated volume of normal tissue. Prior discussions about organ motions along with respiration have been mainly focused on inferior-superior movement that was usually perpendicular to beam axis. On the other hand, the change of the target depth along the beam axis is very important especially in particle radiotherapy, because the range end of beam (Bragg peak) is so sharp as to be matched to distal edge of the target. In treatment planning, the range of the particle beam inside the body is calculated using a calibration curve relating CT number and water equivalent path length (WEL) to correct the inhomogeneities of tissues. The variation in CT number along the beam path would cause the uncertainties of range calculation at treatment planning for particle radiotherapy. To estimate the uncertainties of the range calculation associated with patient breathing, we proposed the method using sequential CT images with respiration waveform, and analyzed organ motions and WELs at patients that had lung or liver cancer. The variation of the depth along the beam path was presented in WEL rather than geometrical length. In analyzed cases, WELs around the diaphragm were remarkably changed depending on the respiration, and the magnitude of these WEL variations was almost comparable to inferior-superior movement of diaphragm. The variation of WEL around the lung was influenced by heartbeat.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.25 no.2
• /
• pp.59-75
• /
• 1999

Skin is continuously exposed to external stimuli including ultraviolet radiation, which is a major cause of skin photoaging. According to recent discoveries, UVA with a lower energy but deep-penetrating properties, compared to UVB, is likely to play a major part in causing skin photoaging. The clinical and histochemical changes of photoaging are well characterized, but the biochemical mechanisms are poorly understood partly due to the lack of suitable experimental systems. In this work, three-dimensional, reconstituted skin culture models were prepared. After certain period of maturation, the equivalent models were shown to be similar in structure and biochemical characteristics to normal skin. Mature dermal and skin equivalent models were exposed to sub-lethal doses of UVA, and the effects of UVA relevant to dermal photoaging were monitored, including the production of elastin, collagen, collagenase(MMP-1), and tissue inhibitor of metalloproteinases-1 (TIMP-1). Interestingly, dermal and skin equivalents reacted differently to acute and chronic exposure to UVA. Elastin production was increased as soon as one week after commencing UVA irradiation by chronic exposure, although a single exposure failed to do so. This early response could be an important advantage of equivalent models in studying elastosis in photoaged skin. Collagenase activity was increased by acute UVA irradiation, but returned to control levels after repeated exposure. On the other hand, collagen biosynthesis, which was increased by a single exposure, decreased slightly during 5 weeks of prolonged UVA exposure. Collagenase has been thought to be responsible for collagen degeneration in dermal photoaging. However, according to the results obtained in this study, elevated collagenase activity is not likely to be responsible for the degeneration of collagen in dermal photoagig, while reduced production of collagen may be the main reason. It can be concluded that reconstituted skin culture models can serve as useful experimental tools for the study of skin photoaging. These culture models are relatively simple to construct, easy to handle, and are reproducible Moreover the changes of dermal photoaging can be observed within 1-4 weeks of exposure to ultraviolet light compared to 4 months to 2 years for human or animal studies. These models will be useful for biochemical and mechanistic studies in a large number of fields including dermatology, toxicology, and pharmacology.

• The Journal of Korean Society for Radiation Therapy
• /
• v.18 no.2
• /
• pp.75-80
• /
• 2006

Purpose: In radiation therapy, precise calculation of dose toward malignant tumors or normal tissue would be a critical factor in determining whether the treatment would be successful. The Radiation Treatment Planning (RTP) system is one of most effective methods to make it effective to the correction of dose due to CT number through converting linear attenuation coefficient to density of the inhomogeneous tissue by means of CT based reconstruction. Materials and Methods: In this study, we carried out the measurement of CT number and calculation of mass density by using RTP system and the homemade inhomogeneous tissue Phantom and the values were obtained with reference to water. Moreover, we intended to investigate the effectiveness and accuracy for the correction of inhomogeneous tissue by the CT number through comparing the measured dose (nC) and calculated dose (Percentage Depth Dose, PDD) used CT image during radiation exposure with RTP. Results: The difference in mass density between the calculated tissue equivalent material and the true value was ranged from $0.005g/cm^3\;to\;0.069g/cm^3$. A relative error between PDD of RTP and calculated dose obtained by radiation therapy of machine ranged from -2.8 to +1.06%(effective range within 3%). Conclusion: In conclusion, we confirmed the effectiveness of correction for the inhomogeneous tissues through CT images. These results would be one of good information on the basic outline of Quality Assurance (QA) in RTP system.