• The KIPS Transactions:PartC
• /
• v.11C no.3
• /
• pp.353-360
• /
• 2004

In this Paper, We propose an efficient iteration decoding control method with variable iteration decoding of iteration codes decoding using Cyclic Redundancy Check. As the number of iterations increases, the bit error rate and frame error rate of the decoder decrease and the incremental improvement gradually diminishes. However, when the iteration decoding number is increased, it require much delay and amount of processing time for decoding. Also, It can be observed the error nor that the performance cannot be improved even though increasing of the number of iterations and SNR. So, Suitable number of iterations for stopping criterion is required. we propose variable iteration control method to adapt variation of channel using Frame Error-Check indicator. Therefore, the amount of computation and the number of iterations required for iteration decoding with CRC method can be reduced without sacrificing performance.

• Journal of IKEEE
• /
• v.5 no.1 s.8
• /
• pp.67-74
• /
• 2001

In this paper, we propose a new method to improve tile processing of route recovery of the existing DSR algorithm on detection of route error. In mobile ad hoc networks, mobile nodes themselves have routing capability. Thus, a well-defined routing protocol is required for route set-up between two mobile nodes. However, the existing DSR routing protocol has problem with dropping of packets due to the recovery delay when a route error occurs. In order to alleviate tile problem, we propose an enhanced DSR protocol to reduce the route error recovery tine and evaluate the protocol through simulation. As tile result of evaluation, we found the proposed DSR protocol provided about 4 to 30 times faster route error recovery time according to the test scenario than the existing DSR protocol.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.7
• /
• pp.72-85
• /
• 1998

In this paper, we propose a new method that sequentially estimates TDOA(Time Delay Of Arrival) and FDOA(Frequency Delay Of Arrival) for extracting the information about the bearing and relative velocity of a target in passive radar or sonar arrays. The objective is to efficiently estimate the TDOA and FDOA between two sensor signal measurements, corrupted by correlated Gaussian noise sources in an unknown way. The proposed method utilizes the one dimensional slice function of the third order cumulants between the two sensor measurements, by which the effect of correlated Gaussian measurement noises can be significantly suppressed for the estimation of TDOA. Because the proposed sequential algoritjhm uses the one dimensional complex ambiguity function based on the TDOA estimate from the first step, the amount of computations needed for accurate estimationof FDOA can be dramatically reduced, especially for the cases where high frequency resolution is required. It is demonstrated that the proposed algorithm outperforms existing TDOA/FDOA estimation algorithms based on the ML(maximum likelihood) criterionandthe complex ambiguity function of the third order cumulant as well, in the MSE(mean squared error) sense and computational burden. Various numerical resutls on the detection probability, MSE and the floatingpoint computational burden are presented via Monte-Carlo simulations for different types of noises, different lengths of data, and different signal-to-noise ratios.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.598-601
• /
• 2006

The radio signal in GNSS was intentionally designed with two frequencies in order to combat the dispersion error caused by trans-ionospheric propagation. By measuring the path delay independently at the two, widely spaced GPS frequencies, L1 & L2, the TEC along the path from satellite to receiver can be measured directly. The issue with dual frequency measurement of the ionosphere is the calibration of L1/L2 interfrequency biases. L1/L2 interfrequency biases are generated because physical electric signal paths of L1 and L2 circuits are different from each other for both satellites and receiver. Conventionally L1/L2 interfrequency bias is estimated and broadcasted by 2D ionospheric model. In this paper, we estimated IFB (interfrequency bias) by 2D & 3D ionospheric models including real time filter methods and compared the result of those and concluded the merit of 3D tomography model to recover the problem of 2D thin shell model. We confirmed our conclusion by experimental data.

• Journal of the Korea Society for Simulation
• /
• v.27 no.4
• /
• pp.27-45
• /
• 2018

The terrestrial communication network and the underwater acoustic communication network have very different communication characteristics each other in operational environments, communication media, propagation delay, frequency bandwidth, transmission speed, bit error rate, and so on. These different characteristics cause some different address schemes and different maximum transmission units and, as a result, these differences must form certainly obstacles to the intercommunication between a terrestrial communication network and an underwater acoustic communication network. In this paper, we presents a method to use the virtual addresses to resolve the interconnection problem caused by different address schemes between a terrestrial communication network and an underwater acoustic communication network, and, through a mathematical modeling, we analyze the performance on the message transceiving delay time in the underwater environment.

• Journal of Positioning, Navigation, and Timing
• /
• v.8 no.4
• /
• pp.209-214
• /
• 2019

Precise point positioning (PPP) requires precise orbit and clock products. International GNSS service (IGS) real-time service (RTS) data can be used in real-time for PPP, but it may not be possible to receive these corrections for a short time due to internet or hardware failure. In addition, the time required for IGS to combine RTS data from each analysis center results in a delay of about 30 seconds for the RTS data. Short-term orbit prediction can be possible because it includes the rate of correction, but the clock correction only provides bias. Thus, a short-term prediction model is needed to preidict RTS clock corrections. In this paper, we used a long short-term memory (LSTM) network to predict RTS clock correction for three minutes. The prediction accuracy of the LSTM was compared with that of the polynomial model. After applying the predicted clock corrections to the broadcast ephemeris, we performed PPP and analyzed the positioning accuracy. The LSTM network predicted the clock correction within 2 cm error, and the PPP accuracy is almost the same as received RTS data.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.10A
• /
• pp.1034-1041
• /
• 2007

In this paper, we propose a FD USE (frequency domain minimum mean square error) equalizer algorithm for MBOK DS-UWB (M-ary bi-orthogonal keying direct sequence UWB) systems considered as a PHY proposal for high-speed wireless communication in IEEE 802.15.TG3a. The conventional FD MMSE equalization scheme has a structural limit due to insertion of the cyclic prefix (CP) in all transmit packets, but the proposed scheme is able to equalize the channel effect without CP. In order to overcome channel estimation error by multipath delay, we introduce a moving FFT and a moving average scheme. Compared with conventional FD MMSE equalizer and the traditional TD (time domain) MMSE-RAKE receiver, the proposed FD MMSE equalizer has better BER performance and we demonstrate this result by computer simulation.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.46 no.2
• /
• pp.114-119
• /
• 2009

Sound source localization systems in service robot applications estimate the direction of a human voice. Time delay information obtained from a few separate microphones is widely used for the estimation of the sound direction. Correlation is computed in order to calculate the time delay between two signals. Inverse cosine is used when the position of the maximum correlation value is converted to an angle. Because of nonlinear characteristic of inverse cosine, the accuracy of the computed angle is varied depending on the position of the specific sound source. In this paper, we propose an efficient sound source localization system using angle division. By the proposed approach, the region from $0^{\circ}$ to $180^{\circ}$ is divided into three regions and we consider only one of the three regions. Thus considerable amount of computation time is saved. Also, the accuracy of the computed angle is improved since the selected region corresponds to the linear part of the inverse cosine function. By simulations, it is shown that the error of the proposed algorithm is only 31% of that of the conventional a roach.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.6A
• /
• pp.547-554
• /
• 2010

Recently, the multi-band orthogonal frequency division multiplexing(MB-OFDM) system, one of UWB system, can satisfy the requirement and can be applied to various wireless communication services because ultra-wideband(UWB) is a wireless communication technique that supports high data rate with low power. In this paper, the method applying Alamouti's space time block code(STBC) and cyclic delay diversity(CDD) is proposed. The proposed method can be easily applied with arbitrary number of relays and only needs two time slots of quasi stationary assumption. And it is applied to the MB-OFDM system. Second, an optimal relaying scheme based on decode-and-forward(DF) method is proposed which is provides good error performance compared to conventional schemes.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.8
• /
• pp.549-557
• /
• 2019

In this paper, we focus on the real-time detection method of a seismic ionospheric disturbance using Global Navigation Satellite System (GNSS) signal. First, the monitor for the detection of the seismic ionospheric disturbance is studied based on the estimated ionospheric delay using the GNSS signals. And then, the threshold for the automatic detection is computed. Moreover, to discriminate the seismic ionospheric disturbance against the other ionospheric anomalies due to other error sources such as cycle slips, the signatures of the ionospheric perturbation caused by the seismic wave is investigated. Based on the observation, the detection strategy is proposed. Using GPS observations collected from the 47 permanent stations in South Korea and Japan, the proposed real-time detection method is evaluated.