• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.1690-1695
• /
• 2007

Lightweight metallic truss structures with open, periodic cell are currently being investigated because of their multi-functionality such as thermal management and load bearing. The Kagome truss PCM has been proved that it has higher resistance to plastic buckling, more plastic deformation energy and lower anisotropy than other truss PCMs. The subject of this paper is an examination of the failure mechanism of Wire woven Bulk Kagome(WBK). To address this issue, the out-of-plane compressive responses of the WBK has been measured and compared with theoretical and finite element (FE) predictions. For the experiment, 2 multi-layered WBK are fabricated and 3 specimens are prepared. For the theoretical analysis, the brazed joints of each wire in WBK are modeled as the pin-joint. Then, the peak stress of compressive behavior and elastic modulus are calculated based on the equilibrium equation and energy method. The mechanical structure with five by five cells on the plane are constructed is modeled using the commercial code, PATRAN 2005. and the analysis is achieved by the commercial FE code ABAQUS version 6.5 under the incremental theory of plasticity.

• Journal of Power System Engineering
• /
• v.18 no.5
• /
• pp.137-143
• /
• 2014

An investigation on lightning characteristics and damage to wind turbines was performed on Jeju and Gangwon regions. The lightning data from January 2010 to September 2013 detected by IMPACT ESP were collected and analyzed in detail. Hangyeong and Seongsan wind farms of Jeju province and Taebaek, Changjuk, Taegisan and Gangwon wind farms of Gangwon province were selected for this study. Lightning rates and lightning damage events at the six wind farms were compared with each other. Lightning maps for the two regions were drawn using lightning frequency data. As a result, lightning frequency of Gangwon region was higher than that of Jeju region, while lightning strength of Gangwon was weaker than that of Jeju. Lightning rates were assessed to be good for all of the six wind farms. No lightning damage to wind turbines occurred at the two wind farms of Jeju, while some lightning damage to wind turbines took place at the four wind farms of Gangwon.

• Transactions of the Korean hydrogen and new energy society
• /
• v.21 no.5
• /
• pp.405-411
• /
• 2010

A 5kW class SOFC cogeneration system consisted of a hot box part, a cold BOP (balance of plant) part, and a hot water reservoir. The hot box part contained a stack, a fuel reformer, a catalytic combustor, and heat exchangers. A cold BOP part was composed of blowers, pumps, a water trap, and system control units. A 5kW stack was designed to integrate 2 sub-modules. In this paper, the 5kW class SOFC system was operated using 2 short stacks connected in parallel to test the sub-module and the system. A short stack had 15 cells with $15{\times}15 cm^2$ area. When a natural gas was used, the total power was about 1.38 kW at 120A. Because the sub-modules were connected in parallel and current was loaded using a DC load, voltages of sub-modules were same and the currents were distributed according to the resistance of sub-modules. The voltage of the first stack was 11.46 V at 61A and the voltage of the second stack was 11.49V at 59A.

• Journal of Urban Science
• /
• v.8 no.1
• /
• pp.7-14
• /
• 2019

Recently, interest in solar energy, which is the center of new government energy policy, is increasing. However, the focus is on mass production of solar power plants, and policies and related technologies for maintenance and management of existing installed PV modules are insufficient. In this study, we use UAV (Unmanned Aerial Vehicle) to acquire RGB and infrared images, apply it to the structure-from-motion (SfM) based image analysis tool, model the three- And the position of the hot spot was monitored and coordinates were detected. As a result, it is possible to provide basic spatial information for maintenance of solar module by monitoring and position detection of hot-spot suspected solar cells by superimposing infrared image and RGB image based on unmanned aerial vehicle.

• Economic and Environmental Geology
• /
• v.55 no.1
• /
• pp.1-17
• /
• 2022

The mechanical and thermal properties of the rock masses can affect the performance associated with both the isolating and retarding capacities of radioactive materials within the deep geological disposal system for High-Level Radioactive Waste (HLW). In this study, the essential parameters for the site descriptive model (SDM) related to the rock mechanics and thermal properties of the HLW disposal facilities site were reviewed, and the technical background was explored through the cases of the preceding site descriptive models developed by SKB (Swedish Nuclear and Fuel Management Company), Sweden and Posiva, Finland. SKB and Posiva studied parameters essential for the investigation and evaluation of mechanical and thermal properties, and derived a rock mechanics site descriptive model for safety evaluation and construction of the HLW disposal facilities. The rock mechanics SDM includes the results obtained from investigation and evaluation of the strength and deformability of intact rocks, fractures, and fractured rock masses, as well as the geometry of large-scaled deformation zones, the small-scaled fracture network system, thermal properties of rocks, and the in situ stress distribution of the disposal site. In addition, the site descriptive model should provide the sensitivity analysis results for the input parameters, and present the results obtained from evaluation of uncertainty.

• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.107-116
• /
• 2005

As a unique payload of Komsat-2, MSC, comprising EOS(Electro-Optical Sub-system), PMU(Payload Management Unit) and PDTS(Payload Data Transmission Sub-system), is supposed to take pictures of one panchromatic and 4 multi-spectral image between wavelength 450mm~900mm, and is being under final Satellite I&T. It will perform the earth remote sensing with applications such as acquisition of high resolution images, surveillance of large scale disasters and its countermeasure, survey of natural resources, etc.. Under the hostile influence of the extreme space environmental conditions due to deep space and direct solar flux, the thermal design is especially of major importance in designing a payload. There are tight temperature range restrictions for electro-optical elements while on the other hand there are low power consumption requirements due to the limited energy source on the spacecraft. This paper describes details of thermal control system for MSC.

• Nuclear Engineering and Technology
• /
• v.9 no.4
• /
• pp.211-222
• /
• 1977

The decomposition of all the individual chemicals used in the Harwell inactive vitrification pilot plant has been studied by means of a thermal balance. Weight loss curves to 110$0^{\circ}C$ have been obtained. The four materials (sodium nitrate, cesium nitrate, lithium nitrate and ruthenium nitroso-nitrate solution) showed a greater weight loss than that based on an oxide yield, and hence these compounds of their products of decomposition are volatile below 110$0^{\circ}C$. The remaining materials suffered a weight loss no more than that corresponding to a full yield of the oxide, and hence they were not volatile below 110$0^{\circ}C$. Most of chemicals begin to decompose at less than 75$^{\circ}C$ but the nitrates of cesium, strontium, barium and sodium not until 295$^{\circ}C$ to 59$0^{\circ}C$. The results obtained can be used in the analysis of process conditions in the vitrification and calcination of highly radioactive wastes and also of the thermal decomposition behaviour of mixtures containing those materials.

• Journal of Yeungnam Medical Science
• /
• v.12 no.2
• /
• pp.331-338
• /
• 1995

Laserthermia is a new method of local hyperthermia using fiber optic guided probe with computer controlled Nd-YAG laser system. We used a synthetic sapphire probe and allowed irradiation with contolled low power laser energy (less than 5W), in different thermal condition (temprature: 38.5~50 degrees C) for 10 minutes, in the normal brain tissue of 18 rabbits. In results, the histological changes of brain tissue was variable (myelin condensation, chromatin condensation, nuclear waving and palisading, RBC discoloration, cell necrosis) in microscopic findings after laser irradiation, but changing area was not occured proportionally in thermal condition level. Cell necrosis appears to over 44.5 degrees C and the distance was about 1.25 mm. This study, using computer controlled laserthermia system for interstitial local hyperthermia, may offer many advantages in the experimental treatment and clinical management of tumor. Minimizing normal tissue damage is now being developed.

• Korean Journal of Environmental Agriculture
• /
• v.42 no.2
• /
• pp.83-92
• /
• 2023

Excess N and P from the livestock manure applied to farmlands, have entered the water systems and poses a serious threat to the natural environment. Consequently, there has been recent awareness towards the management of livestock manure and its related fields. In this study, piggery wastewater was collected from a piggery in Pohang city, Korea. At 800℃, thermal decomposition of a natural stone, magnesite (MgCO₃), yielded powered MgO with particle sizes ranging between 10 to 100 ㎛. Furthermore, NH₄⁺-N and PO₄^3--P were recovered as struvite precipitates from the piggery wastewater, by adjusting the pH with MgO and H₃PO₄. At pH 10, the recovery efficiencies of NH₄⁺-N and PO₄^3--P were found to be 86.1% and 94.1%, respectively. Using an X-ray Diffractometer (XRD), the struvite in the precipitate was confirmed to be consistent with standard pure struvite. Further, the purity of the struvite precipitate was analyzed using an energy dispersive X-ray (EDX) and thermal gravimetry-differential thermal analysis (TG-DTA), and found to be between 79.2% and 93.0%. Additionally, struvite-containing piggery wastewater and sawdust were mixed in a weight ratio of 2.5:1 and processed into a mature compost. The newly manufactured compost passed all quality standards required for first-class graded livestock composts. Moreover, this compost was sprayed directly onto the soil at the test site, and various parameters of the soil's effluent, such as total organic carbon (TOC), total nitrogen (T-N), total phosphorus (T-P), and dissolved oxygen (DO), were analyzed and measured. Based on these results, it is determined that the newly manufactured compost can more significantly reduce water pollution than commercial compost.

• Smart Media Journal
• /
• v.12 no.10
• /
• pp.63-70
• /
• 2023

Recently, energy consumption for heating costs, which is 35% of smart farm energy costs, has increased, requiring energy consumption efficiency, and the importance of new and renewable energy is increasing due to concerns about the realization of electricity bills. Renewable energy belongs to hydropower, wind, and solar power, of which solar energy is a power generation technology that converts it into electrical energy, and this technology has less impact on the environment and is simple to maintain. In this study, based on the greenhouse heat storage tank and heat pump data, the factors that affect the heat storage tank are selected and a heat storage tank supply temperature prediction model is developed. It is predicted using Long Short-Term Memory (LSTM), which is effective for time series data analysis and prediction, and XGBoost model, which is superior to other ensemble learning techniques. By predicting the temperature of the heat pump heat storage tank, energy consumption may be optimized and system operation may be optimized. In addition, we intend to link it to the smart farm energy integrated operation system, such as reducing heating and cooling costs and improving the energy independence of farmers due to the use of solar power. By managing the supply of waste heat energy through the platform and deriving the maximum heating load and energy values required for crop growth by season and time, an optimal energy management plan is derived based on this.