• Journal of Broadcast Engineering
• /
• v.15 no.3
• /
• pp.414-425
• /
• 2010

When we implement the single frequency network (SFN) in ATSC terrestrial DTV system, there is an interference problem to DTV receivers due to the use of same frequency channel among transmitters and repeaters. To resolve this problem, it is recommended to adopt the transmitter identification signals in transmitting equipments. In this paper, we analyzed the influence suffered by legacy DTV receivers when the TxID signal is added to the DTV transmitting signals and the results were further verified by computer simulation, laboratory test and field test. The above tests show that if the TxID signal is added to the level of -30dB compared to the original DTV signal, the TOV(Threshold Of Visibility) increment in legacy receivers is about 0.17 dB. It means that we can insert and transmit the TxID signal in ATSC terrestrial DTV system without making the negative effect to the legacy DTV receivers.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.6
• /
• pp.453-460
• /
• 2008

This paper proposes a new multi-output LLC resonant converter by using single control IC, which has the tight-regulated dual output voltage without additional power devices and controller. The proposed converter has master and slave outputs, of which regulations are achieved by the PWM(pulse width modulation) and PFM(pulse frequency modulation), respectively. Different from the conventional dual-output LLC resonant converter, the proposed converter has no additional post-regulators like a boost converter. Therefore, it features a low cost, small size, and high efficiency. To confirm the validity and prove the superiority of proposed converter, simulated and experimental results on a 50" FHD PDP power set prototype are presented.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.6A
• /
• pp.676-684
• /
• 2008

In digital video broadcasting-terrestrial (DVB-T), which is the European digital terrestrial television standard, the orthogonal frequency division multiplexing (OFDM) has been adopted for signal transmission. The main reasons using OFDM are to increase the robustness against the frequency selective fading and impulse noise, and to use available bandwidth efficiently. However, channel variation within an OFDM symbol destroys orthogonality between subcarriers, resulting in inter-carrier interference (ICI), which increases an error floor in proportional to maximum Doppler spread. This paper provides an ICI analysis in both time and frequency domains while existing literatures analyze the ICI effects mainly in frequency domain and proposes the algorithms that estimate the channel impulse response and channel variation using least square (LS) algorithm which is the most simple channel estimation technique. And we propose adaptive channel estimation algorithm that estimates the velocity of terminals. The simulation results show that proposed algorithm has similar performance with about 1.5% computational complexity of noise and ICI reduction LS algorithm in low speed environments.

• Journal of Korea Society of Industrial Information Systems
• /
• v.7 no.2
• /
• pp.74-81
• /
• 2002

In general, a multipath generator consists of a time delay generator, phase rotator, and amplitude attenuator, and is implemented mostly in an analog manner. Analog, or partially analog versions of a multipath generator is disadvantageous in that they may suffer from problems associated with component aging and adjustment, signal fidelity degradation stemming from repeated A/D and D/A conversion use of high frequency to achieve fine i.e., subsample fractional tin delays. This paper presents the design and implementation methodology of a full digital multipath generator which can be used in performance evaluations of digital terrestrial television as well as communications, receivers. In particular, an efficient practical method is proposed which can achieve both integer and fractional time delays simultaneously, without placing restrictions on the allowable system master clock frequency. The proposed algorithm lends itself to minimizing hardware implementation cost by relegating some fixed put of the computation involved to an IBM PC. The proposed multipath generator occupies only a single digital board space, and its experimental results are provided to corroborate the proposed implementation methodology.

• Aerospace Engineering and Technology
• /
• v.12 no.1
• /
• pp.46-53
• /
• 2013

In this study, the analysis of electromagnetic environment of goheung aviation center was performed. If the test object has restrictions to be tested in indoor test facility, open area test site can be used to perform EMC test. Open area test site shall have no obstacles that can generate or reflect the electric field so as to prevent the measurement result from being influenced by unnecessary field. Goheung aviation center is surrounded by fields, and has no buildings that can reflect electric field, so the center can be a good candidate for open area test site. Ambient noise at Goheung aviation center was measured, and the result show that the center has good electromagnetic environment to perform EMC test for large volume object.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12A
• /
• pp.1034-1043
• /
• 2011

As an introduction of an open spectrum allocation approach with technology and service neutrality is expected as a way to solve problems of frequency shortage due to the expansion of demand for wireless multimedia communications, recently, the new management model of interferences and its standard setting are required. In this paper, as a model for this new interference management considering several candidates, Block Edge Mask(BEM) approach is chosen as the most appropriate model. And to investigate the effects of interference resulting from the standard setting of BEM, assuming the use of LTE systems in the Digital Dividend, BEM out-of-band baseline in the boundaries between digital terrestrial television (DTV) service and LTE mobile communications services which are heterogeneous systems for analysis is derived and the effect of setting guard band is analyzed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39B no.8
• /
• pp.510-517
• /
• 2014

Recently, Cable communications services are becoming the HDTV to 3DTV, UHDTV broadcasting and 100Mbps to 1Gbps Internet. however existing technologies are limited to provide high-quality broadband services in the HFC network. The network upgrade technologies have some problems that Up/Downsteam frequency extension, Cost of upgrading by using DOCSIS3.1, EPOC and Legacy STB compatibility, Cost of upgrading the network by RFoG, RF overlay PON. This paper propose the RF/PON based gigabit Transmission system in order to provide the 1Gbps internet without using frequency and the Multiscreen to IP devices. After the proposed RF/PON system was developed and implemented, this paper evaluate the performance of RF/PON system for simultaneously real-time braodcasting and 1Gbps internet, Multiscreen service, and so on.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.417-417
• /
• 2010

작은 직경의 외부 전극 형광램프와 냉음극 형광램프는 LCD-TV의 광원으로 사용하고 있다. 교류 전압으로 구동되는 외부전극 형광램프와 교류 및 직류 전압으로 구동되는 냉음극 형광램프에서 광 방출 신호를 관측하였다. 이러한 빛은 양광주의 고전압부에서 접지부로 $10^5-10^6\;m/s$의 속도로 전파한다. 램프에서 방출된 광이 양광주를 따라 전파하는 현상은 일반 형광등과 네온싸인관에서도 동일하게 관측된다. 이러한 빛의 전파 현상은 지난 70년의 형광 램프 역사상 처음 관측되었다. 양광주 영역의 플라즈마는 높은 전압과 수 십 kHz가 인가되는 전극부에서 발생한 고밀도 플라즈마의 확산으로 생성된다. 고전압이 인가된 전극부에서 발생한 고밀도의 플라즈마는 인가되어지는 구동 주파수에 해당하는 섭동으로 작용하여 플라즈마 파동으로 양광주 영역으로 전파된다. 이러한 플라즈마 파동은 고밀도 전극부에서 저밀도 양광주 영역으로 플라즈마 밀도의 차이에 의하여 된다. 이때 파동의 전파 속도는 관 전류에 따라 달라진다. 타운젠트 방전 이전의 저 전류일 때는 ${\sim}10^5\;m/s$이며, 타운젠트 방전 이후 글로우 방전에서의 전파 속도는 ${\sim}10^6\;m/s$로 증가한다. 또한 타운젠트 방전 이전의 저 전류에서는 파동이 감쇠하는 경향을 보이며, 고 전류에서의 파동의 감쇠는 매우 작다. 관측된 광신호의 결과로부터 전파되는 파동의 원인은 플라즈마 확산에 의한 밀도의 차이에 의한 것으로 해석된다. 즉, 수 십 kHz의 구동 주파수를 갖는 플라즈마 파동이 양광주의 플라즈마 밀도 구배에 의하여 전파된다. 이러한 파동은 높은 전압이 인가되는 전극부에서 낮은 전압부로 향하는 조류의 흐름과 같이 나타난다.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.9 no.2
• /
• pp.52-58
• /
• 2000

the quality of a TV is closely connected with the high quality surface of Braun tube. To get high quality surface an improved grinding system is needed. It has three main parts : the housing part of supporting frame the outershaft part rotat-ed by motor and the innershaft part having eccentricity from the rotation axis of the outershaft. the housing part and the outershaft part are connected by outerbearings, The outershaft part and the innershaft part are connected by innerbearings. Although the outershaft part is rotated at high-speed the innershaft part is not rotated by offset coupling. The high quality grinding surface can be obtained by this mechanism of panel surface grinder, Because the innershaft is unbalanced by eccentricity from rotation axis of outershaft the unbalancing vibration is resulted In this rotor system with high-speed rota-tion the unbalancing vibration makes the opertion unstable. In this research the transfer function is obtained bythe frequency response analysis of finite element model. The simu-lation result is proved by comparing with the experimental result measured by signal analyzer Then the results are corre-lated. in order to improve the design an optimization method is used instead of two-planes balancing method The parts of the 3-dimensional panel surface grinder satisfy the each constraint, The result shows that the design of the panel surface grinder can be optimized.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2016.06a
• /
• pp.295-296
• /
• 2016

본 논문은 ATSC2.0 기반 8-VSB/MH 융합형 3DTV (A/104 Part 5 Service Compatible 3DTV using Main and Mobile Hybrid Delivery) 방식 다중화기 개발에 대한 내용을 기술한다. ATSC A/104 Part 5 SC-MMH 3DTV 방식은 미국의 지상파 DTV 표준화 논의단체인 ATSC 에서 고정 HD 서비스를 위한 8-VSB 채널과, In-band 모바일 TV 서비스를 위한 ATSC M/H 채널을 이용하여, 주파수 효율을 극대화한 새로운 개념의 3D 콘텐츠 전송기술을 도입한 HD 급 지상파 3DTV 방식으로 2014 년 8 월 융합형 3DTV 서비스 시그널링 방안 및 2015 년 10 월 부가정보(VEI: Video Enhancement Information)를 이용한 화질개선 기술을 ATSC 3DTV Standard 로 채택하였다. 본 논문에서는 이와같은 8-VSB/MH 융합형 3DTV Head-End 핵심장비인 8-VSB/MH 융합형 3DTV 다중화기 구현에 대한 내용을 기술한다.