• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.352-360
• /
• 2008

Recently Task Group (TG) 4 of the Institute of Electrical and Electronics Engineers (IEEE) 802.15a has been recommended a system with ranging capability in existence of multiple Simultaneous operating piconets (SOPs) as well as low-cost, low-power. According to the ranging service, coherent and non-coherent based ranging schemes using ternary code have been adopted as a standard. However it is hard to estimate an accurate time of arrival (TOA) in case of using direct sequence based TOA estimation method because pulse repetition interval (PRI) offered by TG is more limited than the maximum excess delay (MED) of channel. To mitigate inter pulse interference (IPI) problem, this paper proposes a non-coherent TOA estimation scheme using non-periodic transmission (NPT) pattern. The proposed receiver is based on a non-coherent energy detection considering with motivation of low rate wireless personal area network (LR-WPAN). TOA information is estimated via proper comparison with a prescribed threshold after the sliding correlation and search back window (SBW) process for reducing TOA error. To verify the performance of proposed ranging scheme, two distinct channel models approved by IEEE 802.15.4a TG are considered. According to the simulation results, we could conclude that the proposed scheme have performed better performance than the conventional method on the existence of multiple SOPs.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.2
• /
• pp.13-25
• /
• 2008

In this paper, we propose the Location Awareness System adjusting Ranging Technology for CSS(Chirp Spread Spectrum) which is adopted on 2.45GHz standard in IEEE 802.15.4a and TOA(Time-of-Arrival) algorithm. The conventional methods have adopted RSSI, ultrasonic waves and infrared rays in Zigbee. RSSI measures strength indication of received signal and recognizes the position of nodes in RF boundary. However, this technology has the following problems; lots of error by the change of the channel environment and much power consumption. In this paper, adopting chirp pulse on 2.45GHz standard in IEEE 802.15.4a and SDS-TWR(Symmetrical Double Side-Two Way Ranging) method using the characteristic of Spread Spectrum, a new Location Awareness System is suggested. The distance and the coordinate are measured within ${\pm}\;5cm$ by TOA(Time of Arrival) algorithm and proposed algorithm and the data in error rate is decreased less than 1%. Through these results, the algorithm suggested in this paper is verified for its performance in a computer simulation.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.4
• /
• pp.96-103
• /
• 2007

In this paper, we present a novel and numerically efficient algorithm for high resolution TOA(Time Of Arrival) estimation under indoor radio propagation channels. The proposed algorithm is not dependent on the structure of receivers, i.e, it can be used with either coherent or non-coherent receivers. The TOA estimation algorithm is based on a high resolution frequency estimation algorithm of Minimum-norm. The efficiency of the proposed algorithm relies on numerical analysis techniques in computing signal or noise subspaces. The algorithm is based on the two step procedures, one for transforming input data to frequency domain data and the other for estimating the unknown TOA using the proposed efficient algorithm. The efficiency in number of operations over other algorithms is presented. The performance of the proposed algorithm is investigated by means of computer simulations.. Throughout the analytic and computer simulation results, we show that the proposed algorithm exhibits superior performance in estimating TOA estimation with limited computational cost.

• ETRI Journal
• /
• v.35 no.3
• /
• pp.361-370
• /
• 2013

In this paper, a packet-reduced ranging method using a superresolution time of arrival estimation algorithm for a chirp-based real-time locating system is presented. A variety of ranging methods, such as symmetric double-sided two-way ranging (SDS-TWR), have been proposed to remove the time drift due to the frequency offset using extra ranging packets. Our proposed method can perform robust ranging against the frequency offset using only two ranging packets while maintaining almost the same ranging accuracy as them. To verify the effectiveness of our proposed algorithm, the error performance of our proposed ranging method is analyzed and compared with others. The total ranging performance of TWR, SDS-TWR, and our proposed TWR are analyzed and verified through simulations in additive white Gaussian noise and multipath channels in the presence of the frequency offset.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.8
• /
• pp.1789-1798
• /
• 2012

IEEE 802.15.4a standard can provide a variety of location-based services for ZigBee or wireless network applications by adapting the time-of-arrival (TOA) ranging technique. The non-line-of-sight (NLOS) condition is the critical problem in the IEEE 802.15.4a networks, and it can significantly degrade the performance of the TOA-based localization. To enhance the location accuracy due to the NLOS problem, this paper proposes an energy-efficient low complexity localization algorithm. The proposed approach performs the ranging with the multicast method, which can reduce the message overhead due to packet exchanges. By limiting the search region for the location of the node, the proposed approach can enhance the location accuracy. Experimental results show that the proposed algorithm outperforms previous algorithms in terms of the energy consumption and the localization accuracy.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.2
• /
• pp.146-153
• /
• 2013

The IR-UWB radar system radiates a pulse whose width is several hundred pico sec at Tx antenna and check the time to receive the pulse that reflected from target to measure the TOA. In this paper, we present a new algorithm which supplement the conventional ranging algorithm for more accurate estimation. We get received signal data using IR-UWB Radar module which equipped a NVA6000 UWB Transceiver and analysis the data of multi-path. Consequently, we found the property of UWB multi-path signal, which best fit a Gamma distribution. so we present a algorithm using Gamma-distribution and compared a performance with conventional ranging algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.7C
• /
• pp.608-615
• /
• 2007

Generally time of arrival (TOA) information via two way communications can be derived by accurate round trip time (RTT) between two devices. However, response time demanded in RTT measurement is long, a serious TOA error is caused by each different clock drift between two devices. In order to solve this problem, we propose the TOA and time difference of arrival (TDOA) estimation scheme with mitigating clock drift effect. To verify the performance of proposed method, we compared the proposed scheme with one way based TDOA acquisition method introduced by IEEE 802.15.4a Task Group and then we could conclude that the proposed method has better performance over other methods.

• Journal of IKEEE
• /
• v.20 no.1
• /
• pp.1-8
• /
• 2016

In this paper, we propose an effective time-of-arrival (TOA)-based localization method with adaptive bias computation in indoor environments. The goal of the localization is to estimate an accurate target's location in wireless localization system. However, in indoor environments, non-line-of-sight (NLOS) errors block the signal propagation between target device and base station. The NLOS errors have significant effects on ranging between two devices for wireless localization. In TOA-based localization, finding the target's location inside the overlapped area in the TOA-circles is difficult. We present an effective localization method using compensated distance with adaptive bias computation. The proposed method is possible for the target's location to estimate an accurate location in the overlapped area using the measured distances with subtracted adaptive bias. Through localization experiments in indoor environments, estimation error is reduced comparing to the conventional localization methods.

• Journal of Advanced Navigation Technology
• /
• v.23 no.5
• /
• pp.437-443
• /
• 2019

In this paper, a new algorithm for the calculation of the range between an LTE base station (BS) and a user equipment (UE) using time-of-arrival (TOA) measurements of LTE signals is proposed. First, the cell identity (cell ID) of the received signal is acquired using the primary synchronization signal (PSS) and secondary synchronization signal (SSS) to identify the BS transmitted the signal. The proposed algorithm exploits the cell-specific reference signal (CRS), the reference sequence inserted in commercial LTE signals, to estimate the time delay using 2D cross-correlation. The obtained TOA estimations can be used to calculate the range employed from the known BS location. The performance of the proposed algorithm is evaluated with the experiment performed using real LTE signals transmitted from the commercial BS.

• Journal of Positioning, Navigation, and Timing
• /
• v.5 no.3
• /
• pp.137-144
• /
• 2016

In this paper, the performance of ranging measurement, which is generated using two receiver clock offsets in one receiver, was analyzed. A spoofer transmits a counterfeited spoofing signal which is similar to the GPS signal with hostile purposes, so the same tracking technique can be applied to the spoofing signal. The multi-correlator can generate two receiver clock offsets in one receiver. The difference between these two clock offsets consists of the path length from the spoofer to the receiver and the delay of spoofer system. Thus, in this paper, the ranging measurement was evaluated by the spoofer localization performance based on the time-of-arrival (TOA) technique. The results of simulation and real-world experiments show that the position and the system clock offset of the spoofer could be estimated successfully.