• Structural Engineering and Mechanics
• /
• v.72 no.5
• /
• pp.541-555
• /
• 2019

Wind induced dynamic responses on hyperbolic cooling tower (HCT) shells are complicated functions of structure and wind properties, such as the fundamental frequency f_min, damping ratio ζ, wind velocity V, correlationship in meridian direction and so on, but comprehensions on the sensitivities of the dynamic responses to these four factors are still limited and disagree from each other. Following the dynamic calculation in time domain, features of dynamic effects were elaborated, focusing on the background and resonant components σ_B and σ_R, and their contributions to the total rms value σ_T. The σ_R is always less than σ_B when only the maximum σ_T along latitude is concerned and the contribution of σ_R to σ_T varies with responses and locations, but the σ_R couldn't be neglected for structural design. Then, parameters of the above four factors were artificially adjusted respectively and their influences on the gust responses were illustrated. The relationships of σ_R and the former three factors were expressed by fitted equations which shows certain differences from the existing equations. Moreover, a new strategy for wind tunnel tests aiming at surface pressures and the following dynamic calculations, which demands less experiment equipment, was proposed according to the influence from meridian correlationship.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.91-98
• /
• 2013

Magnetic sensor chip for measuring bio-magnetism is implemented in $0.18{\mu}m$ CMOS technology. The magnetic sensor chip consists of a small-sized high inductance coil sensor and an instrumentation amplifier (IA). High inductance coil sensor with suitable sensitivity and bandwidth for measurement of bio-magnetic signal is designed using electromagnetic field simulation. Low gm operational transconductance amplifier (OTA) using transconductance reduction techniques is designed for on-chip solution. Output signal sensitivity of magnetic sensor chip is $3.25fT/{\mu}V$ and reference noise of 21.1fT/${\surd}$Hz. Proposed IA is designed along with band pass filters(BPF) to reduce magnetic signal noise by using current feedback techniques. Proposed IA achieves a common mode rejection ratio of 117.5dB while the input noise referred is kept below $0.87{\mu}V$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.4
• /
• pp.396-405
• /
• 2009

This paper describes playback downlink and telecommand uplink channel design performed for a transportable small-sized KOMPSAT(Korea Multi-Purpose Satellite) ground station. As a result of downlink channel design, required receiving performance was calculated from the threshold signal-to-noise ratio of playback signal and it was revealed that this performance can be guaranteed in 1.5 m ground station with 6.5 dB/K of G/T. For the uplink channel design, 40 dBW of EIRP was derived from the threshold signal-to-noise ratio of telecommand signal received at on-board receiver. The implemented small-sized ground station based on design was evaluated to be fully acceptable for KOMPSAT TT&C(Telemetry, Tracking and Command) system and playback downlink design without taking account of additional 3 dB system link margin was shown to be effective because it had provided constantly initial channel performance without any remarkable degradation over several years of tests with KOMPSAT and KOMPSAT-2, for both uplink and playback downlink in the elevation angle above $10^{\circ}$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.6
• /
• pp.455-459
• /
• 2001

In this paper, the dielectric and pizoelectric properties of 0.05Pb(M $n_{04}$ $W_{0.2}$N $b_{0.4}$) $O_3$-0.95(PbZ $r_{x}$ $Ti_{1-x}$ ) $O_3$+yN $b_2$ $O_{5}$ , are investigated as a function of the mole ratio of Zr and the amount of N $b_2$ $O_{5}$ . Also, the phase is analyzed by XRD. When the mole ratio of Zr is 0.51, the electromechanical coupling coefficient( $k_{p}$ ), relative dielectric constant ($\varepsilon$$^{T}$ $_{33}$ /$\varepsilon$$_{0}$ ), piezoelectric stain constrain ( $d_{33}$ and dielectric loss tangent show maximum, while the mechanical quality factor shows minimum value ; $k_{p}$ =56.5%, $d_{33}$ =258pC/N, $\varepsilon$$^{T}$ $_{33}$ /$\varepsilon$$_{0}$ =1170, $Q_{m}$ =1150, tan$\delta$=0.51%. At that composition, MPB which rhombohedral and tetragonal phase coexist in this ternary system is shown by the results of XRD analysis. Also, when the amount of N $b_2$ $O_{5}$ is 0.3wt%, the mechanical quality factor is increased to about 2000. The phase transition temperature of the ternary piezoelectric ceramic system showed about 35$0^{\circ}C$.TEX>.>.>.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.7
• /
• pp.1022-1032
• /
• 1999

The radiation characteristics of a microstrip circularly-polarized aperture-patch $8\times8$ array antenna are investigated at X-band. The radiator consists of a truncated square aperture on the ground plane with an inclined rectangular patch inside, and it is coupled by a microstrip line on the opposite side of the ground. The element spacing of the array was chosen as $0.8\lambda_0$so as to minimize the mutual coupling and maximize the gain. A corporate feed network was employed to distribute the power to each element through four Wilkinson and two T-junction dividers. Measurement results for the $8\times8$ array at 10 GHz showed a directivity of 26.3 dBi, a gain of 22.2 dBi, an axial ratio of 2.97 dB, and a side lobe level of -12.7dB. It was observed that when the array size increases, the directivity increases while the efficiency decreases.

• Reproductive and Developmental Biology
• /
• v.28 no.4
• /
• pp.227-233
• /
• 2004

This study was conducted to investigate the effect of various addition and exclusion time of glucose (Control: no addition, A: 24～72 h, B: 24～48 h, C: 48～72 h, D: 0～72 h, E: 0～48 h, F: 0～24 h and 48～72 h, G: 0～24 h) on embryonic developmental capacity of 2-cell embryos in mice. Developed blastocysts were assessed for mean cell number by differential staining. The zona-intact blastocyst (ZiB) rates were higher (p<0.05) in group B than control. However, the zona-escape blastocyst (ZeB) rates were not significantly different in all groups. At 72 h, total blastocyst (ZiB + ZeB) formation rates were not significantly different in all groups. The mean cell number was not significantly different among all groups. The inner cell mass (ICM) cell number was higher (p<0.05) in group F than control, group A, B and G. The trophectoderm (TE) cell number was higher (p<0.05) in control than group A and D. The %ICM was higher (p<0.05) in group C, D and F than control. The ICM : TE ratio was not significantly different in all groups. Between control and glucose group, no significant difference was observed in the total blastocysts (ZiB + ZeB) formation rates. Also, no significant difference was observed in the mean cell number, ICM cell number and ICM : TE ratio. However the TE cell number was higher (p<0.05) in control than glucose group and %ICM was higher (p<0.05) in glucose group than control. In conclusion, glucose added in culture medium was not inhibitory on blastocyst formation but glucose added for 48 ～72 h in culture medium increases %ICM of blastocysts in mice.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.10
• /
• pp.1915-1919
• /
• 2008

Second-order rate constants ($k_N$) have been measured spectrophotometrically for reactions of 3,4-dinitrophenyl benzoates (5b) with a series of alicyclic secondary amines in 80 mol % $H_2O$/20 mol % DMSO at 25.0 ${\pm}$ 0.1 ${^{\circ}C}$. The kinetic data have been compared with the data reported previously for the corresponding reactions of 2,4- dinitrophenyl benzoates (5a) to investigate the effect of changing the nucleofuge from 2,4-dinitrophenoxide to 3,4-dinitrophenoxide on reactivity and mechanism. The kinetic results show that aminolyses of 5a and 5b proceed through the same mechanism, i.e., a zwitterionic tetrahedral intermediate ($T^{\pm}$) with a change in the rate-determining step (RDS). Substrate 5a is more reactive than 5b when breakdown of $T^{\pm}$ is the RDS but less reactive when formation of $T^{\pm}$ is the RDS. Dissection of kN values into the microscopic rate constants (e.g., $k_1$ and $k_2/k_{-1 }$ ratio) has revealed that 5a results in larger $k_2/k_{-1}$ ratios but smaller k1 values than 5b for all the amines studied. Since 2,4-dinitrophenoxide is less basic and a better nucleofuge than 3,4-dinitrophenoxide, the larger $k_2/k_{-1}$ ratios determined for the reactions of 5a than for those of 5b are as expected. The steric hindrance exerted by the ortho-nitro group on 5a contributes to the smaller k1 values found for the reactions of 5a than for those of 5b.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.4
• /
• pp.11-20
• /
• 1994

The error rate equation of DS-CDMA/DQPSK skgnal adopting ARQ scheme has been derived in indoor radio channel which is characterized by AWGN, multi-user interference (MUI) and Rician fading, Using the derived equation the error performance has been evaluated and shown in figures as a function of direct to diffuse signal power ratio(KS1rT), the number of active users (K), PN code sequence length (N), the number of parity bit of linear code (b), forward channel BER, and ES1bT/NS1OT. From the results it is known that in severe fading environments (KS1rT=6) the performance of DS-CDMA/DQPSK system is not reliable so it is needed to adopt techniques for improvement. When an ARQ scheme is adopted, as a method for improving error performance, the performance improves compared with that of non-ARQ scheme and the degree of improvement is proportional to the number of parity bits of linear code. As increasing the number of parity bits, system performance is improved vut system throughput efficiency must be considered. In severe fading channel Hybrid ARQ scheme is more effective than ARQ scheme. As a result, ARQ scheme is appropriate for the high-reliability data communication systems over the radio channel in which the real time processing is not required.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.2
• /
• pp.191-203
• /
• 2016

To investigate the dynamic sorptive and hygroexpansive behaviors of wood by different cyclic hygrothermal changing effects, poplar (populus euramericana Cv.) specimens, were exposed to dynamic sorption processes where relative humidity (RH) and temperature changed simultaneously in sinusoidal waves at 75-45% and $5-35^{\circ}C$ (condition A) and where RH changed sinusoidally at 75-45% but temperature was controlled at $20^{\circ}C$ (condition B), both for three cyclic periods of 1, 6, and 24 h. Moisture and dimensional changes measured during the cycling gave the following results: Moisture and transverse dimensional changes were generally sinusoidal. Moisture and dimensional amplitude increased with increasing cyclic period but all were lower for thicker specimens. The amplitude ratio of condition A to condition B ranged from 1.0 to 1.6 with the maximum value of 1.57 occurring at the shortest cyclic period, not as much as expected. T/R increased as cyclic period increased or specimen thickness decreased. T/R from condition B was weaker than that from condition A. Sorption and swelling hysteresis existed in both conditions. Sorption hysteresis was negatively related to cyclic period but in positive correlation with specimen thickness. Sorption hysteresis was found more obvious in condition B, while moisture sorption coefficient and humidity expansion coefficient showed the opposite results.

• ETRI Journal
• /
• v.35 no.3
• /
• pp.371-377
• /
• 2013

An effective signal detection algorithm with low complexity is presented for multiple-input multiple-output orthogonal frequency division multiplexing systems. The proposed technique, QR-MLD, combines the conventional maximum likelihood detection (MLD) algorithm and the QR algorithm, resulting in much lower complexity compared to MLD. The proposed technique is compared with a similar algorithm, showing that the complexity of the proposed technique with T=1 is a 95% improvement over that of MLD, at the expense of about a 2-dB signal-to-noise-ratio (SNR) degradation for a bit error rate (BER) of $10^{-3}$. Additionally, with T=2, the proposed technique reduces the complexity by 73% for multiplications and 80% for additions and enhances the SNR performance about 1 dB for a BER of $10^{-3}$.